Manual Hotpoint RZA50

20 pages 0.23 mb
Download

Go to site of 20

Summary
  • Hotpoint RZA50 - page 1

    FREEZER - MODELS RZA50 INSTRUCTIONS FOR INST ALLA TION & USE GET TING ST ARTED: T o ensure that your freez er runs reliably and efficiently follo w these st eps. Choose a location for your freezer , away from an y heat sources and allow adequate ventilation - 100mm (4 inches) gap above . Level the fr eezer by adjusting the front feet. This will ...

  • Hotpoint RZA50 - page 2

    F or Y our Safety For y our safety , read the following advice: The freezer c ooling system contains a small amount of gas which is en vironmentally friendly but flammable. T o a void any risk :- ● Install the freezer follo wing the installation instruc tions and ensure that ventilation openings are kept clear of obstruction. ● T ake care when ...

  • Hotpoint RZA50 - page 3

    Installation 3 SAFETY & INST ALLA TION Minimum space required to open door The freezer needs a spac e of 600mm (24 inches) in front to allo w the door t o open. When positioning the freezer next to a unit, a gap of 30mm (1 1 / 4 inch) can be lef t at the hinge side of the door to allow the easy remo val of furniture. If preferred the freezer ca ...

  • Hotpoint RZA50 - page 4

    Installation Lev elling: Lev el the freezer when it is in its final location by adjusting the front feet , until firm contact is made with the floor . This will stop rocking or vibration and keep the door aligned which helps the freezer run reliably and efficiently . Note: B efor e plugging in and switching on, leav e the freezer stan ding in its f ...

  • Hotpoint RZA50 - page 5

    Installation Electrical Supply W ARNING: This appliance must be earthed. The freez er must be positioned so that the plug is accessible after installation. Fu se s Y our applianc e comes fitted with a plug and a 13A fuse. I f y ou need to replace the fuse, only use those rated at 13A and AST A appr oved to BS1362. Changing the Plug Cut off and disp ...

  • Hotpoint RZA50 - page 6

    C ontrols Con trolling the T emperature of the F reezer Compartment The control wheel on the fr ont of the worktop adjusts the inter nal freezer temperature . Y our food should be maintained at -18˚C or c older f or long term storage. The setting of the control wheel will depend on the loca tion of the freezer , the room temperature and ho w of te ...

  • Hotpoint RZA50 - page 7

    C ontrols 7 CONTROLS Indicator Lights Green Mains Light The green mains light will sta y on as long as the elec tricity supply is not interrupted . Amber F ast Freez e Light The amber light indicates that the fast fr eeze button has been pressed on. By pressing this button on the freezer mot or will run continuously for extra cooling . Red High T e ...

  • Hotpoint RZA50 - page 8

    C ontrols F ast Freeze Butt on - Freezing fresh food Either the top compartment or the tallest compartment (see page 9), with or without the drawers , should be used to freeze fresh food . Which drawer t o use will depend on the amount and size of the fresh f ood and the size of the food already stored . T ransfer already fro zen food to one of the ...

  • Hotpoint RZA50 - page 9

    Useful A dvice 9 Note: The Rating Plate , which lists the appliance Model Number and Serial Number can be found near the bottom of the interior wall. USEFUL ADVICE F roz en Food Storage C apacit y 58kg Maximum Fr eezing Capacity in 24 hours 16kg Maximum Conservation Time from F ailure 16 hours F ast Fr eeze F ast Fr eeze Sealbreaker Grab Handle ● ...

  • Hotpoint RZA50 - page 10

    Useful A dvice 10 ● Liquid-filled bottles or sealed fizzy dr inks must not be stor ed in freezer , as they may burst. ● Lollipops and wat er ices should not be given to children directly from the freezer the low temper ature may cause ‘freezer burns’ . ● Store ice cr eam towards the top front of the freezer and r emove from freezer 15-30 ...

  • Hotpoint RZA50 - page 11

    Useful A dvice 11 Advic e on Using F reezer Draw ers This freezer can be used with or without the dra wers. However , th e bottom drawer needs to remain in position at all times (to maintain the c orrec t storage t emperature). It is generally more conv enient to use the drawers but if a lot of food is t o be stored the drawers can be taken out and ...

  • Hotpoint RZA50 - page 12

    Defrosting 12 Regular use of your appliance causes ice to gr adually build up on internal sur faces increasing the running costs of your applianc e. When the ice is between 3-5mm ( 1 / 4 inch) Hotpoint recommend ‘fully defrosting your fr eezer’ . F ully defrosting your freezer . W ARNING: Switch off the electr icity supply and pull out the main ...

  • Hotpoint RZA50 - page 13

    Cleaning 13 CLEANING & MAINTENANCE Cleaning W ARNING: Switch off electr ical supply and pull out mains plug bef ore cle aning. Interior W ARNING: D o not use abrasiv e powder , household cleaner , bleach or wax polish to clean the interior , they will leave a smell in the fre ezer . 1. Remove stor ed food, wrap or cov er it and place into insul ...

  • Hotpoint RZA50 - page 14

    Door Rev ersal 14 Y ou will need a cross head screwdriver , a flat blade screwdriver and a 5mm spanner to carr y out this proc edure. Our Ser vice Department can arrange for an Engineer to do the con version for you but a charge will be made. W ARNING: Switch off electr ical supply and pull out the mains plug . Remove all loose fittings from inside ...

  • Hotpoint RZA50 - page 15

    Door Rev ersal 15 Note : Y ou may require assistance to do this: 25. Place the top hinge ont o the door , slide the door onto the bottom hinge pin and support the door whilst screwing the top hinge bracket into position. Ensure that the top hinge bracket is positioned correctly . 26. Adjust the front f eet (see ‘Levelling ’ SAFET Y & INST A ...

  • Hotpoint RZA50 - page 16

    T roubleshooting IS THE FREEZER WORKING AS YOU W ANT? Have y ou read through the instruction book ? If you still hav e a problem, before calling our ser vic e organisation see if any of the tips below help . The freez er will not work 1. Check plug is firmly positioned in the socket outlet and the power supply is switched on. 2. Check power supply ...

  • Hotpoint RZA50 - page 17

    T roubleshooting 17 OPERA TING SOUNDS OF A FREEZER These are the normal types of sound that your freez er will make . The motor (compressor) makes a buzzing or humming sound when it is running. This can be louder when it first switches on. This sound will reduce ov er the first few months. Gases flowing through the pipes can produce gurgling , bubb ...

  • Hotpoint RZA50 - page 18

    “Satisfaction guaranteed or your mone y back ” W e give you a unique ‘sa tisfac tion guarant eed’ promise - valid for 90 da ys - after you have purchased your Hotpoint appliance . If there is a technical probl em simply call Hotpoint Repair ser vic e or visit our web-site at www .theservic ec en tr e .c o .uk and where necessar y , we will ...

  • Hotpoint RZA50 - page 19

    After Sales S ervice “No compan y is b etter positioned to off er an af ter sales servic e on a Hotpoint appliance than us - the manufacturer” As part of our commitment to you, all Hotpoint appliances hav e t he added benefit of a fully inclusive parts and labour guarantee for the first 12 months. In addition to this y ou also have the advantag ...

  • Hotpoint RZA50 - page 20

    General Domestic Appliances Limited, Morley Way , Peterborough, PE2 9JB. PRINTED BY SIMLEX . FOUR ASHES, WOL VERHAMPTON. July 2003 2766200016 - 03 K ey C ontac ts After Sales Ser vice Over 1200 trained specialists, directly employed by us, ensure th at you can ha ve complete confidence in both the applianc es and services we offe r. Repair Ser vic ...

Manufacturer Hotpoint Category Freezer

Documents that we receive from a manufacturer of a Hotpoint RZA50 can be divided into several groups. They are, among others:
- Hotpoint technical drawings
- RZA50 manuals
- Hotpoint product data sheets
- information booklets
- or energy labels Hotpoint RZA50
All of them are important, but the most important information from the point of view of use of the device are in the user manual Hotpoint RZA50.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Hotpoint RZA50, service manual, brief instructions and user manuals Hotpoint RZA50. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Hotpoint RZA50.

Similar manuals

A complete manual for the device Hotpoint RZA50, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Hotpoint RZA50 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Hotpoint RZA50.

A complete Hotpoint manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Hotpoint RZA50 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Hotpoint RZA50, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Hotpoint RZA50, that we can find in the current document
3. Tips how to use the basic functions of the device Hotpoint RZA50 - which should help us in our first steps of using Hotpoint RZA50
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Hotpoint RZA50
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Hotpoint RZA50 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Hotpoint RZA50?

Use the form below

If you did not solve your problem by using a manual Hotpoint RZA50, ask a question using the form below. If a user had a similar problem with Hotpoint RZA50 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)