English dropdown-ico

Manual SkyLink Emergency Dialer Dial-Alert

14 pages 0.72 mb
Download

Go to site of 14

Summary
  • SkyLink Emergency Dialer Dial-Alert - page 1

    101A320 www.skylinkhome.com JUNE, 2004 Emergency Dialer DIAL-ALERT MODEL : AD-433S TM CUSTOMER SERVICE 17 Sheard Avenue, Brampton, Ontario, Canada L6Y 1J3 Tel : (800) 304-1187 Fax : (800) 286-1320 Email : support@skylinkhome.com PAT. D410633 6243000B1 English ...

  • SkyLink Emergency Dialer Dial-Alert - page 2

    AD-433S USER'S INSTRUCTIONS English DIAL-ALERT Emergency Dialer TM SKYLINK TECHNOLOGIES INC. Your Guide to the Emergency Dialer DIAL-ALERT MODEL: AD-433S TM 9 V O L T The AD-433S Emergency Dialer contains all the above items. – 2 – ...

  • SkyLink Emergency Dialer Dial-Alert - page 3

    TABLE OF CONTENTS PACKAGE CONTENTS............................................................................................4 ... OVERVIEW.........................................................................................................5 INSTALLATION........................................................................................... ...

  • SkyLink Emergency Dialer Dial-Alert - page 4

    – 5 – OVERVIEW The AD-433S Dial-Alert dials as many as 9 pre-program med telep hone numbers and sends a personalized pre-recorded mess age. Each telephone number can be dialed up to 9 times and the person receiving the emergency message can confirm receipt of that message by pressing the "#" key on their telephone. A pre-recorded mess ...

  • SkyLink Emergency Dialer Dial-Alert - page 5

    – 7 – INSTALLATION 3. Thread the AC adapter cord through the top hole in the back of the unit and plug it into the AC connector on the circuit board as shown. The adapter cord must be inserted through the back of the unit before it is attached to the wall. 4. Inse rt the 9 volt battery and rotate the antenna from the inside of the dialer to the ...

  • SkyLink Emergency Dialer Dial-Alert - page 6

    – 9 – LIGHTS AND SOUNDS Below is an explanation of the lights and sounds of the Dial-Alert LIGHTS A CPWR light on dialer is being powered by AC adapter. ACPWR light off dialer is not receiving any AC power. LOBATT. light off backup battery is connected and working. LOBATT. light on backup battery is weak, battery needs to be replaced. DISARM li ...

  • SkyLink Emergency Dialer Dial-Alert - page 7

    – 11 – STANDARD PROGRAMMING STORING TELEPHONE NUMBERS This fe ature enables the user to program as many as 9 different telephone numbers. The dialer can send out 2 different messages. One message is the pre-recorded voice message that you programmed earlier, the other message sends numeric information to a pager. There are three different ways ...

  • SkyLink Emergency Dialer Dial-Alert - page 8

    – 13 – STANDARD PROGRAMMING C. Storin g telephone numbers in memory (Sends the numeric information to pager only) 1. Press t he [MEM] key, the display will show a letter “M” on the upper left corner. If nothi ng is entered within 5 seconds, the display will return to the clock mode. 2. W ithin the first 5 seconds, select a memory location b ...

  • SkyLink Emergency Dialer Dial-Alert - page 9

    – 15 – ADVANCED PROGRAMMING PROGRAM THE CALLING TIME T he calling time is the amount of time the phone will ring until the call is dis- contected. If th e phone is not picked up within this period of time, the dialer will either call again, (depends on the redial count), or advance to the next phone number. The calling time is currently set at ...

  • SkyLink Emergency Dialer Dial-Alert - page 10

    – 17 – PROGRAM THE ID CODE OF A TRANSMITTER Before a ny transmitter/sensor/security system can activate the Dial-Alert , they must be learned (programmed) to communicate with each other. Once they are learned, the button on the transmitter, a door with the door/window sensor on it is opened, someone walks through an area monitored by the motion ...

  • SkyLink Emergency Dialer Dial-Alert - page 11

    – 19 – Entering a premises using the delay dialing If entering a premises through a door that is monitored with a door sensor, the delay dialing is set to 0 seconds and the dialer is on, the dialer will dial the preprogrammed telephone numbers immediately once that door is opened or any sensor is activate d. When the dialer is set to a specifie ...

  • SkyLink Emergency Dialer Dial-Alert - page 12

    – 21 – Place the Alar m Senso r besi de the siren of your existing alarm system, once the alarm is activated, the siren will sound and the Alarm Sensor will be triggered and send a signal to the Dial-Alert to activated it. There is no wiring involved in this case. Remove the jumper first PANEL OR SENSOR N.C.. LATCHING DRY CONTACT* (NORMALLY CLO ...

  • SkyLink Emergency Dialer Dial-Alert - page 13

    – 23 – The AD-433S Dial-Alert comes with 1 battery that at some point you may have to replace: One 9 volt alkaline battery for the Dial-Alert Recommendation: Test your Dial-Alert p eriodically to ensure that the battery is working. Dial-Alert Battery The Dial-Alert c omes equipped with a 9V backup battery in case the ele c- trical power is inte ...

  • SkyLink Emergency Dialer Dial-Alert - page 14

    – 25 – ADDITIONAL ACCESSORIES Silent Alarm (SW-433) - Plug into any AC outlet, then plug light into Silent Alarm unit - Light flashes when sensor(s)/transmitter(s) is (are) activated - Silently alerts occupants including the hearing impaired Vibration Sensor (VS-433) - Activates Security Control Panel or Emergency Dialer when vibration is detec ...

Manufacturer SkyLink Category Home Security System

Documents that we receive from a manufacturer of a SkyLink Emergency Dialer Dial-Alert can be divided into several groups. They are, among others:
- SkyLink technical drawings
- Emergency Dialer Dial-Alert manuals
- SkyLink product data sheets
- information booklets
- or energy labels SkyLink Emergency Dialer Dial-Alert
All of them are important, but the most important information from the point of view of use of the device are in the user manual SkyLink Emergency Dialer Dial-Alert.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals SkyLink Emergency Dialer Dial-Alert, service manual, brief instructions and user manuals SkyLink Emergency Dialer Dial-Alert. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product SkyLink Emergency Dialer Dial-Alert.

Similar manuals

A complete manual for the device SkyLink Emergency Dialer Dial-Alert, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use SkyLink Emergency Dialer Dial-Alert by users. Manuals are usually written by a technical writer, but in a language understandable to all users of SkyLink Emergency Dialer Dial-Alert.

A complete SkyLink manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual SkyLink Emergency Dialer Dial-Alert - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the SkyLink Emergency Dialer Dial-Alert, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the SkyLink Emergency Dialer Dial-Alert, that we can find in the current document
3. Tips how to use the basic functions of the device SkyLink Emergency Dialer Dial-Alert - which should help us in our first steps of using SkyLink Emergency Dialer Dial-Alert
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with SkyLink Emergency Dialer Dial-Alert
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of SkyLink Emergency Dialer Dial-Alert in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning SkyLink Emergency Dialer Dial-Alert?

Use the form below

If you did not solve your problem by using a manual SkyLink Emergency Dialer Dial-Alert, ask a question using the form below. If a user had a similar problem with SkyLink Emergency Dialer Dial-Alert it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)