Manual Magnadyne MV1020

20 pages 0.58 mb
Download

Go to site of 20

Summary
  • Magnadyne MV1020 - page 1

    Owner's Manual Mobile DVD/CD Player with 10.2" TFT Monitor Model: MV1020 / MV1020C For operational or technical assistance, after reading this manual, please call us toll free at (800) 638-3600 or visit www .magnadyne.com ...

  • Magnadyne MV1020 - page 2

    2 Safety Information . . . . . . . . . . . . . . . . . . . . 2-3 Disc and SD Card Notes . . . . . . . . . . . . . . . . . 4 Screen and DVD/CD Functions . . . . . . . . . . 5-7 Location of Functions . . . . . . . . . . . . . . . . . . 5 T urning the Unit On . . . . . . . . . . . . . . . . . . . 6 Adjusting the Monitor . . . . . . . . . . . . . . . . ...

  • Magnadyne MV1020 - page 3

    3 Features • This unit can play compatible discs recorded in either P AL or NTSC format. • CD, DVD, CD-R, CD-RW and MP3 Compatible. • SD Card Support. • Full-Function Wireless Remote Controller . • Multi-Language On-Screen Display Menu. • Built-In Dome Light System. • Front Panel Controls. • Wireless IR T ransmitter Module so audio ...

  • Magnadyne MV1020 - page 4

    Disc Formats Supported by this Player: Discs which cannot be played with this player: • DVD-ROM • DVD-R/DVD-RAM • CDV • CD-G 4 Disc and SD Card Notes V I D E O (Single-sided disc only) 8 cm disc 8 cm disc Label side up Do not touch the underside of the disc Do not bend Wipe the disc from center toward the outside edge. Disc Handling • Dir ...

  • Magnadyne MV1020 - page 5

    5 Screen and DVD/CD Functions 1. POWER Button: Press this button to turn the unit On/Off. 2. SOURCE Button: Press this button to change the play source between DVD/CD player and an auxiliary input source. 3. STOP Button: Stops play of picture or audio. 4. Power On LED Indicator 5. Infrared Remote Sensor: Receives the signals from the remote control ...

  • Magnadyne MV1020 - page 6

    T urning the Unit On: Press the POWER on either the remote or the screen housing. Adjusting the Monitor: 1. Press the MODE button on the remote to activate the monitor adjustment menu. The following will be displayed on the screen: 2. Press the MODE button again to select the adjustment bar . 3. Use the UP and DOWN buttons on the remote to adjust t ...

  • Magnadyne MV1020 - page 7

    Screen and DVD/CD Functions 7 Dome Light Switch Infrared Remote Control Sensor: The Infrared remote control sensor receives the signals from the remote control. Wireless T ransmitter Modules Wireless T ransmitter Modules: The audio signal is converted to an infrared light and FM frequency that is transmitted to the IR headphones or the vehicle’ s ...

  • Magnadyne MV1020 - page 8

    8 1 9 10 6 18 19 11 13 22 23 24 14 15 17 5 2 3 4 16 20 21 8 12 7 25 POWER AUDIO ANGLE SUBTITLE DISPLA Y SETUP PLA Y/PAUSE PROG CLEAR PREV REV SLOW SD TITLE NEXT FWD A-B REPEA T SOURCE VOL– ZOOM PBC MENU SEARCH ENTER RETURN STOP EJECT VOL+ MOD E TFT FUN CTION UP MUTE DOWN 1 4 7 2 5 8 0 10+ 3 6 9 Remote Control Locations and Operation 1. POWER : T ...

  • Magnadyne MV1020 - page 9

    POWER AUDIO ANGLE SUBTITLE DISPLA Y SETUP PLA Y/PAUSE PROG CLEAR PREV REV SLOW SD TITLE NEXT FWD A-B REPEA T SOURCE VOL– ZOOM PBC MENU SEARCH ENTER RETURN STOP EJECT VOL+ MOD E TFT FUN CTION UP MUTE DOWN 1 4 7 2 5 8 0 10+ 3 6 9 30 29 26 27 28 31 32 Remote Control Locations and Operation 26. Use CURSOR buttons when selecting items or to move curso ...

  • Magnadyne MV1020 - page 10

    Slow Play Each time the SLOW button is pressed during DVD play the speed is reduced as follows: 10 Basic Operation and Special Functions Display DVD Menu Screen 1. Press the MENU button to display the DVD menu screen. 2. Use the cursor button to select item. 3. Press ENTER or PLA Y to play the selected. Searching for a Specific Chapter or T rack 1. ...

  • Magnadyne MV1020 - page 11

    11 Special Functions and Setup Menu DVD SPECIAL FUNCTIONS (Continued) Multi-Subtitle Language Function Press the SUBTITLE button during playback. Each time the button is pressed the subtitle language on the screen changes. Multi-Audio Language Function Press the AUDIO button during playback. Each time the button is pressed the audio sound- track la ...

  • Magnadyne MV1020 - page 12

    12 Setup Menu DISC SETTINGS Use the CURSOR buttons to make DISC setting selections. Press the ENTER button to confirm the setting. Audio Setting Use this screen to setup the audio language on multi-language discs. Subtitle Language Setting Use this screen to setup the subtitle language on multi-subtitle language discs. Menu Language Setting Use thi ...

  • Magnadyne MV1020 - page 13

    Setup Menu VIDEO SETTINGS Use the CURSOR buttons to make VIDEO setting selections. Press the ENTER but- ton to confirm the setting. TV Aspect Setting Use this screen to setup the desired TV Aspect Ratio. AUDIO SETTINGS Use the CURSOR buttons to make AUDIO setting selections. Press the ENTER but- ton to confirm the setting. TV System Setting Use thi ...

  • Magnadyne MV1020 - page 14

    14 Setup Menu Last Play Function The Last Play function automatically book- marks the position on a DVD/CD disc and remembers the playback settings. Playback will resumes at the position which the player was turned off, the disc was ejected, or the power was cut off. T urning Off Last Play Function Press the SETUP button to display the main menu. T ...

  • Magnadyne MV1020 - page 15

    15 Installation When installing the MV1020 using a Custom Bracket Mounting System refer to the instructions included wi th with the bra cket. War ning: T ake e x tra ca re not to p enetrate the roof of your v ehicle during i nst allati on. Veh icl e ’ s Cei ling Su pp ort Beams Custom B ra cket Mou n t ing System (Opt i o na l) Custom Sh r oud/B ...

  • Magnadyne MV1020 - page 16

    16 Wiring Diagram Black (Video Out) White (L-Audio Out) Red (R-Audio Out) Audio Video Output (Female RCA) Mini DIN Connector Black Wire - Ground Red Wire - Ignition Y ellow Wire - Batter y Blue Wire - Door (+) Y ellow (Video In) White (L-Audio In) Red (R-Audio In) Audio Video Input (Female RCA) 3A ...

  • Magnadyne MV1020 - page 17

    17 Power Harness Wiring: The 4-wire harness provides battery and ignition 12 volts as well as a chassis ground. Route the power harness to the point in the vehicle that you will make the connections. Red Wire: The red wire in the harness should be connected to a +12 volt power wire that is turned on and of by the position of the ignition key . Y el ...

  • Magnadyne MV1020 - page 18

    18 Only qualified service personnel can remove the cover or service this player . Other wise the warranty will become invalid. No Power: • Check to see if the player is set to “On”. • Check to see that the power plug of the main unit is properly connected. • Check to see if that power to the outlet is properly working. No Picture: • Che ...

  • Magnadyne MV1020 - page 19

    19 Replacement Parts Order Form Send Orders T o : Magnadyne Corporation We Accept Checks, Money Orders, Visa and Master Card A TTN: Consumer Parts Sales Make Checks Payable to: Magnadyne Corporation P . O. Box 5365 Carson, CA 90749-5365 SHIP TO: (No P .O. Boxes) LAST NAME FIRST NAME INITIAL STREET ADDRESS (IF P AYING WITH A CREDIT CARD, YOUR BILLIN ...

  • Magnadyne MV1020 - page 20

    Order By Mail Replacement Parts for MovieVision ® Systems DESCRIPTION MODEL # PRICE DVD Remote Control MV-1020RM $39.95 Ea. ONE (1) YEAR LIMITED WARRANTY Magnadyne Corporation or its authorized agents will within 1 year from the date of sale to you, repair , replace or refund the retail sales price of said product or any part thereof, at the optio ...

Manufacturer Magnadyne Category DVD Player

Documents that we receive from a manufacturer of a Magnadyne MV1020 can be divided into several groups. They are, among others:
- Magnadyne technical drawings
- MV1020 manuals
- Magnadyne product data sheets
- information booklets
- or energy labels Magnadyne MV1020
All of them are important, but the most important information from the point of view of use of the device are in the user manual Magnadyne MV1020.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Magnadyne MV1020, service manual, brief instructions and user manuals Magnadyne MV1020. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Magnadyne MV1020.

A complete manual for the device Magnadyne MV1020, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Magnadyne MV1020 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Magnadyne MV1020.

A complete Magnadyne manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Magnadyne MV1020 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Magnadyne MV1020, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Magnadyne MV1020, that we can find in the current document
3. Tips how to use the basic functions of the device Magnadyne MV1020 - which should help us in our first steps of using Magnadyne MV1020
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Magnadyne MV1020
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Magnadyne MV1020 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Magnadyne MV1020?

Use the form below

If you did not solve your problem by using a manual Magnadyne MV1020, ask a question using the form below. If a user had a similar problem with Magnadyne MV1020 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)