English dropdown-ico

Manual Audiovox AS 9075a

16 pages 0.31 mb
Download

Go to site of 16

Summary
  • Audiovox AS 9075a - page 1

    128-6602 1 of 16 Model AS 9075a Installation Manual Remote Start Upgrade Module Installation Instructions This Unit Is Intended For Installation In V ehicles With 12 V olt Negative Ground Electrical Systems, Gasoline or Diesel With T rue T ach Reference And Automatic T ransmissions Only . Kit Contents (1) -Control Module (1) - Multi Pin Input/Outpu ...

  • Audiovox AS 9075a - page 2

    128-6602 2 of 16 This Remote Start/Keyless Entry Upgrade System is designed to be used with Automatic Transmission Vehicles Only! The unit provides a selectable ignition control that allows a 10 second output for glow plug preheat which may be required for certain diesel vehicles, (see selectable feature #5). If the diesel engine has a instant fire ...

  • Audiovox AS 9075a - page 3

    128-6602 3 of 16 Remote Start Connection WIRING THE 6 PIN MAIN POWER HARNESS: RED w/ WHITE Trace Wire: + 12 volts Battery 1 Source Connect this wire to a + 12 VDC constant source found at the vehicle's ignition switch using the 30 Amp fuse and holder provided. This wire provides power for the control circuit as well as the ignition 1 and ignit ...

  • Audiovox AS 9075a - page 4

    128-6602 4 of 16 BLUE Wire: Ignition 1 Output Connect this wire to the ignition 1 wire from the ignition switch. This wire will show +12 volts when the ignition key is turned to the to the "ON" or "RUN" and the "ST AR T" or CRANK" positions, and will have 0 volts when the key is turned to the "OFF" and & ...

  • Audiovox AS 9075a - page 5

    128-6602 5 of 16 the Black w/ White wire is at open circuit through the control switch, the remote starter is disabled. Connect the Black w/ White tracer wire to one of the wires from the back of the previously mounted control switch. Connect the remaining wire of the control switch to chassis ground. Always try to mount the switch so that the ON p ...

  • Audiovox AS 9075a - page 6

    128-6602 6 of 16 This wire should be connected to the ignition input of the alarm system. The Yellow w/ Black wire output will allow you to remote start the vehicle while leaving the alarm armed, and to lock/ unlock the doors while running under control of the remote start unit. (2) WHITE Wires: Parking Light Flasher These wires are the COMMON and ...

  • Audiovox AS 9075a - page 7

    128-6602 7 of 16 NOTE: These wires are typically White w/ Black trace and Violet w/ Y ellow trace, however in later model Cadillacs, they are run through an orange sleeve, and are either both Black, both Y ellow , or both White wires. Consult the factory service manual for additional information. 3. Connect the Light Blue Wire from the Remote Start ...

  • Audiovox AS 9075a - page 8

    128-6602 8 of 16 8 T achometer Input W iring Detail WIRING THE 4 PIN AUXILIARY OUTPUT HARNESS The auxiliary 4 pin connector provides low current outputs to control various functions in the vehicle during different stages of the Remote Start unit's operation. Understanding these outputs and the time in which they occur will allow you to determi ...

  • Audiovox AS 9075a - page 9

    128-6602 9 of 16 9 1. Programmable Features: Feature LtsFlash1X Lts Flash 2X Lts Flash 3X Lts Flash 4X Default 1 Run Time 5 Min. 10 Min. 15Min. 20 Min. 10 Min 2 Park Lights On Steady Flash Steady 3 Input Check Voltage Tach Tach 4 Voltage Level > 0.5V B4 Start < 0.5V B4 Start > 0.5 5 Ign. 2 Crank O f f On On 6 Diagnostics O ff On O f f 7 Cr ...

  • Audiovox AS 9075a - page 10

    128-6602 10 of 16 This Remote Car Starter will learn the tach rate of most vehicles single ignition coils, multiple coil packs, and or single injector. To learn tach; 1. Start with the ignition switch in the "OFF" position and the programming switch in the "ON" position. 2. Turn the ignition key to the ON position. 3. Flip the p ...

  • Audiovox AS 9075a - page 11

    128-6602 11 of 16 Multi Coil Pack Adaptor: (Optional) The multi coil pack adaptor is designed for use with vehicles having multiple ignition coils where a single point tach signal is unavailable. T o use the adaptor , the Green/Black wires must connect to the negative side of the ignition coil(s). 1. For vehicles utilizing independent coils per cyl ...

  • Audiovox AS 9075a - page 12

    128-6602 12 of 16 12 TESTING YOUR INST ALLA TION: CAUTION!! The following procedure must be performed after the installation of an Audiovox Remote Start Device. It is the responsibility of the installing technician to complete these tests. Failure to test the unit in the following manner may result in personal injury , property damage, or both. HOO ...

  • Audiovox AS 9075a - page 13

    128-6602 13 of 16 ignition switch side of the Neutral Start Switch. If the vehicle you are working on does not have an Electrical Neutral Safety Switch, i t will be necessary to reconfigure the Re m ote Starts Wiring t o accommodate this vehicle. The information concerning the Mechanical Neutral Safety Switch provided below will help you to determi ...

  • Audiovox AS 9075a - page 14

    128-6602 14 of 16 margin of safety and will prevent the vehicle with a Mechanical Neutral Start Switch from starting in gear . WE ADVISES THA T YOU MAINT AIN THE F ACTOR Y CIRCUIT WHENEVER POSSIBLE. The following two circuits may be used only if the above circuit is not available. NOTE: When completing an installation using either of the following ...

  • Audiovox AS 9075a - page 15

    128-6602 15 of 16 T o connect to the key in sensor circuit as shown for method 2: A . Locate the control wire that connects the drivers door pin switch to the key in sensor switch. B . Cut this wire and connect the ignition cylinder side to chassis ground. C . Locate the key in sensor switch wire that connects the chime module to the ignition cylin ...

  • Audiovox AS 9075a - page 16

    128-6602 16 of 16 16 © 2003 Audiovox Electronics Corp., Hauppauge, N.Y . 1 1788 128-6602 ...

Manufacturer Audiovox Category Remote Starter

Documents that we receive from a manufacturer of a Audiovox AS 9075a can be divided into several groups. They are, among others:
- Audiovox technical drawings
- AS 9075a manuals
- Audiovox product data sheets
- information booklets
- or energy labels Audiovox AS 9075a
All of them are important, but the most important information from the point of view of use of the device are in the user manual Audiovox AS 9075a.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Audiovox AS 9075a, service manual, brief instructions and user manuals Audiovox AS 9075a. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Audiovox AS 9075a.

Similar manuals

A complete manual for the device Audiovox AS 9075a, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Audiovox AS 9075a by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Audiovox AS 9075a.

A complete Audiovox manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Audiovox AS 9075a - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Audiovox AS 9075a, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Audiovox AS 9075a, that we can find in the current document
3. Tips how to use the basic functions of the device Audiovox AS 9075a - which should help us in our first steps of using Audiovox AS 9075a
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Audiovox AS 9075a
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Audiovox AS 9075a in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Audiovox AS 9075a?

Use the form below

If you did not solve your problem by using a manual Audiovox AS 9075a, ask a question using the form below. If a user had a similar problem with Audiovox AS 9075a it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)