Manual Jensen JiMS-190

16 pages 0.39 mb
Download

Go to site of 16

Summary
  • Jensen JiMS-190 - page 1

    ® DOCKING DIGIT AL MUSIC SYSTEM FOR iPod OWNER'S MANUAL JiMS-190 ® (iPod Not Included) PLEASE READ THIS OPERATING MANUAL COMPLETEL Y BEFORE OPERATING THIS UNIT AND RET AIN THIS BOOKLET FOR FUTURE REFERENCE ...

  • Jensen JiMS-190 - page 2

    ...

  • Jensen JiMS-190 - page 3

    ® DEAR JENSEN CUSTOMER IMPORTANT SAFETY INSTRUCTIONS COMPLIANCE WITH FCC REGULATIONS PRODUCT FEATURES INSTALLA TION LOCATION OF CONTROLS RADIO OPERATIONS ® iPod DOCKING AUXILIARY INPUT CLOCK AND CALENDAR SETTINGS ALARM OPERATIONS CARE AND MAINTENANCE TROUBLESHOOTING GUIDE SPECIFICATIONS SERVICE TABLE OF CONTENTS 2 2 3 4 4 5-6 7 8 9 10 11 12 13 14 ...

  • Jensen JiMS-190 - page 4

    Selecting fine audio equipment such as the unit you've just purchased is only the start of your musical enjoyment. Now it's time to consider how you can maximize the fun and excitement your equipment offers. This manufacturer and the Electronic Industries Association's Consumer Electronics Group want you to get the most out of your e ...

  • Jensen JiMS-190 - page 5

    3 7.Object and Liquid Entry Care should be taken so that objects do not fall and liquids are not spilled into any openings or vents located on the product. 8.Attachments Do not use attachments no recommended by the product manufacturer. 9.Lightning and Power Surge Protection Unplug the unit from the wall outlet and disconnect the periods of time. T ...

  • Jensen JiMS-190 - page 6

    4 INSTALLA TION PRODUCT FEA TURES Clock Back-up Batteries Installation 1.Open the battery compartment door located at the bottom of the unit. 2.Install two DC1.5V 'AAA' (UM-4) batteries (not included) in the battery compartment following the polarity markings shown on it. 3.Replace the battery door on the battery compartment. NOTE:Please ...

  • Jensen JiMS-190 - page 7

    5 LOCATION OF CONTROLS Bottom view T op view Main Unit Rear view 21 22 1 2 12 7 11 6 5 10 4 3 8 9 Front view 13 15 15 14 ® 1.iPod Dock ® 2.iPod Docking Connector 3. POWER On/Off Button T o turn the unit on or off 4. VOLUME +/- Buttons Adjust the volume level up or down 5. SNOOZE/LIGHT Button Activate the snooze function; Turn the LCD backlight on ...

  • Jensen JiMS-190 - page 8

    6 Remote Control LOCATION OF CONTROLS 1.Infra-red Transmitter 2.POWER On/Off Button 3.VOL +/- Button 4.FUNCTION Button 5.ALARM On/Off Button 6.SNOOZE/LIGHT Button 7.TUN Up/Down Buttons for Down, for Up 8.CH +/- Buttons 9.MEM Button 10.MODE Button 11.SLEEP Button ® 12.iPod Skip/Search Forward/Backward Buttons for Backward, for Forward. ® 13.iPod P ...

  • Jensen JiMS-190 - page 9

    7 RADIO OPERATIONS FM Antenna Connect the detachable FM Antenna Wire to the FM Antenna T erminal as instructed in the section “INSTALLA TION”. Fully extend the FM Antenna Wire for the maximum reception. Radio Tuning 1.Press the POWER button to turn on the unit. 2.Press the FUNCTION button repeatedly until “AM” or “FM” mode is reached. 3 ...

  • Jensen JiMS-190 - page 10

    8 If the docking port will not be used for an extended period of time, it is recommended to cover the docking port by using the “Dock Cover” insert (included). 1.Use the iPod adaptor included in your iPod and insert it into the docking area. Your iPod can now be inserted into the docking port by placing the connector on the bottom of the iPod o ...

  • Jensen JiMS-190 - page 11

    9 AUXILIARY INPUT The auxiliary input cable and plug are built in the unit and allows users to connect their CD player, MP3 player or other digital audio players to the unit. 1.Keep turning the Cord Retracting Wheel, located at the rear of the unit, to the right and pull out the AUX IN Cable located next to the wheel. 2.Connect the AUX IN Stereo Pl ...

  • Jensen JiMS-190 - page 12

    10 The clock and calendar can be set in Power Off mode. Clock Setting 1.Press the MODE button 3 times, the clock starts to flash. 2.Press the TUN +/- button to set the hour. 3.Press the VOL +/- button to set the minute. 4.Press the MEM button to confirm the settings. 12/24 Hour Time Display Mode Setting 1.Press the MODE button repeatedly until the ...

  • Jensen JiMS-190 - page 13

    11 ALARM OPERATIONS Wake to Radio ( RAD) - The radio will automatically turn on when the alarm time is reached. It starts softly and becomes gradually louder. - The radio alarm will keep for 60 minutes and then will automatically shut off. - To stop the radio alarm sound immediately , press the ALARM On/Off button once. ® Wake to iPod ( iPod) ® - ...

  • Jensen JiMS-190 - page 14

    12 - Do not subject the unit to excessive force, shock, dust or extreme temperature. - Do not tamper the internal components of the unit. - Clean your unit with a damp (never wet) cloth. Solvent or detergent should never be used. - Avoid leaving your unit in direct sunlight or in hot, humid or dusty places. - Keep your unit away from heating applia ...

  • Jensen JiMS-190 - page 15

    TROUBLESHOOTING GUIDE Symptom Possible Problem Solution The unit does not respond (no power) AC Adaptor is not plugged into a wall outlet or the connector is not plugged into the power supply jack on the back of the unit. Plug the AC adaptor into a wall outlet and plug the connector into the supply jack on the unit. Wall outlet is not functioning. ...

  • Jensen JiMS-190 - page 16

    14 Printed in China SPECIFICATIONS Power Supply Power Adaptor (included) Battery Back-up for Clock Remote Control Frequency Range USA's Radio Broadcast System EU's Radio Broadcast System Japan's Radio Broadcast System Input: AC120V/60Hz Output: DC10V/1400mA DC1.5V 'AAA' (UM-4) Battery X 2 (not included) CR2032 X 1 (included ...

Manufacturer Jensen Category MP3 Docking Station

Documents that we receive from a manufacturer of a Jensen JiMS-190 can be divided into several groups. They are, among others:
- Jensen technical drawings
- JiMS-190 manuals
- Jensen product data sheets
- information booklets
- or energy labels Jensen JiMS-190
All of them are important, but the most important information from the point of view of use of the device are in the user manual Jensen JiMS-190.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Jensen JiMS-190, service manual, brief instructions and user manuals Jensen JiMS-190. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Jensen JiMS-190.

Similar manuals

A complete manual for the device Jensen JiMS-190, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Jensen JiMS-190 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Jensen JiMS-190.

A complete Jensen manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Jensen JiMS-190 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Jensen JiMS-190, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Jensen JiMS-190, that we can find in the current document
3. Tips how to use the basic functions of the device Jensen JiMS-190 - which should help us in our first steps of using Jensen JiMS-190
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Jensen JiMS-190
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Jensen JiMS-190 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Jensen JiMS-190?

Use the form below

If you did not solve your problem by using a manual Jensen JiMS-190, ask a question using the form below. If a user had a similar problem with Jensen JiMS-190 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)