English dropdown-ico

Manual Hans Grohe Metris 31100XX1

12 pages 1.81 mb
Download

Go to site of 12

Summary
  • Hans Grohe Metris 31100XX1 - page 1

    Metris 31100XX1 Metris 31101XX1 Installation Instructions / W arranty ...

  • Hans Grohe Metris 31100XX1 - page 2

    2 Metris Electronic Lavator y Faucet with T emperature Control 31100XX1 Metris Electronic Lavator y Faucet 31101XX1 Caution : Do not bend or twist the supply hoses! T echnical Data Max. water pressure 116 psi Recommended pressure 14.5 - 72 psi Max. hot water temp. 158°F* Recommended hot water temp. 120°F - 140°F* Flow rate 1.5 gpm @ 44 psi Autom ...

  • Hans Grohe Metris 31100XX1 - page 3

    3 Installation Flush the hot and cold supplies thoroughly before install- ing this faucet. Place the faucet in the hole on the mounting surface (1). T ighten the mounting nut (2). Install the adapters and filters on the stops (3). Install the supply lines (4). Be careful not to twist the supply lines, or they may become loose from the faucet, causi ...

  • Hans Grohe Metris 31100XX1 - page 4

    4 T ur n the water on to the faucet (1). Peel the protective film from the sensor (2). W ait 15 seconds, the place a hand in front of the sensor (3). The water should turn on automatically . Model 31100 only : Pivot the temperature control lever for ward to make the water cooler (4). Model 31101 only: Set the temperature T ur n the water off at the ...

  • Hans Grohe Metris 31100XX1 - page 5

    5 Cleaning: Block the sensor for 5 seconds (1). This will turn the water off for approximately 90 seconds, so that the sink may be cleaned (2). Faucet Maintenance Replace the battery When the batter y is low , the sensor will flash. Remove the set screw from the back of the faucet (1). Remove the handle screw and handle (model 31100 only) (2). Remo ...

  • Hans Grohe Metris 31100XX1 - page 6

    6 Reset the faucet: Remove the set screw with a 2.5 mm Allen wrench. Block the sensor for 2 seconds. W ait 10 seconds (1), then replace the set screw (2). W ait 15 seconds (3). Place a hand in front of the sensor (4). The water should turn on. ...

  • Hans Grohe Metris 31100XX1 - page 7

    7 Clean the filters and aerator If the flow of water is reduced, the aerator and/or the filters must be cleaned. T o clean the aerator: Block the sensor for 5 seconds to temporarily shut off the water (1). Unscrew and remove the vandal resistant aerator using the enclosed key (2). Flush any debris from the aerator at another faucet. Replace the aer ...

  • Hans Grohe Metris 31100XX1 - page 8

    8 Replacement Parts 1 aerator 98612000 2 solenoid valve 96904000 3 fixation set 97812000 4 connection hose 98809000 5 check valve 96456000 6 electronics 96905000 7 batter y 97399000 Important note : the check valves should be removed and inspected yearly . 1 2 3 4 5 6 7 ...

  • Hans Grohe Metris 31100XX1 - page 9

    9 Cleaning Recommendation for Hansgrohe Pr oducts Modern lavator y faucets, kitchen faucets, and showers consist of ver y different materials to comply with the needs of the market with regard to design and functionality . T o avoid damage and returns, it is necessar y to consider certain criteria when cleaning. Cleaning Materials for Faucets and S ...

  • Hans Grohe Metris 31100XX1 - page 10

    10 Limited Lifetime Consumer W arranty This product has been manufactured and tested to the highest quality standards by Hansgrohe, Inc. (“Hansgrohe”). This warranty is limited to Hansgrohe products which are purchased by a consumer in the United States after March 1, 1996, and installed in either the United States or Canada. WHO IS COVERED BY ...

  • Hans Grohe Metris 31100XX1 - page 11

    11 Some States do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclu- sion may not apply to you. This warranty gives you specific legal rights, and you may have other rights which var y from State to State. Y ou may be required by law to give us a reasonable opportunity to correct or cure ...

  • Hans Grohe Metris 31100XX1 - page 12

    Hansgrohe, Inc. • 1490 Bluegrass Lakes Parkway • Alpharetta, GA 30004 T el. 770 360-9880 • Fax 770 360 9887 www .hansgr ohe-USA.com US - Installation Instructions • Part No. 90590021 • Revised 05/2008 ...

Manufacturer Hans Grohe Category Indoor Furnishings

Documents that we receive from a manufacturer of a Hans Grohe Metris 31100XX1 can be divided into several groups. They are, among others:
- Hans Grohe technical drawings
- Metris 31100XX1 manuals
- Hans Grohe product data sheets
- information booklets
- or energy labels Hans Grohe Metris 31100XX1
All of them are important, but the most important information from the point of view of use of the device are in the user manual Hans Grohe Metris 31100XX1.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Hans Grohe Metris 31100XX1, service manual, brief instructions and user manuals Hans Grohe Metris 31100XX1. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Hans Grohe Metris 31100XX1.

Similar manuals

A complete manual for the device Hans Grohe Metris 31100XX1, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Hans Grohe Metris 31100XX1 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Hans Grohe Metris 31100XX1.

A complete Hans Grohe manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Hans Grohe Metris 31100XX1 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Hans Grohe Metris 31100XX1, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Hans Grohe Metris 31100XX1, that we can find in the current document
3. Tips how to use the basic functions of the device Hans Grohe Metris 31100XX1 - which should help us in our first steps of using Hans Grohe Metris 31100XX1
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Hans Grohe Metris 31100XX1
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Hans Grohe Metris 31100XX1 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Hans Grohe Metris 31100XX1?

Use the form below

If you did not solve your problem by using a manual Hans Grohe Metris 31100XX1, ask a question using the form below. If a user had a similar problem with Hans Grohe Metris 31100XX1 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)