-
Harman Stove Company P61A - page 1
? ...
-
Harman Stove Company P61A - page 2
...
-
Harman Stove Company P61A - page 3
Agence Américaine pour la Protection de l'Environnement Ce modéle est dispensé par EP A certication d'aprés 40 CFR 60.531 par dènition [Appareil á bois (A) << Ratio air/combustible>>] US ENVIRONMENT AL PROTECTION AGENCY This model is exempt from EP A certication under 40 CFR 60.531 by denition [Wood Heater (A ...
-
Harman Stove Company P61A - page 4
4 P61A Pellet Stove Safety Information 5 Installation 6 V enting 8 ESP Control 15 Automatic Operation 16 Manual Operation 19 Low Draft V oltage Adjustment 21 Maintenance 22 T roubleshooting 27 Fuel Specications 28 Mixing Corn with Pellets 29 Power Failure / Back-up 30 Options 31 Wiring Diagram 32 Specications 32 W arranty 33 Service Parts 35 ...
-
Harman Stove Company P61A - page 5
5 P61A Pellet Stove ? ...
-
Harman Stove Company P61A - page 6
6 P61A Pellet Stove The P61A is bolted (1/4 x 1" hex head bolts) to the skid to prevent movement during shipping. T o free the stove from the skid you must remove the hold-down bolts in the rear of the pedestal base. ? ...
-
Harman Stove Company P61A - page 7
7 P61A Pellet Stove Place the stove on a noncombustible oor or on a oor protector that extends a minimum of 6 inches to the front, (measured from the glass) 6 inches to the sides and 1 inch to the rear of the hopper . It is also recommended that oor protection be installed under any horizontal venting and ...
-
Harman Stove Company P61A - page 8
8 P61A Pellet Stove W ARNING: V enting terminals must not be recessed into a wall or siding. NOTE: Only approved pellet vent pipe, wall pass- throughs, and re stops should be used when venting through ...
-
Harman Stove Company P61A - page 9
9 P61A Pellet Stove Pel let vent ing pipe (kn own as PL vent ) is con struc ted of two layers with air space between the layers. This air space acts as an insulator and reduces the outside surface temperature to allow a clearance to combustibles of 1 to 3 inches. The sections of pipe lock together to ...
-
Harman Stove Company P61A - page 10
10 P61A Pellet Stove Outside air ex pipe goes here. Inlet Cover part# 1-10-08542 Flex pipe part# 1-00-08543 (25') Per national building codes, consideration must be given to combustion air supply to all combustion appli- ances. Failure to supply adequate combustion air for all appliance demands, may lead to back-drafting of those and other ...
-
Harman Stove Company P61A - page 11
1 1 P61A Pellet Stove This method also provides excellent venting for normal operation but requires the stove to be installed farther from the wall. The vertical portion of the vent should be three to ve feet high and at lea st thr ee inc hes fr om a comb ust ible wall . T his vertical ...
-
Harman Stove Company P61A - page 12
12 P61A Pellet Stove This method provides excellent venting for normal operation. This method also provides natural draft in the event of a power failure. If the chimney condition is questionable* you may want to ...
-
Harman Stove Company P61A - page 13
13 P61A Pellet Stove This method provides excellent venting for normal operation. This method also provides natural draft in the event of a power failure. In some places in the US and Canada it is re- qui ...
-
Harman Stove Company P61A - page 14
14 P61A Pellet Stove Through the ceiling vent, follow PL vent manufacturers recommendations when using wall and ceiling pass through. ...
-
Harman Stove Company P61A - page 15
15 P61A Pellet Stove Sets the maximum feed rate. Runs all motors at full speed for one minute t o c h e c k o p e r a t i o n . Afterward the control will simulate a minimum burn and the combustion ...
-
Harman Stove Company P61A - page 16
16 P61A Pellet Stove This setting, see above, will produce a room temperature of 70 degrees with the distribution blower at medium speed. The P61A is a fully automatic stove that feat ...
-
Harman Stove Company P61A - page 17
17 P61A Pellet Stove In the Stove T emperature Mode and with the igniter toggle switch in the Auto position, the stove will light automa tically and can be adjust ed to the desir ed setting using the same temperature control dial as is used in the Room T emperature Mode. The heat o ...
-
Harman Stove Company P61A - page 18
18 P61A Pellet Stove Make sure the unit is plugged into a 120 V AC, 60 HZ electrical source. The power light should be the only light lit. 1. 2. ? ...
-
Harman Stove Company P61A - page 19
19 P61A Pellet Stove The P61A Pellet Stove is capable of manual operation. This also allows the operator to manually control operation during an emergency (i.e. igniter failure, when using a 502H battery backup, as opposed to the 512H, or when using certain generators.) The unit can be switched between "AUTO" and "MANUAL" at any ...
-
Harman Stove Company P61A - page 20
20 P61A Pellet Stove Make sure the unit is plugged into a 120 V AC, 60 HZ electrical source. The power light should be the only light lit. ...
-
Harman Stove Company P61A - page 21
21 P61A Pellet Stove These units are pre-tested at the factory with exactly 120 V olts A.C., 60 Hz. They are checked and adjusted for rebox tightness, gasket leakage, motor operation and igniter operation. The P61A is then factory set at a mid -poin t adju stmen t and in most ca ses wil l not need any adj ustm ent s. ? ...
-
Harman Stove Company P61A - page 22
22 P61A Pellet Stove Whenever wood is burned slowly , the potential exists for creosote to form in the venting. The chimney or venting system should be inspected periodically throughout the heating season to determine if a creosote buildup has occurred. I ...
-
Harman Stove Company P61A - page 23
23 P61A Pellet Stove Wheneve r adding fuel to the hopper , take the time and scrape the grate surface of the burnpot, using the scraper tool provided. This can be done while a re is burning. Wearing heat resistant gloves, open the rebox door . Scrape any accumulated ashes from ...
-
Harman Stove Company P61A - page 24
24 P61A Pellet Stove Exposed blower wheel and ue opening, NOTE: ESP probe is visible. Blower cover removed. ESP probe 6. Remove the ash pan and properly dispose of the ashes. 7. Remove combustion blower cover by turning the blower cover latch vertical, see Fig.26. Sliding the cover out of the slot on the left. This will expose the combustion blo ...
-
Harman Stove Company P61A - page 25
25 P61A Pellet Stove 1. Scrape the top holed surface and sides of the burn pot. (Fig 33) It is not necessa ry to complet ely remove all material from the burn pot. The excess will be pushed out during the next use. 2. Loosen the (2) wing thumb screws ...
-
Harman Stove Company P61A - page 26
26 P61A Pellet Stove Pellet nes may accumulate in the feeder body over a period of time; therefore, a yearly inspection and cleaning of this area must be performed. T o clean out nes: 1. Remove the rear cover panels. 2. Remove wi ...
-
Harman Stove Company P61A - page 27
27 P61A Pellet Stove 1. Air-fuel ratio is too rich. A. Feed rate too high. B. Draft too low caused by a gasket leak. 1. Feed rate too low 2. Draft too low because of gasket leak. 3. Poor qual ...
-
Harman Stove Company P61A - page 28
28 P61A Pellet Stove Pellet fuel quality can uctuate from manufacturer to manufacturer , and even from bag to bag. Hearth & Home T echnologies recommends using only fuel that is certied by the Pellet Fuels Institute (PFI) ...
-
Harman Stove Company P61A - page 29
29 P61A Pellet Stove Harman pellet burning, free-standing stoves and inserts have been tested t o ASTM E1509 for burning shelled corn in a mixture with wood pellets. The listing approves up to a 50% c orn and 50% pellet mixture. Dier ent mixtures of corn will have distinctively di erent burn characteristics depending upon moisture con tent an ...
-
Harman Stove Company P61A - page 30
30 P61A Pellet Stove TM ...
-
Harman Stove Company P61A - page 31
31 P61A Pellet Stove On the rear of the stove hopper there is a hole to fasten the hopper extension into place. On some units, this hole will need to be opened. Y ou will notice a small uncut area on rear of the knockout. Push downward with a screwdriver or like tool until the knockout is rotated as far back to the inside of the hopper as possible. ...
-
Harman Stove Company P61A - page 32
32 P61A Pellet Stove FEEDER AUGER MO TOR ST ANDARD USE W A T TS - 200 @ 120V AC 60Hz = 1.7 A MAX W A T TS - 460 @ 120V AC 60Hz = 3.8 A LOW PRESSURE SWIT CH HARMAN P43/P61A/P68 PELLET STOVE WIRING DIAGRAM 18/3 RUBBER CORD DISTRIBUTION BLOWER COMBUSTION MO TOR CONT ACTS N.O. MALE/FEMALE CONNECTIONS BONDED T ...
-
Harman Stove Company P61A - page 33
4021-645C 12-29-10 Page 1 of 2 Hearth & Home T echnologies Inc. LIMITED LIFETIME W ARRANTY Hearth & Home T echnologies Inc., on behalf of its hearth brands (”HHT”), extends the following warranty for HHT gas, wood, pellet, coal and electric hearth appliances that are purchased from an HHT authorized dealer . W ARRANTY COVERAGE: HHT warr ...
-
Harman Stove Company P61A - page 34
4021-645C 12-29-10 Page 2 of 2 W ARRANTY CONDITIONS: • This warranty only covers HHT appliances that are purchased through an HHT authorized dealer or distributor . A list of HHT authorized dealers is available on the HHT branded websites. • This warranty is only valid while the HHT appliance remains at the site of original installation. • Co ...
-
Harman Stove Company P61A - page 35
01/1 1 ...
-
Harman Stove Company P61A - page 36
01/1 1 IMPORT ANT : THIS IS DA TED INFORMA TION. When requesting service or replacement parts for your appliance please provide model number and serial number . All parts listed in this manual may be ordered from an authorized dealer . ? ...
-
Harman Stove Company P61A - page 37
01/1 1 IMPORT ANT : THIS IS DA TED INFORMA TION. When requesting service or replacement parts for your appliance please provide model number and serial number . All parts listed in this manual may be ordered from an authorized dealer . ? ...
-
Harman Stove Company P61A - page 38
01/1 1 IMPORT ANT : THIS IS DA TED INFORMA TION. When requesting service or replacement parts for your appliance please provide model number and serial number . All parts listed in this manual may be ordered from an authorized dealer . ? ...
-
Harman Stove Company P61A - page 39
01/1 1 IMPORT ANT : THIS IS DA TED INFORMA TION. When requesting service or replacement parts for your appliance please provide model number and serial number . All parts listed in this manual may be ordered from an authorized dealer . ? ...
-
Harman Stove Company P61A - page 40
40 P61A Pellet Stove ? ...
-
Harman Stove Company P61A - page 41
41 P61A Pellet Stove ? ...
-
Harman Stove Company P61A - page 42
42 P61A Pellet Stove ...
-
Harman Stove Company P61A - page 43
...
-
Harman Stove Company P61A - page 44
Proudly P rinted On 100% R ecycled P aper ...
Do you have a question concerning Harman Stove Company P61A?
Use the form below
If you did not solve your problem by using a manual Harman Stove Company P61A, ask a question using the form below. If a user had a similar problem with Harman Stove Company P61A it is likely that he will want to share the way to solve it.