-
Miele DA 5320 W - page 1
Operating and installation instructions Cooker hood DA 5390 W, DA 5320 W To avoid the risk of accidents or damage to this appliance it is essential to read these instructions before it is installed and used for the first time. M.-Nr. 07 260 270 en - GB, AU, NZ ...
-
Miele DA 5320 W - page 2
Caring for the environment . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Warning and Safety instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Guide to the appliance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 Mode of operati ...
-
Miele DA 5320 W - page 3
Disposal of the packing material The transport and protective packing has been selected from materials which are environmentally friendly for disposal, and can normally be recycled. Packaging e.g. cling film, polystyrene and plastic wrappings must be kept out of the reach of babies and young children. Danger of suffocation! Dispose of or recycle al ...
-
Miele DA 5320 W - page 4
This appliance complies with all relevant local and national safety requirements. Inappropriate use can, however, lead to personal injury and damage to property. To avoid the risk of accidents and damage to the appliance, please read these instructions carefully before using it for the first time. They contain important information on the safety, i ...
-
Miele DA 5320 W - page 5
~ Before connecting the appliance to the mains supply, make sure that the voltage and frequency details given on the data plate correspond with the on-site electricity supply (see "After Sales Service"). If they do not correspond the appliance could suffer damage. Consult a qualified electrician if in any doubt. ~ The electrical safety of ...
-
Miele DA 5320 W - page 6
~ Do not connect the appliance to the mains electricity supply by a multi-socket unit or an extension lead. These do not guarantee the required safety of the appliance (e.g. danger of overheating). ~ This appliance may only be used in mobile installations such as ships, caravans, aircraft etc. if a risk assessment of the installation has been carri ...
-
Miele DA 5320 W - page 7
In order to ensure safe operation, and to prevent gases given off by the heating appliances from being drawn back into the room when the cooker hood and the heater are in operation simultaneously, an underpressure of 0.04 mbar (4 pa) is the maximum permissible in the room. Ventilation can be maintained by air inlets which must not be blocked, in wi ...
-
Miele DA 5320 W - page 8
Correct use ~ Never use an open flame beneath the cooker hood. To avoid the danger of fire, do not flambé or grill over an open flame under the cooker hood. When switched on, the cooker hood could draw flames into the filter. Fat particles drawn into the cooker hood present a fire hazard. ~ When using the cooker hood over a gas hob, ensure that an ...
-
Miele DA 5320 W - page 9
~ Safety regulations prohibit the fitting of a cooker hood over solid fuel stoves. ~ All ducting, pipework and fittings must be of non-flammable material. These can be obtained from the Miele Spare Parts department or from builders' merchants. ~ The appliance must not be connected to a chimney or vent flue which is in use. Neither should it be ...
-
Miele DA 5320 W - page 10
Guide to the appliance 10 ...
-
Miele DA 5320 W - page 11
a Telescopic extension piece b Tower c Canopy d Grease filters e Decor panels Miele DDW 53x0 (optional accessory) 3 panels are required for the DA 5390 W, and 4 panels for the DA 5320 W. f Control panel g Hob lighting h Touch control for the hob lighting This control switches the lighting on and off, and is also a dimmer switch. i On/Off touch cont ...
-
Miele DA 5320 W - page 12
The cooker hood works with . . . air extraction: The air is drawn in and cleaned by the grease filters and directed outside. The cooker hood is fitted with a non-return flap which is closed when the cooker hood is switched off. No exchange of room and outside air can take place. When the cooker hood is switched on, the non-return flap opens for the ...
-
Miele DA 5320 W - page 13
Con | ctivity This cooker hood is communication enabled. Communication module XKM 2000 DA a , available as an optional extra, enables the operation of the cooker hood to be automatically controlled by the operating status of a Miele electric hob with onset controls. For communication to take place, the hob must be fitted with communication module X ...
-
Miele DA 5320 W - page 14
To switch the fan on ^ Press the On/Off control. The fan runs at power level "II". The indicator lamp will come on. If the cooker hood has been connected to a window contact switch via the DSM 400 control module, then the fan cannot be switched on if the window is shut. The indicator lamp will flash. To select a power level ^ Use the – ...
-
Miele DA 5320 W - page 15
The indicator lamps for fan power levels I and IV will flash if the automatic switch-off for the Intensive setting is not activated. ^ Press the + control to activate the automatic switch-off. The indicator lamps for fan power levels I and IV will now light up constantly. Press the – control to deactivate the automatic switch-off function. ^ Pres ...
-
Miele DA 5320 W - page 16
To switch the hob lighting on The hob lighting can be switched on and off independently of the fan. ^ Briefly press the hob lighting control to switch on the hob lighting. The indicator lamp will come on. The lighting will switch on at maximum brightness. To dim the hob lighting The brightness of the lighting can be adjusted. ^ With the lighting sw ...
-
Miele DA 5320 W - page 17
Filter operating hours counter The number of hours the appliance has been in operation is stored in memory. The operating hours counter tells you when the grease filters need to be cleaned. Resetting the operating hours counter for the grease filters After 30 hours of operation (or another time if the operating hours counter has been altered), the ...
-
Miele DA 5320 W - page 18
Altering the filter operating hours counter The filter operating hours counter is set at 30 hours. This can be lengthened or shortened to suit the type of cooking you do. You can choose 20, 30, 40 or 50 hours – Select a short time if you roast or fry a lot. – If you use very little fat for cooking, select a longer time. – If you only cook occ ...
-
Miele DA 5320 W - page 19
Before any cleaning or maintenance work is carried out, disconnect the cooker hood from the mains supply. Ensure that: – it is switched off at the isolator, or – it is switched off at the wall socket and the plug removed, or – the fuse from the fused spur connection unit is withdrawn, or – the mains fuse is withdrawn, or – the screw-out f ...
-
Miele DA 5320 W - page 20
Important for appliances with lacquered housing (special order finish) It is very difficult to clean this type of surface without causing minor marks to the surface material. This can become particularly noticeable with darker colours and if there is halogen lighting in the kitchen. Controls The controls may suffer discolouration or damage if soili ...
-
Miele DA 5320 W - page 21
Cleaning the grease filters by hand ^ Clean the filters with a soft nylon brush in a mild solution of hot water and a small amount of washing-up liquid. Do not use undiluted washing up liquid. Do not use: – cleaning agents containing descaling agents, – powder cleaners, cream cleaners or abrasive all-purpose cleaning agents, – oven sprays. Cl ...
-
Miele DA 5320 W - page 22
Changing a halogen lamp ^ Before any cleaning or maintenance work, disconnect the cooker hood from the mains supply. Ensure that– – it is switched off at the isolator, or – it is switched off at the wall socket and the plug is withdrawn, or – the fuse from the fused spur connection unit is withdrawn, or – the mains fuse is disconnected, o ...
-
Miele DA 5320 W - page 23
In the event of a fault which you cannot correct yourself, or if the appliance is under guarantee, please contact: – Your Miele Dealer / Chartered Agent or – The Miele Customer Contact Centre (see back cover for address). When contacting your Dealer or Miele, please quote the model and serial number of your appliance. These are shown on the dat ...
-
Miele DA 5320 W - page 24
DA 5390 W DA 5320 W Appliance dimensions 24 ...
-
Miele DA 5320 W - page 25
The shaded areas 1) and 2) represent the wall or ceiling area for the vent cut-out, for feeding the connection cable through to an external fan and for fitting the connection socket. Connection for air extraction C 200 mm Safety distance between hob and cooker hood (S) When planning the installation height of your cooker hood, the minimum safety di ...
-
Miele DA 5320 W - page 26
Assembly parts Installation 26 ...
-
Miele DA 5320 W - page 27
a 3 protective sheets for use when fitting the tower. b 2 hose clips for securing the exhaust ducting. c Telescopic wall bracket for securing the cooker hood to the wall. Installation instructions 6 screw s5x4 0m m and 6xS8 plugs for securing the bracket to the wall. The screws and plugs are designed for use in solid walls only. For other types of ...
-
Miele DA 5320 W - page 28
Before installation, it is important to read the information given on the following pages as well as the "Appliance dimensions" and the "Warning and Safety instructions" at the beginning of this book. This is particularly crucial when using the cooker hood at the same time as a heating appliance that relies on air from the same ...
-
Miele DA 5320 W - page 29
All electrical work should be undertaken by a suitably qualified and competent person in strict accordance with current national and local safety regulations (BS 7671 in the UK). Installation, repairs and other work by unqualified persons could be dangerous, for which the manufacturer cannot be held liable. Ensure power is not supplied to the appli ...
-
Miele DA 5320 W - page 30
The Miele DSM 400 Control module can be used to combine the cooker hood with other components. It enables the following: Connection to a window contact switch If adequate ventilation to the room can only be ensured by having a window open when the cooker hood is in use at the same time as a heating appliance which depends on the air from the same r ...
-
Miele DA 5320 W - page 31
Connection to a light switch The control module can be used to switch on the cooker hood lighting and also to dim it, depending on model, via a light switch in the house. Installation The tower needs to be removed before the control module can be fitted to the fan unit. The control module is supplied with its own detailed operating and installation ...
-
Miele DA 5320 W - page 32
, Important: To avoid the danger of toxic fumes, please observe the Warning and Safety instructions. This is especially crucial when using the cooker hood at the same time as another heating appliance which relies on air from the same room. The cooker hood should be installed according to local and national building regulations. Seek approval from ...
-
Miele DA 5320 W - page 33
For exhaust ducting with a diameter of 200 mm, the following accessories are required: – Exhaust hose DAS 200 – Exhaust grille DFG 200, for mounting on the external wall. *Lead flashing – Roof ducting DDF 200, for mounting on a sloping tiled roof. – Reducing collar for the exhaust stub if using exhaust ducting with a 150 mm diameter. Connec ...
-
Miele DA 5320 W - page 34
Total connected load - DA 5390 W ................5 8 0W - DA 5320 W ................6 0 0W F a n ........................5 0 0W Hob lighting - DA 5390 W ..............4x2 0W - DA 5320 W .............. 5x2 0W Voltage ....................2 3 0V Frequency .................. 5 0H z Fuse rating GB ................1 3A AUS, NZ: Plug rating .............. ...
-
Miele DA 5320 W - page 35
35 ...
-
Miele DA 5320 W - page 36
Alteration rights reserved / 4209 M.-Nr. 07 260 270 / 03 ...
Do you have a question concerning Miele DA 5320 W?
Use the form below
If you did not solve your problem by using a manual Miele DA 5320 W, ask a question using the form below. If a user had a similar problem with Miele DA 5320 W it is likely that he will want to share the way to solve it.