English dropdown-ico

Manual Palsonic 6138

18 pages 0.15 mb
Download

Go to site of 18

Summary
  • Palsonic 6138 - page 1

    PALSONIC CORPORATION PTY LTD 1 JOYNTON AVENUE WATERLOO NSW 2017 AUSTRALIA TEL:(02)9313 7111 FAX:(02)9313 7555 www.palsonic.com.au PALSONIC CUSTOMER SERVICE TELEPHONE AUSTRALIA:1300 657 888 61CM CORDLESS REMOTE COLOUR TELEVISION MODEL: 6138 OWNER'S MANUAL ...

  • Palsonic 6138 - page 2

    . This equipment has been designed and manufactured to meet the highest international standards, but, like any electrical apparatus which is operated at mains voltage, care must be taken if you are to obtain the best results and safety is to be assured. This is particularly important with audio and TV equipment. read this handbook carefully and kee ...

  • Palsonic 6138 - page 3

    OPERATING INSTRUCTION: POWER ON/OFF SWITCH Press the Power Switch, the appliance will be in "STANDBY" mode. A red light shows on the control panel. Press "PR-/+" buttons to turn on the set. The red light goes out, and a green light, shows on the control panel. If there is no TV signal on the screen for five minutes, the TV set s ...

  • Palsonic 6138 - page 4

    There are two ways to choose the channel number you want-the single-number method and the double-number method. Single-digit Method (highest Program Number is 9) This allows numbers 0 ~ 9 ONLY and is useful for limiting the number of channels if you do not mind some channels on the wrong number (10 and 28 could be put on 1 and 0, for instance). Pre ...

  • Palsonic 6138 - page 5

    VHF-1 When the set finds a TV signal, it will stop searching automatically, and show the TV picture on the screen. The tuning is optimised for strong signals. Weak signals may need fine tuning for the best result. If you want another channel, press the SEARCH button again. The station may be fine-tuned with the FT (-/+) buttons for the best picture ...

  • Palsonic 6138 - page 6

    The settings of picture and sound will be stored in memory until you reset them. TUNING & STORING A VCR The set is provided with Audio/Video sockets that allow direct connection to the VCR, but the set may also be used with the antenna connection. In this case, the VCR acts as a TV station. Connect the VCR and play a tape. The antenna should be ...

  • Palsonic 6138 - page 7

    Low (Left Speaker) THE CONTROL OF PICTURE AND SOUND Function select On the Front Panel, the "PICTURE" button is used to select the following functions: BRIGHTNESS, COLOUR, CONTRAST, BALANCE and VOLUME in that order. Each of the functions is adjusted by means of the adjacent -/+ level control buttons. The -/+ control buttons only work whil ...

  • Palsonic 6138 - page 8

    REMOTE CONTROL UNIT The remote control unit allows almost everything to be adjusted from the armchair. DIGITAL BUTTON 16 MUTE 9 VOLUME UP/DOWN 5 BRIGHTNESS UP/DOWN 2 PR (+/-) 6,7 RECALL 15 BATTERIES: 1. Remove the battery cover of Remote Control Unit. 2. Insert two "AA" 1.5V batteries making sure the polarity ( + / - ) of the batteries ma ...

  • Palsonic 6138 - page 9

    11. S.MPX (Stereo switching) BUTTON LIST The trick is to push the buttons slowly; it takes a moment to register. Be careful that the button does not lock down. Some buttons behave differently in TV and Teletext. The following list is grouped according to TV or Teletext. If the description of a button is missing in one list, it will be found in the ...

  • Palsonic 6138 - page 10

    16. DIGITAL BUTTON In single-digit mode, press these buttons to select any of 0~9 channels. In double-digit mode, press these buttons to select any of 00~39 channels. LISTENING TO STEREO/DUAL-CHANNEL TV SOUND The Model 6138 is fitted with full performance Stereo Theatre Sound where the internal speakers are ducted to the front of the set for maximu ...

  • Palsonic 6138 - page 11

    10 AUDIO OUTPUT AND DISPLAY ON SCREEN Transmission Mode Display on Screen Audio Output Mono STEREO : MONO Ineffective Stereo Dual. Sound STEREO MONO DUAL I DUAL II Stereo Mono (Forced) Sound I Sound II CONNECTING A VCR TO THE TV SET This TV set has AUDIO/VIDEO input and output sockets on the back panel which allow direct connection to a VCR using t ...

  • Palsonic 6138 - page 12

    OUT Sockets These sockets take the signal OUT of the TV set and feed it TN to the VCR. They are hardly ever used. Most VCR’s have their own Tuner built in and do not need the TV set to tune the TV channel for them. The usual setup is to give the VCR the antenna, and feed the TV set out of the VCR’s RF output. (This loops the antenna signal thro ...

  • Palsonic 6138 - page 13

    NOTE: * You can use either RF or Audio/Video input from the VCR, but the quality of picture and sound is better using the Audio/Video sockets. * If the VCR has Mono sound, connect it to the L/Mono input socket. The R/Stereo cable is optional for Stereo and need not be used. CONNECTION DIAGRAMS 1. VIDEO PLAYBACK/RECORD This is the usual connection w ...

  • Palsonic 6138 - page 14

    Press AV Button (13) to switch to Video mode. The TV set will act as a monitor to help edit while dubbing. The set MUST remain in Video mode and MUST NOT be switched off during the session. 3. DUBBING The figure below shows how to connect TWO VCRs to the TV for dubbing one from the other. 13 ...

  • Palsonic 6138 - page 15

    CONNECTING EXTERNAL SPEAKERS You can connect speakers to the EXTERNAL SPEAKER terminals on the TV set to enhance sound from the TV. Note: Before connecting the external speakers, turn off your TV set. While pressing the button, insert the wire into the hole as shown below, and then release the button. Pull firmly on the sire make sure it is secure. ...

  • Palsonic 6138 - page 16

    TROUBLE SHOOTING Many apparent malfunctions may be caused by slight misadjustment of regular controls or some other similar causes. If any difficulty arises in the operation of your set, first check through this list of symptoms and correction. Should the difficulty cause concern, unplug the set and contact your dealer. Symptoms Check these things ...

  • Palsonic 6138 - page 17

    Specifications Colour System: Receivers Channel Cable Channel Stereo Power supply CRT Audio Output Antenna Impedance Dimension (mm) Weight Remote Control Unit Power Supply * Design and specifications are subject to change without notice. : CCIR PAL, B/G; NTSC PLAYBACK : VHFL 0-3; VHFH 4-11; UHF 21-69 : S1-S41 (OPTION) : FULL REAL STEREO : AC 120-24 ...

  • Palsonic 6138 - page 18

    PALSONIC CORPORATION PTY LTD 1 JOYNTON AVENUE WATERLOO NSW 2017 AUSTRALIA TEL:(02)9313 7111 FAX:(02)9313 7555 www.palsonic.com.au PALSONIC CUSTOMER SERVICE TELEPHONE AUSTRALIA: 1300 657 888 604-64063-01 ...

Manufacturer Palsonic Category CRT Television

Documents that we receive from a manufacturer of a Palsonic 6138 can be divided into several groups. They are, among others:
- Palsonic technical drawings
- 6138 manuals
- Palsonic product data sheets
- information booklets
- or energy labels Palsonic 6138
All of them are important, but the most important information from the point of view of use of the device are in the user manual Palsonic 6138.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Palsonic 6138, service manual, brief instructions and user manuals Palsonic 6138. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Palsonic 6138.

Similar manuals

A complete manual for the device Palsonic 6138, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Palsonic 6138 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Palsonic 6138.

A complete Palsonic manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Palsonic 6138 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Palsonic 6138, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Palsonic 6138, that we can find in the current document
3. Tips how to use the basic functions of the device Palsonic 6138 - which should help us in our first steps of using Palsonic 6138
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Palsonic 6138
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Palsonic 6138 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Palsonic 6138?

Use the form below

If you did not solve your problem by using a manual Palsonic 6138, ask a question using the form below. If a user had a similar problem with Palsonic 6138 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)