Manual Majestic ODGSR36ANAU

18 pages 0.52 mb
Download

Go to site of 18

Summary
  • Majestic ODGSR36ANAU - page 1

    MAJESTIC OUTDOOR GAS FIREPLACE Model: ODGSR36ANAU & ODGSR36APAU Installation and Operating Instructions Page 1 of 18 ...

  • Majestic ODGSR36ANAU - page 2

    CONTENTS Part 1: For Your Safety Part 2: Installation Instructions • General Information • Fireplace Dimensions • Clearance to Combustibles • Mantels • Mantel Chart • Hearth • Framing and Finishing • Final Finishing • Gas Specifications • Gas Inlet and Burner Pressures • High Elevations • Valve Access • Gas Fitting Line In ...

  • Majestic ODGSR36ANAU - page 3

    Part 1: For Your Safety For your safety do not operate this appliance before reading this instruction book. WARNING: Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage. For assistance or additional information consult with Raypak Australia, your Raypak distributor, qualified installer or accr e ...

  • Majestic ODGSR36ANAU - page 4

    GENERAL INFORMATION FOR SAFE INSTALLATION AND OPERATION OF YOUR GAS APPLIANCE PLEASE NOTE THE FOLLOWING: a) This appliance gives o ff high temperatures and should be located out of high traffic areas and away from outdoor furn iture and blinds or curtains. b) Children and adults should be ale rted to th e hazards of high surf ace temperatures of th ...

  • Majestic ODGSR36ANAU - page 5

    Ventilation Requirements Adequate combustion and ventilation air must be provided. The fl ow of combustion and ventilation air MUST NOT be obstructed. NOTE: THIS APPLIANCE MUST NOT BE INSTALLED OR USED IND OORS. This appliance shall only be used in an above ground, open-air sit uation with natural ventilation, without stagn a nt areas, where ga s l ...

  • Majestic ODGSR36ANAU - page 6

    See examples below of Outdoor Areas: Figure 1: Overall and framing dimensions. Page 6 of 18 ...

  • Majestic ODGSR36ANAU - page 7

    Clearance to Combustibles (Refer Figure 1) Top framing …………………………………………………… 0 mm to standoff spacer Bottom……………………………… ……………………………0 mm Side framing …………………………………………… ……..0 mm to standoff spacer Back framing ………………? ...

  • Majestic ODGSR36ANAU - page 8

    : A minimum of 100mm above th e fireplace must be non- combustible material (eg fibre cement sheeting). Figure 2a Figure 2b Framing and Finishing Warning: Check appliance to make sure it is levelled and properly positioned. The appliance should on ly be mounted on th e following surfaces: • A flat combustible (burnable) surface. • A raised wood ...

  • Majestic ODGSR36ANAU - page 9

    Figure 3 Finishing CAUTION: All joints between the fini shed wall and the appliance surround (top and sides) may be sealed only with a non-combustible material. Only non-combustible material can be applied as facing to the appliance surround as per Figures 2a and 2b. Gas Specification (always refer to appliance Data plate) GAS SPECIFICATION MODEL G ...

  • Majestic ODGSR36ANAU - page 10

    Valve Access Valve can be accessed in one of two ways: 1. Remove the front panel just below the fr ont of the hea rth pan. This is accomplished by lifting on the panel. To replace the valve access panel line up the two pins with the hole s in the surround bottom and push the panel over the hearth pan. (Refer Figure 4) 2. Lift the brick with Majesti ...

  • Majestic ODGSR36ANAU - page 11

    Part 3: Operating Instructions Log Installation Warning: As with all plastic bags, th ese bags are not toys and should always be kept away from children and infants. 1. Remove logs from packaging. 2. Place left rear log on rear support. Ensure th at log is firmly positioned and there is no side to side movement. (Refer to Figure 11) 3. Carefully pl ...

  • Majestic ODGSR36ANAU - page 12

    Flame Adjustment For units equipped with Hi/Lo valves, flame adjustment is achieved by rota ting the Hi/L o adjustment knob located near the centre of the gas control valve. Figure 12 – SIT 820 Gas Control Knob Flame Characteristics It is important to periodic ally perform a visual check of the pilot and the burner flames (refer Figures 13 & ...

  • Majestic ODGSR36ANAU - page 13

    Page 13 of 18 ...

  • Majestic ODGSR36ANAU - page 14

    Troubleshooting Nova SIT 820 Standing Pilot S T A R T C H E C K Gas supply connected Gas Supply On Shut off valve open N o Lockout has engaged. Wait 60 seconds and try again. Piezo not tight enough for good ground. Y es For spark at electrode while depressing Piezo 1/8” gap to pilot hood required. Gas Supply On N o All wiring connections. Replace ...

  • Majestic ODGSR36ANAU - page 15

    Maintenance Burner and burner compartment It is important to keep the burner and the burner compar tment clean. At least once a year the logs should be removed and the burner comp a rtment vacuumed and wiped out. Remove and replace the logs as per the instructions in this ma nual. Always handle the logs with care as th ey are fragile and may also b ...

  • Majestic ODGSR36ANAU - page 16

    Parts List Page 16 of 18 ...

  • Majestic ODGSR36ANAU - page 17

    Part 6: Warranty LIMITED LIFETIME WARRANTY PRODUCT COVERED BY THIS WARRANTY All Vermont Castings gas stoves, gas inserts, and gas fi replaces, and all Majestic or Northern Flame brand gas fireplaces equipped with an Insta-Flame Ceramic Burner or steel tube burner. BASIC WARRANTY CFM Specialty H ome Products (hereinafter ref erred to coll ectively a ...

  • Majestic ODGSR36ANAU - page 18

    IF WARRANTY SERVICE IS NEEDED... 1) Contact your supplier. Make sure you hav e your warranty, yo ur sales receipt, and the model/serial number of your Raypak Majestic Gas Log fire. 2) DO NOT ATTEMPT TO DO ANY SERVICE WORK YOURSELF Distributed By: Raypak Australia 39 Koornang Road Scoresby Victoria 3179 Ph: 03 9757 3333 Fax: 03 9757 3350 For Service ...

Manufacturer Majestic Category Outdoor Fireplace

Documents that we receive from a manufacturer of a Majestic ODGSR36ANAU can be divided into several groups. They are, among others:
- Majestic technical drawings
- ODGSR36ANAU manuals
- Majestic product data sheets
- information booklets
- or energy labels Majestic ODGSR36ANAU
All of them are important, but the most important information from the point of view of use of the device are in the user manual Majestic ODGSR36ANAU.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Majestic ODGSR36ANAU, service manual, brief instructions and user manuals Majestic ODGSR36ANAU. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Majestic ODGSR36ANAU.

Similar manuals

A complete manual for the device Majestic ODGSR36ANAU, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Majestic ODGSR36ANAU by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Majestic ODGSR36ANAU.

A complete Majestic manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Majestic ODGSR36ANAU - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Majestic ODGSR36ANAU, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Majestic ODGSR36ANAU, that we can find in the current document
3. Tips how to use the basic functions of the device Majestic ODGSR36ANAU - which should help us in our first steps of using Majestic ODGSR36ANAU
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Majestic ODGSR36ANAU
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Majestic ODGSR36ANAU in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Majestic ODGSR36ANAU?

Use the form below

If you did not solve your problem by using a manual Majestic ODGSR36ANAU, ask a question using the form below. If a user had a similar problem with Majestic ODGSR36ANAU it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)