English dropdown-ico

Manual Chauvet DMX512

19 pages 0.43 mb
Download

Go to site of 19

Summary
  • Chauvet DMX512 - page 1

    Snapshot OK on Dimmer Outdoor OK Sound Activated DMX512 Master/Slave 115V/230V Switch Replaceable Fuse User Serviceable Duty Cycle MiN™ S pot USER MANUAL Chauvet, 3000 N 2 9 th Ct, Hollywood, FL 3 3020 U.S.A. (800) 762-1084 – (954 ) 929-1115 FAX (954) 929-5560 www.chauvetlightin g.com ...

  • Chauvet DMX512 - page 2

    T ABLE OF C ONTENTS MiN™ Spot ..................................................................................................................... ................................ 1 USER MA NUAL ................................................................................................................... ........................... 1 1. Bef ...

  • Chauvet DMX512 - page 3

    1. B EFORE Y OU B EGIN What is included ¾ 1 x MiN™ Spot ¾ Power Cord ¾ Warranty Card ¾ User Manual Unpacking Instructions Immediately upon receiving a fixture, carefully unpack the carton, check the contents to ensure that all parts are present, and have been received in good condition. Noti fy the shipper immediately and retain packing mater ...

  • Chauvet DMX512 - page 4

    Safety Instructions Please read these instructions carefully, it includes important information about the installation, usage and maintenance of this product. • Please keep this User Guide for future consultation. If you sell the unit to another user, be sure that they also receive this instruction booklet. • Always make sure that you are conne ...

  • Chauvet DMX512 - page 5

    2. I NTRODUCTION Features CONTROL FEATURES • 5 or 13-channel DMX-512 LED moving yoke • Pan: 540 o / tilt: 270 o • RGB color mixing • Gobo wheel 9 gobos + open Gobo wheel spin effect • Variable electronic strobe • Variable electronic dimmer (0 – 100%) • Vector speed channel for pan/tilt, RGB color mixing and color ma cros • Built-i ...

  • Chauvet DMX512 - page 6

    DMX Channel Summary - 5 Channel Mode C HANNEL F UNCTION 1 Pan 2 Tilt 3 Shutter 4 Color Macro 5 Gobo Product Overview Projector Head Lens Focus LED Readout Control Panel DMX In DMX Out IEC Power Connector with Fuse holder (Rear) Voltage Selector Switch CA-9 Controller Input ( rear ) ( rear ) MiN™ Spot User Manual 6 2008-07-15/12 :39 ...

  • Chauvet DMX512 - page 7

    3. S ETUP Disconnect the power cord before replacing a fuse and always replace with the same type fuse. Fuse Replacement The fuse is located inside this With a flat head screwdriver wedge the fuse holder out of its housing. Remove the damaged fuse from its holder and replace with exact same type fuse. Insert the fuse holder back in its place and re ...

  • Chauvet DMX512 - page 8

    CABLE CONNECTORS CABLE CONNECTORS Cabling must have a male XLR connector on one end and a female XLR connector on the othe r end. Cabling must have a male XLR connector on one end and a female XLR connector on the othe r end. 2 1 3 OUTPUT Termination reduces signal er rors. To avoid signal transmission problems and interference, it is al ways advis ...

  • Chauvet DMX512 - page 9

    Master/Slave Fixture Linking 1. Connect the (male) 3 pin connector side of the DM X cable to the output (female) 3 pin connector of the first fixture. 2. Connect the end of the cable coming from the first fixture which will have a (female) 3 pin connector to the input connector of the next fixtur e consisting of a (male) 3 pin connector. Then, proc ...

  • Chauvet DMX512 - page 10

    4. O PERATING I NSTRUCTIONS Navigating the Control Panel Access control panel functions using the four pa nel buttons located directly underneath the LCD Display. Button Function <MODE/ESC> Used to access the menu or to ret urn to a previous menu option <UP> Scrolls through menu options in ascending order <DOWN> Scrolls through me ...

  • Chauvet DMX512 - page 11

    Menu Map MiN™ Spot User Manual 11 2008-07-15/12 :39 ...

  • Chauvet DMX512 - page 12

    User Configurations TO SET THE PAN TO INVERTING OR NON-INVERTIN G: 1) Press the Mode button until it shows or 2) Use the Up/Down buttons to set to the desired inversion, press enter to confirm. TO SET THE TIL T TO INVE RTING OR NON-INVERTING: 1) Press the Mode button until it shows or 2) Use the Up/Down buttons to set to the desired inversion, pres ...

  • Chauvet DMX512 - page 13

    Stand-Alone Mode ( Auto Mode): This mode allows a single unit to run to a factory installed program in one of two speeds. 1) To set the fixture in auto mode Fast , select . Once confirmed the display reads 2) To set the fixture in auto mode Slow , select Once confirmed the display reads Master/Slave Mode (Master Sound): This mode will allow you to ...

  • Chauvet DMX512 - page 14

    DMX Channel Values (13 Channel) C HA NNE L V ALU E F UNCTION 1 000 Ù 255 Pan 2 000 Ù 255 Pan Fine 3 000 Ù 255 Tilt 4 000 Ù 255 Tilt Fine 5 000 Ù 255 V ector Speed: (Normal → Slow) 6 000 Ù 007 008 Ù 134 135 Ù 239 240 Ù 255 Dimmer/Strobe Closed 100-0% Strobe (slow → fast) Open 7 000 Ù 255 Red 0-100% 8 000 Ù 255 Green 0-100% 9 000 Ù 25 ...

  • Chauvet DMX512 - page 15

    DMX Channel Values (5 Channel) C HANNEL V AL UE F UNCTION 1 000 Ù 255 Pan 2 000 Ù 255 Tilt 3 000 Ù 007 008 Ù 134 135 Ù 239 240 Ù 255 Dimmer/Strobe Closed 100-0% Strobe (slow → Fast) Open 4 000 Ù 007 008 Ù 021 022 Ù 035 036 Ù 049 050 Ù 063 064 Ù 077 078 Ù 091 092 Ù 105 106 Ù 119 120 Ù 133 134 Ù 147 148 Ù 161 162 Ù 175 176 Ù 189 ...

  • Chauvet DMX512 - page 16

    Troubleshooting Symptom Solution(s) Applies to Lights Foggers & Snow Controllers Dimmers & Chaser Auto shut off Check f an thermal switch reset 9 Beam is very dim or not bright Clean optical system or replace lamp Check 220/110v switch for proper setting 9 Breaker/Fuse keeps blowing Check total load placed on device 9 Chase is too slow Chec ...

  • Chauvet DMX512 - page 17

    Technical Support Address: Service Dept. 3000 N 29th Ct, Hollywood, FL 33020 (U.S.A. ) Support (Email): tech@chauvetlighting.com Telephone: (954) 929-1115 - (Pre ss 4) Fax: (954) 929-5560 - (Att ention: Service) Website: http://www.chauvetlighting.com 6. A PPENDIX DMX Primer There are 512 channels in a DMX-512 connection. Channels may be assigned i ...

  • Chauvet DMX512 - page 18

    General Maintenance To maintain optimum performance and minimize we ar fixtures should be cleaned frequently. Usage and environment are contributing factors in determi ning frequenc y. As a general rule, fixtures should be cleaned at least twice a month. Dust build up reduces light output perform ance and can cause overheating. This can lead to red ...

  • Chauvet DMX512 - page 19

    MiN™ Spot User Manual 19 2008-07-15/12 :39 Technical Specifications WEIGHT & DIMENSIONS Length......................................................................................................................... .... 6.8 in (173 mm) Width ..................................................................................................... ...

Manufacturer Chauvet Category Work Light

Documents that we receive from a manufacturer of a Chauvet DMX512 can be divided into several groups. They are, among others:
- Chauvet technical drawings
- DMX512 manuals
- Chauvet product data sheets
- information booklets
- or energy labels Chauvet DMX512
All of them are important, but the most important information from the point of view of use of the device are in the user manual Chauvet DMX512.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Chauvet DMX512, service manual, brief instructions and user manuals Chauvet DMX512. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Chauvet DMX512.

Similar manuals

A complete manual for the device Chauvet DMX512, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Chauvet DMX512 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Chauvet DMX512.

A complete Chauvet manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Chauvet DMX512 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Chauvet DMX512, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Chauvet DMX512, that we can find in the current document
3. Tips how to use the basic functions of the device Chauvet DMX512 - which should help us in our first steps of using Chauvet DMX512
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Chauvet DMX512
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Chauvet DMX512 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Chauvet DMX512?

Use the form below

If you did not solve your problem by using a manual Chauvet DMX512, ask a question using the form below. If a user had a similar problem with Chauvet DMX512 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)