English dropdown-ico

Manual Vulcan-Hart GHF90

24 pages 0.19 mb
Download

Go to site of 24

Summary
  • Vulcan-Hart GHF90 - page 1

    INSTALLATION & OPERATION MANUAL GHF SERIES HEAVY DUTY RANGE MATCHING GAS FRYERS MODELS GHF91 ML-135503 GHF90 ML-135504 FORM 35609 Rev. A (03-05) GHF91 For additional information on Vulcan-Hart or to locate an authorized parts and service provider in your area, visit our website at www.vulcanhart.com VULCAN-HART DIVISION OF ITW FOOD EQUIPMENT GR ...

  • Vulcan-Hart GHF90 - page 2

    – 2 – © VULCAN-HART, 2005 IMPORTANT FOR YOUR SAFETY THIS MANUAL HAS BEEN PREPARED FOR PERSONNEL QUALIFIED TO INSTALL GAS EQUIPMENT, WHO SHOULD PERFORM THE INITIAL FIELD START-UP AND ADJUSTMENTS OF THE EQUIPMENT COVERED BY THIS MANUAL. POST IN A PROMINENT LOCATION THE INSTRUCTIONS TO BE FOLLOWED IN THE EVENT THE SMELL OF GAS IS DETECTED. THIS I ...

  • Vulcan-Hart GHF90 - page 3

    – 3 – Installation, Operation and Care of MODEL GHF91 GAS FR YERS PLEASE KEEP THIS MANU AL FOR FUTURE REFERENCE GENERAL Your Vulcan-Hart Gas Fryer is produced with quality workmanship and material. Proper installation, usage and maintenance will result in many years of satisfactory performance. It is suggested that you thoroughly read this enti ...

  • Vulcan-Hart GHF90 - page 4

    – 4 – LOCATION CAUTION: The equipment area must be kept free and clear of combustible substances. Installation clearances: COMBUSTIBLE NONCOMBUSTIBLE CONSTRUCTION CONSTRUCTION Back: 6" (152 mm) 0 " Right Side: 6" (152 mm) 0 " Left Side: 6" (152 mm) 0 " The installation location must allow adequate clearances for se ...

  • Vulcan-Hart GHF90 - page 5

    – 5 – Fig. 1 Fryers Mounted on Optional Casters Fryers mounted on casters must use a flexible connector (NOT SUPPLIED BY VULCAN) that complies with the Standard for Connectors of Movable Gas Appliances, ANSI-Z21.69 • CSA6.16 and a quick-disconnect device that complies with the Standard for Quick-Disconnect Devices for Use With Gas Fuel, ANSI- ...

  • Vulcan-Hart GHF90 - page 6

    – 6 – Front Gas Connection for Battery Installations Codes require that a gas shutoff valve be installed in the gas line ahead of the fryer and battery of equipment. The gas manifold of a battery lineup of which the fryer is a part, must be installed using a regulator design-certified by a nationally recognized testing lab to the applicable ANS ...

  • Vulcan-Hart GHF90 - page 7

    – 7 – OPERA TION WARNING: HOT OIL AND PARTS CAN CAUSE BURNS. USE CARE WHEN OPERATING, CLEANING AND SERVICING THE FRYER. WARNING: SPILLING HOT OIL CAN CAUSE SEVERE BURNS. DO NOT MOVE FRYER WITHOUT DRAINING ALL OIL FROM THE TANK. Tank warranty may be voided by improper operation. Turn gas valve off when draining or filling. BEFORE FIRST USE Clean ...

  • Vulcan-Hart GHF90 - page 8

    – 8 – LIGHTING THE PILOT 1 . Turn thermostat OFF. Thermostat is located behind the door (Fig. 2). 2 . Turn gas control valve knob to OFF/PILOT (Fig. 3). Wait 5 minutes for unburned gas to vent. 3 . Push gas control knob in (Fig. 3). 4 . While still holding knob in, light the pilot with a lit taper. Continue to depress knob for 30 seconds, then ...

  • Vulcan-Hart GHF90 - page 9

    – 9 – HIGH LIMIT DEVICE A high limit device will shut the fryer down if the oil overheats. DO NOT relight pilot until oil temperature has lowered to at least 350°F (176°C). If the situation persists, contact your local Vulcan-Hart authorized servicer. DAILY FILTERING Turn the gas valve off when draining or filling the fryer. Allow frying comp ...

  • Vulcan-Hart GHF90 - page 10

    – 10 – CLEANING CAUTION: Do not spray with hose or steam cleaner. Doing so will cause extensive damage (not covered under warranty). Daily Clean your fryer regularly. If regular cleaning is neglected, grease will be burned on and discolorations may form. These may be removed by washing with detergent or soap and water. Particularly stubborn dis ...

  • Vulcan-Hart GHF90 - page 11

    – 11 – Fingerprints Fingerprints are sometimes a problem on highly polished surfaces of stainless steel. They can be minimized by applying a cleaner that will leave a thin, oily or waxy film. Wipe cleaner on and remove excess with a soft dry cloth. After using, subsequent fingerprints will usually disappear when wiped lightly with a soft cloth ...

  • Vulcan-Hart GHF90 - page 12

    – 12 – MAINTENANCE WARNING: HOT OIL AND PARTS CAN CAUSE BURNS. USE CARE WHEN OPERATING, CLEANING AND SERVICING THE FRYER. WARNING: SPILLING HOT OIL CAN CAUSE SEVERE BURNS. DO NOT MOVE FRYER WITHOUT DRAINING ALL OIL FROM THE TANK. VENT Annually, when the fryer is cool, check the flue and clear any obstructions. SERVICE AND PARTS INFORMATION To o ...

  • Vulcan-Hart GHF90 - page 13

    – 12 – F35609 Rév. A (03-05) IMPRIMÉ AUX É-U. ENTRETIEN AVERTISSEMENT : LORSQU’ILS SONT CHAUDS, L’HUILE CHAUDE ET LES COMPOSANTS PEUVENT CAUSER DES BRÛLURES. EXERCER UNE EXTRÊME PRUDENCE LORS DE L’EXPLOITATION ET DE L’ENTRETIEN DE LA FRITEUSE. AVERTISSEMENT : LES RENVERSEMENTS D’HUILE CHAUDE PEUVENT CAUSER DE GRAVES BRÛLURES. NE ...

  • Vulcan-Hart GHF90 - page 14

    – 11 – Empreintes de doigts Les empreintes de doigts constituent parfois un problème sur les surfaces en acier inoxydable très polies. Pour en minimiser la formation, appliquer un produit de nettoyage qui laissera un léger film d’huile ou de cire. Étendre le produit sur la surface et enlever l’excédent à l’aide d’un chiffon doux e ...

  • Vulcan-Hart GHF90 - page 15

    – 10 – NETTOYAGE ATTENTION : Ne pas nettoyer l’appareil à la vapeur ou au moyen d’un tuyau d’arrosage, ce qui risque de causer de graves dommages (non couverts par la garantie). Nettoyage quotidien Nettoyer la friteuse régulièrement, faute de quoi la graisse risque de brûler et de décolorer l’intérieur du bac à frire. En cas de d ...

  • Vulcan-Hart GHF90 - page 16

    – 9 – THERMOSTAT DE SÉCURITÉ Un thermostat de sécurité assure l’arrêt de la friteuse et l’extinction de la veilleuse lorsque l’huile dépasse la température sécuritaire. NE PAS rallumer la veilleuse tant que la température de l’huile n’est pas inférieure à 176 °C (350 °F), autrement communiquer immédiatement avec la succu ...

  • Vulcan-Hart GHF90 - page 17

    – 8 – ALLUMAGE DE LA VEILLEUSE 1. Régler le thermostat (placé derrière la porte) à OFF (arrêt) (Fig. 2). 2. Tourner le levier de commande du gaz jusqu’à OFF/PILOT (arrêt de la veilleuse) (Fig. 3). Attendre 5 minutes pour permettre l’échappement des gaz non brûlés. 3. Enfoncer le levier de commande du gaz (Fig. 3). 4. Toujours en a ...

  • Vulcan-Hart GHF90 - page 18

    – 7 – FONCTIONNEMENT AVERTISSEMENT: LORSQU’ILS SONT CHAUDS, L’HUILE CHAUDE ET LES COMPOSANTS PEUVENT CAUSER DES BRÛLURES. EXERCER UNE EXTRÊME PRUDENCE LORS DE L’EXPLOITATION ET DE L’ENTRETIEN DE LA FRITEUSE. AVERTISSEMENT: LES RENVERSEMENTS D’HUILE CHAUDE PEUVENT CAUSER DE GRAVES BRÛLURES. NE PAS DÉPLACER LA FRITEUSE SANS AVOIR AU ...

  • Vulcan-Hart GHF90 - page 19

    – 6 – Branchement du gaz avant pour installations de friteuses en batterie Conformément aux exigences des codes, installer un robinet d’arrêt dans la conduite de gaz, en amont de l’appareil et de l’équipement en batterie. La tubulure d’alimentation en gaz d’un alignement d’appareils en batterie dont la friteuse fait partie doit c ...

  • Vulcan-Hart GHF90 - page 20

    – 5 – Fig. 1 NIVELAGE DE LA FRITEUSE Installations de friteuses autonomes Une fois le branchement du gaz effectué, déposer un niveau à bulle d’air sur le dessus de la friteuse. Régler les pieds pour s’assurer que l’appareil est de niveau d’avant vers l’arrière, puis latéralement dans la position d’installation finale. Installa ...

  • Vulcan-Hart GHF90 - page 21

    – 4 – EMPLACEMENT ATTENTION : Aucune substance combustible ne doit se trouver à proximité de l’appareil. Dégagement requis lors de l’installation : CONSTRUCTION CONSTRUCTION COMBUSTIBLE INCOMBUSTIBLE Arrière : 152 mm (6 po) 0" Côté droit : 152 mm (6 po) 0" Côté gauche : 152 mm (6 po) 0" Installer la friteuse dans un e ...

  • Vulcan-Hart GHF90 - page 22

    – 3 – INST ALLA TION, ENTRETIEN ET FONCTIONNEMENT FRITEUSE A U GAZ MODÈLE GHF91 DOCUMENT À CONSER VER EN CAS DE BESOIN. GÉNÉRALITÉS Les friteuses au gaz Vulcan-Hart sont fabriquées avec le plus grand soin et à partir des meilleurs matériaux. Leur installation et entretien appropriés permettront d’en obtenir un rendement optimal penda ...

  • Vulcan-Hart GHF90 - page 23

    – 2 – © COMPAGNIE VULCAN-HART, 2005 MESURES DE SÉCURITÉ IMPOR T ANTES CE MANUEL A ÉTÉ PRÉPARÉ À L’INTENTION D’UN PERSONNEL QUALIFIÉ ET AUTORISÉ À INSTALLER DES APPAREILS FONCTIONNANT AU GAZ ET À EFFECTUER LE DÉMARRAGE INITIAL CHEZ LE CLIENT DE MÊME QUE LE RÉGLAGE DES APPAREILS CONCERNÉS DANS CE MANUEL. AFFICHER À UN ENDROIT ...

  • Vulcan-Hart GHF90 - page 24

    MODE D’INSTALLATION ET MODE D’EMPLOI GHF91 Pour de plus amples détails concernant Vulcan-Hart ou pour repérer le détaillant de pièces et de service autorisé le plus près, visiter notre site Web à : www.vulcanhart.com VULCAN-HART P.O. BOX 696, LOUISVILLE, KY 40201-0696 UNE DIVISION DE GROUPE ITW ÉQUIPEMENT ALIMENTAIRE, LLC TÉL. (502) 77 ...

Manufacturer Vulcan-Hart Category Fryer

Documents that we receive from a manufacturer of a Vulcan-Hart GHF90 can be divided into several groups. They are, among others:
- Vulcan-Hart technical drawings
- GHF90 manuals
- Vulcan-Hart product data sheets
- information booklets
- or energy labels Vulcan-Hart GHF90
All of them are important, but the most important information from the point of view of use of the device are in the user manual Vulcan-Hart GHF90.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Vulcan-Hart GHF90, service manual, brief instructions and user manuals Vulcan-Hart GHF90. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Vulcan-Hart GHF90.

Similar manuals

A complete manual for the device Vulcan-Hart GHF90, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Vulcan-Hart GHF90 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Vulcan-Hart GHF90.

A complete Vulcan-Hart manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Vulcan-Hart GHF90 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Vulcan-Hart GHF90, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Vulcan-Hart GHF90, that we can find in the current document
3. Tips how to use the basic functions of the device Vulcan-Hart GHF90 - which should help us in our first steps of using Vulcan-Hart GHF90
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Vulcan-Hart GHF90
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Vulcan-Hart GHF90 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Vulcan-Hart GHF90?

Use the form below

If you did not solve your problem by using a manual Vulcan-Hart GHF90, ask a question using the form below. If a user had a similar problem with Vulcan-Hart GHF90 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)