English dropdown-ico

Manual Kenwood DPF-3030

24 pages 0.76 mb
Download

Go to site of 24

Summary
  • Kenwood DPF-3030 - page 1

    CD PLA YER B60-4517-08 (EN) INSTRUCTION MANUAL KENW OOD CORPORA TION DPF-3030 ...

  • Kenwood DPF-3030 - page 2

    2 Before applying power Caution : Read this section carefully to ensure safe operation. Units are designed for operation as follows. Europe and U.K. ..................................................................... A C 230 V only The marking is located on the rear panel and says that the compo- nent uses laser beams that have been classified as ...

  • Kenwood DPF-3030 - page 3

    3 Unpacking Unpack the unit carefully and make sure that all accessories are put aside so they will not be lost. Examine the unit for any possibility of shipping damage. If your unit is damaged or fails to operate, notify your dealer immediately. If your unit was shipped to you directly, notify the shipping company without delay. Only the consignee ...

  • Kenwood DPF-3030 - page 4

    4 Caution : Read this page carefully to ensure safe operation. IMPORT ANT SAFEGUARDS 10. Cleaning – Unplug this appliance from the wall outlet before cleaning. Do not use volatile solvents such as alcohol, paint thinner, gasoline, or benzine, etc. to clean the cabinet. Use a clean dry cloth. 1 1 . Lightning – For added protection for this appli ...

  • Kenwood DPF-3030 - page 5

    5 ...

  • Kenwood DPF-3030 - page 6

    6 System connections Caution: Do not plug in the power lead until all connections are com- pleted. Malfunction of microcomputer If operation is not possible or erroneous display appears even though all connections hav e been made pr oper ly , r eset the microcomputer referring to “In case of difficulty”. ™ Make connections as sho wn below . W ...

  • Kenwood DPF-3030 - page 7

    7 Adjusting the output levels of the output jacks and headphone output The OUTPUT level (UP/DOWN) keys of the remote control unit can adjust the output levels from the LINE/OUT jacks and PHONES jack of the unit. T o use the headphone Connect a stereo headphone to the PHONES jack of the CD player. Adjust the sound volume using the remote control uni ...

  • Kenwood DPF-3030 - page 8

    8 SYSTEM CONTROL OPERA TIONS Remote Control Lets y ou operate this unit with the system remote control unit supplied with the amplifier or receiver . Automatic Operation Automatically switches the input selector on the amplifier or receiver when you start playback from this unit. Synchronized Recording Lets you synchronize recording with the start ...

  • Kenwood DPF-3030 - page 9

    9 Maintenance Be specially cautious against condensation in a following circumstance: When this unit is carried from a place to another across a large difference in temperature, when the humidity in the room where this unit is installed increases, etc. Caution on condensation Condensation (of dew) may occur inside the unit when there is a great dif ...

  • Kenwood DPF-3030 - page 10

    10 TRACK EDIT CCRS TRACK NO. P.C. TOTAL TIME SINGLE TIME 6 1 11 16 7 2 12 17 8 3 13 18 9 4 14 19 10 5 15 20 PGM REPEAT 8 _ : 8 88 8 8 POWER - ON – OFF PHONES P.MODE EDIT CHECK CLEAR PEAK SEARCH TIME DISPLAY OPEN/CLOSE 123 456 789 0+ 1 0 REPEAT 24 bit D.R.I.V.E. II RANDOM 0 76 4¢  1¡  1 90 ! @ # $ % ^ & * 23 4 5 6 7 8 Controls and indi ...

  • Kenwood DPF-3030 - page 11

    11 Operation of remote control unit 1. The supplied batteries are intended for use in operation checks. Therefore, their lives may be shorter than ordinary batteries. 2. When the remote-controllable distance gets shorter than before, replace both batteries with new ones. 3. Malfunction may occur if direct sunlight or the light of a high-frequency l ...

  • Kenwood DPF-3030 - page 12

    12 Normal play (TRACK mode) 2 Load a disc. 3 Start playback. 1 Open the tray. Use the following procedure to play a CD in the original order of tracks from track No. 1. : Keys and control used in the operations described on this page. 3 Close the tray. Playing tracks in order from track No. 1 ÷ Playback starts when a disc has been loaded. T o paus ...

  • Kenwood DPF-3030 - page 13

    13 Playback from desired track Press the numeric keys as shown below.... To enter track No. 23 : 003 To enter track No. 40 : 0000) ÷ Playback starts from the selected track and continues on the subse- quent tracks. Skipping tracks ÷ The track in the direction of the pressed key is skipped, and the selected track will be played from the beginning. ...

  • Kenwood DPF-3030 - page 14

    14 Programmed play (PGM mode) Use the following procedure to program desired tracks in a desired order. (up to 20 tracks) ÷ Load a disc in the CD player. @ Press so that the “PGM” indicator lights. Program desired tracks. 1 2 Preparation : Keys and control used in the operations described on this page. ÷ The programmed contents remain in memo ...

  • Kenwood DPF-3030 - page 15

    15 ÷ When a track No. is selected, the track will be added to the end of the existing program. Press to clear tracks from the end. T o check or change the programmed tracks T o clear tracks from the program 1 Pr ess the CHECK ke y . Press until the track No. to be changed is displayed. 2 Select the new track No. Auto space function During programm ...

  • Kenwood DPF-3030 - page 16

    16 Repeated playback T o repeat only the programmed tracks : Keys and control used in the operations described on this page. ™ Preparation T o cancel repeated playback Press the REPEA T k ey ag ain. Lights up. 1 Press so that the "PGM" indicator lights. 2 Select the desired track No. Press the numeric keys as shown below... To enter tra ...

  • Kenwood DPF-3030 - page 17

    17 T o repeat the entire disc 1 Press so that the “TRACK” indicator lights. 2 Switch REPEAT ON. 3 Start playback. T o cancel repeated playback Press the REPEA T k ey again. : Keys and control used in the operations described on this page. Goes off. Lights up. Lights up. 123 456 789 0+ 1 0 0 76 4¢  1¡  0 0 0 0 REPEAT 6 REPEAT P.MODE TRAC ...

  • Kenwood DPF-3030 - page 18

    18 The following procedure allows to record a CD within the specified tape length so that no music is interrupted in the middle at the ends of sides A and B. Editing Preparation : Keys and control used in the operations described on this page. Press the numeric keys as shown below. 30-minute tape : 000) 46-minute tape : 00006 1 Light the “EDIT” ...

  • Kenwood DPF-3030 - page 19

    19 : Keys and control used in the operations described on this page. Press any one of these keys. ÷ The edited data is cleared entirely. T o clear the edited contents ÷ When the CHECK key is pressed, track numbers and remaining time in the file A are displayed first, then those in the file B. ÷ The "P.C." indicator goes off in a few se ...

  • Kenwood DPF-3030 - page 20

    20 Playback in a random order (Random playback) ÷ Pressing the 4 key once returns to the beginning of the track being played. ÷ Press the RANDOM key to start normal playback. ™ As tracks are selected at random, you can enjoy listening to for a long time. ÷ Load a disc in the CD player. @ Preparation T o select another track in the middle of pl ...

  • Kenwood DPF-3030 - page 21

    21 12 F 00 123 456 789 0 +10 0 76 4¢  1¡  T imer operations Timer playbac k of CD can be started at an y time using an audio timer which is available in audio stores. Preparation ÷ Connect the power cords of the associated components so that their power can be turned ON through the audio timer. (Also, be sure to read carefully the instruct ...

  • Kenwood DPF-3030 - page 22

    22 ÷ Insert the power plug firmly to the AC outlet. ÷ Turn the amplifier’s power ON. ÷ Load the disc again with its label side up. ÷ Insert the disc properly . ÷ Wipe off the dust on the surface of the disc referring to “Disc handling precautions”. 9 ÷ Replace the disc with a new one. ÷ Leave the player for about 1 hour so that the con ...

  • Kenwood DPF-3030 - page 23

    23 Specifications [ Format ] System ..................................................................................... Compact disc digital audio system Laser ................................................................................................................ Semiconduc tor laser [ D/A Conv ertors ] D/A Conversion ................... ...

  • Kenwood DPF-3030 - page 24

    For your records Record the serial number , f ound on the back of the unit, in the spaces designated on the war ranty card, and in the space provided below . R ef er to the model and serial numbers whenever you call upon your dealer for information or service on this product. Model Serial Number ...

Manufacturer Kenwood Category CD Player

Documents that we receive from a manufacturer of a Kenwood DPF-3030 can be divided into several groups. They are, among others:
- Kenwood technical drawings
- DPF-3030 manuals
- Kenwood product data sheets
- information booklets
- or energy labels Kenwood DPF-3030
All of them are important, but the most important information from the point of view of use of the device are in the user manual Kenwood DPF-3030.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Kenwood DPF-3030, service manual, brief instructions and user manuals Kenwood DPF-3030. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Kenwood DPF-3030.

Similar manuals

A complete manual for the device Kenwood DPF-3030, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Kenwood DPF-3030 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Kenwood DPF-3030.

A complete Kenwood manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Kenwood DPF-3030 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Kenwood DPF-3030, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Kenwood DPF-3030, that we can find in the current document
3. Tips how to use the basic functions of the device Kenwood DPF-3030 - which should help us in our first steps of using Kenwood DPF-3030
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Kenwood DPF-3030
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Kenwood DPF-3030 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Kenwood DPF-3030?

Use the form below

If you did not solve your problem by using a manual Kenwood DPF-3030, ask a question using the form below. If a user had a similar problem with Kenwood DPF-3030 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)