Manual Studer C2324 COMPACT

23 pages 1.2 mb
Download

Go to site of 23

Summary
  • Studer C2324 COMPACT - page 1

    STUDER INNOTEC COMPACT COMPACT COMPACT COMPACT User manual COMPACT V2. 0 E User and installer Manual Sinewa v e Inverter, Batter y charger COMPACT C1312 COMPACT C1312 COMPACT C1312 COMPACT C1312 COMPACT C2324 COMPACT C2324 COMPACT C2324 COMPACT C2324 COMPACT C3548 COMPACT C3548 COMPACT C3548 COMPACT C3548 Temperature se nsor CT-35 Remote cont rol R ...

  • Studer C2324 COMPACT - page 2

    STUDER INNOTEC COMPACT COMPACT COMPACT COMPACT User manual COMPACT V2.0 E 2 Index table 1 GENERAL INFORMATION .......................................................................................................... .......................... 4 1.1 O PERA TI NG I NST RUCTI ONS ....................................................................... ...

  • Studer C2324 COMPACT - page 3

    STUDER INNOTEC COMPACT COMPACT COMPACT COMPACT User manual COMPACT V2.0 E 3 4.7.3 Delayed mode of the Trans fer System...................................................................................... ................... 17 4.8 T HE S OL AR C HAR GE R EGU LAT OR ( OPTION ) ........................................................................ ...

  • Studer C2324 COMPACT - page 4

    STUDER INNOTEC COMPACT COMPACT COMPACT COMPACT User manual COMPACT V2.0 E 4 1 General Information 1.1 Operating instructions This manual is a part of the delivery package of every COMPACT inverter-charger. It serves as guidelines for safe and efficient operation of COMPACT. The instructions are only valid for use with the following devices and opti ...

  • Studer C2324 COMPACT - page 5

    STUDER INNOTEC COMPACT COMPACT COMPACT COMPACT User manual COMPACT V2.0 E 5 During operation of COMPACT, high tensions are generated at the connections and inside of the appliance which could be deadly fat al. W ork on the appliance and on the installation should only be carried out by qualified and trained personnel. The whole installation co nnec ...

  • Studer C2324 COMPACT - page 6

    STUDER INNOTEC COMPACT COMPACT COMPACT COMPACT User manual COMPACT V2.0 E 6 2 Introduction The COMPACT is a sine wave in verter with integrated batt ery charger and solar charger regulator with many additional f unctions, it has been developed to be used as stand-alone (independent of a grid-system) AC provider, or as continuous / break-free curren ...

  • Studer C2324 COMPACT - page 7

    STUDER INNOTEC COMPACT COMPACT COMPACT COMPACT User manual COMPACT V2.0 E 7 2.2.4 T he sol ar charge regu lat or (optional) W ith the built-in solar charge regulator, the COMPACT is a complet e solar-power-center. In a solar installation this reg ulator ensures that the batteries are charged cor rectly. W ith the COMPACT, batteries can be charged w ...

  • Studer C2324 COMPACT - page 8

    STUDER INNOTEC COMPACT COMPACT COMPACT COMPACT User manual COMPACT V2.0 E 8 2.3.3 Parallel- Series Connec tion: 3 A ssembl y 3.1 Place of as sembly The location of the COMPACT must be chosen b y the following criteria: Protection from unauthorized handling. Dry dust free room, no condensation. Never install directly over the battery and never in a ...

  • Studer C2324 COMPACT - page 9

    STUDER INNOTEC COMPACT COMPACT COMPACT COMPACT User manual COMPACT V2.0 E 9 3.3.2 Protection cover for the terminals connections The protection is available in option (Or der ref. CFC-01) and avoid to do wrong hazardous connection on the terminals 230Vac. It m ounted with strain relief clam ps for the cable. 3.4 Connecting Plan / Front side . Cauti ...

  • Studer C2324 COMPACT - page 10

    STUDER INNOTEC COMPACT COMPACT COMPACT COMPACT User manual COMPACT V2.0 E 10 K AC Output Connecting terminal for AC-output L Caution… Caution: Check Polarity(+/-) before connecting the battery! Polarity reversal can damage the COMPACT. M Don‘t … Do not open without disconnecting all terminals N 15A Protection 15A Prot ection sw itch for the T ...

  • Studer C2324 COMPACT - page 11

    STUDER INNOTEC COMPACT COMPACT COMPACT COMPACT User manual COMPACT V2.0 E 11 3.5.5 Connect the Solarmodules: SOLA R +/- (Only f or solar op tion) Solar modules are connect ed on these terminals. Under no cir cumstances should any other energ y source i.e. wind generator be connected to these term inals! Only solar modules must be connected with two ...

  • Studer C2324 COMPACT - page 12

    STUDER INNOTEC COMPACT COMPACT COMPACT COMPACT User manual COMPACT V2.0 E 12 OFF AC O UT AC I N Ove r Te mp Overl oad ON/OFF SOLAR CHARGE Batt Lo w/High Contact ma nual AUX. CONTACT 70A 150V 20W OFF 0 Contact active Progr am STANDBY CHARGER Ch a r g e r - I n v e r t e r (Progr am) (Change status ) Lock (select ) CHARGE R IN VE RT ER RESET ALARM TR ...

  • Studer C2324 COMPACT - page 13

    STUDER INNOTEC COMPACT COMPACT COMPACT COMPACT User manual COMPACT V2.0 E 13 4.2 Light Emitting Diodes: LED Marking LED lit LED blinks 1 AC IN Voltage corresponding to self - adjusted values is at the AC IN input. Voltage, outside of the self- adjusted values is at the AC IN input. 2 CHARGER Battery Charger is working The input voltage is out value ...

  • Studer C2324 COMPACT - page 14

    STUDER INNOTEC COMPACT COMPACT COMPACT COMPACT User manual COMPACT V2.0 E 14 4.5 The Inverter An Inverter is built in t he COM PACT, which generat es a sinusoidal alternating voltage of a very high qualit y. W ith this Inverter any alt ernating voltag e consuming device 230Vac up to the nom inal power of your COMPACT can be oper ated. Thanks to the ...

  • Studer C2324 COMPACT - page 15

    STUDER INNOTEC COMPACT COMPACT COMPACT COMPACT User manual COMPACT V2.0 E 15 1.9 2.3 2.50 [V/cell] 2.1 A B C D 20 60 40 70 [A] A B C D t Equalization Absorption Float ing Charging current (adjusted) Charging time Egalization time Absorption time Floa ting 4.6 The Batter y charger 4.6.1 Cycle of charge The full automatic COMPACT Batt ery Charger is ...

  • Studer C2324 COMPACT - page 16

    STUDER INNOTEC COMPACT COMPACT COMPACT COMPACT User manual COMPACT V2.0 E 16 the OUTPUT less it’s give to the charger. Priority f or the OUTPUT. W hen the power sharing is used the LED 200% (red) is lit to point out that’s the char ge is limited. Ca utio n: If the power use on the OUTPUT is higher than the v alue of the INPUT LIMIT (26) the COM ...

  • Studer C2324 COMPACT - page 17

    STUDER INNOTEC COMPACT COMPACT COMPACT COMPACT User manual COMPACT V2.0 E 17 Note: In the I nverter operation, The COMPACT generates a true sinusoidal and quartz stabilized output voltage. W hen, h owever the COMPACT is supplied from a g rid or a generator and the transfer contact is act ive, then you have at the output AC OUT the same voltage as t ...

  • Studer C2324 COMPACT - page 18

    STUDER INNOTEC COMPACT COMPACT COMPACT COMPACT User manual COMPACT V2.0 E 18 Maximum Contact load: -230Vac /16 A mp-30Vdc/1 A ! W ith t he Push Button 21 „AUXILARY CONTACT“ the contact can be manually switched on or off independent of programming and the operating situation. The LED 5 “Contact active” show the state of the contact. The draw ...

  • Studer C2324 COMPACT - page 19

    STUDER INNOTEC COMPACT COMPACT COMPACT COMPACT User manual COMPACT V2.0 E 19 4.11 The Temperature s ensor Operating voltage of lead-acid batter ies change depending on the te mperature. To correct the operating voltages according to t he actual temperatures, a temperature sensor can be connected to th e C OM PAC T. The compensation through the sens ...

  • Studer C2324 COMPACT - page 20

    STUDER INNOTEC COMPACT COMPACT COMPACT COMPACT User manual COMPACT V2.0 E 20 5.3.2 Set the voltage and timi ng threshold The programming is done in accordance with the following steps: Push and hold down, the Push Button 21 (Program) and the Push Button 19 (Change status) for minimum 2 seconds simultaneously. W ith the Push Button 20 (select) selec ...

  • Studer C2324 COMPACT - page 21

    STUDER INNOTEC COMPACT COMPACT COMPACT COMPACT User manual COMPACT V2.0 E 21 5.4.3 Example 5.4.3.1 Auxiliary Contact as generator starter W he n in the programming of the Auxiliary Cont act, the Batter y Capacity (LED 15-18) is used as a condition, then you must take note of the following r equirements. If you have to start an emergency back-up sup ...

  • Studer C2324 COMPACT - page 22

    STUDER INNOTEC COMPACT COMPACT COMPACT COMPACT User manual COMPACT V2.0 E 22 5.5.1 Diagram of the different mode 9 Show an off LED Show a blinking LED Show a lighted LED CHARGER INVERTER AC OUT AC IN 1 2 7 8 9 All the f unctions are enabled. This is the factory set t ing. CHARGER INVERTER AC OUT AC IN 1 2 7 8 9 The inverter is disabled. Only the tr ...

  • Studer C2324 COMPACT - page 23

    STUDER INNOTEC COMPACT COMPACT COMPACT COMPACT User manual COMPACT V2.0 E 23 8 Technical Data Ty pe C1312 C1312 C1312 C1312 C2324 C2324 C2324 C2324 C3548 C3548 C3548 C3548 Inve rter Nominal battery voltage 12V 24V 48V Input voltage range 9.5 – 16V 19 – 32V 38 – 64V Nominal pow er (W ) 1300VA 2300VA 3500VA Max imum power 30 min 1600VA 2500VA 4 ...

Manufacturer Studer Category Battery Charger

Documents that we receive from a manufacturer of a Studer C2324 COMPACT can be divided into several groups. They are, among others:
- Studer technical drawings
- C2324 COMPACT manuals
- Studer product data sheets
- information booklets
- or energy labels Studer C2324 COMPACT
All of them are important, but the most important information from the point of view of use of the device are in the user manual Studer C2324 COMPACT.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Studer C2324 COMPACT, service manual, brief instructions and user manuals Studer C2324 COMPACT. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Studer C2324 COMPACT.

Similar manuals

A complete manual for the device Studer C2324 COMPACT, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Studer C2324 COMPACT by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Studer C2324 COMPACT.

A complete Studer manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Studer C2324 COMPACT - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Studer C2324 COMPACT, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Studer C2324 COMPACT, that we can find in the current document
3. Tips how to use the basic functions of the device Studer C2324 COMPACT - which should help us in our first steps of using Studer C2324 COMPACT
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Studer C2324 COMPACT
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Studer C2324 COMPACT in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Studer C2324 COMPACT?

Use the form below

If you did not solve your problem by using a manual Studer C2324 COMPACT, ask a question using the form below. If a user had a similar problem with Studer C2324 COMPACT it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)