Manual Audiovox APS-55

16 pages 0.4 mb
Download

Go to site of 16

Summary
  • Audiovox APS-55 - page 1

    Kit Contents (1) - APS-55 Control Module (2) - 2 Button High Frequency Transmitters (1) - 3 Channel Code Learning Receiver (1) - Multi Pin Input/Output Harness (1) - Six Pin Power Harness (1) - Two Pin I/O Harness Factory Alarm By-Pass & Diesel Wait To Start Input (1) - 2 Pin Door Lock Harness (2) - 30 Amp In-line Fuse Holders With Fuses (1) - ...

  • Audiovox APS-55 - page 2

    The APS-55 Remote Start/Keyless Entry System is designed to be used with Automatic Transmission Vehicles Only! The unit provides wait to start input for glow plug pre-heat which will be used for all diesel applications. If this wire is not connected, then the unit will remain in the Gasoline mode setting which will crank the car when the RF signal ...

  • Audiovox APS-55 - page 3

    3 IMPORT ANT! DO NOT PLUG THE SIX PIN MAIN POWER HARNESS OR THE MUL TI PIN INPUT / OUTPUT HARNESS INTO THE CONTROL MODULE UNTIL ALL CONNECTIONS TO THE VEHICLE HA VE BEEN MADE. AFTER SELECTING YOUR T ARGET WIRES AS DEFINED BELOW, DISCONNECT THE NEGA TIVE BA TTERY CABLE FROM THE VE- HICLE BA TTERY PRIOR TO MAKING ANY CONNECTIONS. WIRING THE 6 PIN MAI ...

  • Audiovox APS-55 - page 4

    SEE NEUTRAL ST ART SAFETY TEST FOR FUR THER DET AILS. BLUE Wire: Ignition 1 Output Connect this wire to the ignition 1 wire from the ignition switch. This wire will show +12 volts when the ignition key is turned to the to the "ON" or "RUN" and the "ST ART" or CRANK" positions and will have 0 volts when the key is ...

  • Audiovox APS-55 - page 5

    WIRING CONNECTIONS: 12 Pin Input / Output Harness Black Wire: Chassis Ground Source Connect the Black wire to a known vehicle ground source or to a solid clean metal part of the chassis. Be certain to remove any paint or grease and secure this wire with a self tapping screw and ring terminal. BLACK w/WHITE Tracer Wire: Control Switch The Black w/ W ...

  • Audiovox APS-55 - page 6

    the Brown w/ Black trace wire to the output of the brake light switch. If the brake light switch in the vehicle switches ground , do not use the Brown w/ Black wire; see Grey w/ Black tracer wire. Brake Switch Positive Shutdown Detail YELLOW w/ BLACK Tracer Wire: + 12 Volt Alarm By - Pass Output NOTE: YOU MUST DISCONNECT THE IGNITION INPUT OF THE A ...

  • Audiovox APS-55 - page 7

    LIGHT BLUE Wire: Ignition 3 / Shock Disable Output This wire provides a 300mA ground output that becomes active 3 seconds before the Remote Start Unit initializes, and remains grounded while running plus an additional 4 seconds after the Remote Start Unit turns off. In all of the applications described below , a relay will be required. The Light Bl ...

  • Audiovox APS-55 - page 8

    DARK GREEN Wire: Tach Sensor Input This wire will continually monitor the engine tach rate while the unit is under power of the Remote Start module. This wire will be routed to the vehicle ECM tach input or through the firewall into the engine com- partment and connect to the negative side of the ignition coil. This Remote Start unit learns the tac ...

  • Audiovox APS-55 - page 9

    3 Wire Positive Switched Door Locks: In this application, the Red wire of the two pin harness provides a + 12 volt pulse during the disarming sequence, or pulsed 12 volt unlock output. Connect the Red wire to the low current 12 volt signal wire from the factory door unlock switch to the factory door unlock relay . The Green wire of the two pin harn ...

  • Audiovox APS-55 - page 10

    10 1. RF Programmable Features: Feature Selection 1 Flash 2 Flash 3 Flash 4 Flash Default 1 Run Time 5 Min. 10 Min. 15 Min. 20 Min. 10 Min. 2 Ign. 2 During Crank Off On On 3 Light Output During Run Steady Flash Steady 4 Tach Mode N A Tach Tach 5 N A NA NA NA NA NA 6 Trouble Shooting O ff On O f f 7 Door Locks 1 Sec/1 Sec 3.5 Sec/3.5 Sec 1 Sec/Dbl 1 ...

  • Audiovox APS-55 - page 11

    11 Multi Coil Pack Adaptor: (Optional) The multi coil pack adaptor , (P/N 136B1400), is designed for use with vehicles that do not respond to single coil tach programming. Although the tach resolution of this circuit is designed to interface direct with most vehicles, there may be an occasion where the following circuit may be required. T o use the ...

  • Audiovox APS-55 - page 12

    If the unit fails this test, recheck your enable switch connection to the Ground and the Black/White wire of the Audiovox Remote Start Unit. If you have a plug in enable switch, check that the two pin connector is firmly seated in the mating connector on the control module. DO NOT RELEASE THIS VEHICLE TO THE CONSUMER UNTIL YOU CONFIRM THE OPERA TIO ...

  • Audiovox APS-55 - page 13

    13 the equivalent reference wire in the vehicle you are installing the Audiovox Remote Start Unit in. 2. Connect the Cathode, (Striped) end, of a 4000 series diode to this reference wire. 3. Connect the Anode, (Non Striped) end, of the diode to one side of the Remote Start enable switch. 4. Connect the other side of the enable switch to the Black/W ...

  • Audiovox APS-55 - page 14

    14 F . Connect terminal 86 of the relay to a fused +12 volt constant battery source. G. Connect terminal 87 of the relay to the Chime Module side of the previously cut wire in step D. H. Connect terminal 85 of the relay to the Drivers Door side of the pin switch wire previously cut in step B. NOTE: A second 4002 series diode may be required to main ...

  • Audiovox APS-55 - page 15

    15 COMPLETING THE INST ALLA TION: After you have confirmed the operation of the Audiovox Remote Start unit and tested all the safety features of the system: 1. If you have not done so already , place the red rubber handle cover over the handle of the control switch for ease of identification. This will allow your customer to distinguish the Remote ...

  • Audiovox APS-55 - page 16

    WIRING DIAGRAM © 2000 Audiovox Electronics Corp., Hauppauge, NY 1 1788 128-5936A ...

Manufacturer Audiovox Category Automobile Alarm

Documents that we receive from a manufacturer of a Audiovox APS-55 can be divided into several groups. They are, among others:
- Audiovox technical drawings
- APS-55 manuals
- Audiovox product data sheets
- information booklets
- or energy labels Audiovox APS-55
All of them are important, but the most important information from the point of view of use of the device are in the user manual Audiovox APS-55.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Audiovox APS-55, service manual, brief instructions and user manuals Audiovox APS-55. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Audiovox APS-55.

A complete manual for the device Audiovox APS-55, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Audiovox APS-55 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Audiovox APS-55.

A complete Audiovox manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Audiovox APS-55 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Audiovox APS-55, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Audiovox APS-55, that we can find in the current document
3. Tips how to use the basic functions of the device Audiovox APS-55 - which should help us in our first steps of using Audiovox APS-55
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Audiovox APS-55
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Audiovox APS-55 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Audiovox APS-55?

Use the form below

If you did not solve your problem by using a manual Audiovox APS-55, ask a question using the form below. If a user had a similar problem with Audiovox APS-55 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (1)

prayemn

The spa nude waiting visit one of the options massage techniques, is what we do. The beautiful girls our the salon will give you an unforgettable experience. The spa salon is a place of rest and relaxation. The studio nude massage in Long Beach considered much better way relax at the end of the strenuous working day is Japanese massage. Good method better understand in feelings and preferences of a loved one - a common Masseuses massage, developing strong stimulating effect. The skill Bodywork massage in New York discovers space for creativity in building deep relations, besides this is beautiful way express love and appreciation beloved to man. first adult massage in Dallas from Temperamental the therapist the massage. Men coming to the erotic salon you can choose any kind of massage yourself and relax with an erotic massage and we will make an unforgettable massage. Kimberly from the Spa of the Anticellulite massage in Portland become will your own personal masseuse at any day. We have a showroom in Manhattan. : <a href=https://tantric.massage-ny.com>tantric massage</a>