Manual Hobart HHFC4

16 pages 0.72 mb
Download

Go to site of 16

Summary
  • Hobart HHFC4 - page 1

    FORM 33798 Rev. A (Sept. 2001) HHFC SERIES DELI DISPLA Y CASES MODEL HHFC4 ML-114911 High Profile (57 3 ⁄ 8 " High) ML-114917 Low Profile (48 1 ⁄ 2 " High) ML-126809 Two Tier ML-126810 Pedestal ML-126821 Designer HHFC4C ML-114914 Counter HHFC5 ML-126815 High Profile (57 3 ⁄ 8 " High) ML-126816 Low Profile (48 1 ⁄ 2 " Hig ...

  • Hobart HHFC4 - page 2

    – 2 – © HOBART CORPORATION, 1997, 2001 Euro Base High or Low Profile 4, 5, 6 or 8 Foot Full Service or Self-Service Pedestal Base 4, 6 or 8 Foot Full Service or Self-Service Countertop Model 4, 5, 6 or 8 Foot Full Service or Self-Service ...

  • Hobart HHFC4 - page 3

    – 3 – Two Tier 4, 6 or 8 Foot Self-Service Designer Base 4, 6 or 8 Foot Full Service or Self-Service Island Case 4 Foot Self-Service ...

  • Hobart HHFC4 - page 4

    – 4 – Installation, Operation and Care of HHFC SERIES DELI DISPLA Y CASES SA VE THESE INSTRUCTIONS GENERAL The HHFC Series Deli Display Cases hold food products at regulated temperatures, maintaining both freshness and quality. The deli cases feature uniform heating. Clear-view glass surrounds the food holding area. Full Service units provide t ...

  • Hobart HHFC4 - page 5

    – 5 – INSTALLATION CODES AND STANDARDS In the United States, Hobart HHFC Series Deli Display Cases must be installed in accordance with state and local codes and the National Electrical Code, ANSI/NFPA-70 (latest edition). In Canada, Hobart HHFC Series Deli Display Cases must be installed in accordance with local codes and the Canadian Electric ...

  • Hobart HHFC4 - page 6

    – 6 – Fig. 1 1. Lift the front glass into the upright position. 2. Remove the operator side service doors. 3. Place the stainless steel well adapter insert into the deli case well on the side (left or right) that is provided with the two-foot wide short piece of front glass. 4. Align the mid-divider glass bracket located on the stainless steel ...

  • Hobart HHFC4 - page 7

    – 7 – ELECTRICAL CONNECTIONS WARNING : ELECTRICAL AND GROUNDING CONNECTIONS MUST COMPLY WITH THE APPLICABLE PORTIONS OF THE NATIONAL ELECTRICAL CODE AND/OR OTHER LOCAL ELECTRICAL CODES. WARNING : DISCONNECT ELECTRICAL SUPPLY AND PLACE A TAG AT THE DISCONNECT SWITCH TO INDICATE THAT YOU ARE WORKING ON THE CIRCUIT. Make electrical connections per ...

  • Hobart HHFC4 - page 8

    – 8 – CONTROLS — All Models with Overhead Radiant Heat Lamp Bulbs, Euro, Counter, Designer, Two Tier or Pedestal Models, Full Service or Self-Service, Model HHFC4 (Case Length: 4 Foot), Model HHFC5 (Case Length: 5 Foot), Model HHFC6 (Case Length: 6 Foot) or Model HHFC8 (Case Length: 8 Foot) The size of the deli case and the model number deter ...

  • Hobart HHFC4 - page 9

    – 9 – HIGH MED LOW OFF OVERHEAD HEA TER WELL THERMOST A T WELL INDICA TOR LIGHT OFF 10 9 8 7 6 5 4 3 2 1 FUSE HOLDER MAIN (ON/OFF) OVERHEAD LIGHTS ON/OFF PL-53651 ZONE CONTROL CONTROLS — Countertop, Euro Style or Pedestal, Model HHFC4 or HHFC4C (Case Length: 4 Foot), with Overhead Heater and Halogen Lighting Each zone has its own separate hea ...

  • Hobart HHFC4 - page 10

    – 10 – OFF OVERHEAD HEA TER WELL THERMOST A T OFF 10 9 8 7 6 5 4 3 2 1 WELL INDICA TOR LIGHT MAIN (ON/OFF) OVERHEAD LIGHTS ON/OFF FUSE HOLDER PL-53653 ZONE CONTROL Fuse Holder — Replace fuse with same size and type. Overhead Heater — Regulates the heating elements to Low, Medium or High settings. Overhead Lights — Turns the overhead halog ...

  • Hobart HHFC4 - page 11

    – 11 – OFF HIGH LOW OVERHEAD HEA TER WELL THERMOST A T OFF 10 9 8 7 6 5 4 3 2 1 WELL INDICA TOR LIGHT MAIN (ON/OFF) OVERHEAD LIGHTS ON/OFF FUSE HOLDER WELL THERMOST A T OFF 10 9 8 7 6 5 4 3 2 1 WELL INDICA TOR LIGHT ZONE CONTROL ZONE CONTROL PL-53654 CONTROLS — Countertop, Euro Style or Pedestal, Model HHFC8 or HHFC8C (Case Length: 8 Foot), w ...

  • Hobart HHFC4 - page 12

    – 12 – HIGH MED LOW OFF OVERHEAD HEA TER WELLS THERMOST A T WELLS INDICA TOR LIGHT OFF 10 9 8 7 6 5 4 3 2 1 FUSE HOLDER MAIN (ON/OFF) OVERHEAD LIGHTS ON/OFF PL-53650 CONTROLS — Designer or Two Tier, Model HHFC4 (Case Length: 4 Foot), with Overhead Heater and Halogen Lighting One thermostat control adjusts the well heaters for the entire case; ...

  • Hobart HHFC4 - page 13

    – 13 – CENTER WELLS THERMOST A T WELLS INDICA TOR LIGHT OFF 10 9 8 7 6 5 4 3 2 1 END WELLS THERMOST A T WELLS INDICA TOR LIGHT OFF 10 9 8 7 6 5 4 3 2 1 FUSE HOLDER MAIN (ON/OFF) OVERHEAD LIGHTS ON/OFF OFF HIGH LOW OVERHEAD HEA TER PL-53655 CONTROLS — Designer or Two Tier, Model HHFC5 (Case Length: 5 Foot) or Model HHFC6 (Case Length: 6 Foot), ...

  • Hobart HHFC4 - page 14

    – 14 – CONTROLS — Designer or Two Tier, Model HHFC8 (Case Length: 8 Foot), with Overhead Heater and Halogen Lighting One thermostat control (with heating indicator light) adjusts the heaters for the two extreme left and two extreme right end wells while another thermostat control (and heating indicator light) adjusts the heaters for the three ...

  • Hobart HHFC4 - page 15

    – 15 – BEFORE FIRST USE Before using the deli case for the first time, thoroughly clean the deli case with warm soapy water. Rinse thoroughly and wipe dry with a soft clean cloth. Clean all glass surfaces with a quality glass cleaner. USING THE DELI CASE Preheating Before placing products in the deli case, preheat for approximately 30 to 45 min ...

  • Hobart HHFC4 - page 16

    – 16 – MAINTENANCE WARNING : THE DELI CASE AND ITS PARTS ARE HOT. USE CARE WHEN OPERATING, CLEANING OR SERVICING THE DELI CASE. WARNING : DISCONNECT ELECTRICAL SUPPLY AND PLACE A TAG AT THE DISCONNECT SWITCH TO INDICATE THAT YOU ARE WORKING ON THE CIRCUIT BEFORE PERFORMING ANY MAINTENANCE. REPLACING THE OVERHEAD HEAT LAMPS WARNING : THE HEAT LA ...

Manufacturer Hobart Category Kitchen Utensil

Documents that we receive from a manufacturer of a Hobart HHFC4 can be divided into several groups. They are, among others:
- Hobart technical drawings
- HHFC4 manuals
- Hobart product data sheets
- information booklets
- or energy labels Hobart HHFC4
All of them are important, but the most important information from the point of view of use of the device are in the user manual Hobart HHFC4.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Hobart HHFC4, service manual, brief instructions and user manuals Hobart HHFC4. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Hobart HHFC4.

Similar manuals

A complete manual for the device Hobart HHFC4, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Hobart HHFC4 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Hobart HHFC4.

A complete Hobart manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Hobart HHFC4 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Hobart HHFC4, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Hobart HHFC4, that we can find in the current document
3. Tips how to use the basic functions of the device Hobart HHFC4 - which should help us in our first steps of using Hobart HHFC4
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Hobart HHFC4
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Hobart HHFC4 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Hobart HHFC4?

Use the form below

If you did not solve your problem by using a manual Hobart HHFC4, ask a question using the form below. If a user had a similar problem with Hobart HHFC4 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)