Manual Regency Wraps F33

28 pages 1.63 mb
Download

Go to site of 28

Summary
  • Regency Wraps F33 - page 1

    01/1 1/07 F33 Freestanding Gas Stove FOR YOUR SAFETY What to do if you smell gas: Do not try to light any appli- ance Do not touch any electri- cal switch: do not use any phone in your building. Immediately call your gas supplier from a neighbour's phone. Follow the gas sup- plier's instructions. If you cannot reach your gas supplier , ca ...

  • Regency Wraps F33 - page 2

    2 Regency ® F33-3 Freestanding Gas Stove T o the New Owner: Congratulations! Y ou are the owner of a state-of-the-art Gas Stove by Fireplace Products International Ltd. The Regency ® Gas Series of hand crafted appliances has been designed to provide you with all the warmth and charm of a woodstove, at the fl ick of a switch. The models F33-NG3 a ...

  • Regency Wraps F33 - page 3

    Regency ® F33-3 Freestanding Gas Stove 3 T ABLE OF CONTENTS D ATA B A D G E Data Badge ................................................................ 4 INST ALLA TION Before Y ou Start ......................................................... 5 General Safety Information ........................................ 5 Installation Checklist ......... ...

  • Regency Wraps F33 - page 4

    4 Regency ® F33-3 Freestanding Gas Stove D ATA B A D G E This is a copy of the label that accompanies each Regency ® F33-3 Freestanding Gas Stove. We have printed a copy of the contents here for your review . DA T A BADGE NOTE: Regency ® units are constantly being improved. Check the label on the unit and if there is a difference, the label on t ...

  • Regency Wraps F33 - page 5

    Regency ® F33-3 Freestanding Gas Stove 5 INST ALLA TION 10) Installation and any repairs to this appliance should be done by an authorised service person. An authorised service person should be called to inspect this appliance annually . Make it a practice to have all of your gas appliances checked annually . 11 ) Do not strike the glass door . 12 ...

  • Regency Wraps F33 - page 6

    6 Regency ® F33-3 Freestanding Gas Stove PEDEST AL ASSEMBL Y 1) For easier assembly , tip the stove on its back (preferably onto a soft surface to prevent scratching). 2) Unscrew the 4 bolts in the underside of the stove. Align the holes in the corners of the pedestal top with the corresponding holes in the base of the stove. Use washers which are ...

  • Regency Wraps F33 - page 7

    Regency ® F33-3 Freestanding Gas Stove 7 INST ALLA TION Pedestal & Leg/Bottom Shield Wiring Instructions 1) Disconnect the fan harness plug. 2) Disconnect the 240V power cord from the terminal block 3) Disconnect the three wires from the 3-way fan switch. 4) Install the 3-way fan switch into the Bottom Shield or Pedestal. Note: remove dummy sw ...

  • Regency Wraps F33 - page 8

    8 Regency ® F33-3 Freestanding Gas Stove DRAFT HOOD The heater has a draft hood built into its back. It must not be altered or obstructed, and the unit must be installed so that the draft hood is in the same atmospheric pressure zone as the combustion air inlet to the burner . FLUEING This heater is a vented appliance and must be connected to a ch ...

  • Regency Wraps F33 - page 9

    Regency ® F33-3 Freestanding Gas Stove 9 INST ALLA TION SYSTEM DA T A NG LPG Injector size # 36 # 52 Input Rating 33 mj 33 mj Manifold Pressure 0.8 kPa 2.38 kPa GAS PIPE PRESSURE TESTING The appliance must be isolated from the gas supply piping system by closing its individual manual shut-off valve during any pressure testing of the gas supply pip ...

  • Regency Wraps F33 - page 10

    10 Regency ® F33-3 Freestanding Gas Stove LOG AND EMBER INST ALLA TION W ARNING: Dangerous operating conditions may occur if these logs are not positioned in their approved locations. Read the instructions below carefully and refer to the diagrams. If logs are broken do not use the unit until they are replaced. Broken logs can interfere with the p ...

  • Regency Wraps F33 - page 11

    Regency ® F33-3 Freestanding Gas Stove 11 Note: The door must be kept closed at all times, except during maintenance. The unit must never be operated without the glass in the door , or with the door open. DOOR HANDLE Attach spring handle by rotating counter clockwise onto rod. Ensure that the spring fi ts into the entire length of the rod. SAFETY ...

  • Regency Wraps F33 - page 12

    12 Regency ® F33-3 Freestanding Gas Stove OPTIONAL REMOTE W ALL SWITCH 1) Run wire through the opening in the rear of the unit. Be careful not to damage wire. Note: W e recommend a maximum of 4.5m of wire but if you wish to go with a longer run use the Thermostat Wire T able. 2) Connect wire to wall switch and install into receptacle box. Caution: ...

  • Regency Wraps F33 - page 13

    Regency ® F33-3 Freestanding Gas Stove 13 SHUTDOWN PROCEDURE 1) Use the ON/OFF switch, wall switch, thermostat or remote control to turn off the burner . 2) Push in the PILOT knob slightly and turn clockwise to of f. Do not force. 3) Turn of f all electric power to the appliance if service is to be per- formed. OPERA TING INSTRUCTIONS LIGHTING PRO ...

  • Regency Wraps F33 - page 14

    14 Regency ® F33-3 Freestanding Gas Stove COPY OF THE LIGHTING PLA TE INSTRUCTIONS OPERA TING INSTRUCTIONS 1 ) Push in the gas control knob slightly and turn clockwise t o OFF. Do not force. FOR YOUR SAFETY READ BEFORE LIGHTING A ) This appliance has a pilot which must be lighted by hand, following the instructions below exactly. B) BEFORE L ...

  • Regency Wraps F33 - page 15

    Regency ® F33-3 Freestanding Gas Stove 15 MAINTENANCE NORMAL OPERA TING SOUNDS OF GAS APPLIANCES It is possible that you will hear some sounds from your gas appliance. This is perfectly normal due to the fact that there are various gauges and types of steel used within your appliance. Listed below are some examples. All are normal operating sounds ...

  • Regency Wraps F33 - page 16

    16 Regency ® F33-3 Freestanding Gas Stove GENERAL FLUE MAINTENANCE Conduct an inspection of the fl ue system at least annually . Recom- mended areas to inspect are: 1) Check areas of the Flueing System which are exposed to the ele- ments for corrosion. These will appear as rust spots or streaks, and in extreme cases, holes. These components shoul ...

  • Regency Wraps F33 - page 17

    Regency ® F33-3 Freestanding Gas Stove 17 REMOVING V AL VE ASSEMBL Y 1) Shut off gas supply . 2) If optional fan is installed, disconnect power source to stove. 3) Remove access panel. a) Front panel on pedestal model. See diagram 1. b) Panel from bottom of leg shield. See diagram 2. Note: Access panel only has to be loosened to be taken out. Diag ...

  • Regency Wraps F33 - page 18

    18 Regency ® F33-3 Freestanding Gas Stove VIEW FROM BOTTOM OF THE STOVE Front of S tove Piezo Ignitor Hi/Lo On/Off Front Cover Screws Thermopile wires Orifice assembly mounting screws Orifice Thermocouple wire Thermocouple nut Gas Inlet Gas Outlet V alve mounting screws Thermodisc Bracket Thermodisc x 1 T-O-D 3 SA 9426 L200-40F 9426 L200-40F 31371 ...

  • Regency Wraps F33 - page 19

    Regency ® F33-3 Freestanding Gas Stove 19 View from back of stove S train relief grommet WA R N IN G 2 4 0 V o l t s Turn o ff p o wer b e fo re o pe nin g. Placement of Decal “W arning 240 V olts T urn Off Power” Wiring Diagram Diagram 3 F AN REPLACEMENT For Leg Unit: Remove 7 screws, remove bottom access panel and replace fan assembly . 1) D ...

  • Regency Wraps F33 - page 20

    20 Regency ® F33-3 Freestanding Gas Stove Note: Before troubleshooting the gas control system, be sure external gas shut off is in the "on" position. TROUBLESHOOTING THE GAS CONTROL SYSTEM W ARNING: BEFORE DOING ANY GAS CONTROL SER VICE WORK, REMOVE THE GLASS FRONT . POSSIBLE PROBLEM CAUSES CORRECTIVE ACTION TROUBLESHOOTING GUIDE Spark i ...

  • Regency Wraps F33 - page 21

    Regency ® F33-3 Freestanding Gas Stove 21 MAIN ASSEMBL Y P ARTS LIST Part # Description Part # Description 1) 460-532 Door Screen (Aust. only) 2) 850-141 Small Door - Black 850-142 Small Door - Gold 850-143 Small Door - Nickel Accent 850-144 Small Door - Gold Accent 850-151 Large Door - Black 850-152 Large Door - Gold 850-153 Large Door - Nickel A ...

  • Regency Wraps F33 - page 22

    22 Regency ® F33-3 Freestanding Gas Stove P ARTS LIST BURNER & LOG ASSEMBL Y Part # Description Part # Description 52) 910-190 Piezo Ignitor & Nut 53) 490-061 Control Panel 54) 908-672 Control Panel Decal 462-560/P Complete V alve Assy-SIT (NG) 462-561/P Complete V alve Assy-SIT (LPG) 63) 910-478 V alve SIT - NG/LPG 66) 910-034 Pilot Assem ...

  • Regency Wraps F33 - page 23

    Regency ® F33-3 Freestanding Gas Stove 23 P ARTS LIST Part # Description Part # Description Bottom Shield & Leg Option 100) 948-216 Logo Plate - Regency ® 102) 904-257 Magnetic Catch - Large 103) * 1 1" Pedestal Hinge 108) 910-246 Burner ON/OFF Switch 109) 910-140 Fan Hi/Off/Low Switch 1 10) * Strain Relief for power cord 121) * Access P ...

  • Regency Wraps F33 - page 24

    24 Regency ® F33-3 Freestanding Gas Stove NOTES ...

  • Regency Wraps F33 - page 25

    Regency ® F33-3 Freestanding Gas Stove 25 NOTES ...

  • Regency Wraps F33 - page 26

    26 Regency ® F33-3 Freestanding Gas Stove NOTES ...

  • Regency Wraps F33 - page 27

    Regency ® F33-3 Freestanding Gas Stove 27 Exclusions: This limited Lifetime W arranty does not extend to or include paint, door or glass gasketing or trim. It does not cover installation and operational related problems such as over-fi ring, downdrafts or spillage caused by environmental conditions, nearby trees, buildings, hilltops, mountains, i ...

  • Regency Wraps F33 - page 28

    PRINTED IN CANADA © Copyright 2007, FPI Fireplace Products International Ltd. All rights reserved. ...

Manufacturer Regency Wraps Category Stove

Documents that we receive from a manufacturer of a Regency Wraps F33 can be divided into several groups. They are, among others:
- Regency Wraps technical drawings
- F33 manuals
- Regency Wraps product data sheets
- information booklets
- or energy labels Regency Wraps F33
All of them are important, but the most important information from the point of view of use of the device are in the user manual Regency Wraps F33.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Regency Wraps F33, service manual, brief instructions and user manuals Regency Wraps F33. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Regency Wraps F33.

A complete manual for the device Regency Wraps F33, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Regency Wraps F33 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Regency Wraps F33.

A complete Regency Wraps manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Regency Wraps F33 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Regency Wraps F33, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Regency Wraps F33, that we can find in the current document
3. Tips how to use the basic functions of the device Regency Wraps F33 - which should help us in our first steps of using Regency Wraps F33
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Regency Wraps F33
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Regency Wraps F33 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Regency Wraps F33?

Use the form below

If you did not solve your problem by using a manual Regency Wraps F33, ask a question using the form below. If a user had a similar problem with Regency Wraps F33 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)