-
Proline PLFW108 - page 1
R ange H oods For model numbers: PLJW109 / PLFW108 / PLJW125 / PLJW129 user m anu al pro line ...
-
Proline PLFW108 - page 2
Dear Valued Customer, Congratulations on your recent purchase of a new PROLINE range hood! To use your hood to its maximum potential, familiarize yourself with the controls and features of your new hood. This manual will step you through the installation of your hood, and how to maintain it. Read and use this care manual thoroughly, beginning with ...
-
Proline PLFW108 - page 3
T abl e of C ont ent s 1 Saftey Notice 1 2 Diagrams 2-7 Wall Hood . . . . . . . . . . . . . . . . 2 Control Panel . . . . . . . . . . . . . . . 3 Filters . . . . . . . . . . . . . . . . 4-5 Venting . . . . . . . . . . . . . . . . 6-7 3 Installation 8-11 Preparation . . . . . . . . . . . . . . 8 Wall Hood . . . . . . . . . . . . . . 9-11 4 Care & ...
-
Proline PLFW108 - page 4
Installer: Leave this guide with the homeowner. Consumer: Keep this guide for future reference. The Important Safety Notice and warnings in this manual are not meant to cover all possible problems and situations that can occur. Use common sense and caution when installing, maintaining or operating this or any other appliance. Always contact the PRO ...
-
Proline PLFW108 - page 5
w arning ♦ If you receive a damaged product, immediately contact PROLINE Customer Support. Do not install or use a damaged hood. ♦ Do not install, repair or replace any part of the range hood unless specifically recommend- ed in the literature accompanying it. ♦ Use the range hood only for its intended purpose as outlined in this manual. DO N ...
-
Proline PLFW108 - page 6
2 | PROLINE RANGE HOODS W a l l Hood A - HOOD directs heat and smoke into the hood’s internal blower system. The blower forces heat and smoke from cooking into the chimney. B - CHIMNEY vents air from cooking to the outside of the home. C - CONTROL PANEL - controls the hood’s various features. D - FILTER(S) - Stainless steel baffle filters preve ...
-
Proline PLFW108 - page 7
USER MANU AL | 3 C on tr ol P a nel Lights: 2 levels, high and low. Tap button to turn on or off. Tap again to go between high and low light levels. Speeds: 4 speeds. Press the button of your desired fan speed. The lowest speed is the most quiet. The highest speed is the most powerful. Power: Press the power button once to turn on, press twice to t ...
-
Proline PLFW108 - page 8
4 | PROLINE RANGE HOODS gre a se fil t ers baffle fi l ter The baffle filter is equipped with a spring loaded handle. To remove from the hood, pull back toward the wall and down. The baffle filter can also be opened for easy cleaning. To open unscrew the cylin- drical handle and separate the layers to clean.. ...
-
Proline PLFW108 - page 9
USER MANU AL | 5 1. Remove the stainless steel or aluminum filters from the bottom of the hood. 2. Locate the existing raised support screws (A) on each side of the internal motor(s). 3. For each motor side, position charcoal filter over its support screw and rotate to lock into place. charc o al f il ter We recommend venting your hood directly out ...
-
Proline PLFW108 - page 10
6 | PROLINE RANGE HOODS ven ting op tions horiz ont al w al l venting Option 1 Option 2 ver tic al r oof vent ing ...
-
Proline PLFW108 - page 11
USER MANU AL | 7 height & ven ting re quirement s ♦ allow 28-36” between the top of your cooking surface and the bottom of hood ♦ vent vertically through the roof if possible ♦ vent through a side wall if you can- not vent directly above your range hood ♦ use 6” or 8” round (or 3-1/4 x 10” rectangular) metal ducting ♦ use as f ...
-
Proline PLFW108 - page 12
8 | PROLINE RANGE HOODS prep ar a t ion inspe c t range hood 1. Check contents of box: ♦ range hood ♦ wall or ceiling mounting bracket ♦ small bag of hardware ♦ chimney (only on certain models) ♦ support brackets (only on certain models) ♦ transition duct (only on certain models) 2. Test ♦ plug in and test controls, lights, fan ♦ in ...
-
Proline PLFW108 - page 13
USER MANU AL | 9 Plan where the ductwork will be located. Install proper-sized duct work, and roof or wall cap, depending on where you will be venting your hood. Recommended and most com- mon installations are shown in the venting diagrams above. Adjust your measurements to accomodate heights of ceilings, cabinets, or rangetops. w al l hood ins t a ...
-
Proline PLFW108 - page 14
10 | PROLINE RANGE HOODS s tep 3 w al l hood ins t al l a tion Hang hood and connect s tep 2 Install ceiling bracket ♦ Place the chimney bracket against the ceiling ♦ Find the center point of the bracket and mark it ♦ Line the bracket center point with the center point on the wall ♦ Mark the locations of bracket holes on wall ♦ Drill hole ...
-
Proline PLFW108 - page 15
USER MANU AL | 11 w al l hood ins t al l a tion s tep 5 Install grease filter s tep 4 Install chimney ♦ Take off protective laminate coating ♦ Place the chimney on top of range hood base ♦ Make sure the chimney is facing the correct direction (the vertical vent should be on the top) ♦ Secure the lower portion of the chimney to the base of t ...
-
Proline PLFW108 - page 16
12 | PROLINE RANGE HOODS C a re & C le aning w arning ♦ Never put your hand into the area housing the fan while the fan is operating ♦ Turn off power to the hood before cleaning ♦ Make sure your cooktop and hood are cool before cleaning ♦ Use only the types of cleaning solutions mentioned in this manual ♦ Completely dry the filter(s) ...
-
Proline PLFW108 - page 17
USER MANU AL | 13 13 | PROLINE RANGE HOODS replacing t he ligh t bulb ♦ Make sure the range hood is unplugged or turn OFF breaker ♦ Place a flat-head screwdriver between light cover and housing to remove cover ♦ Gently pull defective bulb straight out and discard ♦ Wear a cotton glove or use a cloth to handle the replacement bulb (DO NOT ha ...
-
Proline PLFW108 - page 18
14 | t roubl e shoo t ing NOTHING WORKS (Control Panel not lit, Blower not working) Solution 1: Turn on power at circuit breaker panel or fuse box. Check for tripped breaker or blown fuse. Solution 2: Make sure hood main power switch is on. LIGHTS NOT TURNING ON Solution 1: see “nothing works” Solution 2: Swap out lights to determine if bulbs a ...
-
Proline PLFW108 - page 19
USER MANU AL | 15 W arran t y All PROLINE range hoods come with a Two Year Warranty on Parts, and a One Year Warranty on Labor. Who is Covered: Only the original purchaser for residential products purchased in the continental United States (limited warranty in Canada, Hawaii, and Alaska). Two Year Warranty - Parts & Labor For two years from the ...
-
Proline PLFW108 - page 20
16 | PROLINE RANGE HOODS Ret urns 1. You must report damage directly to PROLINE within 7 days to receive a full refund. 2. Send a photo showing the damage. We need this before we can approve your damage claim. 3. Once your claim is approved, we will arrange for a damage pickup. 4. A new replacement hood will be sent to you after the damaged hood ha ...
-
Proline PLFW108 - page 21
return claims no t a c cepted if : ♦ Hood has been installed ♦ Hood has been custom cut or otherwise altered ♦ Damage is reported after 7 days ♦ Original packaging or parts are missing exch ange s 1. You must request an exchange directly to PROLINE within 14 days. 2. Notify us of your reason for the exchange. Provide a photo if your hood is ...
-
Proline PLFW108 - page 22
PRO LINE R ange Hoods 1750 S 500 W Salt Lake City, UT 84115 • 1-877-901-5530 • www.prolinerangehoods.com ...
Do you have a question concerning Proline PLFW108?
Use the form below
If you did not solve your problem by using a manual Proline PLFW108, ask a question using the form below. If a user had a similar problem with Proline PLFW108 it is likely that he will want to share the way to solve it.