Manual Stovax 8050

20 pages 0.4 mb
Download

Go to site of 20

Summary
  • Stovax 8050 - page 1

    Brunel Mk III Conventional Flue With upgradeable control valve Instructions for Use, Installation and Servicing For use in GB, IE (Great Britain and Eire) PR0595 Issue 4 (August 2008) IMPOR T ANT Do not attempt to burn rubbish in this fire. This stove must only be operated with the door secured firmly in position. The outer casing of this stove wil ...

  • Stovax 8050 - page 2

    2 CONTENTS COVERING THE FOLLOWING MODELS BRUNEL - 8050 - P8050 PAGE APPLIANCE COMMISIONING CHECKLIST 3 USER INSTRUCTIONS 4 INSTALLATION INSTRUCTIONS 8 Technical Specifications 8 Site Requirements 9 Installation 10 Commissioning 13 SERVICING INSTRUCTIONS 14 Servicing Requirements 14 Fault Finding 14 How to replace parts 15 Basic spare parts list 18 ...

  • Stovax 8050 - page 3

    3 FLUE CHECK PASS FAIL 1. Flue is correct for appliance 2. Flue flow test 3. Spillage test GAS CHECK 1. Gas soundness & let by test 2. Standing pressure test mb 3. Appliance working pressure (on High Setting) mb NB All other gas appliances must be operating on full 4. Gas rate m 3 /h 5. Does ventilation meet appliance requirements 6. Have contr ...

  • Stovax 8050 - page 4

    4 USER INSTRUCTIONS 2.3 • Holdin for 5to 10seconds and thenrelease The pilot remains lit. If the pilot does not light, repeat the procedure. 2 AR0396 2.4 If the pilot still does not light after repeated attempts:  • Contactthe retaileror installerfrom whomthe appliance was pur ...

  • Stovax 8050 - page 5

    5 4.2 • Holdin the controlknob androtate anti-clockwise until the knob is pointing at the ignition symbol ( ★ )  • Applya lightedmatch tothe pilothood, Diagram 3 3 AR0897 4.3 When the pilot is lit:  • Extinguishthe matchand continueto holdin the? ...

  • Stovax 8050 - page 6

    6 USER INSTRUCTIONS AR0900 6 6.4 • Placethree coals equallyspaced onthe rear ofthe fuel bed so they touch the rear panel, Diagram 7 AR0901 7 6.5 • Placefive coals onthe frontof the fuelbed sothey rest on the front coal effect and lean against the vertical finger ...

  • Stovax 8050 - page 7

    7 USER INSTRUCTIONS 9. 'RUNNING IN' 9.1 The surface coating on your GAZCO stove will ‘burn off’ during the first 24 hours of operation on high, producing a harmless and temporary odour. If the odour persists ask your retail for advice. 10. SERVICING 10.1 A qualified gas engineer must service the stove every 12 months. In all correspon ...

  • Stovax 8050 - page 8

    8 INSTALLATION INSTRUCTIONS TECHNICAL SPECIFICATION Covering the following models Brunel - 8050 - P8050 Model Gas Cat. Gas Type Pressure Nox Class Aeration Injector Gas Rate m 3 / h Input kW (Gros) Country Hoog Laag Brunel 8050 I 2H Natural Gas (G20) 20mbar 5 4 x 16 120 0.43 4.5 2.25 GB, IE Brunel P8050 I 3+ Butane (G30) 29 mbar 5 16 x 23 (2) 260 0 ...

  • Stovax 8050 - page 9

    9 INSTALLATION INSTRUCTIONS SITE REQUIREMENTS 1. FLUE AND CHIMNEY REQUIREMENTS 1.1 The chimney or flue system must comply with the rules in force, and must be a minimum of 127mm (5”) in diameter. The following are suitable for use with this appliance. A) 230mm x 230mm (9” x 9”) conventional brick or stone built chimney. B) A precast flue syst ...

  • Stovax 8050 - page 10

    10 2.3 Having run the gas supply to the stove, PURGE THE SUPPLY PIPE, this is essential to expel any debris that may block the gas controls.  • Connectthe gassupply tothe 8mm-compressionelbow at the RH rear corner of the stove, Diagram 3. AR0396 3 2.4 • Checkthe pull ofthe fluesystem by? ...

  • Stovax 8050 - page 11

    11 AR0886 4 2.7 • Placethe closure plateagainst thefireplace opening • • Ensurethere is sufficientoverlap aroundthe perimeter to allow a fume tight seal to be made  • Cutstraight acrossthe topof theplate if trimmingis required 2.8 • ...

  • Stovax 8050 - page 12

    12 3.5 • Placefive coals onthe frontof the fuelbed sothey rest on the front coal effect and lean against the vertical fingers, Diagram 9 AR0902 9 3.6 • Placethe remaining fourcoals betweenthe two rowsof coals  • Rotatethe coalsto ensurethey? ...

  • Stovax 8050 - page 13

    13 INSTALLATION INSTRUCTIONS COMMISSIONING 1. COMMISSIONING 1.1 • Closeall openable doorsand windowsin the room  • Ignitethe stoveand operateon maximum for10 minutes AR0539 1 If there is any doubt, run the stove for a further 10 minutes, and repeat the test. 1.2 If there are any ...

  • Stovax 8050 - page 14

    14 IGNITION FUNCTIONAL CHECK 1 PILOT WILL NOT LIGHT Ensure there is no debris around the pilot assembly, (e.g. soot, etc.) which could short the spark, clean the area. Operate the valve. Is there a spark? Consult Section 2 and retry. Check alignment of pilot burner head, change the ignition lead, see diagram 1 on page 17. Check isolation tap and ga ...

  • Stovax 8050 - page 15

    15 SERVICING INSTRUCTIONS FAULT FINDING CHARTS PILOT WILL NOT STAY LIT OR FIRE GOES OUT IN USE Ensure there is no debris around the pilot assembly, e.g. coal, soot etc. which could short the spark, clean the area. Problem is with the pipework or fittings which lead to the fire. Correct and retry. Is thermocouple connection good in back of valve? Re ...

  • Stovax 8050 - page 16

    16 3. IGNITION LEAD AND PIEZO Due to the method of manufacture, these components can only be replaced as an integral unit. 3.1 • Turnthe gas supplyoff atthe isolation device  • Pullthe controlknob offthe gasvalve spindle toreveal the piezo securing screw access holes Using ...

  • Stovax 8050 - page 17

    17 AR0320 3  • Prisethe smallretaining ringout ofthe inlet andremove the filter 4.2 • Replacewith a newfilter andpush into positionensuring that it sits on the shoulder  • Replacethe retainingring andpush intoposition. 4.3 • Replace? ...

  • Stovax 8050 - page 18

    18 8. PRIMARY AERATION PLATE 8.1 • Turnthe gas supplyoff atthe isolation device. 8.2 To open the doors:  • Slackenthe domednut onthe upperdoor and loosen the bolt from behind the latch 8.3 • Removethe two screwssecuring thepilot unit andundo ...

  • Stovax 8050 - page 19

    19 SERVICE RECORDS 1ST SERVICE 2ND SERVICE Date of Service: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Date of Service: ................................. Next Service due: ............................... N e x t S e r v i c e d u e : ............................... Signed: ....................................... S i g n e d : . ...

  • Stovax 8050 - page 20

    Gazco Limited, Osprey Road, Sowton Industrial Estate, Exeter, Devon, England EX2 7JG Tel: (01392) 261999 Fax: (01392) 444148 E-mail: info@gazco.com A member of the Stovax Group ...

Manufacturer Stovax Category Indoor Fireplace

Documents that we receive from a manufacturer of a Stovax 8050 can be divided into several groups. They are, among others:
- Stovax technical drawings
- 8050 manuals
- Stovax product data sheets
- information booklets
- or energy labels Stovax 8050
All of them are important, but the most important information from the point of view of use of the device are in the user manual Stovax 8050.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Stovax 8050, service manual, brief instructions and user manuals Stovax 8050. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Stovax 8050.

A complete manual for the device Stovax 8050, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Stovax 8050 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Stovax 8050.

A complete Stovax manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Stovax 8050 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Stovax 8050, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Stovax 8050, that we can find in the current document
3. Tips how to use the basic functions of the device Stovax 8050 - which should help us in our first steps of using Stovax 8050
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Stovax 8050
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Stovax 8050 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Stovax 8050?

Use the form below

If you did not solve your problem by using a manual Stovax 8050, ask a question using the form below. If a user had a similar problem with Stovax 8050 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)