-
Nokia 9400 S - page 1
Owner’s Manual MEDIAMASTER 9400S ...
-
Nokia 9400 S - page 2
...
-
Nokia 9400 S - page 3
GB 3 Contents FOR YOUR SAFETY 4 Rear panel 4 Front panel 5 INSTALLATION OF THE MEDIAMASTER 5 Connecting the Mediamaster to the satellite dish 6 Connecting the Mediamaster to a TV set 6 Connecting to a TV and a video recorder 7 If your VCR does not have a SCART - Connector 7 Connecting to an analogue satellite - receiver and a video recorder 7 Conne ...
-
Nokia 9400 S - page 4
GB 4 • Keep a clear space around the Mediamaster to allow for sufficient ventilation. • Do not cover the Mediamaster or place it on a unit that emits heat. • Use a soft cloth and a mild solution of dish washing liquid to clean the casing. • Never allow liquids, spray or other materials to come into contact with the inside of the Mediamaster ...
-
Nokia 9400 S - page 5
GB 5 The box for your Mediamaster should contain the following items: Medi a master 9400 S includes About the SCART sockets Ÿ The rear panel of the Mediamaster is equipped with 2 SCART sockets . When you connect other products to any of these sockets, always use fully featured SCART cables (as supplied). There are “ less well specified ” SCART ...
-
Nokia 9400 S - page 6
GB 6 Installing the satellite dish Ÿ Your satellite dish should be installed with a cable for you to connect to t he Mediama ster. If you do not have this cable you will need to buy one from a dealer (tell the dealer you need a coaxial cable and F - connectors). Ÿ Connect the cable from the satellite dish to the socket marked ” LNB IN ” on th ...
-
Nokia 9400 S - page 7
GB 7 Refer to your video recorder manual for full instructions. Ÿ Connect one SCART cable between the main SCART socket on the TV and the TV SCART socket on the Mediamaster. Ÿ Connect another SCART cable between the VCR and the AUX SCART socket on the Mediamaster. Ÿ Connect the RF cable from the RF output on t he VCR to the TV aerial input on th ...
-
Nokia 9400 S - page 8
GB 8 Connect an RCA/Cinch stereo cable from the AUDIO L R sockets on the Mediamaster to the LINE, AUX, SPARE or EXTRA input sockets on your Hi Fi system . Ÿ Remove the cover on the battery compartment at the bottom of the remote control handset. Ÿ Insert the 2 x AAA (1 , 5 V) batteries, as shown in the diagram, taking care to observe the + and - ...
-
Nokia 9400 S - page 9
GB 9 This section describes how to operate the Mediamaster using the buttons on the remote control. Some of the functions can also be carried out using the buttons on the front panel. T o switch the Mediamaster in and out of standby mode. EXIT TV To return to the viewing mode from a menu without storing settings (in menu mode). To switch between TV ...
-
Nokia 9400 S - page 10
GB 10 Once you have correctly connected the Mediamaster, you also have to perform some “ Basic Settings ” . During this procedure, helpful information is displaye d at the bottom of the menus. Please note! The OK button always confirms a selection within these menus, and pressing it will take you to the next step in the installation process. Ho ...
-
Nokia 9400 S - page 11
GB 1 1 To install the Mediamaster properly you have to adjust a few settings. You will always be guided by the information at the bottom of the menus. When you have finished the final part of the setup procedure you can start watching TV channels and listening to radio channels. Now you should have the Welcome Menu on the TV screen. Press the OK bu ...
-
Nokia 9400 S - page 12
GB 12 S atellite name : From here you can select a name for the configuration. Switch Type : There are in principle two kinds of external DiSEqC switches on the market at pre sent. One for connection of two LNBs. The other one for connection of up to 4 LNBs. If you have the other switch, defined as DiSEqC, Level 1 or 2 on the market, select “ DiS ...
-
Nokia 9400 S - page 13
GB 13 You can use manual channel search if you want to add new channels later. For example If you have a special antenna configuration which is not assigned in the “ Antenna alternative ” menu, you can add new channels using the “ manual channel search ” func tion. When you perform a Manual Search you first need to enter some parameters for ...
-
Nokia 9400 S - page 14
GB 14 If you have a TV set with a 4:3 picture format, and the transmission is in 16:9, y ou can select “ 4:3 (Pan & Scan) ” or “ 4:3 ( Letterbox ) ” to change display format. “ 4:3 (Pan & Scan) ” will fill up the screen vertically, but cut off some information from the left and right sides of the picture. “ 4:3 ( Letterbox ) ? ...
-
Nokia 9400 S - page 15
GB 15 By pressing the GUIDE button you obtain access to the TV Guide which give s the titles of the current programme s on the different channels. By pressing the LEFT or RIG HT button you also can also obtain information about the next programme. The minimized viewing window also helps you to select channels and information. Use the Up/Down button ...
-
Nokia 9400 S - page 16
GB 16 While listening to radio Programmes you can see a programme list on the screen by pressing the OK button. You can change to another channel by pressing the UP/DOWN buttons and then press ing the OK button. To move faster ( 8 at the time) between the channels you can also use the DOUBLE ARROW buttons. With a Video Cassette Recorder (VCR) conne ...
-
Nokia 9400 S - page 17
GB 17 TV/Radio Channels will show a list with the names of the different channels. To move faster within the list, use the DOUBLE ARROW buttons. Press OK to enter a marked channel. These guides will give you an overview of programme i nformation from the TV/Radio channels. Step to different channel numbers with the UP/DOWN buttons. If you stop on a ...
-
Nokia 9400 S - page 18
GB 18 If you have created several Favorite lists you can determine the sequence in which the lists will appear. To rearrange channels, select the list which you want to move using the OK button. Move the channels to the desired posit ion using the UP/DOWN button and press OK. You can change the list name with the virtual keyboard on the screen. Typ ...
-
Nokia 9400 S - page 19
GB 19 Y ou can arrange the order of channels within your favorite lists. To rearrange channels, select the channel which you want to move using the O K button. Move the channels to the desired position using the UP/DOWN button and press OK. From here, when the “ All TV ” list is selected in the “ Edit Channels ” menu, you can remove channel ...
-
Nokia 9400 S - page 20
GB 20 Change a ccess code From here you can change the access code from the standard 1234. DO NOT FORGET IT! Without it you do not have access to any of the functions where the code is required! If you forget it, you have to contact an Authorized Nokia Service Center t o get help. From here you can change the language for the menus, main audio lang ...
-
Nokia 9400 S - page 21
GB 21 You can en joy this On/Off Timer for such a convenience as wake - up or automatic VCR recording. Mediamaster will be automatically switched - on and play specified channel for the specified time, and then switched - off. You may specify up to 8 separate lists with turn - on time, date, duration, channel and occurrence options. Time Setting Yo ...
-
Nokia 9400 S - page 22
GB 22 Select this Menu from the line “ Installat ion ” in the Main Menu. The submenu will give you the opportunity to change the preferences performed during first time installation. You can also add features that were not included in the first installation. Please note that helpful information for every line is given at the end of the menu . P ...
-
Nokia 9400 S - page 23
GB 23 This will start the Installation procedure from the “ Welcome Menu ” . When you press OK in the “ Welcome Menu ” again, be aware of the fact, that all previous channels and settings will be erased! To exit the ” Reinstall ” menu without erasing any channels, press “ Back ” . This gives general information about which hardware ...
-
Nokia 9400 S - page 24
GB 24 AGC Acquisition Gain Control. Audio system With digital satellite reception, the sound is transmitted in packages and is elected either in a special audio mode or pre - selected by using the installation set - up. This makes it possible to select between several different languages in a film. The numbe r of choices is dependent on what is ava ...
-
Nokia 9400 S - page 25
GB 25 Problem Possible causes What to do The display on the front panel does not light up/is not lit. Mains lead is not connected. Check that the mains lead is plugged into the power socket . No sound or picture. The satellite dish is not po inting at the satellite. No signal or weak signal. The LNB is faulty. Adjust the dish. Check the signal leve ...
-
Nokia 9400 S - page 26
GB 26 Transmission Standards DVB,MPEG2 LNB/Tuner input Connector 2 x F - type (Loop Through) Input frequency 950 - 215 0MHz Max Current 500mA max Supply Voltage 13V/18V DiSEqC 1.0 RF Impedance 75 ohm Demodulator QPSK Symbol rate 2 - 45 Msym/s SCPC and MCPC Video decoder MPEG - 2 Main Profile @ Main Level Data rates up to 15Mbit/ s Video formats 4:3 ...
-
Nokia 9400 S - page 27
GB 27 System Settings 1.TV Screen Format 2.Output Selection 3.UHF Channel Number 4.RF Modulator Type 5.Information Box Time out 6.Display Volume Indicator 7.Date Setting(dd/mm/yyyy) 8.Time Setting(hh:mm) 9.GMT Offset 7.Game First Time Installation MENUS SCREEN STRUCTURE Welcome Menu Language Settings 1.Menu Language 2.Main Audio Lang … 3.Alternat ...
-
Nokia 9400 S - page 28
Nokia is a registered trademark of Nokia Corporation www.nokia.com 66 76967-10 KQX1A668Y ...
Do you have a question concerning Nokia 9400 S?
Use the form below
If you did not solve your problem by using a manual Nokia 9400 S, ask a question using the form below. If a user had a similar problem with Nokia 9400 S it is likely that he will want to share the way to solve it.