English dropdown-ico

Manual Zenoah G455AVS

30 pages 0.36 mb
Download

Go to site of 30

Summary
  • Zenoah G455AVS - page 1

    The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. WARNING OWNER / OPERA T OR MANUAL CHAINSA WS 2812-93112 (901) G455A VS  IMPORTANT: Before operating your RedMax product, read this manual carefully and completely. ...

  • Zenoah G455AVS - page 2

    ...

  • Zenoah G455AVS - page 3

    Thank you for choosing our RedMax® chain saw . This manual will provide you with full understanding of the necessary instructions for assembly , operation and maintenance of the equipment. Please read it carefully before starting operation. For continued safe and reliable operation, use ONL Y original RedMax parts and accessories, Adhere to all no ...

  • Zenoah G455AVS - page 4

    1. For Safe Operation 2 1. Never operate a chain saw when you are fatigued, ill, or upset, or under the influence of medication that may make you drowsy, or if you are under the influence of alcohol or drugs. 2. Use safety footwear, snug fitting clothing and eye, hearing and head protection devices. 3. Always use caution when handling fuel. Wipe up ...

  • Zenoah G455AVS - page 5

    3 1 6 . Operate the chain saw only in well ventilated areas. Never start or run the engine inside a closed room or building. Exhaust fumes contain dangerous carbon monoxide. 1 7 . Do not operate a chain saw in a tree unless specially trained to do so. 18. Guard against kickback. Kickback is the upward motion of the guide bar which occurs when the s ...

  • Zenoah G455AVS - page 6

    The saw chain has very sharp edges. Use thick protective gloves for safety. 1. Loosen the nuts and remove the chain cover. 2. Install the attached spike to the power unit. 3. Gear the chain to the sprocket and, while fitting the saw chain around the guide bar, mount the guide bar to the power unit, Then adjust the position of chain tensioner nut on ...

  • Zenoah G455AVS - page 7

    ■ FUEL The RedMax engines are lubricated by oil specially formulated for air-cooled 2-cycle gasoline engine use. If RedMax oil is not available, use an anti-oxidant added quality oil expressly labeled for air-cooled 2-cycle engine use. RECOMMENDED MIXING RATIO GASOLINE 32 : OIL 1 Exhaust emission are controlled by the fundamental engine parameter ...

  • Zenoah G455AVS - page 8

    Starting engine 1 . Fill fuel and chain oil tanks respectively, and tighten the caps securely. 2. Tilt the switch lever upward. 3. While holding the throttle lever together with the throttle interlock, push in the side latch and release the throttle lever to hold it at the starting position. 4. Pull out the choke knob to the closed position. Note: ...

  • Zenoah G455AVS - page 9

    5 . While holding the saw unit securely on the ground, pull the starter rope vigorously. Do not start the engine while hanging the chain saw with a hand. The saw chain may touch your body. It's very dangerous. 6. When engine has ignited first, push in the choke knob and pull the starter again to start the engine. 7 . Allow the engine to warm u ...

  • Zenoah G455AVS - page 10

    1. H and L needles are restricted within the number of turn as shown below, because this engine conforms to 1995 California regulations for utility and lawn and garden equipment engines as applicable. H needle: 1 / 4 L needle: fixed 2 . Start engine and allow it to warm up in low speed for a few minutes. 3. Turn idle adjusting screw (T) countercloc ...

  • Zenoah G455AVS - page 11

    Chain brake This machine is equipped with an automatic brake to stop saw chain rotation upon occurrence of kickback while in saw cutting operation. The brake is automatically operated by inertial force which acts on the weight fitted inside the front gurd. This brake can also be operated manually with the front guard turned down to the guide bar. T ...

  • Zenoah G455AVS - page 12

    NOTE: • Before proceeding to your job, read “For Safe Operation” section. It is recommended to first practice sawing easy logs. This also helps you get accustomed to your unit. • It is not necessary to force the saw into the cut. Apply only light pressure while running the engine at full throttle. • Racing the engine with the chain seized ...

  • Zenoah G455AVS - page 13

    1. Decide the felling direction considering the wind, Iean of the tree, location of heavy branches, ease of job after felling, and other factors . 2. While clearing the area around the tree, arrange a good foothold and retreat path. 3. Make a notch cut one-third of the way into the tree on the felling side. 4. Make a felling cut from the opposite s ...

  • Zenoah G455AVS - page 14

    6. Maintenace Before cleaning, inspecting or repairing your unit, make sure that engine has stopped and is cool. Disconnect the spark plug to prevent accidental starting. A. Maintenance after each use 1. Air filter Dust on the cleaner surface can be removed by tapping a corner of the cleaner against a hard surface. To clean dirt in the meshes, spli ...

  • Zenoah G455AVS - page 15

    B. Periodical service points 1. Cylinder fins Dust clogging between the cylinder fins will cause overheating of the engine. Periodically check and clean the cylinder fins after removing the air cleaner and the cylinder cover. When installing the cylinder cover, make sure that switch wires and grommets are positioned correctly in place. 2. Fuel filt ...

  • Zenoah G455AVS - page 16

    A. Saw Chain It is very important for smooth and safe operation to keep the cutters always sharp. Your cutters need to be sharpened when: • Sawdust becomes powder-like. • You need extra force to saw in. • The cut way does not go straight. • Vibration increases. • Fuel consumption increases. Cutter setting standards: Be sure to wear safety ...

  • Zenoah G455AVS - page 17

    After every cutter has been set, check the depth gauge and file it to the proper level as illustrated. Be sure to round off the front edge to reduce the chance of kickback or tie-strap breakage. Make sure every cutter has the same length and edge angles as shown below. 15 ...

  • Zenoah G455AVS - page 18

    B. Guide Bar • Reverse the bar occasionally to prevent partial wear. • The bar rail should always be a square. Check for wear of the bar rail. Apply a ruler to the bar and the outside of a cutter. If a gap is observed between them, the rail is normal. Otherwise, the bar rail is worn. Such a bar needs to be corrected or replaced. 16 WARNING: Thi ...

  • Zenoah G455AVS - page 19

    Check fuel for water or incorrect mixture. Replace with proper fuel. Check engine for flooding. Remove and dry the spark plug. Repeat pulling starter with no choke. Remove spark plug and check for correct sparking. Replace with a new plug. 8. T roubleshooting Guide 17 Case 1. Starting failure: Check fuel for water or incorrect mixture. Replace with ...

  • Zenoah G455AVS - page 20

    9. Specifications Model G455AVS Power unit: Dis placement cc (cu. in.) 45.0 (2. 75) Fuel Mixture (Gasoline 32: Two-cycle oil 1) Fuel tank capacity cc (pints) 550 (1.17) Chain oil Motor oil SAE#10W-30 Oil tank capacity cc (pints) 260 (0.55) Carburetor Diaphragm type (Walbro WT) Ignition system C.D.I. with timing advance function Spark plug Champion ...

  • Zenoah G455AVS - page 21

    10. Parts List NOTE : 1. Use KOMATSU ZENOAH genuine parts as specified in the parts list for repair and/or replacement. 2. KOMATSU ZENOAH does not warrant the machines, which have been damaged by the use of any parts other than those specified by the company. 3. When placing parts orders for repair and/or replacement, check if the model name and th ...

  • Zenoah G455AVS - page 22

    10. Parts List : G455A VS 20 ...

  • Zenoah G455AVS - page 23

    21 ...

  • Zenoah G455AVS - page 24

    Key# Part Number Description Q'ty NOTE 1 2670-12112 CYLINDER 1 2 2810-14110 INLET PIPE 1 3 2817-14121 GASKET 1 ✻ 1 4 2670-14130 SCREW 2 5 2880-14150 GUIDE 1 6 2670-14311 BRACKET 1 7 2670-14320 SCREW 2 8 2880-14350 SPACER 1 9 2880-14360 GASKET 1 10 2670-14211 GASKET 1 ✻ 1 11 2850-14220 BOLT 4 12 2810-15220 BOLT 2 13 2850-15230 NUT 2 14 2812 ...

  • Zenoah G455AVS - page 25

    Key# Part Number Description Q'ty NOTE 107 2880-35211 DAMPER 2 108 3350-35170 BOLT 2 109 2880-35250 CAP 2 110 2810-31115 CYLINDER COVER 1 111 2670-14320 SCREW 5 112 3359-83340 LABEL 1 113 2810-83305 CLEANER COVER COMP. 1 114 3356-83322 KNOB 1 115 3388-83340 GASKET 1 116 2810-83500 CLEANER COMP. 1 117 2810-83520 SEAL 1 118 1600-33130 SCREW 1 11 ...

  • Zenoah G455AVS - page 26

    10. Parts List : G455A VS 24 ...

  • Zenoah G455AVS - page 27

    25 ✻ 1 Special tools (Opt. Part) Key# Part Number Description Q'ty NOTE 1 2812-81000 CARBURETOR ASS’Y – 2 3306-81380 SCREEN 1 3 2810-81120 COVER 1 4 3310-81130 SCREW 1 5 ––––––––– ––––––– – 6 2812-06020 GASKET KIT 1 7 ––––––––– ––––––– – 8 ––––––––– – ...

  • Zenoah G455AVS - page 28

    THE CALIFORNIA AIR RESOURCES BOARD AND KOMATSU ZENOAH Co. ARE PLEASED TO EXPLAIN THE EMISSION CONTROL SYSTEM WARRANTY ON YOUR 1995 AND LATER LAWN AND GARDEN EQUIPMENT ENGINE. IN CALIFORNIA, NEW UTILITY AND LAWN AND GARDEN EQUIPMENT ENGINES MUST BE DESIGNED, BUILT AND EQUIPPED TO MEET THE STATE'S STRINGENT ANTI-SMOG STANDARDS. KOMATSU ZENOAH Co ...

  • Zenoah G455AVS - page 29

    RedMax CHAIN SAW MODELS G455AVS 1-YEAR LIMITED WARRANTY KOMATSU ZENOAH AMERICA INC. 1505 Pavilion Place Suite A Norcross, Georgia 30093  EMISSION-RELATED PARTS, FOR TWO (2) YEARS FROM THE DATE OF ORIGINAL DELIVERY OF THE MODEL G455AVS UNIT, KOMATSU ZENOAH AMERICA INC. (THE COMPANY), THROUGH ANY RedMax DEALER, WILL REPAIR OR REPLACE, FREE OF CHAR ...

  • Zenoah G455AVS - page 30

    KOMATSU ZENOAH AMERICA INC. 1505 Pavilion Place Suite A Norcross, Georgia 30093  Printed in Japan ...

Manufacturer Zenoah Category Chainsaw

Documents that we receive from a manufacturer of a Zenoah G455AVS can be divided into several groups. They are, among others:
- Zenoah technical drawings
- G455AVS manuals
- Zenoah product data sheets
- information booklets
- or energy labels Zenoah G455AVS
All of them are important, but the most important information from the point of view of use of the device are in the user manual Zenoah G455AVS.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Zenoah G455AVS, service manual, brief instructions and user manuals Zenoah G455AVS. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Zenoah G455AVS.

Similar manuals

A complete manual for the device Zenoah G455AVS, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Zenoah G455AVS by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Zenoah G455AVS.

A complete Zenoah manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Zenoah G455AVS - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Zenoah G455AVS, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Zenoah G455AVS, that we can find in the current document
3. Tips how to use the basic functions of the device Zenoah G455AVS - which should help us in our first steps of using Zenoah G455AVS
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Zenoah G455AVS
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Zenoah G455AVS in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Zenoah G455AVS?

Use the form below

If you did not solve your problem by using a manual Zenoah G455AVS, ask a question using the form below. If a user had a similar problem with Zenoah G455AVS it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)