-
JVC UX-H300 - page 1
LVT1193-003A [B] MICR O COMPONENT SYSTEM UX-H330 UX-H300 –Consists of CA-UXH330 and SP-UXH330 –Consists of CA-UXH300 and SP-UXH300 INSTR UCTIONS UX-H330&H300[B]cover1.p65 04.3.17, 0:06 PM 1 ...
-
JVC UX-H300 - page 2
G-1 W arnings, Cautions and Other s CA UTION— (ST ANDBY/ON) button! Disconnect the mains plug to shut the power off completely (all lamps and indications go off). The (ST ANDBY/ON) button in an y position does not disconnect the mains line. • When the unit is on standby , the ST ANDBY lamp lights red. • When the unit is turned on, the ST ANDB ...
-
JVC UX-H300 - page 3
G-2 SAFETY INSTRUCTIONS “ SOME DOS AND DON ’ TS ON THE SAFE USE OF EQUIPMENT ” This equipment has been designed and manuf actured to meet international safety standards, b ut like an y electr ical equipment, care must be tak en if you are to obtain the best results and saf ety is to be assured. Do read the operating instructions bef ore you a ...
-
JVC UX-H300 - page 4
1 Power sources • When unplugging the unit from the wall outlet, always pull on the plug, not the A C power cord. DO NO T handle the AC po wer cord with wet hands. Moisture condensation Moisture may condense on the lenses inside the unit in the follo wing cases: • After starting to heat the room. • In a damp room. • If the unit is brought d ...
-
JVC UX-H300 - page 5
2 Contents Location of the Buttons and Controls ............................. 3 Main Unit .................................................................................. 3 Remote Control ......................................................................... 5 Getting Started .................................................................. 6 ...
-
JVC UX-H300 - page 6
3 Location of the Buttons and Controls Become familiar with the b uttons and controls on your unit. Main Unit OPEN COMPACT DIGITAL AUDIO DAIL Y TIMER/SNOOZE 1 3 2 COMPACT DIGITAL AUDIO ST ANDBY CD PHONES DOWN 4 # / 8 7¢ UP AUX PUSH OPEN T APE FM/AM AUX VOLUME + – MICRO COMPONENT SYSTEM AUTO REVERSE REC 4 5 6 7 8 p 9 q w e r t T op view Front vie ...
-
JVC UX-H300 - page 7
4 Display window Display window 1 D AIL Y 1/2/3 (timer number) indicator 2 (timer) indicator 3 ON/OFF (timer on-time/of f-time) indicators 4 REC (recording timer) indicator 5 (group folder) indicator 6 SLEEP indicator 7 SNOOZE indicator 8 FM mode indicators • MONO , ST (stereo) 9 MP3 indicator p SOUND indicator q BASS indicator w REC (recording) ...
-
JVC UX-H300 - page 8
5 Remote Control See pages in parentheses for details. COMPACT DIGITAL AUDIO ST ANDBY CD PHONES DOWN 4 # / 8 7¢ UP AUX T APE FM/AM AUX VOLUME + – REC When using the remote control, point it at the remote sensor on the front panel. 1 ST ANDBY/ON button (8, 22) 2 SLEEP button (23) 3 CLOCK/TIMER button (8, 21) 4 SET button (8, 15, 21, 22) 5 CANCEL ...
-
JVC UX-H300 - page 9
6 Getting Started Unpacking After unpacking, check to be sure that you ha ve all the follo wing items. The number in parentheses indicates the quantity of each piece supplied. • AM (MW) loop antenna (1) • Remote control (1) • Batteries (2) If any item is missing, consult your dealer immediately . Connecting AM (MW) and FM Antennas 1 Connect t ...
-
JVC UX-H300 - page 10
7 Connecting Other Equipment T o connect an audio equipment Y ou can connect audio equipment — used only as a playback de vice. • DO NO T connect any equipment while the power is on. • DO NO T plug in any equipment until all connections are complete. F or playing other equipment through this unit, connect between the audio output jacks on the ...
-
JVC UX-H300 - page 11
8 Common Operations Setting the Clock Before operating the unit any further , first set the unit ’ s clock. When you plug in the po wer cord, “ 0:00 ” starts flashing on the display . Y ou can set the clock when the unit is either turned on or in standby mode. On the r emote control ONL Y : 1 Press CLOCK/TIMER. The hour indication start flash ...
-
JVC UX-H300 - page 12
9 Selecting the Source T o select the source, press CD 6 , T APE 2 3 , FM/AM, or AU X . • When you select CD as the source, playback starts automatically . T o operate the CD player , see pages 10 to 13. T o operate the tape deck, see page 14. T o operate the tuner (FM or AM (MW)), see pages 15 to 18. T o record on a tape, see pages 19 and 20. T ...
-
JVC UX-H300 - page 13
10 Playing Back the Entire Disc — Normal Play 1 Press ) OPEN on top of the unit. The disc cov er opens. • Y ou can insert a disc while listening to another source. 2 Place a disc correctly with its label side up. 3 Close the disc cov er gently . 4 Press CD 6 . The unit automatically turns on and the source changes to the CD player . After loadi ...
-
JVC UX-H300 - page 14
11 T o remo ve the disc, press ) OPEN on the unit, then take out the disc by holding it at the edges while pressing the unit ’ s pi vot lightly . • If the disc cannot be read corr ectly (because it is scratched, for example) or an unr eadable CD-R or CD-R W is inserted Playback will not start. • If no disc is inserted “ NO DISC ” appears ...
-
JVC UX-H300 - page 15
12 Repeating T racks — Repeat Play Y ou can have all the tracks, the program or indi vidual trac k currently playing, repeat as many times as you lik e. On the remote contr ol ONL Y : Press REPEA T r epeatedly befor e or during playback. • Each time you press the button, Repeat Play changes as follo ws, and the following repeat indicators light ...
-
JVC UX-H300 - page 16
13 RDS MODE REMAIN Displaying the Remaining Time during Playback Y ou can display the remaining time of the current track/disc and the elapsed time of the current track/disc during playing. On the remote contr ol ONL Y : Press REMAIN r epeatedly . When playing bac k audio CD: • Each time you press the button, the display changes as follo ws, and ...
-
JVC UX-H300 - page 17
14 If no cassette is inserted when you pr ess T APE ¤ ‹ “ NO T APE ” appears on the display . T o stop playing, press 7 . T o fast-wind to the left or to the right, press ¢ or 4 (or UP ¢ or DO WN 4 on the unit). The tape direction indicator ( 3 or 2 ) starts flashing rapidly on the display . T o remov e the cassette, press PUSH OPEN on the ...
-
JVC UX-H300 - page 18
15 T uning in to a Station 1 Press FM/AM to select either “ FM ” or “ AM (MW). ” The unit automatically turns on and tunes in to the previously recei ved station — either FM or AM (MW). • Each time you press the button, the band alternates between FM and AM (MW). • If the station pre viously selected is stored in a preset number , the ...
-
JVC UX-H300 - page 19
16 123 456 78 0 9 OVER FM/AM PRESET GROUP PRESET GROUP UP DOWN T uning in to a Preset Station On the r emote control ONL Y : 1 Press FM/AM to select either “ FM ” or “ AM (MW). ” The unit automatically turns on and tunes in to the previously recei ved station — either FM or AM (MW). • Each time you press the button, the band alternates ...
-
JVC UX-H300 - page 20
17 Searching for Programs by PTY Codes (PTY Search) One of the adv antages of RDS is that you can locate a particular kind of program by specifying the PTY codes. • For details on the PTY codes, see “ Descr iption of the PTY codes ” on the right column. • There is a time limit in doing the follo wing steps. If the setting is canceled before ...
-
JVC UX-H300 - page 21
18 Listening to the External Equipment Y ou can listen to the external equipment such as MD recorder , cassette deck, or other auxiliary . • First, make sure that the external equipment is proper ly connected to the unit. (See page 7.) 1 Set the volume le vel to the minimum position. 2 Press A UX. “ AU X ” appears on the display . 3 Start pla ...
-
JVC UX-H300 - page 22
19 3 Start playing the source — FM, AM (MW), or auxiliary equipment connected to A UX jack. • When the source is FM or AM (MW), tune in to the station you want to record. • When recording from discs, see “ Recording Discs — Disc Synchronized Recording ” on page 20. 4 Press REC (r ecording). • The REC indicator appears and 3 indicator ...
-
JVC UX-H300 - page 23
20 T o stop recording f or a moment, press REC. Both the CD playback and tape recording are paused. T o resume recording, press T APE ¤ ‹ . T o stop recording, press 7 . The recording stops and the CD playback is paused. T o record on both sides — Reverse Mode On the remote contr ol ONL Y : Press REV .MODE (re verse mode) repeatedly until or i ...
-
JVC UX-H300 - page 24
21 Using the T imers There are four timers a vailable — Daily T imer, Recording T imer , Snooze T imer , and Sleep T imer . • Before using these timers, make sure the b uilt-in clock is set correctly (see page 8). Using Daily T imer and Recording Timer Y ou can set the timer whether the unit is on or off. How the Timer actually works When the o ...
-
JVC UX-H300 - page 25
22 3 F or the Recording T imer ONL Y : Set the off-time y ou want the unit to turn off . (1) Press UP or DO WN to set the hour , then press SET . (2) Press UP or DO WN to set the minute, then press SET . If you want to change the time setting, press CANCEL. • The Recording T imer is activ ated. The (timer) and REC indicators light up. The display ...
-
JVC UX-H300 - page 26
23 Using Sleep T imer W ith Sleep T imer , you can fall asleep to your fav orite music or radio program. • Y ou can set Sleep T imer only when the unit is turned on. • Y ou can also turn off the unit automatically by using Auto Standby . (See page 8.) How the Sleep Timer actually works The unit automatically turns off after the specif ied lengt ...
-
JVC UX-H300 - page 27
24 Maintenance T o get the best performance of the unit, keep your discs, tapes and mechanism clean. General Notes In general, you will hav e the best performance by keeping your discs, tapes and the mechanism clean. • Store discs and tapes in their cases, and keep them in cabinets or on shelves. Cleaning the unit • Stains on the unit Should be ...
-
JVC UX-H300 - page 28
25 If you are having a problem with your unit, check this list for a possible solution before calling for service. If you cannot solve the problem from the hints gi ven here, or the unit has been physically damaged , call a qualified person, such as your dealer for service. T roubleshooting Symptom Po wer does not come on. No sound is heard. Hard t ...
-
JVC UX-H300 - page 29
26 Amplifier Section Output Po wer: 15 W per channel, min. RMS, driven into 4 Ω at 1 kHz with no more than 10% total harmonic distortion. (IEC268-3) Audio input sensiti vity/Impedance (at 1 kHz) A UX: 500 mV/50 k Ω Speakers Impedance: 4 Ω – 16 Ω T uner FM tuning range: 87.50 MHz – 108.00 MHz AM (MW) tuning range: 522 kHz – 1 629 kHz C ...
-
JVC UX-H300 - page 30
MEMO memo_HX-Z77D&55D[U]fff.p65 04.2.18, 9:30 AM 1 ...
-
JVC UX-H300 - page 31
MEMO memo_HX-Z77D&55D[U]fff.p65 04.2.18, 9:30 AM 2 ...
-
JVC UX-H300 - page 32
EN 0304AIMMDWORI © 2004 VICTOR COMPANY OF JAPAN, LIMITED VICT OR COMP ANY OF JAP AN, LIMITED UX-H330/UX-H300 MICRO COMPONENT SYSTEM UX-H330&H300[B]cover1.p65 04.3.17, 0:06 PM 2 ...
Do you have a question concerning JVC UX-H300?
Use the form below
If you did not solve your problem by using a manual JVC UX-H300, ask a question using the form below. If a user had a similar problem with JVC UX-H300 it is likely that he will want to share the way to solve it.