Manual Snapper EP217019BV

28 pages 9.25 mb
Download

Go to site of 28

Summary
  • Snapper EP217019BV - page 1

    Safety Instructions & Operator’s Manual for EUROPEAN 21” STEEL DECK WALK MOWERS SERIES 19 MODEL NUMBER EXPLANATION E P 21 70 19 B V EUROPEAN MODEL ENGINE DESIGNATION SELF-PROPELLED SERIES DESIGNATION CUTTING WIDTH ENGINE HORSE POWER * E – European Model 21 – 21” Cutting Width 70 – 7.0 HP (Engine Horse Power) B – Briggs & Strat ...

  • Snapper EP217019BV - page 2

    2 IMPORTANT SAFETY INSTRUCTIONS WARNING: This pow erful cutting machine is capable of amputating hands and feet and can throw objects that can cause injury and damage! Failure to comply w ith the follow ing SAFETY instructions could result in serious injury or death to the operator or other persons. The owner of the machine must understand these in ...

  • Snapper EP217019BV - page 3

    3 IMPORTANT SAFETY INSTRUCTIONS SAFE HANDLING OF GASOLINE (Continued From Previous Page) 3. DO NOT remove fuel cap or add fuel w ith the engine running. Allow the engine to cool before refueling. 4. DO NOT refuel the machine indoors. 5. DO NOT store the machine or fuel container inside w here there is an open flame, spark or pilot light such as on ...

  • Snapper EP217019BV - page 4

    4 IMPORTANT SAFETY INSTRUCTIONS MAINTENANCE AND STORAGE (Continued From Previous Page) 9. Mow er blades are sharp and can cut. Wrap the blades or w ear heavy leather glov es and use CAUTION w hen handling them. 10. DO NOT test for spark by grounding spark plug next to spark plug hole; spark plug could ignite gas exiting engine. 11. Have machine ser ...

  • Snapper EP217019BV - page 5

    5 TABLE OF CONTENTS IMPORTANT SAFETY INSTRUCTIONS ...................................................................... 2 - 4 TABLE OF CO NTENTS ...................................................................................................... 5 SECTION 1 - FAMI LIARIZATI ON...................................................................... ...

  • Snapper EP217019BV - page 6

    6 Section 1 - FAMILIARIZATION FIGURE 1.1 1.1 INTRODUCTION This manual has been prepared for the operators of the SNAPPER WALK BEHIND MOWERS. Its purpose, aside from recommending operating and routine service requirements, is to promote safety through the use of accepted operating practices. Read, Understand and Follow the “IMPORTANT SAFETY INSTRU ...

  • Snapper EP217019BV - page 7

    7 Section 2 - OPERATING INSTRUCTIONS 2.1 PRE-START CHECK LIST Make the following checks and perform the service required before each start-up. 2.1.1. Check guards, deflectors, grass bag, adapter and covers to make sure all are in place and securely tightened. 2.1.2. Check blade control, wheel drive control, and engine speed control to insure they w ...

  • Snapper EP217019BV - page 8

    8 Section 2 - OPERATING INSTRUCTIONS 2.2.2. PROPELLING MOWER 1. Start engine. Refer to Section “Starting & Operation”. 2. Move ground speed control to the desired speed position. See Figure 2.6. 3. Move wheel drive control against handle to engage wheel drive and propel mower forward. Forward speed can be adjusted while the mower is moving ...

  • Snapper EP217019BV - page 9

    9 Section 2 - OPERATING INSTRUCTIONS 2.6 INSTALLATION of GRASS BAG ADAPTER WARNING DO NOT attempt any maintenance, adjustments or service with engine and blade running. STOP engine and blade. Disconnect spark plug w ire and secure aw ay from spark plug. Engine and components are HOT. Avoid serious burns, allow sufficient time for all components to ...

  • Snapper EP217019BV - page 10

    10 Section 2 - OPERATING INSTRUCTIONS WARNING DO NOT attempt any maintenance, adjustments or service with engine and blade running. STOP engine and blade. Disconnect spark plug w ire and secure aw ay from spark plug. Engine and components are HOT. Avoid serious burns, allow sufficient time for all components to cool. 2.9 INSTALLATION of DISCHARGE D ...

  • Snapper EP217019BV - page 11

    11 Section 3 – MAINTENANCE 3.1 INTRODUCTION To retain the quality of the mower, use genuine SNAPPER replacement parts only. Contact a local SNAPPER dealer for parts and service assistance. For the correct part or information for a particular mower, always mention model and serial number. WARNING DO NOT attempt any maintenance, adjustments or serv ...

  • Snapper EP217019BV - page 12

    12 Section 3 – MAINTENANCE WARNING DO NOT attempt any maintenance, adjustments or service with engine and blade running. STOP engine and blade. Disconnect spark plug w ire and secure aw ay from spark plug. Engine and components are HOT. Avoid serious burns, allow sufficient time for all components to cool. Wear heavy leather gloves w hen handling ...

  • Snapper EP217019BV - page 13

    13 Section 4 - REPAIR & ADJUSTMENTS WARNING DO NOT attempt any maintenance, adjustments or service with engine and blade running. STOP engine and blade. Disconnect spark plug w ire and secure aw ay from spark plug. Engine and components are HOT. Avoid serious burns, allow sufficient time for all components to cool. Wear heavy leather gloves w h ...

  • Snapper EP217019BV - page 14

    14 Section 4 - REPAIR & ADJUSTMENTS WARNING DO NOT attempt any maintenance, adjustments or service with engine and blade running. STOP engine and blade. Disconnect spark plug w ire and secure aw ay from spark plug. Engine and components are HOT. Avoid serious burns, allow sufficient time for all components to cool. 4. Sharpen blade on a grindin ...

  • Snapper EP217019BV - page 15

    15 Section 4 - REPAIR & ADJUSTMENTS WARNING DO NOT attempt any maintenance, adjustments or service with engine and blade running. STOP engine and blade. Disconnect spark plug w ire and secure aw ay from spark plug. Engine and components are HOT. Avoid serious burns, allow sufficient time for all components to cool. 4.3 DRIVEN AND DRIVE DISC SER ...

  • Snapper EP217019BV - page 16

    16 Section 4 - REPAIR & ADJUSTMENTS WARNING DO NOT attempt any maintenance, adjustments or service with engine and blade running. STOP engine and blade. Disconnect spark plug w ire and secure aw ay from spark plug. Engine and components are HOT. Avoid serious burns, allow sufficient time for all components to cool. 4.3.3. DRIVEN DISC ADJUSTMENT ...

  • Snapper EP217019BV - page 17

    17 Section 4 - REPAIR & ADJUSTMENTS WARNING DO NOT attempt any maintenance, adjustments or service with engine and blade running. STOP engine and blade. Disconnect spark plug w ire and secure aw ay from spark plug. Engine and components are HOT. Avoid serious burns, allow sufficient time for all components to cool. 4.3.4. Replacing Rubber Drive ...

  • Snapper EP217019BV - page 18

    18 Section 4 - REPAIR & ADJUSTMENTS WARNING DO NOT attempt any maintenance, adjustments or service with engine and blade running. STOP engine and blade. Disconnect spark plug w ire and secure aw ay from spark plug. Engine and components are HOT. Avoid serious burns, allow sufficient time for all components to cool. 4.3.6. Replacement Of Bearing ...

  • Snapper EP217019BV - page 19

    19 Section 4 - REPAIR & ADJUSTMENTS WARNING DO NOT attempt any maintenance, adjustments or service with engine and blade running. STOP engine and blade. Disconnect spark plug w ire and secure aw ay from spark plug. Engine and components are HOT. Avoid serious burns, allow sufficient time for all components to cool. 4.4.1. Engine Drive Belt Repl ...

  • Snapper EP217019BV - page 20

    20 TROUBLESHOOTING PROBLEM PROBABLE CAUSE CORRECTIVE ACTION Engine Will Not Start 1. Fuel tank empty. 1. F ill fuel tank w ith fresh fuel. Using Recoil Starter 2. Engine needs priming. 2. Pr ime engine. Check Engine Manual for Instructions. 3. Spark plug wire disconnected. 3. Place spark plug w ire onto spark plug. Engine Stalls or Stops A fter Run ...

  • Snapper EP217019BV - page 21

    21 SERVICE SCHEDULE ITEM SERVICE PERFORMED REF. EACH USE 5 HRS 25 HRS 50 HRS 100 HRS EACH SEASON Engine Oil Check Oil Level Page 7 X Initial Oil Change Page 11 X Periodic Oil Change Page 12 X* Air Pre-Cleaner Clean Sponge Element Engine Manual X** Air Cleaner Clean or Replace Engine Manual X** Spark Plug Replace Engine Manual X Engine Cooling Syste ...

  • Snapper EP217019BV - page 22

    22 DECAL IDENTIFICATION (1) WARNING INSTRUCTIONS. (2) WARNING: Do Not operate without entire Grass Catcher or Guard in place. (3) PRIME (on engine): Use for initial engine starting. Read and follow engine operating and maintenance instructions. Push bulb to prime engine. (4) SPARK PLUG: Warns of potential electrical shock from spark plug w hile eng ...

  • Snapper EP217019BV - page 23

    23 DECAL IDENTIFICATION (7) OPERATOR PRESENCE CONTROL (OPC): Arrow points to the OPC bail. When bail is rotated rearw ard, the engine may be started and w ill run as indicated by the engine with rotating arrow . With the engine running, the blade is rotating as indicated by the cut grass sy mbol. When the bail is released and rotates forw ard, the ...

  • Snapper EP217019BV - page 24

    24 2 YEAR LIMITED WARRANTY For two (2) years from purchase date for the orig inal purchaser's residential, non-commercial use, SNAPPER , through any authorized SNAPPER dealer will replace, free of charge (except for taxes where applicable), any part or parts found upon examination by the factory at McDonough, Georgia, to be defective in materi ...

  • Snapper EP217019BV - page 25

    25 NOTES ___________________________________________________________________ ___________________________________________________________________ ___________________________________________________________________ ___________________________________________________________________ ___________________________________________________________________ _ ...

  • Snapper EP217019BV - page 26

    26 NOTES ___________________________________________________________________ ___________________________________________________________________ ___________________________________________________________________ ___________________________________________________________________ ___________________________________________________________________ _ ...

  • Snapper EP217019BV - page 27

    27 NOTES ___________________________________________________________________ ___________________________________________________________________ ___________________________________________________________________ ___________________________________________________________________ ___________________________________________________________________ _ ...

  • Snapper EP217019BV - page 28

    28 Safety Instructions & Operator’s Manual for EUROPEAN 21” STEEL DECK WALK MOWERS SERIES 19 IMPORTANT Snapper products are built using engines that meet or exceed all applicable emissions requirements on the date manufactured. The labels on those engines contai n very important emissions information and critical safety warnings. Read, Unde ...

Manufacturer Snapper Category Lawn Mower

Documents that we receive from a manufacturer of a Snapper EP217019BV can be divided into several groups. They are, among others:
- Snapper technical drawings
- EP217019BV manuals
- Snapper product data sheets
- information booklets
- or energy labels Snapper EP217019BV
All of them are important, but the most important information from the point of view of use of the device are in the user manual Snapper EP217019BV.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Snapper EP217019BV, service manual, brief instructions and user manuals Snapper EP217019BV. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Snapper EP217019BV.

Similar manuals

A complete manual for the device Snapper EP217019BV, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Snapper EP217019BV by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Snapper EP217019BV.

A complete Snapper manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Snapper EP217019BV - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Snapper EP217019BV, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Snapper EP217019BV, that we can find in the current document
3. Tips how to use the basic functions of the device Snapper EP217019BV - which should help us in our first steps of using Snapper EP217019BV
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Snapper EP217019BV
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Snapper EP217019BV in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Snapper EP217019BV?

Use the form below

If you did not solve your problem by using a manual Snapper EP217019BV, ask a question using the form below. If a user had a similar problem with Snapper EP217019BV it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)