English dropdown-ico

Manual Telex BTR-24

23 pages 1.11 mb
Download

Go to site of 23

Summary
  • Telex BTR-24 - page 1

    BTR-24 TR-24 Wireless Intercom System Operating Manual Bosch Communications Systems ...

  • Telex BTR-24 - page 2

    Table of Contents Section 1 Introduction ................................................................. 1-1 General Description ..................................................................... 1-1 System Features ........................................................................ 1-1 Section 2 BTR-24 Base Station ...................... ...

  • Telex BTR-24 - page 3

    General Description The Telex BTR -24 System is a full duplex ( simult aneous talk and listen), multi-ch annel, wireless inter com system. The system offers a com plete soluti on for up to 10, full duplex use rs per base station, m any m ore if in push-to-tra nsmit m ode. With fast and ea sy set-up, durable bel tpacks, 64 bit audi o encrypti on, an ...

  • Telex BTR-24 - page 4

    1. On/Off Switch – Turns the power on/off to t he base stati on. 2. Power / Low Batte ry Light – Indicates the base stati on has power, either from the inter nal battery or external power connected t o the unit. Battery Indicat ion: • GREEN = Battery O K • RED = Battery Low ( » 30 m inutes left ) • No Light = Battery D epleted 3. AP Acti ...

  • Telex BTR-24 - page 5

    1. Volume Control and Po wer Switch – Turns the beltpac k power on/off and cont rols headset volum e. 2. Battery Light /Power Light – Indicates the belt pack has power, either from the inter nal battery or AC power connected t o the unit. • GREEN = Battery I ndication : battery OK • RED = Battery Low ( » 15 minutes l eft) • NO Light = Ba ...

  • Telex BTR-24 - page 6

    Section 4 - Specifications RF Technology ............................................................................................................IEEE 802.11 (WiFi) Frequency Band of Operation ......................................................................................2.412 to 2.462 GHz FCC License ..................................... ...

  • Telex BTR-24 - page 7

    Wireless Mode Description The TR-24 has the ability t o be booted in one of thre e modes. These modes are wireless, wired and master wireless. Th is section will discu s the w ireless mode. The wireless m ode is the m ost used m ode of the bel tpack. The wireless m ode is set by holding the <TALK> but ton down as the unit boots. Then re lease ...

  • Telex BTR-24 - page 8

    Set-up Below are i nstructions for the set-up and operati on of a single BTR-24 wit h up to ten TR-24's. 1. Prior to use t he TR-24 and BTR-24 should have their bat tery packs fully charged . Refer to the “Battery Charging Instructions” ne ar the end of this s ection. 2. Plug the BTR-24's external power supply into an AC out let if av ...

  • Telex BTR-24 - page 9

    Figure 5-5 Top View of TR-24 The sidet one (amount of your own voic e fed back to your earphones) and m icrophone gain of the beltpacks m ay need adjusted fro m the factory defaults. The defau lts are: • Microphone Level = 4 • Sidetone Level = 2 Microphone Level Adj ust – Press <1> + <TALK > until a voice prompt i ndicates m icrop ...

  • Telex BTR-24 - page 10

    Up to ten bel tpacks, in full duplex ( simult aneous talk and li sten), may comm unicate with each other o ver a Ethernet netwo rk. In fact do to the f lexibility of th e BTR-2 4 system, wired beltpacks connected vi a a hub to a network coul d communica te to a BT R-24 connected t o the same net work. This base sta tion could then be connected wire ...

  • Telex BTR-24 - page 11

    The sidet one (amount of your own voic e fed back to your earphones) and m icrophone gain of the beltpacks m ay need adjusted fro m the factory defaults. The defau lts are: • Microphone Level = 4 • Sidetone Level = 2 Microphone Level Adj ust – Press <1> + <TALK > until a voice prompt i ndicates m icrophone adjust m ode has been en ...

  • Telex BTR-24 - page 12

    2. Plug the m aster TR-24’s ext ernal power supply i nto an AC outlet i f desired. If external pow er is not desire d then run off internal battery. 3. Place the TR-2 4’s in a lo cation wh ere it will hav e the best visibility to the o ther TR-2 4s. 4. Plug a headset i nto the m aster TR-24 bel tpack. 5. Power-up the master TR-24 beltpack in ma ...

  • Telex BTR-24 - page 13

    The sidet one (amount of your own voic e fed back to your earphones) and m icrophone gain of the beltpacks m ay need adjusted fro m the factory defaults. The defau lts are: • Microphone Level = 4 • Sidetone Level = 2 Microphone Level Adj ust – Press <1> + <TALK > until a voice prompt i ndicates m icrophone adjust m ode has been en ...

  • Telex BTR-24 - page 14

    Encryption Code The BTR/TR-2 4 system uses a 64 b it DES (Dig ital Encryptio n Standard) encrypt ion algorit hm to encrypt all audio in the s ystem . The beltpacks in the system have a “key” that th e algorith m uses as the basis for t he encrypt ion. The same “ke y” must be used in all beltpacks on the system for comm unication to occ ur. ...

  • Telex BTR-24 - page 15

    10. Plug the othe r end of the Ethernet cable into the be ltpack. 11. Type, telnet 192.168.1.X at the com puter’s com mand prompt, then p ress <ENT ER>. Fill in f or X th e last digit of the IP address t hat is on the back l abel on the TR-24. 12. After about 20 sec onds the beltpack wi ll respond with a l ogin request. Enter the following: ...

  • Telex BTR-24 - page 16

    Battery Care To ensure the long l ife and safe handl ing of the Li-Ion bat tery within the BT R-24 and TR-24 pleas e following the f ollowing precautions: 1. Store the TR-24s a nd BTR-24 in a cle an, cool, dry l ocation away from heat. 2. Do not store for extende d periods of ti me in direct sunlight. 3. Do not disassem ble the bat tery packs wit h ...

  • Telex BTR-24 - page 17

    Please rerea d the operation and e ncryption/pas sword section of this m anual to make s ure you have com pleted sy stem set -up properly. The fol lowing contains t roubleshooting ti ps that m ay be helpful in solvi ng the problem . Section 8 If you are unabl e to solve the probl em, contact the manufac turer or dealer from whom you purchase d the ...

  • Telex BTR-24 - page 18

    Section 8 - Trouble shooting co ntinued 8-2 Problem Possible Cause Solution When the BTR-24 power switch was turned on nothing happens. The power light does not light. • Internal batte ry is completely exhausted • Plug the AC power pl ug into the BTR-24. A llow the u nit at least 5 minutes for the in ternal batte ry to receive an initial charge ...

  • Telex BTR-24 - page 19

    802.11 RF Channels The BTR-24 syst em has t he ability to operate on any one of eleven RF channels. Althoug h there are several d ifferent frequency cha nnel settings, t here is overlap bet ween the channels. T here are three non-overla pping channels avai lable in the FCC regul atory dom ain. When choosing frequency cha nnels for system s in the v ...

  • Telex BTR-24 - page 20

    Regulatory I nformation The TR-24 and BTR -24 comply with Part 15 of FCC rules and Canada RSS-210 . Operation is s ubject to the fol lowing conditions: 1. This device may not cause harmful interference. 2. This device must accept any interference received, including interference that may cause undesired op eration. 3. Use only the m anufacture r or ...

  • Telex BTR-24 - page 21

    Section 11 - Accessories and Replacement Items Model Number Part Number Description TR-24 PRD000065000 TR-24 Beltpack and US Power Supply. NOTE: User must provide the IP address of all TR-24/ BTR-24s in system with order. RPT-3 302054007 3 ft. coax with TNC reverse polarity plug connector. RPT-10 302054008 10 ft. coax with TNC reverse polarity plug ...

  • Telex BTR-24 - page 22

    Model Number Part Number Description BTR-24 PRD000066000 BTR-24 Base Station a nd US power supply. NOTE: User must provide IP address of all TR-24/BTR-24's in system with order. SYS-243 SYS000007000 System includes Carry Case, 3 TR-24 Beltpacks, 1 BTR-24 Base Station, Omni antennas, rack mounts, 3' Ethernet c able, and US power supplies. ...

  • Telex BTR-24 - page 23

    8601 East Cornhusker Highway, Lincoln, NE 68507 Made in U.S.A. PN LIT000078TX Rev. A Bosch Communications Systems ...

Manufacturer Telex Category Intercom System

Documents that we receive from a manufacturer of a Telex BTR-24 can be divided into several groups. They are, among others:
- Telex technical drawings
- BTR-24 manuals
- Telex product data sheets
- information booklets
- or energy labels Telex BTR-24
All of them are important, but the most important information from the point of view of use of the device are in the user manual Telex BTR-24.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Telex BTR-24, service manual, brief instructions and user manuals Telex BTR-24. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Telex BTR-24.

Similar manuals

A complete manual for the device Telex BTR-24, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Telex BTR-24 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Telex BTR-24.

A complete Telex manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Telex BTR-24 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Telex BTR-24, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Telex BTR-24, that we can find in the current document
3. Tips how to use the basic functions of the device Telex BTR-24 - which should help us in our first steps of using Telex BTR-24
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Telex BTR-24
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Telex BTR-24 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Telex BTR-24?

Use the form below

If you did not solve your problem by using a manual Telex BTR-24, ask a question using the form below. If a user had a similar problem with Telex BTR-24 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)