English dropdown-ico

Manual EchoStar 9630

24 pages 1.25 mb
Download

Go to site of 24

Summary
  • EchoStar 9630 - page 1

    AutoScan Satellite System 9630 9630-LP Inst allation and Operating Instructions 1 1200 Hampshire Avenue South, Bloomington, MN 55438-2453 Phone: (800) 982-9920 Fax: (952) 922-8424 www .kingcontrols.com 1352 REV M Satellite Solutions for Mobile Markets AutoScan TM ...

  • EchoStar 9630 - page 2

    ...

  • EchoStar 9630 - page 3

    Page 1 IMPORT ANT! The satellite TV market is exp anding and changing. The information in this manual was accurate at the time of printing. If your King-Dome does not operate as outlined in this manual please call King Controls at ( 800) 982-9920 or visit our website at www .kingcontrols.com. T ABLE OF CONTENTS Section Contents Page 1. INTRODUCTION ...

  • EchoStar 9630 - page 4

    Page 2 The King-Dome AutoScan Satellite System includes 2 main components ( Fig. 1) . Dome (Antenna) Unit Located on the roof of the vehicle. The dish is covered by a protective dome that keeps operational component s free from the elements. Controller Located in the vehicle. Used to activate the system, position the dish, and access diagnostic inf ...

  • EchoStar 9630 - page 5

    Page 3 AZIMUTH: Circular rotation around the vehicle. (like a clock face: front of vehicle is 12:00, rear is 6:00) (Fig. 2) ELEV A TION: Angle in degrees measured from the ground plane (Fig. 3) . SIGNAL STRENGTH: Intensity of electronic signal received from the satellite transmission. SECTION 2 DEFINITION OF TERMS Fig. 2 Fig. 3 ...

  • EchoStar 9630 - page 6

    Page 4 KIT CONTENTS: 1. Unpack and identify all component s (Fig. 4) . SECTION 3 INST ALLA TION Fig. 4 TOOLS AND MA TERIALS REQUIRED: - drill and drill bit set - tape measure - 7/16” open end wrench (coax connections) - adhesive sealant (compatible with roof material) - appropriate fasteners to install all component s and wiring - 5/32” allen w ...

  • EchoStar 9630 - page 7

    Page 5 IMPORT ANT! The tie strap and sp acer , and the bolt s and washers must be removed from the bottom of the dome unit prior to inst allation. DO NOT REMOVE THE DOME COVER TO REMOVE THESE SHIPPING RESTRAINTS. YOU MUST PLUG THE SHIPPING BOL T HOLES WITH THE SUPPLIED PLUGS (A TT ACHED TO TIE STRAP SHIPPING RESTRAINT). 2. Remove and discard the ti ...

  • EchoStar 9630 - page 8

    Page 6 DOME LOCA TION 4. Select an area on the roof for the dome unit and the location where the wiring will enter the vehicle through the roof to the satellite receiver , controller , and 12 volt power source inside, using the following criteria: a) The shortest distance between the dome unit and the satellite receiver is most desirable. b) The do ...

  • EchoStar 9630 - page 9

    Page 7 5. Place dome unit on installation location chosen using the criteria discussed in the previous section. Shipping restraints must be removed (Fig. 5, Page 5) , and cable connections must AL W A YS be positioned facing rear of vehicle. 6. The dome unit must be positioned so that both feet on each side of the vehicle are equal distances from t ...

  • EchoStar 9630 - page 10

    Page 8 7. Mount the dome unit. Use the pre-drilled holes in the mounting feet as a guide to install the fasteners into the roof. Use additional fasteners whenever necessary . 8. T est that the dome unit is secure by pulling upward from each foot location. EXTERNAL WIRING 9. Plug external wire harness into wiring port on back of dome unit and tighte ...

  • EchoStar 9630 - page 11

    Page 9 1 1. Run wires from the back of the dome unit to the roof edge, then along edge to location where wiring will be fed into the vehicle. (If installing an optional second receiver , run auxiliary coax to location where it will enter the vehicle.) Secure wiring to roof every 12-18 inches (Fig. 10) . 12. Drill 3/4” hole through the roof and in ...

  • EchoStar 9630 - page 12

    Page 10 14. Inside vehicle, connect main coax from the dome unit directly to the “satellite in” port of the main receiver . Do not go through an “A-B” or any other switch, box, or booster . Connect auxiliary coax directly to optional second receiver . 15. Connect red and black two conductor wire to a power source and ground. Red connects to ...

  • EchoStar 9630 - page 13

    Page 1 1 SECTION 4 OPERA TION 1. T urn TV and satellite receiver on. 2. Go to the signal meter screen on TV . Choose transponder number: Dish Network #1 1 DIRECTV #19 3. Enter local ZIP code on signal meter screen to determine satellite elevation. If you do not know your local zip code, determine your elevation from the maps on p ages 12-14. 4. Pre ...

  • EchoStar 9630 - page 14

    Page 12 Elevation Map for DIRECTV 101 Find your location on the map. Use the elevation lines to determine your approximate elevation. ...

  • EchoStar 9630 - page 15

    Page 13 Elevation Map for Dish/DIRECTV 1 10 Find your location on the map. Use the elevation lines to determine your approximate elevation. ...

  • EchoStar 9630 - page 16

    Page 14 Elevation Map for Dish/DIRECTV 1 19 Find your location on the map. Use the elevation lines to determine your approximate elevation. ...

  • EchoStar 9630 - page 17

    Page 15 While the dish rotates, the direction of the dish in relation to the vehicle’ s position will be displayed on the controller as a clock number . (The windshield is always 12:00 o’clock: see Fig. 2, Page 3.) This information can be used to determine when the dish is close to pointing at the desired satellite. IMPORT ANT! Y ou must contin ...

  • EchoStar 9630 - page 18

    Store Satellite Position #1 1. Once locked onto a desired satellite, hold LEFT AND RIGHT arrows simultaneously until display flashes. 2. Hold LEFT arrow until 1P (Position 1) appears on display . Position #1 is stored in memory for this position. Store Satellite Position #2 3. Once locked onto the second desired satellite, hold LEFT AND RIGHT arrow ...

  • EchoStar 9630 - page 19

    Page 17 SECTION 6 DIAGNOSTICS ...

  • EchoStar 9630 - page 20

    Page 18 The King-Dome Satellite System has been designed to be maintenance and trouble free. For optimum signal strength, keep the dome clean from dirt, bugs, and other debris. Periodic washing of the dome with mild soap and water is recommended. If you plan on storing your vehicle for long periods of time, it is recommended that the system be put ...

  • EchoStar 9630 - page 21

    Page 19 Every King Controls Satellite System is thoroughly inspected and tested before leaving the factory . It is covered by a two year part s and one year labor limited warranty from the date of original purchase. This warranty does not cover installation and external wiring or refurbished unit s. Should any trouble develop during the warranty pe ...

  • EchoStar 9630 - page 22

    Page 20 Notes ...

  • EchoStar 9630 - page 23

    ...

  • EchoStar 9630 - page 24

    1 1200 Hampshire Avenue South, Bloomington, MN 55438-2453 Phone: (800) 982-9920 Fax: (952) 922-8424 www .kingcontrols.com AutoScan ...

Manufacturer EchoStar Category Satellite TV System

Documents that we receive from a manufacturer of a EchoStar 9630 can be divided into several groups. They are, among others:
- EchoStar technical drawings
- 9630 manuals
- EchoStar product data sheets
- information booklets
- or energy labels EchoStar 9630
All of them are important, but the most important information from the point of view of use of the device are in the user manual EchoStar 9630.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals EchoStar 9630, service manual, brief instructions and user manuals EchoStar 9630. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product EchoStar 9630.

Similar manuals

A complete manual for the device EchoStar 9630, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use EchoStar 9630 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of EchoStar 9630.

A complete EchoStar manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual EchoStar 9630 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the EchoStar 9630, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the EchoStar 9630, that we can find in the current document
3. Tips how to use the basic functions of the device EchoStar 9630 - which should help us in our first steps of using EchoStar 9630
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with EchoStar 9630
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of EchoStar 9630 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning EchoStar 9630?

Use the form below

If you did not solve your problem by using a manual EchoStar 9630, ask a question using the form below. If a user had a similar problem with EchoStar 9630 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)