Manual Edimax HP-5001

22 pages Not applicable
Download

Go to site of 22

Summary
  • Edimax HP-5001 - page 1

    ...

  • Edimax HP-5001 - page 2

    1 Copyright Copyright  Ed imax Technology Co., Ltd . all rights reserved . No part of this p ublication may be reproduced, transmitte d, transcribed , stored in a retrieval system, or tran slated into any langu age or comp uter language , in any form or b y any means, electronic, mechan ical, magnetic, optic al, chemical, man ual or otherwise, w ...

  • Edimax HP-5001 - page 3

    2 Contents Chapter 1: Introduction ..................................................................................................................................... 3 1.1 Product Features .................................................................................................................................. 3 1.2 Application ......... ...

  • Edimax HP-5001 - page 4

    3 Chapter 1 : In troduction 1.1 Product Featur es  Data rates up to 50 0Mbps  Transmits network data via existing ele ctrical wires (no externa l cabling requ ired)  Easy plug-and-p lay setup  Works with route rs, compute rs, and other net work devices  Consumes less th an 1W of power in power saving mode 1.2 Application  High-def ...

  • Edimax HP-5001 - page 5

    4 1.4 System Requir ements Operating System Utility can support Windows 2000/ XP/Vista /7 CPU Intel P entium III 2.0GHz ( or higher) RAM 128MB (at least) Free Disk Space 20MB (at least) Network In terface Fast Ethernet (100Mbps) n etwork interface an d an Ethernet cable ...

  • Edimax HP-5001 - page 6

    5 Chapter 2 : Ad apter 2.1 Ethernet Por t You can connect the HP-5001 to a router, a compute r, or any network devic e via this Ethernet port. 2.2 Buttons Reset Press and h old the reset butt on for 3 seconds to restore the powerline adapter t o factory d efaults. Security (Group) Press and hold the “ Security (Group ) ” button for more than 10 ...

  • Edimax HP-5001 - page 7

    6 2.3 LEDs Ethernet Port Green On Ethernet connection established Flashing Network activity Off No Ethernet c onnection Power Green On Powered on Flashing  In power savin g mode  Device resetting  Synchronizing p assword Off Powered off PLC Green/ Orange/ Red On Green: PHY RATE > 80Mbps Orange: 40 Mbps < PHY RATE < 80Mb ps Red: PH ...

  • Edimax HP-5001 - page 8

    7 Chapter 3 : Uti lity Software Installa tion Step 1 Before installing th e utility so ft ware, make sure that no other powerline u tility is installed on your compute r. If any other utility software is inst alled, uninstall it and reboot the c omputer. Step 2 Insert the CD into your CD -ROM drive. When the following image ap pears, click “ 500M ...

  • Edimax HP-5001 - page 9

    8 Note : You will get the following image , if your compu ter did not install WinP cap4.1.2 before. Please click “ Apply ” to install WinP cap4.1.2. ...

  • Edimax HP-5001 - page 10

    9 ...

  • Edimax HP-5001 - page 11

    10 ...

  • Edimax HP-5001 - page 12

    11 Step 4 When th e setup wizard appears, c lick “ Next ” to continue. Step 5 Select where you want to install the utility software, and then click “ Next ” . ...

  • Edimax HP-5001 - page 13

    12 ...

  • Edimax HP-5001 - page 14

    13 Step 6 After the installation is comp lete, click “ Close ” . Step 7 An icon will app ear on your desktop. Click the icon to open the utility software . Note: You can manage all th e connected powerline ad apters with the utility software. However, i nstalling th e utility software is opt ional. ...

  • Edimax HP-5001 - page 15

    14 Chapter 4 : Using the Utility Softw are 4.1 Main Tab The “ Main ” tab provides a list of p owerline adapte rs connected to the compu ter. The upper p anel displays local powerline adapters . The lower panel displays remote powe rline adapters in the network. Connect Click “ Connec t ” and the utility software will scan for other local po ...

  • Edimax HP-5001 - page 16

    15 4.2 Privacy Tab In the “ Privacy ” tab , you ca n create a private n etwork by changing the default network name and c onfigure its security sett ings. If the network nam e is modified to an ything other than the d efault, the network type in the “ Main ” tab will be changed to “ Private ” . Set Local Device Only Thi s butt on is use ...

  • Edimax HP-5001 - page 17

    16 4.3 Diagnostics Ta b The “ Diagnostics ” tab displays the system information and h istory of all remote devices. The upper p anel displays technic al data concerning the software and hardware on the host compute r and t he lower panel displays the history of all re mote devices. ...

  • Edimax HP-5001 - page 18

    17 4. 4 About Tab The “ About ” tab contains some basic information about the software. You can also enable or d isable the autoscan fun ction under “ Preferenc es ” . ...

  • Edimax HP-5001 - page 19

    18 Chapter 5 : Se curity Button This section dem onstrates how to add or remove devic es from a HomePlug AVLN with the “ Security (Group) ” button. T he “ Power ” LED ind icates the operation statu s and result. 5.1 Forming a Hom ePlug AV Logical N etwork When two devic es with different NMK val ues are conn ected to the same powerline an d ...

  • Edimax HP-5001 - page 20

    19 Step 2 Press the “ Sec urity ” button on any device in th e network for less th an 3 second s. This should be done within 1 m inute. Step 3 Wait for the connection to comp lete. The “ Power ” LED on both devices will blink evenly at 1-second intervals until the operation succee ds or fails. If the c onnection succee ds, it will illumina ...

  • Edimax HP-5001 - page 21

    20 Federal Communic at ion Commis sion Interf erence Statement This equipment has b een tested and found to comply with the limits for a Cl ass B digital device, pursu ant to Part 15 of FCC Rules. These li mits are designed to provide reas o nable protection against harmful in terference in a r esidential installation. This equip ment generat es, u ...

  • Edimax HP-5001 - page 22

    21 ...

Manufacturer Edimax Category Network card

Documents that we receive from a manufacturer of a Edimax HP-5001 can be divided into several groups. They are, among others:
- Edimax technical drawings
- HP-5001 manuals
- Edimax product data sheets
- information booklets
- or energy labels Edimax HP-5001
All of them are important, but the most important information from the point of view of use of the device are in the user manual Edimax HP-5001.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Edimax HP-5001, service manual, brief instructions and user manuals Edimax HP-5001. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Edimax HP-5001.

Similar manuals

A complete manual for the device Edimax HP-5001, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Edimax HP-5001 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Edimax HP-5001.

A complete Edimax manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Edimax HP-5001 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Edimax HP-5001, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Edimax HP-5001, that we can find in the current document
3. Tips how to use the basic functions of the device Edimax HP-5001 - which should help us in our first steps of using Edimax HP-5001
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Edimax HP-5001
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Edimax HP-5001 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Edimax HP-5001?

Use the form below

If you did not solve your problem by using a manual Edimax HP-5001, ask a question using the form below. If a user had a similar problem with Edimax HP-5001 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)