English dropdown-ico

Manual Dell POWERCONNECT 5524

20 pages 1.48 mb
Download

Go to site of 20

Summary
  • Dell POWERCONNECT 5524 - page 1

    Dell PowerConnect 5500 Series Getting Started Guide Regulatory Models: PowerConnect 5524, 5524P , 5548, 5548P ContaxGS.book Page 1 Frid ay, August 20, 2010 1:53 PM ...

  • Dell POWERCONNECT 5524 - page 2

    Notes, Cautions, and W arnings NOTE: A NOTE indicates important in formation that helps you make better use of your system. CAUTION: A CAUTION indicates potential damage to hardware or loss of data if instructions are not followed. WAR NIN G: A WARNING indicates a potential for property damage, personal injury , or death. ____________________ Infor ...

  • Dell POWERCONNECT 5524 - page 3

    Contents 3 Contents 1 Installation . . . . . . . . . . . . . . . . . . . . . . . . 5 Overview . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Site Preparation . . . . . . . . . . . . . . . . . . . . . . 5 Unpacking . . . . . . . . . . . . . . . . . . . . . . . . . 6 Package Contents . . . . . . . . . . . . . . . . . . 6 Unpacking the Switch . ...

  • Dell POWERCONNECT 5524 - page 4

    4 Contents 3 Configuring the Switch . . . . . . . . . . . . . 13 Configuration W ork Flow . . . . . . . . . . . . . . . . 13 Connecting the Switch to the T erminal . . . . . . . . . 14 Booting the Switch . . . . . . . . . . . . . . . . . . . . 15 Configuring the Stack . . . . . . . . . . . . . . . . . . 16 Configuration Using the Setup Wizard . . . ...

  • Dell POWERCONNECT 5524 - page 5

    Getting Started Guide 5 Installation Overview This guide describes how to install and run the P owerConnect 5500 series switches. F or mor e information, see the Dell P owerConnect 5500 Series User Guide , available on your Documentation CD, or check the Dell Support website at support.dell.com/manuals for the latest updates on documentation and so ...

  • Dell POWERCONNECT 5524 - page 6

    6 Installation • Cabling — The cabling is routed to avoid sou rces of electrical noise, such as radio transmitters, broadcast ampl ifiers, power lines, and fluor escent lighting fixtures. • Ambient Re quirements — The ambient unit operating temperatur e range is 0 to 45ºC (32 to 113ºF) at a re lative humidity of 10% to 90%, non- condensin ...

  • Dell POWERCONNECT 5524 - page 7

    Installation 7 Installing the Switch The P o werConnect 5500 Series switches can be: • Installed o n a rack • Placed on a flat surface Installing in a Rack CAUTION: Disconnect all cables from the unit before mounting the switch in a rack or cabinet. CAUTION: When mounting multiple switches into a rack, mount the switches from the bottom up. T o ...

  • Dell POWERCONNECT 5524 - page 8

    8 Installation 3 Repeat the process for the rack-mountin g brack et on the other side of the switch. 4 Insert the unit into the 48.26-cm (19-inch) rack, ensuring that the rack-mounting holes on the switch l ine up to the mounting holes on the rack. 5 Secur e the unit to the rack with the rack screws (not provided). F asten the lower pair of screws ...

  • Dell POWERCONNECT 5524 - page 9

    Getting Started Guide 9 Stacking Overview Each switch is a member in a stack, although the stack may consist of only a single switch. Up to eight switches ar e supported per stack. All stacks must have a Master unit, and may have a Master Backup unit. All other switches ar e connected to the stack as members (slaves). Stacking Switches P o werConne ...

  • Dell POWERCONNECT 5524 - page 10

    10 Stacking F igure 2-1 shows this process. Figure 2-1. Stacking Cable Diagram HDMI Ports F r o n t P a n e l HDMI Ports F r o n t P a n e l HDMI Ports F r o n t P a n e l F r o n t P a n e l HDMI Ports ContaxGS.book Page 10 Frid ay, August 20, 2010 1:53 PM ...

  • Dell POWERCONNECT 5524 - page 11

    Stacking 11 Unit ID Assignment Each switch in the stack has a unique uni t ID that defines the unit’s position and function in the stack. F igure 2-2 describes the stacking LEDs on the front panel of the switch. Figure 2-2. Stacking LEDs on Front Panel The Unit ID of each switch can be ei ther automatically assigned or manually assigned, as descr ...

  • Dell POWERCONNECT 5524 - page 12

    12 Stacking Manual Assignment T o assign unit IDs to the switches in the stack, do the following for each switch in the stack: 1 Connect the switch to the terminal, as described in "Connecting the Switch to the T erminal". 2 T urn on the switch to begin auto boot and pr ess Re turn or Esc to abort and enter the Start Up menu. 3 Select Sta ...

  • Dell POWERCONNECT 5524 - page 13

    Getting Started Guide 13 Configuring the Switch This section describes the configuratio n that must be performed after the switch is installed and connected to power supplies. Additional advanced functions ar e described in the Dell P owerConnect 5500 Series User Guide on the Documentation CD. NOTE: Before proceeding further , read the re lease not ...

  • Dell POWERCONNECT 5524 - page 14

    14 Configuring the Switch Connecting the Switch to the T erminal The switch is configur ed and monitored through a terminal desktop system that runs terminal emulation softwar e. The switch connects to the terminal through the console port. T o connect the switch to a terminal: 1 Connect an RS-232 cable to a VT100-co mpatible terminal or the serial ...

  • Dell POWERCONNECT 5524 - page 15

    Configuring the Switch 15 Booting the Switch After the local terminal is connected, turn on power . The switch then goes through power -on self -test (POST). PO ST runs every time the switch is started and checks har dware componen ts, to determine if the switch is operational before completely booting. If the system detects a critical problem, the ...

  • Dell POWERCONNECT 5524 - page 16

    16 Configuring the Switch Configuring the Stack The switch is always consider ed to be a stack of switches even if the stack only contains a single switch. If ther e is mo r e than one switch in the stack, each switch must be configur ed individual ly . See "Unit ID Assignment" for instructions on how to configur e the stack. Configuratio ...

  • Dell POWERCONNECT 5524 - page 17

    Configuring the Switch 17 • The IP addr ess to be assigned to the VLAN 1 interface through which the switch is to be managed (by d efault, every external and internal port is a member of the VLAN 1) • The IP subnet mask for the network • The default gateway (ne xt hop rout er) IP address for configuring the default route 2 Boot the Master uni ...

  • Dell POWERCONNECT 5524 - page 18

    18 Configuring the Switch To manage the switch usin g SNMP (required for Dell Network Manager) you can: • Setup the initial SNMP version 2 account now. • Return later and set up the SNMP version account. For more information on setting up a SNMP version 2 account, see the user documentation. Would you like to set up the SNMP management interfac ...

  • Dell POWERCONNECT 5524 - page 19

    Configuring the Switch 19 7 Set up user account privilege level, as follows: The following information is displayed: Now we need to set up y our initial privilege (Level 15) user account. Th is account is used to login to the CLI and Web interface. You may set up other accounts and change privilege levels later. For more information on se tting up ...

  • Dell POWERCONNECT 5524 - page 20

    20 Configuring the Switch 11 P ress Enter . The following information is displayed: Finally, set up t he default gateway. Please enter the IP address of the gateway from which this network is reachable (e.g. 192.168.2.1).D efault gateway (A.B.C.D):[0.0.0.0] 12 Enter the default gateway . 13 P ress Enter . The following is displayed (example): This ...

Manufacturer Dell Category Personal Computer

Documents that we receive from a manufacturer of a Dell POWERCONNECT 5524 can be divided into several groups. They are, among others:
- Dell technical drawings
- POWERCONNECT 5524 manuals
- Dell product data sheets
- information booklets
- or energy labels Dell POWERCONNECT 5524
All of them are important, but the most important information from the point of view of use of the device are in the user manual Dell POWERCONNECT 5524.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Dell POWERCONNECT 5524, service manual, brief instructions and user manuals Dell POWERCONNECT 5524. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Dell POWERCONNECT 5524.

Similar manuals

A complete manual for the device Dell POWERCONNECT 5524, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Dell POWERCONNECT 5524 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Dell POWERCONNECT 5524.

A complete Dell manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Dell POWERCONNECT 5524 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Dell POWERCONNECT 5524, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Dell POWERCONNECT 5524, that we can find in the current document
3. Tips how to use the basic functions of the device Dell POWERCONNECT 5524 - which should help us in our first steps of using Dell POWERCONNECT 5524
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Dell POWERCONNECT 5524
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Dell POWERCONNECT 5524 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Dell POWERCONNECT 5524?

Use the form below

If you did not solve your problem by using a manual Dell POWERCONNECT 5524, ask a question using the form below. If a user had a similar problem with Dell POWERCONNECT 5524 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)