English dropdown-ico

Manual Optoma Technology EP730

27 pages 1.8 mb
Download

Go to site of 27

Summary
  • Optoma Technology EP730 - page 1

    FCC Notice This equi pment ha s been tested a nd found to comply with the li mits for a Cla ss B digital device, pursua nt to Part 15 of FCC Rules. These limits are designed to pro- vide reasonable protection against harmful interference in a residential installation. Trademarks Trademarks are the rights of their respective owners. ...

  • Optoma Technology EP730 - page 2

    1 English Usage Notice Precautions .......................................................................................... 2 Introduction Product Features .................................................................................. 3 Package Overview ............................................................................... 4 Product ...

  • Optoma Technology EP730 - page 3

    2 English Precautions Follow all warnings, pr ecautions a nd maintena nce a s recommended in this user’s ma nual to maxi mize the life of your unit. Do: q Turn off the product before cleaning. q Use a soft cloth moistened with mild detergent to clean the display housing. q Disconnect the power plug from AC outlet if the product is not being used ...

  • Optoma Technology EP730 - page 4

    3 English Product Features This pr oduct, is a n SV GA single chi p 0.7” DLP ä Pr ojector . The outsta nding featur es of it ar e listed a s follows: q T rue SV GA, 800 x 600 addre ssa ble pixels q 3.3 lbs. (1.5 kgs) lightweight compa ct design q Single chi p DLP ä technology q XGA compression a nd V GA, SV GA re-sizing q 130 W atts user repla ...

  • Optoma Technology EP730 - page 5

    4 English Package Overview This pr ojection display comes with all the items shown below . Check to ma ke sur e your unit is complete. Conta ct your dealer i mmedi ately if a nything is missing. Projection Display Power Cord S-Video Cable RCA Audio Ca ble V GA Sign al Ca ble Remote Control Carrying Case Warranty Card Composite Video Cable RCA to D- ...

  • Optoma Technology EP730 - page 6

    5 English Product Overview Spe a ker Focus Ring Remote Control Receiver Zoom Ring Zoom Lens Power Connector Elevator Button Connection Ports HDTV/Component Video & Computer Input Connector S-video Input Connector Audio Input Connector Composite Video Input Connector Pa nel Control Power On / Sta ndby Menu (On/Off) Enter / Resync Source Four Dir ...

  • Optoma Technology EP730 - page 7

    6 English Re mote Control Source Resync Reset Freeze Keystone Correction Power / Sta ndby V olume ( + / - ) Mute Four Direction al Select Keys Enter Menu Zoom In / Zoom Out ...

  • Optoma Technology EP730 - page 8

    7 English Connecting the Projector Installation v T o ensur e the pr ojector works well with your computer , plea se configur e the display mode of your gra phic card to ma ke it less tha n or equal to 800 X 600 r esolution. M a ke sur e timi mg of the display mode is compatible with the pr ojector . Refer to the“Compatibility Modes”section on ...

  • Optoma Technology EP730 - page 9

    8 English u u u u u Powering On the Projector 1. Remove the lens ca p.  2. Ensure that the power cord a nd signal ca ble are securely connected. 3. The “Power/Sta ndby” indicator will fla sh.  And press the “Power/Sta ndby” button again to start on your projector. The startup screen will display for 20 seconds a nd the Power/Sta ndby ...

  • Optoma Technology EP730 - page 10

    9 English u u u u u Powering Off the Projector 1. Press the “Power/Sta ndby” button to turn off the projector la mp. 2. After pressing the “Power/Sta ndby” button, you will see a message “Power off the la mp?” on the on-screen display . Press the “Power/Sta ndby” button again to confirm. Otherwise the message will disappear after 5 ...

  • Optoma Technology EP730 - page 11

    10 English Adjusting the Projected Image u u u u u Adjusting the Projector He ight The projector is equi pped with a n elevator foot for a djusting the projector height. T o raise the projector: 1. Press the elevator button  . 2. Raise the projector to the desired display a ngle  , then relea se the button to lock the elevator foot into posit ...

  • Optoma Technology EP730 - page 12

    11 English . x a M " 5 2 " 8 9 " 3 2 1 " 7 9 1 " 6 4 2 " 0 0 3 . n i M" 0 2" 2 8" 2 0 1" 3 6 1" 4 0 2" 5 4 2 ) H x W ( . x a M " 0 . 5 1 x " 0 . 0 2 " 8 . 8 5 x " 4 . 8 7 " 8 . 3 7 x " 4 . 8 9 " 2 . 8 1 1 x " 6 . 7 5 1 " 6 . 7 4 1 x " 8 . 6 ...

  • Optoma Technology EP730 - page 13

    12 English Pa nel Contr ol & Remote Contr ol Ther e ar e two ways for you to contr ol the functions: Remote Contr ol a nd Pa nel Control. User Controls Power / Sta ndby 4 Refer to the “Power On/Of f the Projection Display” section on page 8~9. Source 4 Press “Source” to choose R GB, Digital RGB, S-V ideo a nd Composite sources. Reset 4 ...

  • Optoma Technology EP730 - page 14

    13 English Use the Pa nel Contr ol 4 Automatically synchronizes the projector to the input source, when you press this button while the OSD isn’t displayed. Four Dir e ctional Select Keys 4 Use or to select items. Use or to make a djustments for your selection. Menu 4 Press “Menu” to open the on-screen display (OSD) menus a nd press key to se ...

  • Optoma Technology EP730 - page 15

    14 English 4 The Pr ojector ha s a multilingual On-Screen Display(OSD) menu that allows you to ma ke i mage adjustments a nd cha nge a variety of settings. In computer sour ce, the OSD will be the “Computer OSD”. In video sour ce, the OSD will be the “ V ideo OSD”. The projector will detect the sour ce automatically . 4 T o open the OSD men ...

  • Optoma Technology EP730 - page 16

    15 English 4 Brightness Adjusting the brightness of the image. l Press the to darken the image. l Press the to lighten the image. 4 Contra st The contra st controls the degree of dif ference between the lightest a nd darkest parts of the picture. Adjusting the contra st cha nges the amount of bla ck a nd white in the i mage. l Press the to decrease ...

  • Optoma Technology EP730 - page 17

    16 English 4 Brightness Adjusting the brightness of the image. l Press the to darken the image. l Press the to lighten the image. 4 Contra st The contra st controls the degree of dif ference between the lighte st a nd darkest parts of the picture. Adjusting the contrast cha nges the a mount of black a nd white in the i mage. l Press the to decrease ...

  • Optoma Technology EP730 - page 18

    17 English 4 Frequency “Frequency” is for cha nging the display data frequency to match the frequency of your computer’s graphic card. When you experience a vertical flickering bar, use this function to make a n a djustment. 4 T ra cking Choose “ Tracking” item to synchronize the signal timing of the display with that of the graphic card. ...

  • Optoma Technology EP730 - page 19

    18 English Audio Image-I Image-II La nguage M a n agement Keystone 16:9 / 4:3 Color T emp. Reset Ye s No Video mode Image-II (V ideo mode) 4 Keystone Correction Adjusts image distortion caused by tilting the projector. 4 16 : 9 / 4 : 3 Y ou ca n select this function to fit your desired a spect ratio type. 4 Color T e mperature Adjusts the color tem ...

  • Optoma Technology EP730 - page 20

    19 English 4 V olume l Press the to decrease the volume. l Press the to increase the volume. 4 T reble The treble setting controls the higher frequencies of your audio source. l Press the to decrease the treble. l Press the to increase the treble. 4 Ba ss The Bass setting controls the lower frequencies of your audio source. l Press the to decrease ...

  • Optoma Technology EP730 - page 21

    20 English 4 Menu Location Choose the Menu location on the display screen. 4 Projection l Front-Desktop The factory default setting. l Rear -Desktop When you select this function, the projector reverses the i mage so you ca n project behind a tra nslucent screen. l Front-Ceiling When you select this function, the projector turns the image upside do ...

  • Optoma Technology EP730 - page 22

    21 English Problem: No image appears on screen. 4 Ensure all the ca bles a nd power connections are correctly a nd securely connected as described in the “Installation” section. 4 Ensure the pins of connectors are not crooked or broken. 4 Check if the projection la mp ha s been securely installed. Plea se ref er to the “Cha nging the lamp” ...

  • Optoma Technology EP730 - page 23

    22 English 4 If you are using a Notebook PC: 1. Y ou are required to i mple ment a bove steps of resolution setting of computer first. 2. Switch the Notebook PC display to the “external display only” or “CR T only” mode. 4 If you are experiencing dif ficulty in cha nging resolutions or your monitor freezes, restart all the equipment and the ...

  • Optoma Technology EP730 - page 24

    23 English Proble m : The screen is outstr etched when displaying 16:9 D V D. The projector itself will automatically detect 16:9 D V D a nd a djust the aspect ratio by digitiza- tion to full screen with 4:3 default setting. If the projector is still outstretched, you will also need to a djust the aspect ratio by ref erring to the following: 4 Plea ...

  • Optoma Technology EP730 - page 25

    24 English Changing the lamp The projection display will detect the la mp lif e itself. It will show you a warning message “ Lamp is running out of standard lifetime. Be sure to replace the lamp as soon as possible.”. When you see this message, change the lamp as soon as possible. M ake sure the projector ha s been cooled down f or at lea st 30 ...

  • Optoma Technology EP730 - page 26

    25 English Specifications Light V alve - Si ngle Chi p DLP TM T echnology Contra st Ratio - 500:1 (Full On / Full Off) La mp - 130W User Repla cea ble P-VIP La mp Number of Pixels - 800 pixels(H) X 600 lines(V) Displayable Color - 16.7M colors Projection Lens - F2.2~2.4 f=28.51~34.21mm with 1.2 x zoom & focus Projection Screen Size - 20”~300? ...

  • Optoma Technology EP730 - page 27

    26 English A G V A S E V 0 5 3 X 0 4 6 0 7 5 . 1 3 A G V A S E V 0 5 3 X 0 4 6 5 8 9 . 7 3 A G V A S E V 0 0 4 X 0 4 6 0 7 5 . 1 3 A G V A S E V 0 0 4 X 0 4 6 5 8 9 . 7 3 A G V A S E V 0 8 4 X 0 4 6 0 6 5 . 1 3 A G V A S E V 0 8 4 X 0 4 6 2 7 9 . 7 3 A G V A S E V 0 8 4 X 0 4 6 5 7 5 . 7 3 A G V A S E V 0 8 4 X 0 4 6 5 8 3 . 3 4 A G V A S E V 0 0 4 ...

Manufacturer Optoma Technology Category Projector

Documents that we receive from a manufacturer of a Optoma Technology EP730 can be divided into several groups. They are, among others:
- Optoma Technology technical drawings
- EP730 manuals
- Optoma Technology product data sheets
- information booklets
- or energy labels Optoma Technology EP730
All of them are important, but the most important information from the point of view of use of the device are in the user manual Optoma Technology EP730.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Optoma Technology EP730, service manual, brief instructions and user manuals Optoma Technology EP730. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Optoma Technology EP730.

Similar manuals

A complete manual for the device Optoma Technology EP730, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Optoma Technology EP730 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Optoma Technology EP730.

A complete Optoma Technology manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Optoma Technology EP730 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Optoma Technology EP730, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Optoma Technology EP730, that we can find in the current document
3. Tips how to use the basic functions of the device Optoma Technology EP730 - which should help us in our first steps of using Optoma Technology EP730
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Optoma Technology EP730
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Optoma Technology EP730 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Optoma Technology EP730?

Use the form below

If you did not solve your problem by using a manual Optoma Technology EP730, ask a question using the form below. If a user had a similar problem with Optoma Technology EP730 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)