English dropdown-ico

Manual Napoleon Fireplaces fireplaces

24 pages 7.26 mb
Download

Go to site of 24

Summary
  • Napoleon Fireplaces fireplaces - page 1

    1 W415-0319 / E / 01.17.07 ...

  • Napoleon Fireplaces fireplaces - page 2

    2 W415-0319 / E / 01.17.07 Hood Louvre Bracket Hinge Screen Louvre Installation & Removal Heat Shield S tand Off Removal Logo Placement 16-17 OPTIONS Patented Catalytic Glass Door Blower Installation 18-19 OPERA TION / MAINTENANCE Operating Instructions Maintenance Catalytic Tile Maintenance Oxygen Depletion Sensor Pilot Cleaning Pilot Flame Ap ...

  • Napoleon Fireplaces fireplaces - page 3

    3 W415-0319 / E / 01.17.07 NAPOLEON gas fireplaces are manufactured under the strict Standard of the world recognized ISO 9001 : 2000 Quality Assurance Certificate. NAPOLEON products are designed with superior components and materials, assembled by trained craftsmen who take great pride in t heir work. The burner and valve assembly are leak and tes ...

  • Napoleon Fireplaces fireplaces - page 4

    4 W415-0319 / E / 01.17.07 This fireplace may be installed in an aftermarket per- manently located, manufactured (mobile) home, where not pr ohibited by local codes . This fireplace is only for use with the type of gas indi- cated on the r a ting plate . This fire place is not convert- ible for use with other gases, unless a certified kit is used. ...

  • Napoleon Fireplaces fireplaces - page 5

    5 W415-0319 / E / 01.17.07 This heater shall not be installed in a confined space or unusually tight construction unless pro- visions are provided for adequate combustion and ventila tion air . In order to avoid the possibility of exposed insu- lation or vapour bar rier coming in contact with the fire place body , it is r ecommended tha t the walls ...

  • Napoleon Fireplaces fireplaces - page 6

    6 W415-0319 / E / 01.17.07 50 If in this example a solid door separates Room 1 from Room 2, the volume of Room 2 could not be used. In this case the maximum BTU/h would be: Maximum BTU/h: 800 x 1000 = 16,000 BTU/h This would be considered a confined space since it can not support the 30,000BTU/h input of the heater and it would be necessary to prov ...

  • Napoleon Fireplaces fireplaces - page 7

    7 W415-0319 / E / 01.17.07 FIGURES 4 a-d PENINSULA OPEN-END SEE-THRU 4-SIDED ...

  • Napoleon Fireplaces fireplaces - page 8

    8 W415-0319 / E / 01.17.07 Note: In order to avoid the possibility of exposed insula- tion or vapour barrier coming in contact with the fireplace body , it is recommended that the walls of the fireplace enclosure be “finished” (ie: drywall/sheetrock), as you would finish any other outside wall of a home. This will ensure that clearance to combu ...

  • Napoleon Fireplaces fireplaces - page 9

    9 W415-0319 / E / 01.17.07 Combustible materials may be installed flush with the front of the fireplace but must not cover any of the black face- areas of the fireplace. Non-combustible material (brick, stone or ceramic tile) may protrude in these areas. It is not necessary to install a hearth extension with this fireplace system. When roughing in ...

  • Napoleon Fireplaces fireplaces - page 10

    10 W415-0319 / E / 01.17.07 FIGURE 14 Note: In order to avoid the possibility of exposed insula- tion or vapour barrier coming in contact with the fireplace body , it is recommended that the walls of the fireplace enclosure be “finished” (ie: drywall/sheetrock), as you would finish any other outside wall of a home. This will ensure that clearan ...

  • Napoleon Fireplaces fireplaces - page 11

    11 W415-0319 / E / 01.17.07 Install the base panels as illustrated in steps 1-4 on page 9. Both side panels sit under the bracket tab . Holding the side panel in position, bend down the tab to secure. [DE- T AIL 6]. DRYWALL DRYWALL 4" MIN FIGURE 17 Note: In order to avoid the possibility of exposed insula- tion or vapour barrier coming in cont ...

  • Napoleon Fireplaces fireplaces - page 12

    12 W415-0319 / E / 01.17.07 Combustible materials may be installed flush with the front of the fireplace but must not cover any of the black face- areas of the fireplace. Non-combustible material (brick, stone or ceramic tile) may protrude in these areas. It is not necessary to install a hearth extension with this fireplace system. When roughing in ...

  • Napoleon Fireplaces fireplaces - page 13

    13 W415-0319 / E / 01.17.07 PHAZER TM logs, glowing and charcoal embers, exclusive to Napoleon fireplaces, provide a unique and realistic glow- ing effect that is dif ferent in every installation. T ake the time to carefully position the embers for a maximum glowing effect. Figures 21 A - H. 1 . Place log #1 diagonally across the textured burner co ...

  • Napoleon Fireplaces fireplaces - page 14

    14 W415-0319 / E / 01.17.07 The curtain mesh must be kept fully closed during opera- tion to help prevent accidental burns from occurring. The heater must not be used when the hood is re- moved. Hook the hood over the lip of the curtain support plate. Combustible mantle clearance can vary according to the mantle depth. Use the graph to help evaluat ...

  • Napoleon Fireplaces fireplaces - page 15

    15 W415-0319 / E / 01.17.07 L36 L OUVRE INST ALLA TION FIGURE 32 a-c HOOD Attach the hood by pressing the top flange into the clips along the top of the louvre opening. Secure using a screw through the centre slot. LOWER LOUVRES Insert the hinge clips into the slots located at the bottom left and right corners of the unit. T o remove the louvres, p ...

  • Napoleon Fireplaces fireplaces - page 16

    16 W415-0319 / E / 01.17.07 Notes: Ornamental insets can not be used in conjunction with the catalytic door When using a catalytic door , glassed doors must be used on all other side or end openings. This unique patented catalytic system was designed to provide unparalleled safety and peace of mind. The top of the door contains four catalytic tiles ...

  • Napoleon Fireplaces fireplaces - page 17

    17 W415-0319 / E / 01.17.07 Remove the thermodisc bracket from the top of the firebox. Remove the thermodisc from the bracket supplied in the blower kit and install the thermodisc into the fireplace bracket. Then replace the bracket in the location it was removed. Connect the two ends of the unattached wires by the bracket to the thermodisc. Connec ...

  • Napoleon Fireplaces fireplaces - page 18

    18 W415-0319 / E / 01.17.07 When lighting and re-lighting, the gas knob cannot be turned from pilot to off unless the knob is depressed. 1. STOP! Read the above safety information on this la- bel. 2. Set the thermostat to lowest setting. 3. Turn off all electric power to the fireplace. 4. Open the control door . Turn the gas knob clockwise to off. ...

  • Napoleon Fireplaces fireplaces - page 19

    19 W415-0319 / E / 01.17.07 THIS PROCEDURE MUST BE PERFORMED BY A QU ALIFIED SERVICE PERSON! Inspect the pilot for any visible contamination or debris (usually lint, pet hair , spider webs, carpet fibre, etc.) and remove. Disconnect the pilot from the pilot tubing line. Using a 7 / 16 ” wrench, remove the injector from the pilot housing. Blow out ...

  • Napoleon Fireplaces fireplaces - page 20

    20 W415-0319 / E / 01.17.07 Contact your dealer for questions concerning prices and availability of replacement parts. Normally all parts can be ordered through your Napoleon dealer or distributor . # P ART No . DESCRIPTION 1* W361-0016 GLOWING EMBERS 2* W550-0001 CHARCOAL EMBERS 3* GD660 ST ANDARD W ALL SWITCH & 20 FT OF WIRE 4* W385-0245 NAPO ...

  • Napoleon Fireplaces fireplaces - page 21

    21 W415-0319 / E / 01.17.07 ...

  • Napoleon Fireplaces fireplaces - page 22

    22 W415-0319 / E / 01.17.07 Main burner goes out; pilot stays on. Pilot flame is not large enough or not engulfing the thermopile - service or replace Oxygen Depletion Sensor System - correct piping and/or regulator to provide correct pressure Thermopile shorting - clean thermopile connection to the valve. Reconnect. - replace Oxygen Depletion Sens ...

  • Napoleon Fireplaces fireplaces - page 23

    23 W415-0319 / E / 01.17.07 White / grey film forms on the glass of the optional cata- lytic door . Sulphur from fuel is being deposited on glass, logs or combustion chamber sur- faces. - clean the glass with a recommended gas fireplace glass cleaner . DO NOT CLEAN GLASS WHEN HOT . If deposits are not cleaned off regularly , the glass may become pe ...

  • Napoleon Fireplaces fireplaces - page 24

    24 W415-0319 / E / 01.17.07 W olf Steel Fir eplace Ser vice Histor y This fireplace must be serviced annually depending on usage. Date Service T echnician Name Service Performed Special Concerns Dealer Name ...

Manufacturer Napoleon Fireplaces Category Indoor Fireplace

Documents that we receive from a manufacturer of a Napoleon Fireplaces fireplaces can be divided into several groups. They are, among others:
- Napoleon Fireplaces technical drawings
- fireplaces manuals
- Napoleon Fireplaces product data sheets
- information booklets
- or energy labels Napoleon Fireplaces fireplaces
All of them are important, but the most important information from the point of view of use of the device are in the user manual Napoleon Fireplaces fireplaces.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Napoleon Fireplaces fireplaces, service manual, brief instructions and user manuals Napoleon Fireplaces fireplaces. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Napoleon Fireplaces fireplaces.

Similar manuals

A complete manual for the device Napoleon Fireplaces fireplaces, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Napoleon Fireplaces fireplaces by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Napoleon Fireplaces fireplaces.

A complete Napoleon Fireplaces manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Napoleon Fireplaces fireplaces - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Napoleon Fireplaces fireplaces, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Napoleon Fireplaces fireplaces, that we can find in the current document
3. Tips how to use the basic functions of the device Napoleon Fireplaces fireplaces - which should help us in our first steps of using Napoleon Fireplaces fireplaces
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Napoleon Fireplaces fireplaces
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Napoleon Fireplaces fireplaces in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Napoleon Fireplaces fireplaces?

Use the form below

If you did not solve your problem by using a manual Napoleon Fireplaces fireplaces, ask a question using the form below. If a user had a similar problem with Napoleon Fireplaces fireplaces it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)