English dropdown-ico

Manual Hobart HR7E

24 pages 1.14 mb
Download

Go to site of 24

Summary
  • Hobart HR7E - page 1

    HR7E ROTARY OVEN N S T R U C T I O N S I 701 S. RIDGE A VENUE TROY , OHIO 45374-0001 937 332-3000 www .hobartcorp.com FORM 35508 Rev. C (May 2005) MODEL HR7E ROT AR Y OVEN MODEL HR7E STAINLESS STEEL INTERIOR, GLASS BACK ML-132092 STAINLESS STEEL INTERIOR, SOLID BACK ML-132095 COATED INTERIOR, GLASS BACK ML-132093 COATED INTERIOR, SOLID BACK ML-1320 ...

  • Hobart HR7E - page 2

    – 2 – © HOBART 2005 T ABLE OF CONTENT GENERAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Location . . . . . . . . . . . . . . . . . ...

  • Hobart HR7E - page 3

    – 3 – Installation, Operation and Care of MODEL HR7E ROT AR Y OVENS SA VE THIS MANUAL FOR FUTURE REFERENCE GENERAL The model HR7E Oven is a seven-spit rotary oven that features a full view tempered glass door and quartz lighting that promote visual appeal and stimulate customer interest. The solid back model is used when the oven is positioned ...

  • Hobart HR7E - page 4

    – 4 – PLACING THE ROTOR IN THE OVEN The rotor must properly engage with the drive mechanism. Orient the rotor so that the end plate with square drive slots is on the same side of the oven as the drive arm. STEP 1: Stop the drive arm so it is in the down position (Fig. 1). Fig. 1 Fig. 2 Fig. 3 Fig. 4 Fig. 6 Fig. 5 MOTOR DRIVE PINS THROUGH DRIVE ...

  • Hobart HR7E - page 5

    – 5 – ELECTRICAL CONNECTIONS WARNING : ELECTRICAL AND GROUNDING CONNECTIONS MUST COMPLY WITH THE APPLICABLE PORTIONS OF THE NATIONAL ELECTRICAL CODE AND / OR OTHER LOCAL ELECTRICAL CODES. WARNING : DISCONNECT ELECTRICAL POWER TO THE MACHINE AND FOLLOW LOCKOUT / TAGOUT PROCEDURES. Single Oven Access the electrical connection point by removing th ...

  • Hobart HR7E - page 6

    – 6 – OPERA TION WARNING : HOT GLASS, GREASE AND PARTS CAN CAUSE BURNS. USE CARE WHEN OPERATING AND SERVICING THE OVEN. CONTROLS (Fig. 7) MAIN POWER SWITCH — Turns oven and controls on or off. PROGRAM — Enters program mode to modify a cook program; press P for 3 seconds. CLOCK — Sets the clock for time of day. PROBE — Displays temperatu ...

  • Hobart HR7E - page 7

    – 7 – INITIAL STARTUP Power On Toggle the Main Power switch on the front panel of the oven to the ON position; the red indicator light on the switch comes on (Fig. 5). Idle Mode When the oven is first turned on, the display shows the time of day and the last operated program number. Any programmed steps for the selected program are indicated by ...

  • Hobart HR7E - page 8

    – 8 – SAVING OR VERIFYING A COOK PROGRAM (PROGRAM 1 – 9) Begin from Idle Mode. Program display shows last operated program (0 – 9). • Select a program (1 – 9). Program 0 is Manual Mode and cannot be saved into memory. • Press P for 3 seconds to enter programming mode. The program display shows the program/number being modified or veri ...

  • Hobart HR7E - page 9

    – 9 – Cooking 'Step 3' LED is lit. Time display blinks. • Enter the desired cook time from 0:01 (1 minute) to 6:00 (6 hours). • Press ENTER to accept (or, press CLEAR to void and reenter). An invalid entry produces a double beep. Entering 0:00 for the time turns step 3 off and skips to step 4. Temperature display blinks. • Enter ...

  • Hobart HR7E - page 10

    – 10 – PROGRAMMED COOKING (Program 1 – 9) Begin from Idle Mode. The Program display shows the last operated program (0 – 9). • Select a saved cook program (1 – 9). Any programmed steps for the selected program are indicated by lit step LEDs. • Press START to run a preprogrammed cook cycle. While running a cooking program . . . The con ...

  • Hobart HR7E - page 11

    – 11 – MANUAL COOKING (Program 0) Begin from Idle Mode. The Program display shows the last operated program (0 – 9). • Select manual mode by selecting program 0: [0, ENTER]. Cook Step 1 LED is lit. Time display blinks. • Enter the desired cook time from 0:01 (1 minute) to 6:00 (6 hours). • Press ENTER to accept (or, press CLEAR to void ...

  • Hobart HR7E - page 12

    – 12 – HOLDING CYCLE (SILENCING THE 'END OF CYCLE' ALARM) After a cook cycle has been completed, the beeper sounds and the oven automatically executes the Hold cycle (Step 4 of the cooking program). The Hold cycle will not execute if it was programmed 'off', using Hold Temp = 000. • Press to silence the beeper. • Program ...

  • Hobart HR7E - page 13

    – 13 – ADDING COOK TIME • Press ADD 5 MIN during a cooking cycle to add 5 minutes of cook time to the current step of the program in process. Press during the end of cycle buzzer or during Hold cycle to add 5 minutes of cook time to the last step of the last operated program. Press multiple times to add as much as desired up to a maximum tota ...

  • Hobart HR7E - page 14

    – 14 – SUGGESTED ROASTING GUIDELINES The suggested cooking times and temperatures in the table may require adjustment for proper doneness depending on initial product temperature, weight, size, shape and other factors. Oven Cook Time Final Internal Capacity Product Temperature Setting HH:MM Temperature HR7E Chicken, Whole, 350 – 375 ° F 1:10 ...

  • Hobart HR7E - page 15

    – 15 – STEP 1 STEP 2 STEP 3 STEP 4 TEMPERATURE TIME STEP 1 STEP 2 STEP 3 STEP 4 TEMPERATURE TIME STEP 1 STEP 2 STEP 3 STEP 4 TEMPERATURE TIME STEP 1 STEP 2 STEP 3 STEP 4 TEMPERATURE TIME STEP 1 STEP 2 STEP 3 STEP 4 TEMPERATURE TIME STEP 1 STEP 2 STEP 3 STEP 4 TEMPERATURE TIME STEP 1 STEP 2 STEP 3 STEP 4 TEMPERATURE TIME STEP 1 STEP 2 STEP 3 STE ...

  • Hobart HR7E - page 16

    – 16 – Bring chickens from cooler. Check temperature — range should be from 37 ° F to 42 ° F. Insert approved popper, if available; it will pop out when chicken is done.  PREPARING, TYING & SPITTING — CHICKENS ON V-SPITS The rotary oven is not designed to roast frozen foods. Use only fresh or previously thawed product. Using an app ...

  • Hobart HR7E - page 17

    – 17 –  INCORRECT SPITTING — CHICKENS ON V-SPITS WRONG — Angle of spit is in line with breast. This will split the backbone and could possibly result in falling off the spit during cooking. WRONG — Legs and thighs are not on same side as breast. This could cause legs to fall off during cooking. WRONG — Legs are being inserted first. ...

  • Hobart HR7E - page 18

    – 18 – 1 2 Skip 3 4 Skip 5 6 Skip 7 WARNING : SPITS ARE SHARP. USE CARE WHEN LOADING PRODUCT.  SPITTING — CHICKENS ON FORK SPITS Press pointed ends of spits into whole poultry so points go through the chest-wing and leg-thigh regions (Fig. 8). Load four or five chickens on each fork spit. Fig. 8  SPITTING — CHICKENS ON THERMO-WAVE SPI ...

  • Hobart HR7E - page 19

    – 19 –  Loading V-Spits or Thermo-Wave Spits on the Rotor 1. Place pointed end of V-spit into small outside hole on non-drive side of rotor (Fig. 12). 2. Fit notched end of V-spit into appropriate holes on drive side of rotor (Fig. 13). 3. Make sure the spit is level. If the spit is not level, you might be using the wrong holes. NON-DRIVE SI ...

  • Hobart HR7E - page 20

    – 20 – PERSONAL PROTECTIVE EQUIPMENT Chickens and accessories are hot. Use care during unloading by using appropriate personal protective equipment such as 18" insulated gloves, an apron, long sleeved clothing and closed toed shoes. UNLOADING ACCESSORIES FROM OVEN Opening the door does not stop the rotor, heaters or fan. 1. Press STOP to s ...

  • Hobart HR7E - page 21

    – 21 – CLEANING WARNING : DISCONNECT ELECTRICAL POWER TO THE MACHINE AND FOLLOW LOCKOUT / TAGOUT PROCEDURES BEFORE CLEANING OR SERVICING. Proper cleaning prolongs the life and productivity of the oven. The oven should be routinely cleaned throughout the day and thoroughly cleaned at the end of the day. Allow oven to cool before cleaning. CAUTIO ...

  • Hobart HR7E - page 22

    – 22 – CLEANING GUIDELINES FOR NONSTICK COA TED SURF ACES Abrasion and aggressive chemicals reduce the life of the nonstick coating. With proper care, the nonstick coated surface should provide a long life of easy-to-clean service. DO NOT do the following: • DO NOT use abrasive cleaning aids such as steel wool. NOTE: Abrasive pads remove the ...

  • Hobart HR7E - page 23

    – 23 – MONTHLY CLEANING Clean ventilation grate and fan blades located in the top of the oven. 1. Remove ventilation grate by unscrewing nuts on both sides of vents. 2. Unscrew nut (clockwise) in center of fan blade. 3. Wash in a sink with warm soapy water. 4. Rinse thoroughly and dry with a soft dry cloth. 5. Wipe fan blades with a clean damp ...

  • Hobart HR7E - page 24

    – 24 – FORM 35508 Rev. C (May 2005) PRINTED IN U.S.A. MAINTENANCE WARNING : DISCONNECT ELECTRICAL POWER TO THE MACHINE AND FOLLOW LOCKOUT / TAGOUT PROCEDURES BEFORE CLEANING OR SERVICING. WARNING : HOT GLASS, GREASE, AND PARTS CAN CAUSE BURNS. USE CARE WHEN OPERATING AND SERVICING THE OVEN. TROUBLESHOOTING PROBLEM POSSIBLE CAUSE 1. Control does ...

Manufacturer Hobart Category Oven

Documents that we receive from a manufacturer of a Hobart HR7E can be divided into several groups. They are, among others:
- Hobart technical drawings
- HR7E manuals
- Hobart product data sheets
- information booklets
- or energy labels Hobart HR7E
All of them are important, but the most important information from the point of view of use of the device are in the user manual Hobart HR7E.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Hobart HR7E, service manual, brief instructions and user manuals Hobart HR7E. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Hobart HR7E.

Similar manuals

A complete manual for the device Hobart HR7E, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Hobart HR7E by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Hobart HR7E.

A complete Hobart manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Hobart HR7E - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Hobart HR7E, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Hobart HR7E, that we can find in the current document
3. Tips how to use the basic functions of the device Hobart HR7E - which should help us in our first steps of using Hobart HR7E
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Hobart HR7E
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Hobart HR7E in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Hobart HR7E?

Use the form below

If you did not solve your problem by using a manual Hobart HR7E, ask a question using the form below. If a user had a similar problem with Hobart HR7E it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (1)

Miguel Torres Cauich

NESECITO EL MANUEAL DE OPERACION DEL HR7E