-
Dimplex VCX1525 - page 1
Owner ’ s Manual Model VCX1525 VCX1525-WH T o view the full line of Dimplex products, please visit www .dimplex.com 7209350100R03 IMPORT ANT SAFETY INFORMA TION: Always read this manual rst before attempting to install or use this replace. For your safety , always comply with all warnings and safety instructions contained in this manual to ...
-
Dimplex VCX1525 - page 2
2 www .dimplex.com T able of Contents Always use a qualied technician or service agency to repair this replace. ! NOTE: Procedures and techniques that are considered important enough to emphasize. CAUTION: Procedures and techniques which, if not carefully followed, will result in damage to the equipment. W ARNING: Procedures and technique ...
-
Dimplex VCX1525 - page 3
3 W elcome & Congratulations Thank you and congratulations for choosing to purchase an electric replace from Dimplex, the world leader in electric replaces. Please carefully read and save these instructions. CAUTION: Read all instructions and warnings carefully before starting installation. Failure to follow these instructions may result ...
-
Dimplex VCX1525 - page 4
4 www .dimplex.com When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following: ① Read all instructions before using the Convex In-Stud replace. ② The heater is hot when in use. T o avoid burns, do not let bare skin touch hot surfaces ...
-
Dimplex VCX1525 - page 5
5 SA VE THESE INSTRUCTIONS IMPORT ANT INSTRUCTIONS ⑬ Do not modify the replace. Use it only as described in this manual. Any other use not re com men ded by th e m an uf ac tur er may cause re, electric shock or injury to persons. ⑭ This unit may have a polarized plug (one blade is wider than the other). The plug will t in a polarized ...
-
Dimplex VCX1525 - page 6
6 www .dimplex.com IMPORT ANT INSTRUCTIONS W ARNING: Remote control contains small batteries. Keep away from children. If swallowed, seek medical attention immediately . W ARNING: Do not install battery backwards, charge, put in re or mix with used or other battery types - may explode or leak causing injury . ! NOTE: Changes or modications no ...
-
Dimplex VCX1525 - page 7
7 Fireplace Installation ! NOTE: A 15 Amp, 120 V olt circuit is required. A dedicated circuit is preferred but not essential in all cases. A dedicated circuit will be required if, after installation, the circuit breaker trips or the fuse blows on a regular basis when the heater is operating. Additional appliances on the same circuit may exceed the ...
-
Dimplex VCX1525 - page 8
8 www .dimplex.com W ARNING: The Convex In Stud replace is wall mountable and can be built in a wall space 16 inches (406 mm) over-center between 2” x 4” wall studs. Follow the installation instructions for either wall mount or built-in mounting; failure to do so may cause damage or injury . W all Mounting Instructions ① Leave the glass as ...
-
Dimplex VCX1525 - page 9
9 Fireplace Installation obstruct the bottom of this heater . Bottom of unit must be a minimum of 14 inches (356 mm) above the oor or any surface such as a tabletop to ensure adequate space for heat exhaust from the bottom of the replace (Figure 3). ③ W ith a w all stu d nde r , loc ate the center of the wall stud, drive a wood screw in ...
-
Dimplex VCX1525 - page 10
10 www .dimplex.com ⑦ With the glass assembly taken off, mount the rebox onto the two (2) mounting screws. ⑧ Mark position of hole “H”. ⑨ Remove replace from wall. ⑩ Install drywall anchor into drywall at marked position. ⑪ With the glass assembly of f, mount the replace onto the two (2) mounted screws. ⑫ T ighten both moun ...
-
Dimplex VCX1525 - page 11
11 Fireplace Installation installation should be entrusted to duly qualied personnel where required by law . ① Leave the frame uninstalled from the replace chassis until step 13. ② Prepare a wall opening following the dimensions shown in Figure 5. Note that a four (4) inch (102 mm) minimum depth including the thickness of dry wall is requ ...
-
Dimplex VCX1525 - page 12
12 www .dimplex.com ④ Remove the outer jacket and strip the individual conductor from the end. ⑤ Loosen the screw securing the junction box cover and remove the cover . ⑥ T ake the cables out from the junction box, loosen the two (2) wire nuts and remove the cord set (Figure 6). ⑦ Route the power supply wire through the knockout on supplied ...
-
Dimplex VCX1525 - page 13
13 Fireplace Installation fasteners. Attach supplied wall cover brackets to the top and the bottom of replace to cover the gap on the dry wall (Figure 8). ⑬ Attach replace frame as shown in Figure 4 . Bathroom Installation This rebox must be protected by a GFI receptacle or circuit for bathroom use. If receptacle Fireplace Junction Box W ...
-
Dimplex VCX1525 - page 14
14 www .dimplex.com Operation Figure 9 T op Light Dimmer Thermostat Heater On/Off Switch Main On/Off Switch A. Main On/Off Switch The switch has two ON positions marked with and “ ON ”. The “ ON ” position is for manual operation. In this position the built-in remote control is by- passed. The position is for operating the unit with the pro ...
-
Dimplex VCX1525 - page 15
15 Operation Resetting The T emperature Cutoff Switch Should the heater overheat, an automatic cut out will turn the replace off and it will not come back on without being reset. It can be reset by switching the Main On/Off Switch to OFF and waiting ve (5) minutes before switching the unit back on. CAUTION: If you need to continuously reset t ...
-
Dimplex VCX1525 - page 16
16 www .dimplex.com Figure 1 1 Lift to remove Glass assembly Bulb Replacement Instructions: ① Disconnect power supply to the replace either by unplugging the replace or switch off at the breaker panel. ② Remove glass assembly . Remove the screws securing the glass assembly on the chassis (Figure 4). ③ Hold on to the glass assembly with ...
-
Dimplex VCX1525 - page 17
17 Maintenance Figure 12 Light Block ⑥ Replace with new bulbs. ⑦ Reassemble light block and glass assembly in reverse order . Glass Cleaning The front glass is cleaned in the factory during the assembly operation. During shipment, installation, handling, etc., the front glass may collect dust particles, these can be removed by dusting lightly w ...
-
Dimplex VCX1525 - page 18
18 www .dimplex.com W arranty Products to which this limited warranty applies This limited warranty applies to newly purchased Dimplex replaces and surrounds (mantels) and trims. This limited warranty applies only to purchases made in any province of Canada except for Y ukon T erritory , Nunavut, or Northwest T erritories or in any of the 50 Sta ...
-
Dimplex VCX1525 - page 19
19 W arranty Dimplex will in its sole discretion • either repair or replace such defective product or part without charge. If Dimplex is unable to repair or replace such product or part, or if repair or replacement is not commercially practicable or cannot be timely made, Dimplex may , in lieu of repair or replacement, choose to refund the purcha ...
-
Dimplex VCX1525 - page 20
20 www .dimplex.com © 201 1 Dimplex North America Limited Dimplex North America Limited 1367 Industrial Road Cambridge ON Canada N1R 7G8 Replacement Parts Front Glass - VCX1525 . . . . . . . . . . . . . . . . . . . . . . 5901 170100RP VCX1525-WH . . . . . . . . . . . . . . . . . . 5901 170200RP Flicker Motor .............................. 2 0 0 0 ...
Do you have a question concerning Dimplex VCX1525?
Use the form below
If you did not solve your problem by using a manual Dimplex VCX1525, ask a question using the form below. If a user had a similar problem with Dimplex VCX1525 it is likely that he will want to share the way to solve it.