Manual Bunn 40119.0000G

9 pages 1.06 mb
Download

Go to site of 9

Summary
  • Bunn 40119.0000G - page 1

    TIT AN DUAL™ INST ALLA TION & OPERA TING GUIDE BUNN-O-MA TIC CORPORA TION POST OFFICE BO X 3227 SPRINGFIELD , ILLINOIS 62708-3227 PHONE: (217) 529-6601 F AX: (217) 529-6644 40119.0000G 5/12 ©2007 Bunn-O-Matic Corporation T o ensure you have the latest revision of the manual or to obtain the illustrated parts catalog, please visit the Bunn-O- ...

  • Bunn 40119.0000G - page 2

    Page 2 INTRODUCTION This equipment will brew coffee into an awaiting server or airpot. The brewer may have an auxillar y hot water faucet. It is only for indoor use on a sturdy and level counter or shelf. Please install in an area where there are no water jet devices. This brewer can be programmed to adjust different functions of the brewing proces ...

  • Bunn 40119.0000G - page 3

    Page 3 40119 010412 #00656.0001 As directed in the International Plumbing Code of the International Code Council and the Food Code Manual of the Food and Drug Administration (FDA), this equipment must be installed with adequate backflow prevention to comply with federal, state and local codes. For models installed outside the U.S.A., you must compl ...

  • Bunn 40119.0000G - page 4

    Page 4 40119 080108 ELECTRICAL REQUIREMENTS WARNING - If the power cord is ever damaged, it must be replaced by the manufacturer or its service agent with a special cord available from the manufacturer or its service agent in order to avoid a hazard. Refer to Data Plate on the Brewer , and local/national electrical codes to determine circuit requir ...

  • Bunn 40119.0000G - page 5

    Page 5 40119 010412 PLUMBING REQUIREMENTS This brewer must be connected to a cold water system with operating pressure between 20 and 90 psi (138 and 620 kPa) with a minimum of 4.0 gpm from a 1⁄2" or larger supply line. A shut-off valve should be installed in the line before the brewer . Install a regulator in the line when pressure is great ...

  • Bunn 40119.0000G - page 6

    Page 6 40119 080108 A. MAIN ON/OFF SWITCH This switch, located under the brewer in front of the right rear leg, turns power on and off to all components in the brewer . B. ON/OFF SWITCH (ENABLE BREW) Pressing the "ON/OFF" switch will alternately turn the selected brewing side on and off. Pressing this switch during the brew cycle will int ...

  • Bunn 40119.0000G - page 7

    Page 7 INITIAL SET -UP CAUTION – The brewer must be disconnected from the power source throughout the initial setup, except when specified in the instructions. 1. Insert an empty funnel into the funnel rails of one of the brew stations. 2. Place an empty server under the funnel. 3. Connect the brewer to the power source. Make sure the correspond ...

  • Bunn 40119.0000G - page 8

    Page 8 COFFEE BREWING 1. Begin each brew cycle with a clean empty brew funnel. 2. Insert a BUNN filter into the funnel. NOTE: The funnels are equipped with 4 wire loops that can be folded over top edge of filter if desired, to prevent filter from folding in during the brew cycle. 3. Pour the fresh coffee into the filter and level the bed of gro ...

  • Bunn 40119.0000G - page 9

    Page 9 40119 010412 CLEANING 1. The use of a damp cloth rinsed in any mild, nonabrasive, liquid detergent is recommended for cleaning all surfaces on Bunn-O-Matic equipment. Do NOT clean this equipment with a water jet device. 2. Check and clean each sprayhead. The sprayhead holes must always remain open. NO TE: Any buildup on the sprayhead may res ...

Manufacturer Bunn Category Coffeemaker

Documents that we receive from a manufacturer of a Bunn 40119.0000G can be divided into several groups. They are, among others:
- Bunn technical drawings
- 40119.0000G manuals
- Bunn product data sheets
- information booklets
- or energy labels Bunn 40119.0000G
All of them are important, but the most important information from the point of view of use of the device are in the user manual Bunn 40119.0000G.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Bunn 40119.0000G, service manual, brief instructions and user manuals Bunn 40119.0000G. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Bunn 40119.0000G.

Similar manuals

A complete manual for the device Bunn 40119.0000G, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Bunn 40119.0000G by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Bunn 40119.0000G.

A complete Bunn manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Bunn 40119.0000G - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Bunn 40119.0000G, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Bunn 40119.0000G, that we can find in the current document
3. Tips how to use the basic functions of the device Bunn 40119.0000G - which should help us in our first steps of using Bunn 40119.0000G
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Bunn 40119.0000G
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Bunn 40119.0000G in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Bunn 40119.0000G?

Use the form below

If you did not solve your problem by using a manual Bunn 40119.0000G, ask a question using the form below. If a user had a similar problem with Bunn 40119.0000G it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)