English dropdown-ico

Manual Cambridge SoundWorks II

20 pages 0.87 mb
Download

Go to site of 20

Summary
  • Cambridge SoundWorks II - page 1

    User Manual ...

  • Cambridge SoundWorks II - page 2

    ...

  • Cambridge SoundWorks II - page 3

    3 3 ...

  • Cambridge SoundWorks II - page 4

    4 Introduction ................................................................4 Carton Contents..........................................................5 Setup Options..........................................................6-7 Connection Diagram ..............................................8-9 Positioning Y our Speakers ....................... ...

  • Cambridge SoundWorks II - page 5

    5 CARTON CONTENTS A B E C F G H No.10 screws and plastic anchors D A) T wo Satellite Loudspeakers B) Desktop Stands,Thumb screws (installed on satellites) C) W allmount hardwar e, Self-adhesive Feet D) Hook and Loop fastener (for volume control, if not used on Desktop Stand) E) One Subwoofer/Amplifier Loudspeaker F) Power Adapter (AC to AC) G) V ol ...

  • Cambridge SoundWorks II - page 6

    SETUP OPTIONS Cambridge SoundWorks, Inc. supplies scr ews and plastic anchors for convenience, but it is the speaker purchaser’ s responsibility to insur e that any speaker mounting or placement is secure, stable and r eliable. Cambridge SoundWorks assumes no r esponsibility for damage to its products or any damage to pr operty resulting from spe ...

  • Cambridge SoundWorks II - page 7

    7 Remove, Invert and Replace Grille Panel W all Mounting With A Swivel Bracket Contact Cambridge SoundWorks about available swivel brackets. F) Follow the installation instructions for your par ticu- lar mounting bracket to attach it to a flat surface. If desired, you can install the whole bracket/satellite assembly inverted. This places the bracke ...

  • Cambridge SoundWorks II - page 8

    8 8 8 CONNECTION DIAGRAM AUDIO OUT Computer sound card Portable Playe Insert the green miniplug into your primary music source’s stereo minijack output (a sound card, a stereo TV or a Cambridge Connect a second sound source with a variable output to INPUT B . MusicW orks RED Connect the blue miniplug to INPUT A . MicroWorks II V olume Control Hea ...

  • Cambridge SoundWorks II - page 9

    9 RL -- R ++ Music er RED RED Left Speaker MicroWorks II Subwoofer Input Panel RED ...

  • Cambridge SoundWorks II - page 10

    10 10 10 POSITIONING YOUR SPEAKERS SUBWOOFER/AMPLIFIER Place the Subwoofer cabinet on the floor , preferably near a wall. Do not place it on a desktop or shelf. For the most efficient bass performance, place the subwoofer near a corner . If the subwoofer is placed away from the intersection of two r oom surfaces, the maximum bass output will be red ...

  • Cambridge SoundWorks II - page 11

    11 11 POSITIONING THE SA TELLITES 11 11 W all Placement (Swivel brackets available separately) Avoid facing a satellite parallel to a nearby wall (within 6-8 inches). The reflected sound fr om the wall degrades the sound coming directly fr om the satellite (diagram A). T ry to position wall-mounted satellites so both are approximately at your ear l ...

  • Cambridge SoundWorks II - page 12

    12 12 12 12 CONNECTIONS V olume On/Off Control A) If you are using the Desktop Stand, slide the V olume Contr ol onto the support strut on one of the stands. B) The BLUE miniplug of the V olume On/Of f Control should be inserted into the subwoofer minijack “A” labeled “TO VOLUME CONTROL.” Signal Connections C) The GREEN miniplug of the V ol ...

  • Cambridge SoundWorks II - page 13

    13 Other Connection Situations 1) Using the MicroWorks II as a high performance stereo television sound system. a) A stereo television with audio signal output typically has two RCA-type jacks (one red, one white). T o connect the V olume On/Of f Control to these jacks, obtain an audio cable adapter with two RCA plugs at one end and a 3.5 mm stereo ...

  • Cambridge SoundWorks II - page 14

    14 2) Using the MicroWorks II as a sound system for a component CD player . T ypically , there ar e two RCA-type jacks (one red, one white) on the CD player . T o connect to these jacks, obtain a stereo signal cable with two RCA plugs on one end and a 3.5 mm stereo minijack at the other end. Connect the RCA plugs to the RCA jacks on the player . Co ...

  • Cambridge SoundWorks II - page 15

    15 15 15 15 Speaker Connections T o connect the 2-meter speaker cables (two wires at each end): Push back the red speaker input tab on a satellite, exposing the wire hole. Fully insert one of the wires with a red band into the wire hole and r elease the tab. Repeat the procedur e with the adjacent speaker wire and the black speaker input tab on tha ...

  • Cambridge SoundWorks II - page 16

    16 OPERA TION AND FINAL ADJUSTMENT 16 16 16 1) Use the V olume Control or the signal sour ce control to vary output level. 2) Defeat or cancel any “tone control” or other sound adjustments within your audio program sour ce. Portable CD players may have “bass boost” switch- es and many computer sound programs have audio adjustments concealed ...

  • Cambridge SoundWorks II - page 17

    SPECIFICA TIONS Analog Input: 775 millivolts for full output 10 kohms input impedance Amplifiers: Satellite: 20 watts continuous at 1 kHz, two channels driven at less than .1% total harmonic distor tion. Subwoofer: 40 watts continuous at 100 Hz, one channel driven at less than .3% total harmonic distor tion. System Frequency response: Satellite: 15 ...

  • Cambridge SoundWorks II - page 18

    ...

  • Cambridge SoundWorks II - page 19

    ...

  • Cambridge SoundWorks II - page 20

    P81-1750 CAMBRIDGE SOUNDWORKS, INC. 26 DARTMOUTH STREET , WESTWOOD, MA 02090 T elephone: 1-800-367-4434 Fax: 1-617-527-3194 A Company ...

Manufacturer Cambridge SoundWorks Category Portable Speaker

Documents that we receive from a manufacturer of a Cambridge SoundWorks II can be divided into several groups. They are, among others:
- Cambridge SoundWorks technical drawings
- II manuals
- Cambridge SoundWorks product data sheets
- information booklets
- or energy labels Cambridge SoundWorks II
All of them are important, but the most important information from the point of view of use of the device are in the user manual Cambridge SoundWorks II.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Cambridge SoundWorks II, service manual, brief instructions and user manuals Cambridge SoundWorks II. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Cambridge SoundWorks II.

Similar manuals

A complete manual for the device Cambridge SoundWorks II, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Cambridge SoundWorks II by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Cambridge SoundWorks II.

A complete Cambridge SoundWorks manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Cambridge SoundWorks II - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Cambridge SoundWorks II, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Cambridge SoundWorks II, that we can find in the current document
3. Tips how to use the basic functions of the device Cambridge SoundWorks II - which should help us in our first steps of using Cambridge SoundWorks II
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Cambridge SoundWorks II
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Cambridge SoundWorks II in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Cambridge SoundWorks II?

Use the form below

If you did not solve your problem by using a manual Cambridge SoundWorks II, ask a question using the form below. If a user had a similar problem with Cambridge SoundWorks II it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)