English dropdown-ico

Manual Axis Communications Q1635

24 pages 1.06 mb
Download

Go to site of 24

Summary
  • Axis Communications Q1635 - page 1

    AXIS Q1635 Network Camera Installation Guide ...

  • Axis Communications Q1635 - page 2

    Legal Considerations Video and audio surveillance can be regulated by laws that vary from country to country . Check the laws in your local region before using this product for surveillance purposes. This product includes one (1) H.264 decoder license and one (1) AAC decoder license. To purchase further licenses, contact your reseller . Liability E ...

  • Axis Communications Q1635 - page 3

    television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver . • Connect the equipment into an outlet on a circuit ...

  • Axis Communications Q1635 - page 4

    ...

  • Axis Communications Q1635 - page 5

    AXIS Q1635 Network Camera Safety Infor mation Read through this Installation Guide carefully before installing the product. Keep the Installation Guide for future reference. Hazard Levels DANGER Indicates a hazardous situation which, if not avoided, will result in death or serious injury . WARNING Indicates a hazardous situation which, if not avoid ...

  • Axis Communications Q1635 - page 6

    AXIS Q1635 Network Camera Safety Instructions NO NO NO TICE TICE TICE • The Axis product shall be used in compliance with local laws and regulations. • To use the Axis product outdoors, or in similar environments, it shall be installed in an approved outdoor housing. • Store the Axis product in a dry and ventilated environment. • Avoid expo ...

  • Axis Communications Q1635 - page 7

    AXIS Q1635 Network Camera WARNING • Risk of explosion if the battery is incorrectly replaced. • Replace only with an identical battery or a battery which is recommended by Axis. • Dispose of used batteries according to local regulations or the battery manufacturer's instructions. 7 ...

  • Axis Communications Q1635 - page 8

    8 ...

  • Axis Communications Q1635 - page 9

    AXIS Q1635 Network Camera Installation Guide This Installation Guide provides instructions for installing AXIS Q1635 Network Camera on your network. For other aspects of using the product, see the User Manual available at www .axis.com Installation Steps 1. Make sure the package contents, tools and other materials necessary for the installation are ...

  • Axis Communications Q1635 - page 10

    AXIS Q1635 Network Camera Hardware Overview 12 1 1 13 14 15 16 5 6 7 8 9 1 0 1 4 3 2 1. Status LED indicator 2. Focus ring 3. Lock screw for focus ring 4. Zoom puller 1 0 ...

  • Axis Communications Q1635 - page 11

    AXIS Q1635 Network Camera 5. I/O connector 6. Iris connector 7. P ower connector 8. P ower LED indicator 9. Network LED indicator 1 0. RS485/RS422 connector 1 1. Network connector (P oE) 12. Control button (1) 13. Function button (2) 14. microSD Card slot 15. Audio in 16. Audio out Important If the Axis product is installed in an external camera ho ...

  • Axis Communications Q1635 - page 12

    AXIS Q1635 Network Camera LED Indicators LED Color Indication Green Steady for connection to a 1 00 Mbit/s network. Flashes for network activity . Amber Steady for connection to a 1 0 Mbit/s network. Flashes for network activity . Net- work Unlit No network connection. Green Steady green for normal operation. Amber Steady during startup and when re ...

  • Axis Communications Q1635 - page 13

    AXIS Q1635 Network Camera Status LED Behavior for Focus Assistant Color Indication Green Focus Assistant is enabled The lens is optimally adjusted Amber The camera has been moved, or an object has been inserted in front of the lens. Exit and restart the Focus Assistant. The lens is less optimally adjusted. Red The camera has been moved, or an objec ...

  • Axis Communications Q1635 - page 14

    AXIS Q1635 Network Camera NO NO NO TICE TICE TICE Due to local regulations or the environmental and electrical conditions in which the product is to be used, a shielded network cable (STP) may be appropriate or required. All cables connecting the product to the network and that are routed outdoors or in demanding electrical environments shall be in ...

  • Axis Communications Q1635 - page 15

    AXIS Q1635 Network Camera SD Card Slot A microSD card (not included) can be used for local recording with removable storage. For more information, see Specications on page 15 . NO NO NO TICE TICE TICE To prevent corruption of recordings, the SD card should be unmounted before removal. To unmount, go to Setup > System Options > Storage > ...

  • Axis Communications Q1635 - page 16

    AXIS Q1635 Network Camera I/O connector 4–pin terminal block for: • 0 V DC (-) • Auxiliary power (DC output) • Digital Input • Digital Output 1 2 3 4 Function Pin Notes Specications 0 V DC (-) 1 DC output 2 Can be used to power auxiliary equipment. Note: This pin can only be used as power out. 12 V DC Max load = 50 mA Digital input – ...

  • Axis Communications Q1635 - page 17

    AXIS Q1635 Network Camera 12 V max 50 mA 1 2 3 4 Setup example: 3. I/O congured as input 4. I/O congured as output P ower Connector 2-pin terminal block for power input. Use a Safety Extra Low V oltage (SELV) compliant limited power source (LPS) with either a rated output power limited to ≤ 100 W or a rated output current limited to ≤ 5 A ...

  • Axis Communications Q1635 - page 18

    AXIS Q1635 Network Camera Audio Connector 3.5 mm audio connectors (stereo) 1 2 3 1 Tip 2 Ring 3 Sleeve Audio Input Microphone/Line in Ground Audio Output Line out (mono) Ground RS485/422 Connector Two 2-pin terminal blocks for RS485/RS422 serial interface. The serial port can be congured to support: • Two-wire RS485 half duplex • Four-wire R ...

  • Axis Communications Q1635 - page 19

    AXIS Q1635 Network Camera Install the Hardware NO NO NO TICE TICE TICE Due to local regulations or the environmental and electrical conditions in which the product is to be used, a shielded network cable (STP) may be appropriate or required. Any network cables that are routed outdoors or in demanding electrical environments shall be shielded (STP) ...

  • Axis Communications Q1635 - page 20

    AXIS Q1635 Network Camera 1. Open the product’s home page and go to Setup > Basic Setup > Focus . 2. Under the Basic tab , click Open iris . If the button is inactive the iris is already open. 3. If focus has been set before, click Reset to reset the back focus. 4. Loosen the zoom puller and the lock screw for the focus ring (see Hardware O ...

  • Axis Communications Q1635 - page 21

    AXIS Q1635 Network Camera 6. Turn the focus ring slowly counter-clockwise until the status indicator ashes green or amber (not red). 7. To exit the Focus Assistant, press the Function button again. The Focus Assistant is switched off automatically after 15 minutes. 8. Retighten the lock screw for the focus ring. 9. Open the Live View page in the ...

  • Axis Communications Q1635 - page 22

    AXIS Q1635 Network Camera Note • If you select a DC iris conguration le for a P-iris lens, an error message will appear below the iris conguration type in the Camera Settings page. For custom DC Iris lenses, select Generic DC Iris option. • There is no need to restart the product after changing the lens. However , the product must be r ...

  • Axis Communications Q1635 - page 23

    AXIS Q1635 Network Camera Visit Axis learning center www .axis.com/academy for useful trainings, webinars, tutorials and guides. Warranty Information For information about Axis’ product warranty and thereto related information, see www .axis.com/warranty/ 23 ...

  • Axis Communications Q1635 - page 24

    Installation Guide V er . M1.2 AXIS Q1635 Network Camera Date: December 20 14 © Axis Communications AB, 2014 P art No. 61 1 17 ...

Manufacturer Axis Communications Category Security Camera

Documents that we receive from a manufacturer of a Axis Communications Q1635 can be divided into several groups. They are, among others:
- Axis Communications technical drawings
- Q1635 manuals
- Axis Communications product data sheets
- information booklets
- or energy labels Axis Communications Q1635
All of them are important, but the most important information from the point of view of use of the device are in the user manual Axis Communications Q1635.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Axis Communications Q1635, service manual, brief instructions and user manuals Axis Communications Q1635. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Axis Communications Q1635.

Similar manuals

A complete manual for the device Axis Communications Q1635, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Axis Communications Q1635 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Axis Communications Q1635.

A complete Axis Communications manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Axis Communications Q1635 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Axis Communications Q1635, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Axis Communications Q1635, that we can find in the current document
3. Tips how to use the basic functions of the device Axis Communications Q1635 - which should help us in our first steps of using Axis Communications Q1635
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Axis Communications Q1635
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Axis Communications Q1635 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Axis Communications Q1635?

Use the form below

If you did not solve your problem by using a manual Axis Communications Q1635, ask a question using the form below. If a user had a similar problem with Axis Communications Q1635 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)