English dropdown-ico

Manual Sears 200.71232

16 pages 0.26 mb
Download

Go to site of 16

Summary
  • Sears 200.71232 - page 1

    Sears, Roebuck and Co., Hoffman Est ates, IL 60179 U.S.A. B A TTER Y CHARGER 60/20/2 Amp Fully A utomatic 275/125 AMP ENGINE ST AR TER With Batter y T ester Model No. 200.71232 O WNER’S MANU AL 00-99-000314/0103 CA UTION: Read all Safety Rules and Operating Instructions, and follow them with each use of this product. ® ...

  • Sears 200.71232 - page 2

    ...

  • Sears 200.71232 - page 3

    1 W arranty .................................................................... 1 Important Saf ety Instructions ................................. 2 P arts .......................................................................... 3 Before Using Y our Battery Charger ........................ 4 Assembling y our charger ............................. ...

  • Sears 200.71232 - page 4

    2 Help us help you Remember: • Place charger as far away from battery being charged as the charger cables will permit. • Do not expose charger to rain or snow. • Never charge a frozen battery. If battery fluid (electrolyte) becomes frozen, bring battery into a warm area to thaw before you begin charging. • Never allow battery acid to drip o ...

  • Sears 200.71232 - page 5

    3 Pa r t s This section shows an illustration of your battery charger. Use it to become familiar with where all the parts are located, and what they look like. Replacement Parts List DieHard 71232 Item Description Part Number 1. Plastic Top 3799001210 2. Hub Cap 5200000008 3. Wheel 0099000120 4. Axle 0099000060 5. Power Cord 90026133 6. Negative (B ...

  • Sears 200.71232 - page 6

    4 To attach the axle assembly: 1. Remove charger from packing materials and place upside down on a flat surface. Attach mounting foot and secure with the two 1/4-20 thread cutting screws. 2. Hold axle upright on floor or work surface. Then, using a hammer, tap one of the plastic hubs onto the top end of the axle. Be sure to tap the hub on straight. ...

  • Sears 200.71232 - page 7

    5 3. Tap the other axle cap onto the opposite end of the axle and place the axle assembly onto the bottom of the charger. Place one end of the bracket into slot, then place the axle assembly under each bracket. Fasten the other side of the brackets using the two 10-32 screws provided. To attach the handle: Turn the charger right side up onto its fo ...

  • Sears 200.71232 - page 8

    6 A TEMPORARY adapter may be used to connect the charger to a two-pole outlet if a properly grounded outlet is not available. Use the adapter ONLY until a properly grounded outlet can be installed by a qualified electrician. MINIMUM RECOMMENDED EXTENSION CORD Length of Cord, in Feet 25 50 100 150 AWG* Size of Cord 16 12 10 8 *AWG=American Wire Gaug ...

  • Sears 200.71232 - page 9

    7 For best results from your battery charger, learn to use it properly. This section tells how to set the controls, charge a battery in or out of the vehicle, use the ENGINE START feature and test the battery. Using Y our Battery Charger All the controls for your charger are located on the front of the unit. Follow these instructions to obtain the ...

  • Sears 200.71232 - page 10

    8 • TIME: To select a charging time, you must be in the MANUAL mode and have selected a charge rate. Touch the TIME pad until the desired time shows on the meter. The following chart shows the amount of time available for each charge rate and the amount of time, in hours, added for each touch of the TIME pad. RATE 2 Amps 20 Amps 60 Amps Maximum 1 ...

  • Sears 200.71232 - page 11

    9 Charging Y our Battery Charging your battery in the vehicle: 1. Arrange the power cord and charging leads carefully in order to avoid damage that could be caused by the hood, door, or moving engine parts. 2. Keep clear of the fan blades, belts, pulleys, and other parts that can cause injury. 3. Check the polarity of the battery posts using the id ...

  • Sears 200.71232 - page 12

    10 8. For automatic charging, touch AUTO then a charge-rate pad 2, 20, or 60 Amps. The charging will stop when the battery is fully charged. 9. For manual charging, touch a charge rate pad then select a charge time up to 18 hours. If more than 135 minutes of charging time is needed, reset the time when the original time runs out. Refer to the Time ...

  • Sears 200.71232 - page 13

    11 Calculating charge times • Marine, or deep-cycle batteries are usually rated in Reserve Capacity (RC) . • NR means that the charger setting is NOT RECOM- MENDED . Find your battery’s rating on the chart below and note the charge time given for each charger setting. The times given are for batteries with a 50-percent charge prior to recharg ...

  • Sears 200.71232 - page 14

    12 A minimal amount of care can keep your battery charger working properly for years. 1. Clean the clamps each time you are finished charging. Wipe off any battery fluid that may have come in contact with the clamps to prevent corrosion. 2. Coil the input and output cords neatly when storing the charger. The cords can be wrapped around the handle o ...

  • Sears 200.71232 - page 15

    13 T roubleshooting Performance problems often result from little things that you can fix yourself. Please read through this table for a possible solution if a problem occurs. PROBLEM POSSIBLE CAUSE SOLUTION/REASONS No reading on the Clamps are not making a Check for poor connections at battery and frame. Make ammeter . good connection. sure connec ...

  • Sears 200.71232 - page 16

    For information about troubleshooting, call toll-free from anywhere in the U.S.A. 7 am to 4:30 pm CT Monday through Friday. 1-800-SEARS-64 (1-800-732-7764). For repair parts or the location of a Sears Parts and Repair Center call: 1-800-4-MY-HOME ® (1-800-469-4663). ...

Manufacturer Sears Category Battery Charger

Documents that we receive from a manufacturer of a Sears 200.71232 can be divided into several groups. They are, among others:
- Sears technical drawings
- 200.71232 manuals
- Sears product data sheets
- information booklets
- or energy labels Sears 200.71232
All of them are important, but the most important information from the point of view of use of the device are in the user manual Sears 200.71232.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Sears 200.71232, service manual, brief instructions and user manuals Sears 200.71232. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Sears 200.71232.

Similar manuals

A complete manual for the device Sears 200.71232, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Sears 200.71232 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Sears 200.71232.

A complete Sears manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Sears 200.71232 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Sears 200.71232, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Sears 200.71232, that we can find in the current document
3. Tips how to use the basic functions of the device Sears 200.71232 - which should help us in our first steps of using Sears 200.71232
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Sears 200.71232
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Sears 200.71232 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Sears 200.71232?

Use the form below

If you did not solve your problem by using a manual Sears 200.71232, ask a question using the form below. If a user had a similar problem with Sears 200.71232 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)