English dropdown-ico

Manual Telex USR-100

26 pages 0.38 mb
Download

Go to site of 26

Summary
  • Telex USR-100 - page 1

    T elex Operating Instructions USR-100 ...

  • Telex USR-100 - page 2

    Table of Contents General . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 USR-100 Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Frequency Agility . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Channel Lockout . . . . . . . . . . . . . . . . . . . . ...

  • Telex USR-100 - page 3

    Table of Contents (continued) SH-100 Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 Power Switch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 Battery Test Button . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 Battery Meter . . . . . . . . . . . . . . . . . . . . ...

  • Telex USR-100 - page 4

    GENERAL INFORM ATION The Telex Model USR-100 Receiver and associated Transmitters is a 100 Channel, frequency-selectable full diversity system operating within the frequency range of 668.0 to 746.0 MHz on specific pre-set frequen - cies. Systems consisting of the USR-100 and its companion transmitter are capable of operating on at least 5 frequenci ...

  • Telex USR-100 - page 5

    Posi Phase Diversity The USR-100 receiver utilizes Telex’s patented Posi Phase auto diversity circuit. Unlike other types of diversity which receive with only one antenna at a time, Posi Phase utilizes both antennas at all times. This results in a stronger signal from the microphone for cleaner audio and greater range. If the microphone signal be ...

  • Telex USR-100 - page 6

    Displays The 7 Segment LED channel display already mentioned (00 to 99). 2. A 5 segment LED light array for AF, that aids in setting micro - phone gains and monitoring receiver microphone and line level outputs. Light numbers 4 and 5 have a Peak Hold feature. 3. A 5 segment LED light array for R F , that aids in checking the transmitter and monitor ...

  • Telex USR-100 - page 7

    USR-100 Receiver Specifications RF Frequency Range . . . . . . . . . . . . . . . 668.0 to 746.0 MHz Channels . . . . . . 100 (0-99) (within TV Ch. 47/48 & 58/59) R.F. Stability . . . . . . . . . . . . . . . . . . . . . . . . 0.005% or better Modulation Type . . . . . . . . . . . . . . . . . FM, 40 KHz nominal Type . . . . . . . . . . . . . . . ...

  • Telex USR-100 - page 8

    Model SH-100 Transmitter Specifications Frequency of operation . . . . . . . . . 668.000 to 746.000 MHz. (Current models operate in 2 frequency ranges.) 668.000 to 679.500 MHz and 734.100 to 745.500 MHz. Number of Channels . . . . . . . . 100 User Selectable Channels in each range. Power Output (Terminated) . . . 10 mW, High switch setting, 1.0 mW ...

  • Telex USR-100 - page 9

    Model LT-100 Transmitter Specifications Frequency of operation . . . . . . . . . 668.000 to 746.000 MHz. (Current models operate in 2 frequency ranges.) 668.000 to 679.500 MHz and 734.100 to 745.500 MHz. Number of Channels . . . . . . . . . . . . . . . . 100 User Selectable Channels in each range. Power Output (Terminated) . . . . 10 m W, High swit ...

  • Telex USR-100 - page 10

    Figure 1 Front Panel Power Switch: When turned on, the channel display illuminates and one of the diversity lights will come on. Channel Select Buttons: Push once to increase display by one. Push and hold to increase display more than one. Left button changes “10’s”, Right button changes “1’s”. Channel Lockout: To enable/disable Channel ...

  • Telex USR-100 - page 11

    Figure 2 Rear Panel Antenna Jacks: Two antenna jacks for posi phase diversity recep - tion. Attach an antenna to each jack. Audio Output: XLR type jack connects to audio sound system (Amplifier/Mixer). Pin 1 ground, Pin 2 +, Pin 3 -. Audio Adjust: Screwdriver adjustable potentiometer, controls audio output. Use supplied screwdriver to adjust to des ...

  • Telex USR-100 - page 12

    Receiver Set-up Connect the supplied AC power adapter to an AC outlet supplying 105 to 125 volts AC, 60 Hz. The 230 volt export model should connect to an AC outlet supplying 210-240 VAC, 50-60 Hz. Connect the USR-100 to your equipment: Insert a 3 pin female “XLR” audio connector and cable into the Audio Output receptacle on the rear of the USR ...

  • Telex USR-100 - page 13

    Figure 4 SH-100 Bottom View -10- ...

  • Telex USR-100 - page 14

    SH-100 Power Switch: Located on the bottom of the handle. Battery Test Button: Press to check the remaining life of the batteries. Battery Meter: The number of segments that light when the Battery Test Button is pushed indicate the approximate time of battery life remaining. Channel Select Switches: Control the transmit channel. Must be set to matc ...

  • Telex USR-100 - page 15

    Figure 5 LT-100 LT-100 Power Switch: Located on the top of the case. Battery Test Button: Press to check the remaining life of the batteries. Battery Meter: The number of segments that light when the Battery Test Button is pushed indicate the approximate time of battery life remaining. Microphone Connector: wired as follows: Top View Back View Pin ...

  • Telex USR-100 - page 16

    Channel Select Switches: Control the transmit channel. Must be set to match the channel of the receiver. Microphone Gain: Controls the gain of the audio circuit to prevent under or over modulation. Transmit Power Switch: Set to high for maximum range. Set to low to prolong battery life. Set-Up NOTE: Do not use carbon-zinc batteries. Ni-Cad batterie ...

  • Telex USR-100 - page 17

    System Set-Up NOTE: Whe employing two or more wireless microphones, the transmitters should be a minimum of 10-15 feet away from the receiver(s) to prevent “front-end” overload. Turn on the receiver. Set the Channel to the number desired on both the transmitter and receiver. Check the RF lights. If any light except light #1 is on, this indicate ...

  • Telex USR-100 - page 18

    Remote mounting antennas will increase the effective reception range when appropriately positioned. The two 1/4 wave antennas supplied are not ground independent and therefore not appropriate for remote mounting. See the accessories section of this manual for remote- mountable antenna options. The diversity antenna system operates most efficiently ...

  • Telex USR-100 - page 19

    Figure 7 Antenna Placement with Accessory Brackets and Cables If possible, do not mount the brackets on a wall. See Figure 7 for bracket and antenna placement. Antenna Connection Attach the two antenna cables to the back of the USR-100. Be sure the connectors are tightened securely. Route the cable to the antennas and attach in the same manner. -16 ...

  • Telex USR-100 - page 20

    Installing Rack Mounts The USR-100 is supplied with rack mounts for both double and single mounting in a 19" equipment rack. For single mounting, the long and short rack “ears” are used. For dual mounting, use the short “ears and the mid brackets from two USR-100’s. Figure 8 Assembly of Rack Mount Assembly To assemble the rack mount to ...

  • Telex USR-100 - page 21

    Double Mounting: Align the mid brackets (Item No. 2) with the holes on the adjacent sides of each unit. Install the previously removed screws. Insert an additional screw (Item No. 4 provided in the parts pack) into the remaining holes. Tighten all screws securely. Place the two assemblies side by side with the mid brackets together. (The left brack ...

  • Telex USR-100 - page 22

    ACCESSORIES AND REPLACEMENT PARTS Model AB-2 Combination Antenna Bracket with hardware and 10 foot (3 meter) coaxial cable TNC Connectors. Use with Model CAL-X Antennas. Order No. 71138000 AC Power Supply 120 V olt, 60 Hz Order No. 730131 1/4 Wave Replacement Antenna Part No. 879010 Model CLA-X - 1/2 Wave Antenna - for remote mounting Model Part No ...

  • Telex USR-100 - page 23

    Model ALP-450 450-900 MHz Directional Log Periodic Antenna includes mounting hardware and 10 foot (3 meter) coaxial cable with TNC Connectors. 9 1/2" long x 11" high. Unique forward coverage pattern increases signal gain up to 5 db. Covers all frequencies and increases range. Order No. 71147000 Model UAD-2 Four Way Antenna Splitter Order ...

  • Telex USR-100 - page 24

    FCC INFORM ATION The TELEX Model USR-100 receiver is authorized under Part 15 of the Federal Communication Commission. Licensing of TELEX equip - ment is the user’s responsibility and licensability depends upon the user’s classification, and frequency selected. TELEX strongly urges the user to contact the appropriate telecommunications authorit ...

  • Telex USR-100 - page 25

    CUSTOMER SERVICE INFORMATION If your receiver or transmitter should need servicing under the warranty, please contact: Customer Service Department TELEX COMMUNIC ATIONS, INC. 8601 East Cornhusker Highway, P.O. Box 5579, Lincoln, Nebraska 68505-5579 U.S.A. Phone: (402) 467-5321 or 465-7021 FAX: (402) 467-3279 All claims of defect or shortage should ...

  • Telex USR-100 - page 26

    TELEX COMMUNICATIONS, INC. 8601 East Cor nhusker Highway w P.O. Box 5579 w Lincoln, Nebraska 68505-5579 PN 801585-1 JUNE 1998 ...

Manufacturer Telex Category Microphone

Documents that we receive from a manufacturer of a Telex USR-100 can be divided into several groups. They are, among others:
- Telex technical drawings
- USR-100 manuals
- Telex product data sheets
- information booklets
- or energy labels Telex USR-100
All of them are important, but the most important information from the point of view of use of the device are in the user manual Telex USR-100.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Telex USR-100, service manual, brief instructions and user manuals Telex USR-100. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Telex USR-100.

Similar manuals

A complete manual for the device Telex USR-100, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Telex USR-100 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Telex USR-100.

A complete Telex manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Telex USR-100 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Telex USR-100, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Telex USR-100, that we can find in the current document
3. Tips how to use the basic functions of the device Telex USR-100 - which should help us in our first steps of using Telex USR-100
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Telex USR-100
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Telex USR-100 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Telex USR-100?

Use the form below

If you did not solve your problem by using a manual Telex USR-100, ask a question using the form below. If a user had a similar problem with Telex USR-100 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)