-
U-Line 2075 - page 1
P .O. Box 245040 M ilwaukee, WI 53224-9540 P hone: 414.354.0300 F ax: 414.354.7905 www .u-line.com Printed in U.S.A. P/N 30001 Échelon ™ U S E R M A N U A L ...
-
U-Line 2075 - page 2
U-LINE CORPORA TION LIMITED W ARRANTY U-Line Cor poration warr ants each U-Line product to be free from defects in materials and wor kmanship f or a per iod of one year from the date of purchase; and warrants the sealed system (consisting of the compressor , the condenser , the e vaporator , the hot gas bypass v alv e, the dryer and the connecting ...
-
U-Line 2075 - page 3
INTRODUCTION Congratulations on your purchase of the U-Line 2075DWRR drawer unit. A pioneer in the field for more than 40 years, U-Line is the world’ s number one manufacturer of built-in, under-counter ice making and spe- cialty refrigeration products. U-Line dedicates 100% of its research and development to these products. The result: U-Line te ...
-
U-Line 2075 - page 4
If you do not return your Product Registration Card, U-Line will use the date of sale to the U-Line distributor as the first date of warranty for your unit. Please also record the purchase date of your U- Line unit and your dealer ’ s name, address and telephone numbe r . Model Number: ______________________________________ Serial Number: _______ ...
-
U-Line 2075 - page 5
SAFETY PRECAUTIONS Do not attempt to install or operate your unit until you have read the safe- ty precautions in this manual. Safety items throughout this manual are labeled with a Danger , W arning or Caution based on the risk type. DEFINITIONS Danger means that failure to follow this safety statement may result in severe personal injur y or deat ...
-
U-Line 2075 - page 6
GENERAL PRECAUTIONS RISK OF CHILD ENTRAPMENT . Before you throw away your old refrigerator or freezer , take off the doors and leave shelves in place so that children may not easily climb inside. • Never attempt to repair or perfor m maintenance on the unit until the electricity has been disconnected. • Altering, cutting of power cord, removal ...
-
U-Line 2075 - page 7
INST ALLATION SITE PREP ARATION Y our U-Line drawer unit must be installed under a counter or in a wall. The unit is designed so it can be installed next to a wall, because the crisper can be accessed from either side. 1. Position the unit on a flat, level surface, capable of suppor ting the entire weight of the unit. Remember the unit will be sign ...
-
U-Line 2075 - page 8
Y our U-Line Drawer unit is designed so it can be installed next to the wall on either side because the crisper can be accessed from either side (Figure 1, 2). Figure 1 – Right wall installation The anti-tip kit must be installed on this unit before it is used. Never use the drawers as steps or a shelf to support more than the drawers’ content. ...
-
U-Line 2075 - page 9
Figure 2 – Left wall installation Figure 3 – Front Clearance DW R003 24" MIN. CABINET OR W ALL DW R002 7 ...
-
U-Line 2075 - page 10
4. Position the unit to allow free air flow through the front grille (Figure 4). Figure 4 LEVELING THE UNIT It is impor tant that the unit is level. All Échelon™ Series units are equipped with adjustable feet for leveling and height adjustment (Figure 5). To level the unit: 1. Adjust all four leveling feet evenly so that the top of the cabinet i ...
-
U-Line 2075 - page 11
4. Place the unit in position where it is to be installed. Re-check cabi- net height and levelness (Figure 6) and adjust if necessar y . Figure 5 Figure 6 DW R021 LEVEL TWO PLACES DWR005 RAISE LOWER 9 ...
-
U-Line 2075 - page 12
10 User’ s Manual BUIL T -IN INST ALLATION Y our U-Line product is designed for built-in installation only . When built-in, it does not require additional air space for the top, sides, or rear . However , the front grille must NOT be obstructed. NOTE To ease unit installation and removal, it is r ecommended that the cabinet rough opening dimensio ...
-
U-Line 2075 - page 13
Figure 7 CUSTOM DRAWER P ANELS T wo types of custom drawer panels can be installed on your U-Line unit to harmonize with or accent the surrounding decor . FULL OVERLA Y DRAWER P ANEL Full overlay drawer panels completely cover the drawer frames and han- dle to give a built-in appearance. See T able 1 for full overlay drawer panel dimensions (Figure ...
-
U-Line 2075 - page 14
OVERLA Y PANEL KIT P ARTS • The total weight of both drawer panels must not weigh more than 20 lbs. • The thickness of the drawer panel must be 3/4". Remove existing drawer front fr om cabinet: 1. Open drawer . Pull door gasket (Figure 8) out of the groove (top edge of door only). Star t in the mid- dle and pull outward, moving toward the ...
-
U-Line 2075 - page 15
13 5. On a clean surface, place the wood panel face down and tape the existing drawer panel (removed in step 3) on the back of the wood panel (Figure 10) and drill the five (5) holes (5/32" drill 3/8" deep) through the coated steel panel and 3/8" into the wood panel according to the diagram (Figure 11). Remove tape from the draw- er ...
-
U-Line 2075 - page 16
User’ s Manual 14 6. Attach the drawer panel to the wood panel using #10 x 5/8" (P/N 42121) wood screws and nylon spacers (P/N 42120). The nylon spacers fit between the wood panel and the drawer panel as shown (Figure 12). Figure 12 Drawer panel and wood panel must be aligned pr operly or drawer will not operate correctly . Assembling the dr ...
-
U-Line 2075 - page 17
15 CUSTOM INSERT DRAWER PANEL Custom drawer panels can be inser ted into the drawer frames to match the surrounding decor . Custom drawer panels can be flat or raised, as long as the maximum panel thickness where inser ted into the drawer reveal (channel) is 1/4" thick. For raised panels, the depth of the reveal is 1/4" on all four sides. ...
-
U-Line 2075 - page 18
Install the custom inser t as follows: Insert edges may be SHARP! Use care when installing. 1. Open drawer . Pull drawer gas- ket out of groove (top edge of drawer only). Star t in the mid- dle and pull outward, moving toward the edge (Figure 14). This may take some force, be careful. 2. Remove the three screws behind the gasket. Carefully pull the ...
-
U-Line 2075 - page 19
5. Slide custom drawer panel inser t into 1/4" channel in drawer front. 6. Attach the full handle to the lower handle using the 3 screws removed in step 2. 7. Holding drawer gasket out of the way , replace handle on drawer making sure it is seated properly on inser t and that screw holes line up. 8. Install two screws removed in step 3. 9. Sta ...
-
U-Line 2075 - page 20
18 User’ s Manual TEMPERA TURE CONTROLLER Figure 17 The temperature controller (Figure 17) is located in the top drawer . It consists of an LED display , two LED status indicator lights and three touch pad buttons. The LED display shows the temperature set point and is calibrated in degrees Fahrenheit. The controller is factor y programmed for a ...
-
U-Line 2075 - page 21
19 DRAWERS The drawers should only be removed for ser vicing by a trained and cer tified repair person. TOP STORAGE BIN Grasp the bin handle and slide back- ward to access the contents below (Figure 18). The bin may be completely removed for cleaning once it clears the guides on each side of the drawer . If heavy items are stored in bin, push front ...
-
U-Line 2075 - page 22
20 User’ s Manual OPERATION DRAWER ORGANIZER Adjust the drawer organizer to compensate for different size bottles or items. The organizer can be used in either drawer , but is shipped from the factor y in the top drawer . The organizer may be adjusted left-to-right or front-to-back as required. When adjusting the organizer , open the drawer fully ...
-
U-Line 2075 - page 23
21 Be sure that items stored in the rear of the top drawer do not interfere with the sliding operation of the stor- age bin (Figure 21). T all items such as milk jugs can be stored toward the front of the drawer as long as they do not interfere with the closing of the drawer . T aller items can be stored on their side in the storage bin. The storag ...
-
U-Line 2075 - page 24
LIGHT BULB REPLACEMENT Light bulb replacement in the Échelon™ series is simple. 1. Remove the light housing cover by sliding the cover toward the tab, swinging the end opposite the tab down and pulling down and away (Figure 22). 2. Replace bulb with genuine U-Line #31317 replacement. U-Line P/N 31317 Do not use any other replacement bulb than th ...
-
U-Line 2075 - page 25
23 CLEANING & MAINTENANCE Periodic cleaning and proper maintenance will ensure efficiency , top per- formance, and long life. The maintenance inter vals listed are based on normal conditions. Y ou may want to shor ten the inter vals if you have pets, the unit is used outdoors, or other special considerations. EXTERIOR CLEANING — AS REQUIRED T ...
-
U-Line 2075 - page 26
24 User’ s Manual 5. Reconnect power to the unit. • DO NOT use solvent cleaning agents or abrasives on the interior . These cleansers may damage or discolor the interior . CONDENSER CLEANING - EVERY 3 MONTHS Disconnect electric power to the unit before cleaning the condenser . To remove and replace the grille for access to the condenser fins fo ...
-
U-Line 2075 - page 27
25 DO NOT touch the condenser fins. The condenser fins are SHARP and can be easily damaged. 3. Clean the condenser coil using a soft brush with a “combing” action or vacuum cleaner . Do not touch the condenser coil. 4. Position the grille to align the screw holes with the cabinet. 5. Inser t the grille screws and tighten. Do not over tighten. S ...
-
U-Line 2075 - page 28
26 User’ s Manual TROUBLESHOOTING BEFORE CALLING FOR SERVICE If the unit appears to be malfunctioning, read through NORMAL OPERA- TION first. If the problem persists, check the TROUBLESHOOTING GUIDE. Locate the problem in the guide and refer to the cause and its remedy before calling for ser vice. The problem could be something ver y simple which ...
-
U-Line 2075 - page 29
27 Problem Possible Cause Remedy The unit is not T emperature not set Set temperature controller to cold enough cold enough. colder setting. See page 18. (continued) Allow 24 hours for temperature to stabilize. Noise during Cer tain sounds Soft sounds from the operation. are normal. compressor and fan motor will be heard. Fresh food Drawer not clos ...
-
U-Line 2075 - page 30
28 User’ s Manual ...
-
U-Line 2075 - page 31
P .O. Box 245040 M ilwaukee, WI 53224-9540 P hone: 414.354.0300 F ax: 414.354.7905 www .u-line.com Printed in U.S.A. P/N 30001 (Rev. 5/03) Échelon ™ U S E R M A N U A L ...
Do you have a question concerning U-Line 2075?
Use the form below
If you did not solve your problem by using a manual U-Line 2075, ask a question using the form below. If a user had a similar problem with U-Line 2075 it is likely that he will want to share the way to solve it.