English dropdown-ico

Manual Electrolux ES18

15 pages 5.21 mb
Download

Go to site of 15

Summary
  • Electrolux ES18 - page 1

    PN. 249411 REV . 03 (01/05) Electrolux Outdoor Products Via Como 72 23868 V almadrera (Lecco) IT ALIA Phone + 39 0341 203111 - Fax +39 0341 581671 www .electrolux.com Our policy of continuous improvement means that the specification of products may be altered from time to time without prior notice. Electrolux Outdoor Products manufacture products f ...

  • Electrolux ES18 - page 2

    ...

  • Electrolux ES18 - page 3

    ...

  • Electrolux ES18 - page 4

    ENGLISH – 1 A. GENERAL DESCRIPTION 1) Rear handle 2) Rear hand guard 3) Front handle 4) Front hand guard/chain brake lever 5) Chain tensioner knob/sc rew 6) Chain tensioner pin 7) Oil tank cap 8) Oil tank inspection gauge 9) Air vents 10) Cable 11) Manual 12) Switch 13) Switch bl ock 14) Chain 15) Drive tooth 16) Cutting link 17) Cutting depth ga ...

  • Electrolux ES18 - page 5

    ENGLISH - 2 B. SAFETY PRECAUTIONS MEANING OF SYMBOLS Warning! Read the instruction manual carefully Protective boots Protective goggles or visor, protective helmet and hearing protection Protective cut- proof gloves Protective long, cut-proof trousers Chain brake: deactivated, activated Disconnect the plug if the cable is damaged Correct direction ...

  • Electrolux ES18 - page 6

    ENGLISH – 3 reference number of the corresponding component to draw the reader’s attention to the main safety procedure linked with that particular situation; the machine parts shown in “A – GENERAL DESCRIPTION” are indicated in italics in the text for easy identification. Precautions prior to machine use. Never permit this machine to be ...

  • Electrolux ES18 - page 7

    ENGLISH - 4 6. Health precautions – Chemical agents. Avoid all chain oil contact with skin and eyes. 7. Health precautions - Electricity. All extension cords, plugs, and electricity lines must be homologated, to standard and in compliance with current regulations. Make sure that the main line to which the machine is connected is equipped with a r ...

  • Electrolux ES18 - page 8

    ENGLISH – 5 sure that the cable/ extension cord is kept behind the user, controlling that it does not create a source of danger for the user or for other persons, and check that it cannot be damaged (by heat, sharp objects, sharp edges, oil, etc); Always assume a stable standing position on both legs; keep the handles dry and clean; during use ke ...

  • Electrolux ES18 - page 9

    ENGLISH - 6 The chain brake can be activated in two modes: the first using the left wrist by pushing forwards, or when it comes into contact with the brake system as a result of kickback; or by inertia, in the case of particularly violent kickback. When the machine is used with the bar in horizontal position, for example during tree felling, the ch ...

  • Electrolux ES18 - page 10

    ENGLISH – 7 case do not tighten the chain immediately after use, but wait until it cools down. In cases where the loosened chain needs to be adjusted, always unscrew the bar retaining nuts / knob before adjusting the chain tensioning screw/knob ; adjust the tension and tighten the bar retaining nuts /knob accordingly. E. START-UP AND ARREST 1,4,5 ...

  • Electrolux ES18 - page 11

    ENGLISH - 8 Check that the chain is sharpened correctly (See below), in good working condition and that the tension is correct. If the chain is irregularly worn, or if the cutting teeth are only 3 mm high, the chain must be replaced(fig.3). Clean the air vents regularly to prevent motor overheating. Check that the switch and switch block function c ...

  • Electrolux ES18 - page 12

    ENGLISH – 9 - At the end of each cutting operation the user will notice a considerable change in the strength necessary for controlling the machine. Great care must be taken not to loose control . Below is a description of two different types of cutting operation: Cutting action by pulling the chain (from top to bottom) (fig.2) can lead to danger ...

  • Electrolux ES18 - page 13

    ENGLISH - 10 and lower cut. The meeting point between the two sides of the notc h is called “directional cut line” This line must be perfectly horiz ontal at right angles (90°) to the felling direction. The felling cut that provokes the tree fall, is performed at 3 to 5 cm above the lower par t of the directional felling cut line, finis hing a ...

  • Electrolux ES18 - page 14

    ENGLISH – 11 M. TROUBLESHOOTING TABLE Motor does not start Motor turns with difficulty or loses power The machine starts but does not cut properly Motor turns improperly or at reduced speeds Braking devices do not stop the chain properly Make sure the main line is powered z Make sure the machine is properly plugged in z Make sure your cable/ext. ...

  • Electrolux ES18 - page 15

    ENGLISH - 12 N. DECLARATION OF CONFORMITY The undersigned, authorized by E.O.P.I., declares that the foll owing products model: type ES15, ES 15/1, ES 15/2, ES16, ES 16/1, ES18 starting from 2004 onwards, manufactu red by E.O.P.I., Valmadrera, Italy, comply with European Directive: 98/37/EEC (Machine Direc tive), 93/68/E EC (EEC Marking Directive) ...

Manufacturer Electrolux Category Chainsaw

Documents that we receive from a manufacturer of a Electrolux ES18 can be divided into several groups. They are, among others:
- Electrolux technical drawings
- ES18 manuals
- Electrolux product data sheets
- information booklets
- or energy labels Electrolux ES18
All of them are important, but the most important information from the point of view of use of the device are in the user manual Electrolux ES18.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Electrolux ES18, service manual, brief instructions and user manuals Electrolux ES18. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Electrolux ES18.

Similar manuals

A complete manual for the device Electrolux ES18, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Electrolux ES18 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Electrolux ES18.

A complete Electrolux manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Electrolux ES18 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Electrolux ES18, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Electrolux ES18, that we can find in the current document
3. Tips how to use the basic functions of the device Electrolux ES18 - which should help us in our first steps of using Electrolux ES18
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Electrolux ES18
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Electrolux ES18 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Electrolux ES18?

Use the form below

If you did not solve your problem by using a manual Electrolux ES18, ask a question using the form below. If a user had a similar problem with Electrolux ES18 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)