English dropdown-ico

Manual Audiovox APS 500

24 pages 0.41 mb
Download

Go to site of 24

Summary
  • Audiovox APS 500 - page 1

    Model APS 500 Installation Manual SELECTABLE FEATURES Note : The method of manual override can either be selected to operate from the valet switch or operate as custom code. Be certain to place a check mark indicating the method used in the box located on the last page of the owner's manual. Dip Switch Selectable Features : Switch Number ON Po ...

  • Audiovox APS 500 - page 2

    Page 2 INSTALLATION OF MAJOR COMPONENTS Control Module : Select a mounitng location inside the passenger compartment ( up behind the dash ), and secure using the two screws provided. The control module can also be secured in place using cable ties. Do not mount the control module in the engine compartment, as it is not waterproof. Y ou should also ...

  • Audiovox APS 500 - page 3

    Page 3 WIRING THE SYSTEM Large 8 Pin Edge Connector : Red Fused Wire : + 12 VDC CONSTANT BATTERY SOURCE This wire controls the sensitivity of the voltage sensing circuit, which detects the turning on of an interior light when a door is opened. It will also detect the switching on of parking or headlamps, and in many cases will trigger the alarm whe ...

  • Audiovox APS 500 - page 4

    Orange Wire : 300 mA GROUND OUTPUT WHEN ARMED - N. C. STARTER DISABLE This wire is provided to control the starter cut relay . Connect the orange wire to terminal 86 of the relay . Connect relay terminal 85 to an ignition wire in the vehicle that is live when the key is in the on and crank positions, and off when the key is in the of f position. ( ...

  • Audiovox APS 500 - page 5

    Page 5 Orange w/ White T race Wire : 300 mA Ground Output When Disarmed - N. O. S tarter Disable This wire is provided to control the starter cut relay. Connect the orange w/white trace wire to terminal 86 of the relay. Connect relay terminal 85 to an ignition wire in the vehicle that is live when the key is in the on and crank positions, and off w ...

  • Audiovox APS 500 - page 6

    Page 6 4 Pin White Connector : SHOCK SENSOR Route the red, black, blue, and green wires in the 4 pin white connector from the shock sensor to the control module, and plug one end into the shock sensor , and the other end into the mating white connec- tor on the side of the module. Red & Green 2 Pin White Connector : DOOR LOCK OUTPUTS These wire ...

  • Audiovox APS 500 - page 7

    Page 7 RED TO +12 VDC IGN./CRANK 87A 85 86 30  CUT  EXISTING +12 VOLT PARKING LIGHT WIRE +12 VDC BATTERY Connect to a +12 Volt Battery Source. (See Note on Voltage Sensing) RED w/WHITE WHITE BLACK EXISTING PARKING LIGHT  SHOCK SENSOR Red, Black, Blue, and Green WIres. APS-500 CONTROL MODULE DARK BLUE CHANNEL 2 Negative Pulsed Output for Op ...

  • Audiovox APS 500 - page 8

    APS-500 CONTROL MODULE Page 8 BLACK +  DOOR LOCK OUTPUTS (+) Lock Pulse (-) Unlock Pulse (-) Lock Pulse (+) Unlock Pulse GREEN RED LT. BLUE L.E.D. ZONE 1 Optional Negative Triggering Alarm Accessories LT. GREEN HEADLIGHT OUTPUT 30 Second Ground Output During Arm & Disarm (Optional Relay Required) WHITE w/BLUE IGNITION SOURCE To +12 Volts Ign ...

  • Audiovox APS 500 - page 9

    SÉLECTION DES FONCTIONS Remarque: On peut choisir une des deux méthodes de dérivation manuelle: soit par l'interrupteur de sevice voiturier, soit par le code personnalisé. Assurez-vous de bien indiquer quelle est la méthode employée en cochant la case appropriée á l dernière page du manuel d'utilisation. Fonctions sélectionnées ...

  • Audiovox APS 500 - page 10

    Page 10 INSTALLATION DES COMPOSANTS PRINCIPAUX MODULE DE COMMANDE: Choisir un emplacement de fixation à l’intérieur du compartiment passager (en haut sous le tableau de bord) et serrer à l’aide des deux vis fournies. On peut également fixer le module de commande en place à l’aide de serre-câbles. Ne pas monter le module de commande dans ...

  • Audiovox APS 500 - page 11

    Page 1 1 CÂBLAGE DU SYSTÈME Gros connecteur de bord à 8 broches: FIL ROUGE À FUSIBLE: TENSION POSITIVE 12 VOL TS, COURANT CONTINU ST ABLE DE LA BA TTERIE Ce fil commande la sensibilité du circuit de détection de tension qui capte l’allumage et l’extinction des lampes intérieures lorsqu’on ouvre une porte. Il détecte également l’all ...

  • Audiovox APS 500 - page 12

    Page 12 FIL ORANGE: SORTIE DE MISE À LA MASSE DE 300 mA LORSQUE LE CIRCUIT EST ARMÉ. CIRCUIT NORMALEMENT OUVERT , DÉSACTIV A TION DU DÉMARREUR Ce fil est fourni pour commander le relais de coupure du circuit de démarreur . Connecter le fil orange à la borne 86 du relais. Connecter la borne 85 du relais à un fil d’allumage du véhicule qui ...

  • Audiovox APS 500 - page 13

    FIL ORANGE À RUBAN BLANC: SORTIE DE MISE À LA MASSE DE 300 mA - CIRCUIT NORMALEMENT OUVER T , DÉSACTIV A TION DU DÉMARREUR Ce fil est fourni pour commander le relais de coupure du démarreur . Connecter le fil orange à ruban à blanc la borne 86 du relais. Connecter la borne 85 du relais à un fil d’allumage du véhicule qui est chaud lorsqu ...

  • Audiovox APS 500 - page 14

    Page 14 CONNECTEUR BLANC À QUA TRE BROCHES : DÉTECTEUR DE VIBRA TIONS Faire passer les fils rouge, noir , bleu et vert venant du détecteur de vibrations et allant au module de commande dans le connecteur blanc à quatre broches, et enficher l’un des côtés dans le détecteur de vibrations et l’autre dans le connecteur blanc correspondant si ...

  • Audiovox APS 500 - page 15

    Page 15 ROUGE 85 86 30     VOIR 2 Sortie À Impulsions Négatives Pour Ouverture *Demarreur à Distance *Fermeture De Fenêtre *Du Coffre à Distance 85 86 87A 30 87 ORANGE COUPER 15A FUSE BLANC FUEX DE STATIONNEMENT EXISTANTS APS-500 MODULE DE COMMANDE BLEU FONCÉ CAPTEUR DE CHOCS Fils Rouge, Noir, Bleu, Et Vert . VERS MARCHE DU SOLENO ...

  • Audiovox APS 500 - page 16

    Page 16 +  SORTIE DE PHARE Sortie de mise à la masse de 30 secondes durant l'armement et le désarmement (relais en option requis) -   +  MARRON  VERT FONCE POURPRE BLANC/BLEU VERT CLAIR BLEU CLAIR CONTACTEUR DE PORTE EXISTANT À IMPULSION NEGATIVE (DE TYPE GM) LAMPE DE PLAFONNIER EXISTANT NOIR/BLANC ZONE 1 Accessoires d'a ...

  • Audiovox APS 500 - page 17

    FUNCIONES SELECCIONABLES Nota: El método de anulación manual puede seleccionarse para funcionar desde el interruptor valet o con un código especial. Ponga una marca de control para indicar el método usado en el casillero que hay en la última página del manual del propietario. Las funciones seleccionables del interruptor DIP: Número de interr ...

  • Audiovox APS 500 - page 18

    Page 18 INSTALACIÓN DE LOS COMPONENTES PRINCIPALES MÓDULO DE CONTROL: Seleccione un lugar de instalación dentro del compartimiento de pasajeros (arriba detrás del tablero), y fijelo usando los dos tornillos incluidos. El módulo de control puede también fijarse en su lugar empleando ligaduras de alambre. El módulo de control no debe instalars ...

  • Audiovox APS 500 - page 19

    Page 19 CABLEADO DEL SISTEMA Conector grande de 8 clavijas: CABLE ROJO CON FUSIBLES: FUENTE DE BATERÍA CONSTANTE DE + 12 VCC Este cable controla la sensibilidad del circuito detector de voltaje que detecta el encendido de una luz interior cuando se abre una puerta. T ambién detecta el encendido de las luces de est acionamiento o los faros y , en ...

  • Audiovox APS 500 - page 20

    Page 20 CABLE ANARANJADO: SALIDA A TIERRA DE 300 mA AL EST AR ACTIV ADO - DESACTIV ACIÓN DEL ARRANCADOR Este cable sirve para controlar el relé de corte del arrancador . Conecte el cable anaranjado al terminal 86 del relé. Conecte el terminal 85 del relé a un cable de encendido del vehículo que esté activo cuando la llave se encuentre en las ...

  • Audiovox APS 500 - page 21

    Page 21 CABLE ANARANJADO CON MARCAS BLANCAS: SALIDA A TIERRA DE 300 mA AL EST AR DESACTIV ADO - DESACTIV ACIÓN DEL ARRANCADOR Este cable sirve para controlar el relé de corte del arrancador . Conecte el cable anaranjado con blancas al terminal 86 del relé. Conecte el terminal 85 del relé a un cable de encendido del vehículo que esté activo cu ...

  • Audiovox APS 500 - page 22

    Page 22 CONECTOR BLANCO DE 4 CLA VIJAS: DETECTOR DE CHOQUE Pase los cables rojo, negro, azul y verde del conector blanco de cuatro clavijas desde el detector de choque hasta el módulo de control y enchufe un extremo en el detector de choque y el otro en el conector blanco del costado del módulo. CONECTOR (BLANCO) DE DOS CLAVIJAS ROJO Y VERDE-SALI ...

  • Audiovox APS 500 - page 23

    Page 23 ROJO 87A 85 86 30   5A FUSE 15A FUSE   CANAL 2 Salida Pulsada Negativa Para Abertura * Arranque Remoto *Subida De Ventanas * De Baúl 85 86 87A 30 EMPALME A BATERIA DE +12 VDC PARA CONMUTACION POSITIVA DEL CIRCUITO DE LUA INTERNA (TIPO FORD) O CONECTE A TIERRA EN EL CHASIS PARA CONMUTACION NEGATIVA DEL CIRCUITO DE LUZ INTERNA (T ...

  • Audiovox APS 500 - page 24

    Page 24 NEGRO +  SALIDAS DE CERRADURA DE PUERTAS (+) Impulso De Cerradura (-) Impulso De Apertura De Puertas (-) Impulso De Cerradura (+) Impulso De Apertura De Puertas -   GRAY APS-500 MÓDULO DE CONTROL PURPURADO LAMPARA INTERIOR EXISTENTE AMARILLO +   PARDO LAMPARA INTERIOR EXISTENTE BLANCO/AZUL VERDE CLARO ZONA 1 Activación Opci ...

Manufacturer Audiovox Category Automobile Alarm

Documents that we receive from a manufacturer of a Audiovox APS 500 can be divided into several groups. They are, among others:
- Audiovox technical drawings
- APS 500 manuals
- Audiovox product data sheets
- information booklets
- or energy labels Audiovox APS 500
All of them are important, but the most important information from the point of view of use of the device are in the user manual Audiovox APS 500.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Audiovox APS 500, service manual, brief instructions and user manuals Audiovox APS 500. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Audiovox APS 500.

Similar manuals

A complete manual for the device Audiovox APS 500, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Audiovox APS 500 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Audiovox APS 500.

A complete Audiovox manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Audiovox APS 500 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Audiovox APS 500, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Audiovox APS 500, that we can find in the current document
3. Tips how to use the basic functions of the device Audiovox APS 500 - which should help us in our first steps of using Audiovox APS 500
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Audiovox APS 500
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Audiovox APS 500 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Audiovox APS 500?

Use the form below

If you did not solve your problem by using a manual Audiovox APS 500, ask a question using the form below. If a user had a similar problem with Audiovox APS 500 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (1)

FRANCO SONZOGNO

Improvvisamente, durante il caricamento di una base sonora, in uscita "LINE" e in uscita cuffie è sparito il suono normale ed è comparso solo un forte fruscio il cui volume è influenzato dalla posizione del potenziometro master. La registrazione sulle varie tracce sembra funzionare regolarmente in quanto il grafico sul display si vede normalmente. Nulla comunque si sente in uscita se non il fortissimo fruscio.