English dropdown-ico

Manual Maretron GPS200

23 pages 0.38 mb
Download

Go to site of 23

Summary
  • Maretron GPS200 - page 1

    ® ® Revision 1.2 Page i GPS200 GPS Antenna/Receiver User’s Manual Revision 1.2 Copyright © 2012 Maretron, LLP All Rights Reserved Maretron, LLP 9014 N. 23 rd Ave #10 Phoenix, AZ 85021-7850 http://www.maretron.com Maretron Manual Part #: M002501 ...

  • Maretron GPS200 - page 2

    GPS200 User’s Manual Page ii Revision 1.2 Revision History Revision Description 1.0 Initial Revision 1.1 Corrected address in Section 7 1.2 Added prohibition of red Loctite th readlocking compound and cleaning agents containing acetone ...

  • Maretron GPS200 - page 3

    ® ® Revision 1.2 Page iii Table of Contents 1  Introduc tion .................................................................................................................. ..... 1  1.1  Firmware Revi sion .................................................................................................... 1  1.2  GPS200 Feat ure ...

  • Maretron GPS200 - page 4

    GPS200 User’s Manual Page iv Revision 1.2 This page intentionally left blank. ...

  • Maretron GPS200 - page 5

    ® ® Revision 1.2 Page 1 1 Introduction Congratulations on your purchase of the Ma retron GPS200 GPS Antenna/Receiver. Maretron has designed and built yo ur GPS200 to the highest sta ndards for years of reliable, dependable, and accurate service. The Maretron GPS200 is designed to operate wit hin the harsh demands of the marine environment. Howeve ...

  • Maretron GPS200 - page 6

    GPS200 User’s Manual 1. Level with the earth’s horizontal plane – This gives the GPS200 antenna the optimal view of satellites from all directions. 2. High Enough to have a clear view of the sky to the horizon in all directions unblocked by masts or antennas – The GPS200 provides the best r eadings when it has access to as many satellites a ...

  • Maretron GPS200 - page 7

    ® ® Figure 1 – Mounting the G PS200 to a flat surface 2.3.2 Mounting the GPS200 to a Standard Marine Pole Mount Screw the included GPS200 antenna mount base to the standard marine mount. Thread the NMEA 2000 ® cable through the standard marine mount and the antenna mount base from the bottom out through the top and connect it to the GPS200 uni ...

  • Maretron GPS200 - page 8

    GPS200 User’s Manual Page 4 Revision 1.2 interface through a connector that can be found on the bottom of the device (see Figure 3 ). e cable. Please follow recommended practices for installing NMEA 2000 ® network products. 2.4 Connecting the GPS200 The Maretron GPS200 provides a connection to an NMEA 2000 ® NMEA 2000 ® Connector Figure 3 – ...

  • Maretron GPS200 - page 9

    ® ® Figure 4 – NMEA 2000 ® Connector Face Views 2.4.1 Checking Connections Once the NMEA 2000 ® connection to the Maretron GPS200 has been completed, check to see that GPS information is being properly transmitt ed by observing an appropr iate display. Refer to Section 5 , “Troubleshooting”, if no GPS information appears. 3 Operation As s ...

  • Maretron GPS200 - page 10

    GPS200 User’s Manual Page 6 Revision 1.2 These parameters may be confi gured using a Maretron display (DSM250), or the parameters can be configured using a Maretron NMEA 2000 ® /USB gateway (USB100) and Maretron’s N2KAnalyzer software. Users with direct access to the NMEA 2000 ® interface may configure these parameters directly through the NM ...

  • Maretron GPS200 - page 11

    ® ® Revision 1.2 Page 7 • Clean the unit with a soft cloth. Do not use chemical cleaners as they may remove paint or markings or may corrode the GPS200 enclosure or seals. Do not use any cleaners containing acetone, as they will deteriorate the plastic enclosure. • Ensure that the unit is mounted securely an d cannot be moved relative to the ...

  • Maretron GPS200 - page 12

    GPS200 User’s Manual Page 8 Revision 1.2 5 Troubleshooting If you notice unexpected operatio n of the Maretron GPS200, follow the troubleshooting procedures in this section to remedy simple problems. Symptom Troubleshooting Procedure No data output Check the connections to the NMEA 2000 ® connector and tighten if necessary Ensure that power is s ...

  • Maretron GPS200 - page 13

    ® ® Revision 1.2 Page 9 6 Technical Specifications Specifications Parameter Value Comment Position Accuracy (Autonomous) <3m 2D RMS (95% of Data Falls Within 10m ) Position Accuracy (WAAS) <2.5m 2D RMS (95% of Data Falls Within 3m) Channels 32 Simultaneous Tracking of 32 Satellites Tracking Sensitivity -159dBm Position Update Rate 5 per Sec ...

  • Maretron GPS200 - page 14

    GPS200 User’s Manual Page 10 Revision 1.2 Electrical Parameter Value Comment Operating Voltage 9 to 16 Volts DC Voltage Power Consumption <100mA Average Current Drai n Load Equivalence Number (LEN) 2 NMEA 2000 ® Spec. (1LEN = 50 mA) Reverse Battery Protection Yes Indefinitely Load Dump Protection Yes E nergy Rated per SAE J1113 Mechanical Par ...

  • Maretron GPS200 - page 15

    ® ® 8 Installation Template Please check the dimensions before using the fo llowing diagram as a template for drilling the mounting holes; the printing process may have distorted the dimensions. 2.11” Figure 5 – Horizontal Mounting Surface Template Revision 1.2 Page 11 ...

  • Maretron GPS200 - page 16

    GPS200 User’s Manual Page 12 Revision 1.2 9 Maretron (2 Year) Limited Warranty Maretron warrants the GPS200 to be free from defects in materia ls and workmanship for t wo (2) years from the date of original purchase. If within the applicable per iod any such products sh all be proved to Maretron’s satisfaction to fail to meet the above lim ited ...

  • Maretron GPS200 - page 17

    ® ® Revision 1.2 Appendix A – NMEA 2000 ® Interfacing Page A1 Appendix A – NMEA 2000 ® Interfacing GPS200 NMEA 2000 ® Periodic Data Transmitted PGNs PGN 126992 – System Time The GPS200 uses this PGN to provide a regular transmission of UTC time and date and to provide synchronism for measur ement data. The factory default for periodic tr ...

  • Maretron GPS200 - page 18

    GPS200 User’s Manual Page A2 Appendix A – NMEA 2000 ® Interfacing Revision 1.2 The GPS200 uses this PGN to provide lati tude and longitude referenced to WGS84. The factory default for periodic transmission rate is 10 times per second. The transmission of this PGN can be disabled or the tr ansmission rate of this PGN can be changed (see PGN 126 ...

  • Maretron GPS200 - page 19

    ® ® Revision 1.2 Appendix A – NMEA 2000 ® Interfacing Page A3 4: Latitude – Latitude in 1x10 -16 degrees ("-" = south, “+” = north) 5: Longitude – Longitude in 1x10 -16 degrees ("-" = west, “+” = east) 6: Altitude – Altitude referenced to WGS-84 in (resolution of 1x10 -6 m) 7: Type of System – This fi eld is ...

  • Maretron GPS200 - page 20

    GPS200 User’s Manual Page A4 Appendix A – NMEA 2000 ® Interfacing Revision 1.2 4: Reserved (2 bits) – This field is rese rved by NMEA; therefore, this field always contains a value of 0x3 (the GPS200 sets all reserved bits to a logic 1) 5: HDOP – This field is used to indicate the horizo ntal diluti on of precision with a resolution of 1x1 ...

  • Maretron GPS200 - page 21

    ® ® Revision 1.2 Appendix A – NMEA 2000 ® Interfacing Page A5 GPS200 NMEA 2000 ® Non-Periodic Data Transmitted PGNs PGN 129538 – GNSS Control Status The GPS200 uses this PGN to provide the GN SS com mon satellite receiv er parameter status. GPS200 sends this PGN only when r equested by PGN 059904 (ISO Request). Field 1: SV Elev ation Mask ? ...

  • Maretron GPS200 - page 22

    GPS200 User’s Manual Page A6 Appendix A – NMEA 2000 ® Interfacing Revision 1.2 This will change the confi guration of the GPS200. Field 1: Complex Command Group Function Code (8 bits) – set this field’s value to 0x01, which denotes a command PGN. 2: Commanded PGN (24 bits) – set this field’s value to 129538, which denotes the GNSS Cont ...

  • Maretron GPS200 - page 23

    ® ® Revision 1.2 Appendix A – NMEA 2000 ® Interfacing Page A7 11: Software Code (16 bits) – set this field’s value to 0x0001, which is the identifier for this version of the Mare tron proprietary protocol 12: Maretron Co mmand (8 bits) – set this fiel d’s value to 0x30, which will force the GPS Engine to restart as selected by the foll ...

Manufacturer Maretron Category GPS Receiver

Documents that we receive from a manufacturer of a Maretron GPS200 can be divided into several groups. They are, among others:
- Maretron technical drawings
- GPS200 manuals
- Maretron product data sheets
- information booklets
- or energy labels Maretron GPS200
All of them are important, but the most important information from the point of view of use of the device are in the user manual Maretron GPS200.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Maretron GPS200, service manual, brief instructions and user manuals Maretron GPS200. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Maretron GPS200.

Similar manuals

A complete manual for the device Maretron GPS200, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Maretron GPS200 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Maretron GPS200.

A complete Maretron manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Maretron GPS200 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Maretron GPS200, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Maretron GPS200, that we can find in the current document
3. Tips how to use the basic functions of the device Maretron GPS200 - which should help us in our first steps of using Maretron GPS200
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Maretron GPS200
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Maretron GPS200 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Maretron GPS200?

Use the form below

If you did not solve your problem by using a manual Maretron GPS200, ask a question using the form below. If a user had a similar problem with Maretron GPS200 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)