-
Dual Electronics Corporation MXDM51 - page 1
INSTALLATION/OWNER ' S MANUAL AM/FM/CD/MP3/WMA Receiver with Detach Face MXDM51 MARINE ...
-
Dual Electronics Corporation MXDM51 - page 2
2 MXDM51 INSTALLATION Preparation TYPICAL FRONT-LOAD DIN MOUNTING METHOD Please read entire manual before installation. Before You Start • Disconnect negative battery terminal. Consult a qualified technician for instructions. • Avoid installing the unit where it would be subject to high temperatures, such as from direct sun ...
-
Dual Electronics Corporation MXDM51 - page 3
3 MXDM51 INSTALLATION Wiring Diagram FUSE When replacing the fuse, make sure new fuse is the correct type and amperage. Using an incorrect fuse could damage the radio. The MXDM51 uses one 10 amp AGC fuse (Battery) located in-line. ...
-
Dual Electronics Corporation MXDM51 - page 4
4 MXDM51 OPERATION Control Locations Release Power Mute Audio Band/Play/Pause Auto Store/Preset Scan/Enter Mode/Search Eject Tune/Track Up/Down Loudness Display/0 1 2 3 4 5 6 7 8 9 10 11 EQ/9 Tuner Scan/8 Local/Distance/7 Preset 6/Folder Up Preset 5/Folder Down Preset 4 Preset 3/Intro Preset 2/Random Preset 1/Repeat Volume Up/Down 12 13 14 1 ...
-
Dual Electronics Corporation MXDM51 - page 5
5 MXDM51 OPERATION General Operation Press RELEASE and pull away from the left side to remove. To re-install, insert right side of faceplate first then push left side to secure. Remove trim ring and install supplied #1 x 7/32” Phillips hea d scr ew th rou gh lef t sid e of mou nti ng fr ame in to fac epl ate . Press PWR or any other button ...
-
Dual Electronics Corporation MXDM51 - page 6
6 MXDM51 OPERATION General Operation In tuner mode, press and hold DISP then press TUNE > > to select function priority display. “FREQ” will momentarily appear in the display. Note: "FUNC" will appear in CD or AUX modes. Radio frequency (tuner mode), CD track/elapsed time (CD mode) or AUX (AUX mode) will be displaye ...
-
Dual Electronics Corporation MXDM51 - page 7
Press AUD to select between Volume (default), Bass, Treble, Balance & Fader. Press AUD until BAS appears Press VOL t or s to adjust ( -6 minimum / +6 maximum) Press AUD until TRE appears Press VOL t or s to adjust ( -6 minimum / +6 maximum) Press AUD until BAL appears Press VOL t or s to adjust (BAL L 12-BAL 00-BAL R 12) BAL 00 represents equal ...
-
Dual Electronics Corporation MXDM51 - page 8
Press TUNE < < or TUNE > > momentarily to seek the next strong station. Press TUNE < < or TUNE > > for more than 2 seconds, then release. "MANUAL" will momentarily appear in the display. Press TUNE < < or TUNE > > momentarily to move radio frequency ...
-
Dual Electronics Corporation MXDM51 - page 9
Insert CD Eject CD Track Select Fast Forward and Reverse Pause Intro Repeat Random CD-R/CD-RW Compatibility With the label facing up, insert a standard size CD into the CD slot. The CD will automatically begin playback. Press EJECT to eject the CD. The unit will change to previous mode of operation (AM, FM, or auxiliary input). ...
-
Dual Electronics Corporation MXDM51 - page 10
10 MXDM51 OPERATION CD Player Operation - MP3/WMA Files Playing an MP3/WMA Disc MP3 Icon WMA Icon Folder Icon Displaying Information Character Support When an MP3/WMA encoded disc is first inserted, “READING” will appear in the display. Depending on the number of files and folders, this may take several ...
-
Dual Electronics Corporation MXDM51 - page 11
11 MXDM51 OPERATION Press SEARCH for more than 3 seconds, to select between the following modes: • Direct File Select • Alphanumeric File or Folder Search • File or Folder Navigate Press SEARCH for more than 3 seconds, then release. “MP3 T * " or “WMA T * ” will flash in the display. Use the buttons in the above table (3 ...
-
Dual Electronics Corporation MXDM51 - page 12
MXDM51 OPERATION 12 CD Player Operation - MP3/WMA Files Alphanumeric File or Folder Search Step 1 Step 2 Step 3 Step 4 Step 5 File/Folder Navigate Step 1 Step 2 Step 3 Step 4 *Folder Access (Up one level) Press SEARCH for more than 3 seconds, then release. Press SEARC ...
-
Dual Electronics Corporation MXDM51 - page 13
Press F to select the previous folder. Press F to select the next folder. *Folder access is only available on MP3/WMA discs recorded with more than one folder. Press RPT momentarily to continuously repeat selected file. Press RPT again to cancel. Press RPT for more than 2 seconds to consecutively repeat all files in the current folder only. The ico ...
-
Dual Electronics Corporation MXDM51 - page 14
14 15 MXDM51 OPERATION The following types of discs/files are compatible: • CD-ROM (ISO), CD-R, CD-RW • CD-DA • MP3 data • WMA data The following types of discs/files are not compatible: • WMA files that are protected by DRM (Digital Rights Management). • WMA lossless format • Discs recorded with Track At Once or packet writing ? ...
-
Dual Electronics Corporation MXDM51 - page 15
14 15 MXDM51 OPERATION An internal buffer provides ESP (Electronic Skip Protection) to virtually eliminate skipping. When playing a disc recorded with regular audio files (CD-DA or .WAV) and MP3/WMA files, the unit will play the MP3/WMA files only. Onl y MP3 file s with file nam e exte nsi on (. mp3 ) can be playe d. Onl y WMA file s with file ...
-
Dual Electronics Corporation MXDM51 - page 16
16 17 Limited One Year Warranty MXDM51 WARRANTY This warranty gives you specific legal rights. You may also have other rights which vary from state to state. Dual Electronics Corp. warrants this product to the original purchaser to be free from defects in material and workmanship for a period of one year from the date of the original p ...
-
Dual Electronics Corporation MXDM51 - page 17
16 17 Frequency response: 10Hz-20kHz Channel separation @ 1kHz: >65dB D/A converter: 1 Bit Tuning range: 87.5MHz-107.9MHz Usable sensitivity: 8.5dBf 50dB quieting sensitivity: 10dBf Stereo separation @ 1kHz: 40dB Frequency response: 30Hz-13kHz Tuning range: 530kHz-1710kHz Usable sensitivity: 22uV Frequency response: 30Hz-2.2kHz Operating volta ...
-
Dual Electronics Corporation MXDM51 - page 18
18 Problem Cause Action Unit will not turn on (no power) Yellow wire not connected or incorrect voltage Red wire not connected or incorrect voltage Check connections for proper voltage (11~16VDC) Black wire not connected Check connection to ground Fuse blown Replace fuse Unit has power (but no sound) Speaker wires not conne ...
-
Dual Electronics Corporation MXDM51 - page 19
Notes MXDM51 OPERATION 19 ...
-
Dual Electronics Corporation MXDM51 - page 20
Dual Electronics Corp. Toll Free: 1-866-382-5476 www.dualav.com ©2006 Dual Electronics Corp. All rights reserved. Windows Media and the Windows logo are trademarks, or registered trademarks of Microsoft Corporation in the United States and or other countries. NSA0806-V01 ...
Do you have a question concerning Dual Electronics Corporation MXDM51?
Use the form below
If you did not solve your problem by using a manual Dual Electronics Corporation MXDM51, ask a question using the form below. If a user had a similar problem with Dual Electronics Corporation MXDM51 it is likely that he will want to share the way to solve it.