Manual Kenwood KDC-4051UM

19 pages 0.75 mb
Download

Go to site of 19

Summary
  • Kenwood KDC-4051UM - page 1

    KDC-U449 KDC-U3049 KDC-U349 KDC-4051UM CD-RECEIVER INSTRUCTION MANUAL GET0691-001A (MW/M2W/M0/M20) © 2010 Kenwood Corporation All Rights Reserved. Declaration of Conformity with regard to the EMC Directive 2004/108/EC Manufacturer: Kenwood Corporation 2967-3 Ishikawa-machi, Hachioji-shi, T okyo, 192-8525 Japan EU Representative’s: Kenwood Electr ...

  • Kenwood KDC-4051UM - page 2

    2 C ONTENTS Safety 2 Preparation 3 How to attach/detach the faceplate How to reset your unit How to prepare the remote controller (RC-405) Basic operations 4 Getting started 6 Canceling the display demonstration Setting the demonstration mode Adjusting the clock Initial settings before operations Listening to the radio 7 Changing the frequency step ...

  • Kenwood KDC-4051UM - page 3

    3 ENGLISH Preparation How to attach/detach the faceplate 2 1 1 2 Do not expose the faceplate to direct sunlight, excessive heat, or humidity . Also avoid places with too much dust or the possibility of water splashing. Keep the faceplate in its casing while detached. The faceplate is a precision piece of equipment and can be damaged by shocks or jo ...

  • Kenwood KDC-4051UM - page 4

    4 KDC-U449: KDC-U3049/ KDC-U349/ KDC-4051UM: The following indicator lights up when... ST : A stereo broadcast is r eceived. IN : A disc is in the unit. KDC-U449 only: ATT (blink) : The sound attenuates. EQ : [SYSTEM Q] is set to an EQ mode other than [NATURAL] . (page 13) B.BOOST : [BASS BOOST] is set to [1] or [2] . (page 13) : I n Search Mode or ...

  • Kenwood KDC-4051UM - page 5

    5 ENGLISH When you press or hold the f ollowing button(s)... Main unit Remote controller General operation SRC — T urns on. T urns off if pressed and held. SRC Selects the available sources ( TUNER, USB or iPod, CD , AUX, ST ANDBY ), if the power is turned on. • If the source is ready, playback also starts. “iPod” or “CD” is selectable ...

  • Kenwood KDC-4051UM - page 6

    6 Getting started Canceling the display demonstration The display demonstration is always turned on unless you cancel it. When you turn on the power (or after you reset the unit), the display shows: [CANCEL DEMO] [PRESS] [VOLUME KNOB] 1 Press the volume knob. [YES] is selected as the initial setup. 2 Press the volume knob again to confirm. [DEM ...

  • Kenwood KDC-4051UM - page 7

    7 ENGLISH Continued... Item Selectable setting (Preset: *) PRESET TYPE NORMAL/ NORM *: Memorizes one station for each preset button in each band (FM1/ FM2/ FM3/ MW/ LW/ SW1/ SW2). ; MIX: Memorizes one station for each preset button regardless of the selected band (FM1/ FM2/ FM3/ MW/ LW/ SW1/ SW2). KEY BEEP ON */ OFF: Activates/deactivates the keypr ...

  • Kenwood KDC-4051UM - page 8

    8 Changing the frequency steps (KDC-U449/ KDC-U3049/ KDC-U349 only) Y ou can change the frequency step of FM/ MW: FM : 50 kHz to 200 kHz MW : 9 kHz to 10 kHz 1 Press and hold SRC to turn off the power. 2 While pressing number buttons 1 and 5 (MEMO MY LIST) , press SRC . Release your fingers from the buttons after the display appears. T o restore th ...

  • Kenwood KDC-4051UM - page 9

    9 ENGLISH For KDC-4051UM: Available Program Type: SPEECH MUSIC NEWS AFFAIRS INFO SPORT EDUCATE DRAMA CULTURE SCIENCE VARIED POP M (music) ROCK M (music) EASY M (music) LIGHT M (music) CLASSICS OTHER M (music) WEATHER FINANCE CHILDREN SOCIAL RELIGION PHONE IN TRAVEL LEISURE JAZZ COUNTRY NATION M (music) OLDIES FOLK M (music) DOCUMENT The unit will s ...

  • Kenwood KDC-4051UM - page 10

    10 Start playing a disc 1 Press SRC to turn on the power. 2 Insert a disc into the loading slot. Playback starts automatically. 3 Press number button 6 ( ) to resume/pause playback (if necessary). Ejects the disc. (“NO DISC” appears and “IN” indicator goes off.) Pr ess to select track/file. Hold to fast-forwards/reverses . Listening to a di ...

  • Kenwood KDC-4051UM - page 11

    11 ENGLISH T o return to the root folder (or first track f or audio CD), press BAND . T o return to the previous folder , press . T o cancel the Music Search mode, press and hold . < or > on the display indicates that preceded/next item is available. F or USB device* and iPod: T o sk ip search, press 4 / ¢ . * This operation is effective onl ...

  • Kenwood KDC-4051UM - page 12

    12 Alphabet Search and My Playlist for iPod Selecting a song by alphabet 1 Press to enter Music Search mode. “SEARCH” appears. 2 Turn the volume knob to select a category, then press to confirm. 3 Press again to enter alphabet search mode. “SEARCH < – – – >” appears. 4 Turn the volume knob to select the character to be searched ...

  • Kenwood KDC-4051UM - page 13

    13 ENGLISH Continued... Functions of KDC-U449 with iPod About compatible iPod/iPhone Made for – iPod t ouch (1st, 2nd, and 3rd generation) – iPod classic – iP od with video – iP od nano (1st, 2nd, 3rd , 4th, and 5th generation) – iPhone 4 – iPhone 3GS – iPhone 3G – iPhone F or the latest compatible list and software version of iP od ...

  • Kenwood KDC-4051UM - page 14

    14 Item Selectable setting (Preset: *) MID ADJUST MID CTR FRQ/ MID C FRQ: 0.5K/ 1.0K */ 1.5K/ 2.5K: Selects the center frequency. MID LEVEL: –8 — +8 (Preset: 0): Adjusts the level. MID Q FACTOR/ MID Q FCTR: 0.75/ 1.00 */ 1.25: Adjusts the Q factor. TRE ADJUST TRE CTR FRQ/ TRE C FRQ: 10.0K/ 12.5K */ 15.0K/ 17.5K: Selects the center frequency. TR ...

  • Kenwood KDC-4051UM - page 15

    15 ENGLISH Troubleshooting Symptom Remedy/Cause Sound cannot be heard. Adjust the volume to the optimum level. / Check the cords and connections. “PROTECT” appears and no operations can be done. Check to be sure the terminals of the speaker leads are covered with insulating tape properly, then reset the unit. If “PROTECT” does not disappear ...

  • Kenwood KDC-4051UM - page 16

    16 Installation/connection Part list: A F aceplate.............................................................. (×1) B Escutcheon ......................................................... (×1) C Mounting sleeve ............................................. (×1) D Casing f or faceplate ...................................... (×1) E Wiring harnes ...

  • Kenwood KDC-4051UM - page 17

    17 ENGLISH KDC-4051UM KDC-U449/ KDC-U3049/ KDC-U349 KDC-U449 KDC-U3049/ KDC-U349/ KDC-4051UM Wiring connection Fuse (10 A) Antenna terminal (JASO) Rear/subwoofer output terminals Front output terminals Rear/subwoofer output terminals Blue/White Brown Blue To the terminal that is grounded when either the telephone rings or during conversation. (To c ...

  • Kenwood KDC-4051UM - page 18

    18 Installing the unit Removing the unit 2 1 Connect the wiring harness to the unit. Other wiring connection has been completed earlier. (page 17) Before attaching, make sure the direction of the escutcheon is correct. (Wider hooks on the top side.) Dashboard of your car T: Toyota cars N: Nissan cars 1 Detach the faceplate. 2 Engage the catch pin o ...

  • Kenwood KDC-4051UM - page 19

    19 ENGLISH CD player section Laser diode: GaAIAs Digital filter (D/A): 8 Times Over Sampling D/A converter: 24 Bit Specifications Spindle speed: 500 rpm — 200 rpm (CL V ) Wow & Flutter: Below Measurable Limit Frequency response (±1 dB): 20 Hz — 20 kH z Total harmonic distortion (1 kHz): 0.01 % Signal-to-Noise ratio (1 kHz): 105 dB Dynamic ...

Manufacturer Kenwood Category CD Player

Documents that we receive from a manufacturer of a Kenwood KDC-4051UM can be divided into several groups. They are, among others:
- Kenwood technical drawings
- KDC-4051UM manuals
- Kenwood product data sheets
- information booklets
- or energy labels Kenwood KDC-4051UM
All of them are important, but the most important information from the point of view of use of the device are in the user manual Kenwood KDC-4051UM.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Kenwood KDC-4051UM, service manual, brief instructions and user manuals Kenwood KDC-4051UM. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Kenwood KDC-4051UM.

Similar manuals

A complete manual for the device Kenwood KDC-4051UM, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Kenwood KDC-4051UM by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Kenwood KDC-4051UM.

A complete Kenwood manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Kenwood KDC-4051UM - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Kenwood KDC-4051UM, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Kenwood KDC-4051UM, that we can find in the current document
3. Tips how to use the basic functions of the device Kenwood KDC-4051UM - which should help us in our first steps of using Kenwood KDC-4051UM
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Kenwood KDC-4051UM
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Kenwood KDC-4051UM in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Kenwood KDC-4051UM?

Use the form below

If you did not solve your problem by using a manual Kenwood KDC-4051UM, ask a question using the form below. If a user had a similar problem with Kenwood KDC-4051UM it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)