English dropdown-ico

Manual Echo CS-3000 Type 1E, CS-3400 Type 1E, CS-3450 Type 1E

21 pages 0.67 mb
Download

Go to site of 21

Summary
  • Echo CS-3000 Type 1E, CS-3400 Type 1E, CS-3450 Type 1E - page 1

    X7503200005 99922202726 05/02 Chain Saw Operator ’ s Manual MODELS : CS-3000 TYPE 1E Serial Number 001001 - 630329 CS-3400 TYPE 1E Serial Number 001001 - 580667 CS-3450 TYPE 1E Serial Number 001001 - 594521 W ARNING DANGER Read rules for safe operation and instructions carefully . ECHO provides an Operator ’s Manual and an Engine Operator’s M ...

  • Echo CS-3000 Type 1E, CS-3400 Type 1E, CS-3450 Type 1E - page 2

    2 RULES FOR SAFE OPERA TION A. Kickback Safety Precaution for Chain Saw Users W ARNING! KICKBACK may occur when the nose or tip of the guide bar touches an object, or when the wood closes in and pinches the saw chain in the cut. Tip contact in some cases may cause a lightning fast reverse REACTION, Kicking the guide bar up and back towards the oper ...

  • Echo CS-3000 Type 1E, CS-3400 Type 1E, CS-3450 Type 1E - page 3

    3 CONTENTS Page Rules for Safe Operation ....................................................................................................... ........... 2 T echnical Data ................................................................................................................................. 4 Nomenclature of Parts ..................... ...

  • Echo CS-3000 Type 1E, CS-3400 Type 1E, CS-3450 Type 1E - page 4

    4 1. Hand guard (Chain brake actuating lever) 2. Throttle control lockout 3. Throttle control trigger 4. Sprocket guard 5. Chain catcher 6. Air cleaner cover 7. Purge bulb 8. Guide bar 9. Saw chain 10. Front handle 1 1 . On / Off switch 12. Rear handle guard 13. Fuel tank cap 14. Pull starter 15. Oil tank cap 16. Throttle control latch 17. T ip gua ...

  • Echo CS-3000 Type 1E, CS-3400 Type 1E, CS-3450 Type 1E - page 5

    5 UP PREP ARA TION FOR USE The machine is delivered with guide bar and saw chain separated. Install guide bar and chain as follows. Guide bar Saw chain Holes Guide bar Chain tensioner Direction to tension the chain T ensioner adjusting screw Sprocket guard GUIDE BAR AND SA W CHAIN • Unscrew two nuts and remove sprocket guard. • Mount bar and sl ...

  • Echo CS-3000 Type 1E, CS-3400 Type 1E, CS-3450 Type 1E - page 6

    6 50 CS-3450 CS-3000 CS-3400 FUEL AND LUBRICANT FUEL ST A TEMENT GASOLINE - Use 89 Octane (R+M/2) gasoline or gasohol known to be good quality . Gasohol may contain maximum 10% ethyl (grain) alcohol or 15% MTBE (methyl tertiary-butyl ether). Gasohol containing methy (wood) alcohol is not approved. OIL - ECHO brand premium two-stroke 50:1 oil is pre ...

  • Echo CS-3000 Type 1E, CS-3400 Type 1E, CS-3450 Type 1E - page 7

    7 WHEN THE ENGINE IS HARD TO ST ART • Press throttle control lockout down while holding throttle trigger and push in latch. • Pull starter handle. • When engine starts, immediately push throttle trigger up, to release the latch. CAUTION Clutch engages and chain will rotate when engine is started with throttle latch engaged. After engine start ...

  • Echo CS-3000 Type 1E, CS-3400 Type 1E, CS-3450 Type 1E - page 8

    8 GENERAL Kickback [NOTE] Read the ECHO “CHAIN SAW SAFETY MANUAL” included with your chain saw for additional cutting and safety instruc- tions. In all circumstances the operation of the chain saw is a one-man job. It is difficult at times to take care for your own safety , so don’t assume the responsibility for a helper as well. After you ha ...

  • Echo CS-3000 Type 1E, CS-3400 Type 1E, CS-3450 Type 1E - page 9

    9 2” 45° 2” A falling tree can seriously damage anything it may hit - a car , a house, a fence, a powerline, or another tree. There are ways to make a tree fall where you want it, so first decide where that is! Before cutting, clear the area around the tree. Y ou will need good footing while working and you should be able to work the saw witho ...

  • Echo CS-3000 Type 1E, CS-3400 Type 1E, CS-3450 Type 1E - page 10

    10 Don’t cut with the saw overhead or the bar in a verticle posi- tion. If the saw should kick back you may no have good enough control to prevent possible injury . BUCKING Uphill position FINISH CUT FIRST CUT Board or flat stones KICKBACK • Improper thrust cutting. • When the bar nose hits another tree, etc. Keep in mind that the wood is hea ...

  • Echo CS-3000 Type 1E, CS-3400 Type 1E, CS-3450 Type 1E - page 11

    11 INFORMA TION Kickback Safety Features The following features are recommended for this model as Kickback Safety Features. • Double Guard Low Kick T ype Guide Bar or Asymmetrical Low Kick T ype Guide Bar Note: Y ou saw chain can be equipped with either of these bars. Reduced nose radius NOTE: Replacement Guide Bars The following guide bars may b ...

  • Echo CS-3000 Type 1E, CS-3400 Type 1E, CS-3450 Type 1E - page 12

    12 MAINTENANCE AND CARE AIR FIL TER • Check before every use. • Pull choke all the way out (Close position). • Loosen bolt, and remove air cleaner cover and filter . • Brush off dust lightly , or wash it in water and detergent if necessary . Dry it completely before installation. Air filter Air cleaner cover Oil discharge adjusting screw Oi ...

  • Echo CS-3000 Type 1E, CS-3400 Type 1E, CS-3450 Type 1E - page 13

    13 SP ARK PLUG • Check periodically . • Gap = 0.65 mm (.026”) • Replace if either electrode is worn or if the insulator is fouled by oil or other deposits. • TORQUE = 145 ~ 155 kg•cm (125 ~ 135 in. lb.) CAUTION Do not over torque. CARBURETOR ADJUSTMENT Non Emission Models T ools Required: T achometer P/N 99051 130010 GENERAL ADJUSTMENTS ...

  • Echo CS-3000 Type 1E, CS-3400 Type 1E, CS-3450 Type 1E - page 14

    14 LO SPEED MIXTURE ADJUSTMENT 1. Adjust the Lo speed mixture needle in clockwise (CW) until maximum idle RPM (just before lean drop off) is achieved. NOTE: Engine RPM must be allowed to stabilize a minimum of 20 seconds after each adjustment . 2. Turn the Idle speed adjusting screw to achieve idle of 4,000 RPM. 3. Using tachometer, rich down by ad ...

  • Echo CS-3000 Type 1E, CS-3400 Type 1E, CS-3450 Type 1E - page 15

    15 4. Idle Speed Adjustment. • Start engine and turn “idle” speed adjustment screw (B) CW until the saw chain begins to move, then turn the screw CCW until saw chain stops moving. Turn screw CCW an additional 1/4 turn. 5. Accelerate to full throttle for 2-3 seconds to clear excess fuel from engine then return to idle. Accelerate to full throt ...

  • Echo CS-3000 Type 1E, CS-3400 Type 1E, CS-3450 Type 1E - page 16

    16 30° 85° 60° 91 • Place the depth gauge tool firmly on guide bar so that depth gauge protrudes. Then file top of depth gauge with flat file until flat with top o the gauge tool. - Be sure to round off the front edge of the depth gauge. • Properly filed cutters are shown below . Sharpen bottom edge Depth gauge tool Remove until flat with to ...

  • Echo CS-3000 Type 1E, CS-3400 Type 1E, CS-3450 Type 1E - page 17

    17 TROUBLESHOOTING Poor performance of the engine and/or cutting mechanism can normally be prevented by carefully following the above instruc- tions. Poor performance can easily be corrected even by a beginner . When the engine does not function properly check the following three (3) points first. • Is the engine compression adequate? • Is fuel ...

  • Echo CS-3000 Type 1E, CS-3400 Type 1E, CS-3450 Type 1E - page 18

    18 T able 2 Improper fuel used ..................................... Use fuel with correct mixing ratio. Never use gasoline of poor quality. Spark plug defective (burnt ) ....................... Replace. Ouput (engine speed) insufficient Engine keeps running, but chain does not cut clean Output (engine speed) sufficient Engine overheated Firing fun ...

  • Echo CS-3000 Type 1E, CS-3400 Type 1E, CS-3450 Type 1E - page 19

    19 Kickback Motion: • When the bar nose hits another tree, etc. • Improper thrust cutting. CORRECT USE OF CHAIN BRAKE The installation of a chain brake may be mandatory by law or as stipulated by insurance regulations in your area of operation. Y ou should enquire through local government of fices, your employer or your local dealer to ensure t ...

  • Echo CS-3000 Type 1E, CS-3400 Type 1E, CS-3450 Type 1E - page 20

    S ER VICING I NFORMA TION P ARTS Genuine ECHO Parts and ECHO Re Power Parts and Assemblies for your ECHO products are available only from an Authorized ECHO Dealer. When you do need to buy parts always have the Model Number, Type number and Serial Number of the unit with you. You can find all three numbers on the engine housing. For future referenc ...

  • Echo CS-3000 Type 1E, CS-3400 Type 1E, CS-3450 Type 1E - page 21

    This Supplement contains important information. Please keep with your Instruction Manual. Please use this information when installing or adjusting guide bar/saw chain. SUPPLEMENT TO OPERATOR'S MANUALS PREP ARA TION FOR USE ADJUSTMENT , CHAIN TENSION IMPORT ANT! T ighten guide bar nuts to 90 – 1 10 kgf/cm (80 – 95 in. lbs.) DO NOT over-tigh ...

Manufacturer Echo Category Chainsaw

Documents that we receive from a manufacturer of a Echo CS-3000 Type 1E, CS-3400 Type 1E, CS-3450 Type 1E can be divided into several groups. They are, among others:
- Echo technical drawings
- CS-3000 Type 1E, CS-3400 Type 1E, CS-3450 Type 1E manuals
- Echo product data sheets
- information booklets
- or energy labels Echo CS-3000 Type 1E, CS-3400 Type 1E, CS-3450 Type 1E
All of them are important, but the most important information from the point of view of use of the device are in the user manual Echo CS-3000 Type 1E, CS-3400 Type 1E, CS-3450 Type 1E.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Echo CS-3000 Type 1E, CS-3400 Type 1E, CS-3450 Type 1E, service manual, brief instructions and user manuals Echo CS-3000 Type 1E, CS-3400 Type 1E, CS-3450 Type 1E. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Echo CS-3000 Type 1E, CS-3400 Type 1E, CS-3450 Type 1E.

Similar manuals

A complete manual for the device Echo CS-3000 Type 1E, CS-3400 Type 1E, CS-3450 Type 1E, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Echo CS-3000 Type 1E, CS-3400 Type 1E, CS-3450 Type 1E by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Echo CS-3000 Type 1E, CS-3400 Type 1E, CS-3450 Type 1E.

A complete Echo manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Echo CS-3000 Type 1E, CS-3400 Type 1E, CS-3450 Type 1E - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Echo CS-3000 Type 1E, CS-3400 Type 1E, CS-3450 Type 1E, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Echo CS-3000 Type 1E, CS-3400 Type 1E, CS-3450 Type 1E, that we can find in the current document
3. Tips how to use the basic functions of the device Echo CS-3000 Type 1E, CS-3400 Type 1E, CS-3450 Type 1E - which should help us in our first steps of using Echo CS-3000 Type 1E, CS-3400 Type 1E, CS-3450 Type 1E
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Echo CS-3000 Type 1E, CS-3400 Type 1E, CS-3450 Type 1E
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Echo CS-3000 Type 1E, CS-3400 Type 1E, CS-3450 Type 1E in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Echo CS-3000 Type 1E, CS-3400 Type 1E, CS-3450 Type 1E?

Use the form below

If you did not solve your problem by using a manual Echo CS-3000 Type 1E, CS-3400 Type 1E, CS-3450 Type 1E, ask a question using the form below. If a user had a similar problem with Echo CS-3000 Type 1E, CS-3400 Type 1E, CS-3450 Type 1E it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)