English dropdown-ico

Manual Briggs & Stratton 600 SERIES

20 pages 0.74 mb
Download

Go to site of 20

Summary
  • Briggs & Stratton 600 SERIES - page 1

    Operator ’ s Manual Quick Start Guide on page 4 BRIGGSandSTRA TTON.com E Copyright Briggs & Stratton Corporation Milwaukee, Wisconsin 53201 U.S.A. Form No. 277039-9/06 Printed in U.S.A. Model 120000 Quantum 600 Series 625 Series 650 Series 675 Series ...

  • Briggs & Stratton 600 SERIES - page 2

    Safety References The safety alert symbol is used to identify safety information about hazards that can result in personal injury . A signal word (DANGER, W ARNING, or CAUTION) is used with the alert symbol to indicate the likelihood and the potential severity of injury . In addition, a hazard symbol may be used to represent the type of hazard. DAN ...

  • Briggs & Stratton 600 SERIES - page 3

    3 Know Y our Engine Back view Front view Primer Spark plug Choke (if equipped) Muffler Oil cap & Oil dipstick Fuel fill Rewind/Starter handle Air cleaner Speed control lever Side oil drain plug (if equipped) ...

  • Briggs & Stratton 600 SERIES - page 4

    4 See page 10 for details. HOW? Unscrew and remove oil cap. Pour in oil. Replace cap. WHA T KIND? High quality SAE 30 motor oil. HOW MUCH? T o FULL line on dipstick. Engine holds about 20 oz. (0.61l). SPECIAL CONCERNS? Do not overfill. Do not tip engine. See page 12 for details. W ARNING Starting engine creates sparking. Gasoline and its vapors are ...

  • Briggs & Stratton 600 SERIES - page 5

    5 Rapid retraction of starter cord (kickback) will pull hand and arm toward engine faster than you can let go. T o avoid kickback, slowly pull the cord until you feel resistance, then pull rapidly . Broken bones, fractures, bruises or sprains could result. Rotating parts can contact or entangle hands, feet, hair , clothing, or accessories. T raumat ...

  • Briggs & Stratton 600 SERIES - page 6

    6 Starter Handle will not pull. • Ensure all external equipment/engine loads are removed before starting engine. Direct coupled equipment components must be securely attached such as, but not limited to, blades, impellors, pulleys, sprockets, etc. W ARNING T roubleshooting Engine will not start. • Drain excess oil from engine to bring level to ...

  • Briggs & Stratton 600 SERIES - page 7

    7 ReadyStart E Instructions 1. Check oil level. Ensure level is at FULL mark on dipstick. Use a high quality motor oil. Check the oil recommendations for the correct oil type for expected starting temperature. 2. Move speed control to F AST , if equipped. Operate engine in F AST position. 3. Close bail, operator control bar on equipment with this f ...

  • Briggs & Stratton 600 SERIES - page 8

    8 Starting Instructions 1. Check oil level. Ensure level is at FULL mark on dipstick. Use a high quality motor oil. Check the oil recommendations for the correct oil type for expected starting temperature. 2. Open fuel shut-off valve1/4 turn, if equipped. 3. Firmly push primer bulb 3 times, if equipped. 4. Move speed control to F AST , if equipped. ...

  • Briggs & Stratton 600 SERIES - page 9

    9 Operating Engine After engine has started, let it warm up several seconds to several minutes, depending on outside temperature. For maximum performance and life, operate engine with speed control in F AST , if equipped. • Do not tip engine or equipment at angle which causes gasoline to spill. Periodically remove grass buildup under mower deck. ...

  • Briggs & Stratton 600 SERIES - page 10

    10 Oil Capacity The engine holds approximately (18 oz.; 0.5 liter). • Use a high quality SAE 30 weight motor oil. • Do not use special additives. • Choose a viscosity according to the table opposite. Note: Synthetic oil meeting ILSAC GF-2, API certification mark and API service symbol (shown at left) with “SJ/CF ENERGY CONSERVING” or high ...

  • Briggs & Stratton 600 SERIES - page 11

    11 Changing Oil Change oil after first 5 to 8 hours of use , then every 50 hours or every season. Change oil every 25 hours when operating the engine under heavy load or in high temperatures. 1. Run engine until it runs out of fuel. Otherwise, fuel can leak out, creating a fire/explosion hazard, when you tip engine in Step 4. 2. Disconnect spark pl ...

  • Briggs & Stratton 600 SERIES - page 12

    12 Adding Fuel 1. Remove cap. Fill tank to approximately one inch below top of neck to allow for fuel expansion. Be careful not to overfill. 2. Replace cap before starting. Fuel Fill • T urn engine OFF and let engine cool at least 2 minutes before removing gas cap. • Fill fuel tank outdoors or in well-ventilated area. • Do not overfill fuel t ...

  • Briggs & Stratton 600 SERIES - page 13

    13 Engine Specifications This is a single cylinder , L-head, air-cooled engine. It is a low emissions engine. In the state of California, model 120000 engine covered in this manual is certified by the California Air Resources Board to meet emissions standards for 125 hours. Such certification does not grant the purchaser , owner or operator of this ...

  • Briggs & Stratton 600 SERIES - page 14

    14 Engine Maintenance Regular maintenance will improve the performance and extend the life of the engine. See any Authorized Briggs & Stratton Dealer for service. Use only genuine Briggs & Stratton parts. Other parts may not perform as well, may damage the engine, and may result in injury . In addition, use of other parts may void your warr ...

  • Briggs & Stratton 600 SERIES - page 15

    15 Air Cleaner All engines have an air cleaner cartridge. The cartridge is either flat or oval (see illustrations). In addition, some engines have a pre-cleaner . CAUTION Do not use pressurized air or solvents to clean cartridge. Pressurized air can damage cartridge; solvents will dissolve cartridge. Pre-cleaner T o clean pre-cleaner (if equipped), ...

  • Briggs & Stratton 600 SERIES - page 16

    16 Combustion Deposits We recommend that after every 100-300 hours you have an authorized Briggs & Stratton Service Dealer remove combustion deposits from the cylinder , cylinder head, top of piston, and around valves. Muffler Replacement parts for the muffler must be the same and installed in the same position as the original parts, otherwise ...

  • Briggs & Stratton 600 SERIES - page 17

    17 Storage Engines stored over 30 days need special attention. 1. T o prevent gum from forming in fuel system or on essential carburetor parts: a) if fuel tank contains oxygenated or reformulated gasoline (gasoline blended with an alcohol or an ether), run engine until it stops from lack of fuel, or b) if fuel tank contains gas oline, either run en ...

  • Briggs & Stratton 600 SERIES - page 18

    18 W arranty Information Briggs & Stratton Corporation (B&S), the Califor nia Air Resour ces Board (CARB) and the United States Environmental Pr otection Agency (U.S. EP A) Emissions Control System W arranty Statement (Owner’ s Defect W arranty Rights and Obligations) The California Air Resources Board (CARB), U.S. EP A and B&S are pl ...

  • Briggs & Stratton 600 SERIES - page 19

    19 LIMITED W ARRANTY Briggs & Stratton Corporation will repair or replace, free of charge, any part(s) of the engine that is defective in material or workmanship or both. T ransportation charges on parts submitted for repair or replacement under this warranty must be borne by purchaser . This warranty is effective for and is subject to the time ...

  • Briggs & Stratton 600 SERIES - page 20

    20 Briggs & Stratton welcomes warranty repair and apologizes to you for being inconvenienced. Any Authorized Service Dealer may perform warranty repairs. Most warranty repairs are handled routinely , but sometimes requests for warranty service may not be appropriate. For example, warranty would not apply if engine damage occurred because of mis ...

Manufacturer Briggs & Stratton Category Automobile Parts

Documents that we receive from a manufacturer of a Briggs & Stratton 600 SERIES can be divided into several groups. They are, among others:
- Briggs & Stratton technical drawings
- 600 SERIES manuals
- Briggs & Stratton product data sheets
- information booklets
- or energy labels Briggs & Stratton 600 SERIES
All of them are important, but the most important information from the point of view of use of the device are in the user manual Briggs & Stratton 600 SERIES.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Briggs & Stratton 600 SERIES, service manual, brief instructions and user manuals Briggs & Stratton 600 SERIES. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Briggs & Stratton 600 SERIES.

Similar manuals

A complete manual for the device Briggs & Stratton 600 SERIES, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Briggs & Stratton 600 SERIES by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Briggs & Stratton 600 SERIES.

A complete Briggs & Stratton manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Briggs & Stratton 600 SERIES - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Briggs & Stratton 600 SERIES, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Briggs & Stratton 600 SERIES, that we can find in the current document
3. Tips how to use the basic functions of the device Briggs & Stratton 600 SERIES - which should help us in our first steps of using Briggs & Stratton 600 SERIES
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Briggs & Stratton 600 SERIES
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Briggs & Stratton 600 SERIES in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Briggs & Stratton 600 SERIES?

Use the form below

If you did not solve your problem by using a manual Briggs & Stratton 600 SERIES, ask a question using the form below. If a user had a similar problem with Briggs & Stratton 600 SERIES it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (1)

Михаил

потерял листок с кодами...