English dropdown-ico

Manual Anton/Bauer DUAL 2702

15 pages 0.23 mb
Download

Go to site of 15

Summary
  • Anton/Bauer DUAL 2702 - page 1

    PowerCharger DUAL and QUAD OWNER’ S MANUAL ...

  • Anton/Bauer DUAL 2702 - page 2

    TABLE OF CONTENTS INTRODUCT ION ............................................................................................. 1 STANDARD F EATURES ................................................................................. 1 DISCHARGE OPTION .................................................................................... 1 IMPORTANT NOTIC ...

  • Anton/Bauer DUAL 2702 - page 3

    1 INTRODUCTION This Anton/Bauer Inte rActive 2000 PowerCharger represents over 25 years of Ant on/Bauer technology and experience in a tota lly new portable power system . The technol ogy advancements of this new combinat ion, charger/camera power supply , delivers the features and performance of several essential power products in one economical p ...

  • Anton/Bauer DUAL 2702 - page 4

    2 IMPORTANT NOTICE READ ALL INSTRUCTIONS, NOTES AND OPERATING SPECIFICATIONS FULLY BEFORE OPERATING THIS EQUIPMENT. This unit was packaged at the factory to arrive intact at its destination. If there is any damage to the packaging or the unit when received, please notify the carrier immediately. 1 - - - - - - - 2 - - - - - - - 3 - - - - - - - 4 - - ...

  • Anton/Bauer DUAL 2702 - page 5

    3 SAFEGUARDS Power Sources: This unit was designed to operate at mains voltages from 90 to 250 Volts AC, 50-60 Hz. Risk of Electrical Shock: Refer servicing to quali fied service personnel. TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE. GROUNDING/EARTHING IMPORTANT WARNING: THIS APPARATUS MUST BE EARTHED. To ensure sa ...

  • Anton/Bauer DUAL 2702 - page 6

    4 Charging As with all Anton/B auer chargers, charging with an Int erActive 2000 PowerC harger is fully automatic. Mount any applicable ba ttery to any open Gold Mount position on the charger and the Po werCharger will automatically determine the appropriate ch arge routine and execute it. Applications All PowerCharger models will charge any combin ...

  • Anton/Bauer DUAL 2702 - page 7

    5 Three Stage Charging Methodology In general, the PowerCharger will deliv er a three stage charge routine to each battery. 1. Stage One will deliver a high rate charge matched to the capabilities of th e battery (typi cally a one or two hour ra t e, depending on battery t ype and charger power module rati ng). During this stage, six separate cut o ...

  • Anton/Bauer DUAL 2702 - page 8

    6 1 - - - - - - - 2 - - - - - - - LCD Indications Each PowerCharger’s liquid crystal displa y (LCD) will display the status of each battery, as well as, important PowerCharg er operating indications. The fol lowing information expl ains the indications whic h appear in the LCD. The levels of the LCD display on each Powe rCharger can be obtai ned ...

  • Anton/Bauer DUAL 2702 - page 9

    7 LED Indications Each charge position of a PowerCharger has a pair of LEDs (one red, one green) which indicate the status of th e battery attached to that p osition. The following table identifies all of the PowerCharger LED indicati ons and their meaning: LED INDICATION MEANING Alternating Red & Green Indicates that the PowerCharger is evalua ...

  • Anton/Bauer DUAL 2702 - page 10

    8 Priority Battery Function A unique operating feature of all PowerCharg ers allows the operator to select any battery on any charge position as a PRIORI TY BATTERY. While connecting a battery to any charge position, hold the DISPLAY bu tton until an audible indication sounds and the LCD indicates: The PowerCharger will interrupt th e charging of a ...

  • Anton/Bauer DUAL 2702 - page 11

    9 The standard test is adequ ate for virtually all conditio ns to verify the capacity o f the battery before taking it into the fiel d. The 24 hour test need only be perform ed on a battery, typical ly an older one (2 years or m ore), which may have exhibited questionable performance. Note: The DDM test mode should be used sparingly. Remember that ...

  • Anton/Bauer DUAL 2702 - page 12

    10 When testing is completed, the LCD Main Display will indicate “TEST DONE”. To display or prin t test results: 1. Press the DISPLAY button on the PowerCharger front panel to scrol l to the Primary Position Display for the battery tested. 2. Press the TEST button. Th e LCD will display the capacity of the b attery in ampere hours. If a printer ...

  • Anton/Bauer DUAL 2702 - page 13

    11 OPERATION AS DC CAMERA SUPPLY FROM MAINS Each PowerCharger model can operate cam eras and cam corders using the four pin camera output connector located at the back of the PowerCharger. To power the camera, attach one end of the XLR4 accessory cable (a vailable separately) to the PowerCharger. Attach the other end to the “DC in” four pin XLR ...

  • Anton/Bauer DUAL 2702 - page 14

    12 POWER LOSS MEMORY MODE The PowerCharger features a special Powe r Loss Mem ory or “Power Down” mode. When mains power is interrupted while ba tteries are mounted, the PowerCharger will automatically indicate the charge status o f all batteries until po wer is restored (up to 16 hours). When power is interrupted, an audi ble alert will be hea ...

  • Anton/Bauer DUAL 2702 - page 15

    13 WARRANTY IMPORTANT: PLEASE MAIL WARRANTY REGISTRATION CARD WITHIN TEN (10) DAYS OF PURCHASE. We must have this card on file at our SERVICE DEPARTMENT to establish this warranty. Pr oper registration will also enable us to provide update inform ation on the InterActi ve 2000 PowerCharger battery syst em. All new Anton/Bauer products have been tho ...

Manufacturer Anton/Bauer Category Battery Charger

Documents that we receive from a manufacturer of a Anton/Bauer DUAL 2702 can be divided into several groups. They are, among others:
- Anton/Bauer technical drawings
- DUAL 2702 manuals
- Anton/Bauer product data sheets
- information booklets
- or energy labels Anton/Bauer DUAL 2702
All of them are important, but the most important information from the point of view of use of the device are in the user manual Anton/Bauer DUAL 2702.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Anton/Bauer DUAL 2702, service manual, brief instructions and user manuals Anton/Bauer DUAL 2702. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Anton/Bauer DUAL 2702.

Similar manuals

A complete manual for the device Anton/Bauer DUAL 2702, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Anton/Bauer DUAL 2702 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Anton/Bauer DUAL 2702.

A complete Anton/Bauer manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Anton/Bauer DUAL 2702 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Anton/Bauer DUAL 2702, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Anton/Bauer DUAL 2702, that we can find in the current document
3. Tips how to use the basic functions of the device Anton/Bauer DUAL 2702 - which should help us in our first steps of using Anton/Bauer DUAL 2702
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Anton/Bauer DUAL 2702
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Anton/Bauer DUAL 2702 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Anton/Bauer DUAL 2702?

Use the form below

If you did not solve your problem by using a manual Anton/Bauer DUAL 2702, ask a question using the form below. If a user had a similar problem with Anton/Bauer DUAL 2702 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)