English dropdown-ico

Manual Husqvarna 325HS99X-series

28 pages 0.82 mb
Download

Go to site of 28

Summary
  • Husqvarna 325HS99X-series - page 1

    E E E E n n n n g g g g l l l l i i i i s s s s h h h h 325HS75 X-series 325HS99 X-series Oper ator ′ s manual Please r ead the operator’ s manual carefully and mak e sure you understand the instructions before using the machine. ...

  • Husqvarna 325HS99X-series - page 2

    KEY T O SYMBOLS 2 – English Symbols W ARNING! Incorrect or careless use of a hedge trimmer can tur n it into a dangerous tool that can cause serious or ev en fatal injury . It is extremely important that you read and understand the contents of this operator’ s manual. Please read the operator’ s manual carefully and make sure y ou understand ...

  • Husqvarna 325HS99X-series - page 3

    CONTENTS English – 3 Contents Note the f ollowing bef ore starting: Please read the oper ator’ s manual carefully . KEY T O SYMBOLS Symbols 2 CONTENTS Contents 3 Note the f ollowing bef ore star ting: 3 INTR ODUCTION Dear Customer , 4 WHA T IS WHA T? What is what? 5 GENERAL SAFETY PRECA UTIONS Impor tant 6 P ersonal protective equipment 6 Machi ...

  • Husqvarna 325HS99X-series - page 4

    4 – English INTR ODUCTION Dear Customer , Cong ratulations on your choice to b uy a Husqvarna product! Husqvarna is based on a tradition that dates back to 1689, when the Swedish King Karl XI ordered the construction of a factory on the banks of the Husqvarna River , for production of muskets . The location was logical, since w ater power was har ...

  • Husqvarna 325HS99X-series - page 5

    English – 5 WHA T IS WHA T? What is what? 1 Operator ′ s manual 2 Grease nipple 3 Gear housing 4 Blades 5 Hand guard 6 F ront handle 7 Cylinder cov er 8 Star ter handle 9 Fuel cap 10 Fuel tank 11 Air purge 12 Choke control 13 Throttle lock 14 Throttle control 15 Stop switch 16 Air filter cov er 17 Combination spanner 18 Allen ke y 19 T ranspor ...

  • Husqvarna 325HS99X-series - page 6

    GENERAL SAFETY PRECA UTIONS 6 – English Impor tant P ersonal protective equipment HEARING PR O TECTION Wear hearing protection that provides adequate noise reduction. EYE PRO TECTION Alwa ys wear approved e ye protection. If you use a visor then you must also w ear approved protectiv e goggles. Approv ed protective goggles must comply with standa ...

  • Husqvarna 325HS99X-series - page 7

    GENERAL SAFETY PRECA UTIONS English – 7 CLO THING Wear clothes made of a strong f abric and avoid loose clothing that can catch on twigs and branches. Alwa ys wear heavy , long pants. Do not wear je weller y , shor ts sandals or go barefoot. Secure hair so it is abo ve shoulder lev el. FIRST AID KIT Alwa ys have a first aid kit nearb y . Mac hin ...

  • Husqvarna 325HS99X-series - page 8

    GENERAL SAFETY PRECA UTIONS 8 – English Stop s witch Use the stop switch to s witch off the engine. Star t the engine and mak e sure the engine stops when you mov e the stop switch to the stop setting. Hand guar d The hand guard prev ents hands from coming into contact with the moving blades , for e xample, if the operator loses grip on the front ...

  • Husqvarna 325HS99X-series - page 9

    GENERAL SAFETY PRECA UTIONS English – 9 Nev er use a machine that has a faulty muffler . Regularly check that the muffler is securely attached to the machine. If the muffler on your machine is fitted with a spark arrestor mesh this must be cleaned regularly . A b locked mesh will cause the engine to ov erheat and may lead to serious damage. B ...

  • Husqvarna 325HS99X-series - page 10

    FUEL HANDLING 10 – English Fuel safety Nev er star t the machine: 1 If you ha ve spilt fuel on it. Wipe off the spillage and allow remaining fuel to e vaporate. 2 If you ha ve spilt fuel on yourself or y our clothes, change your clothes. W ash any par t of y our body that has come in contact with fuel. Use soap and water . 3 If the machine is lea ...

  • Husqvarna 325HS99X-series - page 11

    FUEL HANDLING English – 11 Mixing • Alwa ys mix the petrol and oil in a clean container intended for fuel. • Alwa ys star t by filling half the amount of the petrol to be used. Then add the entire amount of oil. Mix (shake) the fuel mixture. Add the remaining amount of petrol. • Mix (shake) the fuel mixture thoroughly bef ore filling the ...

  • Husqvarna 325HS99X-series - page 12

    ST AR TING AND ST OPPING 12 – English Check bef ore star ting • Inspect the working area. Remove an y objects that could be thrown out. • Check the cutting attachment. Ne ver use blades that are dull, crack ed or damaged. • Check that the machine is in perf ect working order. Check that all nuts and scre ws are tight. • Make sure the gear ...

  • Husqvarna 325HS99X-series - page 13

    ST AR TING AND ST OPPING English – 13 W arm engine Primer bulb: Press the air purge repeatedly until fuel begins to fill the bulb . The b ulb need not be completely filled. Starting Hold the body of the machine on the ground using your left hand (CA UTION! Not with your foot!). Grip the starter handle, slowly pull out the cord with y our right ...

  • Husqvarna 325HS99X-series - page 14

    W ORKING TECHNIQ UES 14 – English General working instructions P ersonal protection • Wear personal protectiv e equipment. See instr uctions under the heading P ersonal protective equipment. • Alwa ys wear working clothes and heavy-duty long trousers. • Nev er wear loose clothing or jewellery . • Make sure y our hair does not hang below s ...

  • Husqvarna 325HS99X-series - page 15

    W ORKING TECHNIQ UES English – 15 • W atch out for stumps of branches that can be thrown out during cutting. • Do not cut too close to the ground. Stones and other objects can be thrown out. • Check the working area f or foreign objects such as electricity cables, insects and animals, etc , or other objects that could damage the cutting att ...

  • Husqvarna 325HS99X-series - page 16

    MAINTENANCE 16 – English Carburettor Y our Husqvarna product has been designed and manuf actured to specifications that reduce har mful emissions. After the engine has used 8-10 tanks of fuel the engine will be run-in. T o ensure that it continues to run at peak performance and to minimise harmful exhaust emissions after the running-in period, a ...

  • Husqvarna 325HS99X-series - page 17

    MAINTENANCE English – 17 Low speed jet L T r y to find the highest idle speed by turning the low speed jet L clockwise then anti-cloc kwise. When the highest speed has been found, turn the low speed jet L 1/4 turn anti-clockwise. CA UTION! If the blades mov e while the engine is idling the T screw should be turned anti-clockwise until they stop. ...

  • Husqvarna 325HS99X-series - page 18

    MAINTENANCE 18 – English Muffler CA UTION! Some mufflers are fitted with a catalytic conv er ter. See chapter on T echnical data to see whether your machine is fitted with a catalytic con ver ter . The muffler is designed to reduce the noise le vel and to direct the exhaust gases a way from the oper ator. The exhaust gases are hot and can co ...

  • Husqvarna 325HS99X-series - page 19

    MAINTENANCE English – 19 before taking an y fur ther action. If the spark plug is dirty , clean it and check that the electrode gap is 0.5 mm. The spark plug should be replaced after about a month in operation or earlier if necessary . CA UTION! Always use the recommended spark plug type! Use of the wrong spark plug can damage the piston/ cylinde ...

  • Husqvarna 325HS99X-series - page 20

    MAINTENANCE 20 – English Cleaning and lubrication Clean any resin and plant residue from the blades using cleaning agent 531 00 75-13 (UL22) before and after using the machine. Lubricate the blade bars with special grease, part no. 531 00 75-12 (UL 21) before long periods of storage . ...

  • Husqvarna 325HS99X-series - page 21

    English – 21 MAINTENANCE Maintenance schedule The follo wing is a list of the maintenance that must be performed on the machine. Most of the items are described in the Maintenance section. The user must only carr y out the maintenance and ser vice work described in this Operator’s Manual. More extensiv e work must be carried out by an authorise ...

  • Husqvarna 325HS99X-series - page 22

    22 – English TECHNICAL D A T A T ec hnical data Note 1: Noise emissions in the environment measured as sound power (L W A ) in conformity with EC directive 2000/14/ EC. Note 2: Equivalent sound pressure le vel is calculated as the time-weighted energy total for sound pressure le vels under various working conditions with the follo wing time distr ...

  • Husqvarna 325HS99X-series - page 23

    English – 23 TECHNICAL D A T A EC-declaration of conf ormity (Applies to Europe onl y) Husqvarna AB , SE-561 82 Huskv ar na, Sweden, tel: +46-36-146500, declare under sole responsibility that the hedge trimmers Husqvarna 325HS75 and 325HS99 from 2002’s serial numbers and onwards (the y ear is clear ly stated in plain text on the type plate with ...

  • Husqvarna 325HS99X-series - page 24

    ...

  • Husqvarna 325HS99X-series - page 25

    ...

  • Husqvarna 325HS99X-series - page 26

    ...

  • Husqvarna 325HS99X-series - page 27

    ...

  • Husqvarna 325HS99X-series - page 28

    1151133-26 ´®z+S-@¶6&¨ ´®z+S-@¶6&¨ 2008-03-11 ...

Manufacturer Husqvarna Category Trimmer

Documents that we receive from a manufacturer of a Husqvarna 325HS99X-series can be divided into several groups. They are, among others:
- Husqvarna technical drawings
- 325HS99X-series manuals
- Husqvarna product data sheets
- information booklets
- or energy labels Husqvarna 325HS99X-series
All of them are important, but the most important information from the point of view of use of the device are in the user manual Husqvarna 325HS99X-series.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Husqvarna 325HS99X-series, service manual, brief instructions and user manuals Husqvarna 325HS99X-series. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Husqvarna 325HS99X-series.

Similar manuals

A complete manual for the device Husqvarna 325HS99X-series, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Husqvarna 325HS99X-series by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Husqvarna 325HS99X-series.

A complete Husqvarna manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Husqvarna 325HS99X-series - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Husqvarna 325HS99X-series, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Husqvarna 325HS99X-series, that we can find in the current document
3. Tips how to use the basic functions of the device Husqvarna 325HS99X-series - which should help us in our first steps of using Husqvarna 325HS99X-series
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Husqvarna 325HS99X-series
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Husqvarna 325HS99X-series in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Husqvarna 325HS99X-series?

Use the form below

If you did not solve your problem by using a manual Husqvarna 325HS99X-series, ask a question using the form below. If a user had a similar problem with Husqvarna 325HS99X-series it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)