English dropdown-ico

Manual Sun Microsystems 150

20 pages 1.15 mb
Download

Go to site of 20

Summary
  • Sun Microsystems 150 - page 1

    Sun Microsystems, Inc. 4150 Network Circle Santa Clara, CA 95054 U .S.A. 650-960-1300 Send comments about this document to: docfeedback@sun.com Sun Blade™ 150 CD-R OM, D VD-R OM, and Hard Dr iv e Installation Guide P ar t No. 816-5369-10 June 2002, Re vision A ...

  • Sun Microsystems 150 - page 2

    Please Recycle Copyright 2002 Sun Microsystems, Inc., 4150 Network Circle, Santa Clara, California 95054, U.S.A. All rights reserved. Sun Microsystems, Inc. has intellectual pr operty rights relating to technology embodied in the product that is described in this document. In particular , and without limitation, these intellectual pr operty rights ...

  • Sun Microsystems 150 - page 3

    iii Contents Sun Blade 150 CD-ROM, DVD-ROM, and Hard Drive Installation 1 Required Tools 1 Preparing to Replace Components 2 Powering Off the System 2 Removing the System Cover 3 Attaching the Antistatic W rist Strap 4 Removing a Primary Hard Drive 5 Replacing a Primary Hard Drive 7 Installing a Secondary Hard Drive 8 Removing a CD-ROM or DVD-ROM D ...

  • Sun Microsystems 150 - page 4

    iv Sun Blade 150 CD-ROM, DVD-ROM, and Hard Drive Installation Guide • June 2002 Cleaning a CD or DVD 16 Handling and Storing CDs and DVDs 16 ...

  • Sun Microsystems 150 - page 5

    1 Sun Blade 150 CD-ROM, DVD-ROM, and Har d Drive Installation This guide provides instructions for installing a CD-ROM, DVD-ROM, or hard drive in your Sun Blade 150™ system. Requir ed T ools The following tools are r equired to service the Sun Blade 150 system: ■ No. 2 Phillips screwdriver (magnetized tip suggested) ■ Antistatic wrist strap ? ...

  • Sun Microsystems 150 - page 6

    2 Sun Blade 150 CD-ROM, DVD-ROM, and Hard Drive Installation Guide • June 2002 Pr eparing to Replace Components Follow these procedur es to ensure that you safely save data and power off the system. Powering Of f the System Caution – Exit from the operating system before turning of f system power . Failure to do so may result in data loss. 1. B ...

  • Sun Microsystems 150 - page 7

    Sun Blade 150 CD-ROM, D VD-ROM, and Hard Drive Installation 3 2. V erify the following: ■ The front panel power -indicator LED is off. ■ The system fans are not spinning. 3. T urn off the power to the monitor and any peripheral equipment. 4. Disconnect cables to any peripheral equipment. Caution – Pressing the power switch does not r emove al ...

  • Sun Microsystems 150 - page 8

    4 Sun Blade 150 CD-ROM, DVD-ROM, and Hard Drive Installation Guide • June 2002 FIGURE 2 Removing the System Cover Attaching the Antistatic W rist Strap 1. Unwrap the f irst two folds of the wrist strap. W rap the adhesive side f irmly against your wrist. 2. Peel the liner from the copper foil at the opposite end of the wrist strap. 3. Attach the ...

  • Sun Microsystems 150 - page 9

    Sun Blade 150 CD-ROM, D VD-ROM, and Hard Drive Installation 5 FIGURE 3 Attaching the W rist Strap to the Chassis Removing a Primary Har d Drive 1. Power off the system, remove the system cover , and attach an antistatic wrist strap as described in “Preparing to Replace Components” on page 2. Caution – Use proper ESD gr ounding techniques when ...

  • Sun Microsystems 150 - page 10

    6 Sun Blade 150 CD-ROM, DVD-ROM, and Hard Drive Installation Guide • June 2002 8. Lift the hard drive tray from the hard drive. FIGURE 4 Removing and Replacing a Primary Hard Drive 1 2 3 4 CD/D VD-ROM drive IDE 1 (J504) IDE cable connector ...

  • Sun Microsystems 150 - page 11

    Sun Blade 150 CD-ROM, D VD-ROM, and Hard Drive Installation 7 Replacing a Primary Har d Drive Note – Read the hard drive pr oduct guide for information about jumpers, switch settings, or other installation tasks. Note – Before you r eplace any hard drive, verify that the hard drive mode-select jumper is set to “CS,” “Enable Cable Select,? ...

  • Sun Microsystems 150 - page 12

    8 Sun Blade 150 CD-ROM, DVD-ROM, and Hard Drive Installation Guide • June 2002 Installing a Secondary Har d Drive The optional secondary hard drive mounts next to the primary hard drive on the hard drive tray ( FIGURE 5 ). The secondary IDE cable assembly is used with the secondary hard drive. Use the following procedur e to install the optional ...

  • Sun Microsystems 150 - page 13

    Sun Blade 150 CD-ROM, D VD-ROM, and Hard Drive Installation 9 FIGURE 5 Installing a Secondary Hard Drive 10. V erify that the secondary IDE cable connector is connected to riser board connector IDE2 (J503). See FIGURE 7 . Note – Ensure that the cables ar e properly oriented by aligning the connector keys. 1 1. V erify that the CD-ROM or DVD-ROM c ...

  • Sun Microsystems 150 - page 14

    10 Sun Blade 150 CD-ROM, DVD-ROM, and Hard Drive Installation Guide • June 2002 FIGURE 6 Riser Board, Side T wo 13. Connect the power cable to the secondary hard drive ( FIGURE 7 ). 14. Connect the power cable to the primary hard drive. 15. Connect the secondary hard drive to the cable connector labeled “Secondary HDD”. The following diagram ...

  • Sun Microsystems 150 - page 15

    Sun Blade 150 CD-ROM, D VD-ROM, and Hard Drive Installation 11 16. Detach the wrist strap, replace the system cover , and power on the system as described in “Finishing Component Replacement” on page 13. Removing a CD-ROM or DVD-ROM Drive 1. Remove any CD or DVD media from the drive. 2. Power off the system, remove the system cover , and attach ...

  • Sun Microsystems 150 - page 16

    12 Sun Blade 150 CD-ROM, DVD-ROM, and Hard Drive Installation Guide • June 2002 FIGURE 8 Removing and Replacing a CD-ROM or DVD-ROM Drive Replacing a CD-ROM or DVD-ROM Drive Note – Before you r eplace the CD-ROM or DVD-ROM drive, verify that the CD-ROM drive jumper (located on the CD-ROM drive back panel) is set to either “CS,” “Cable Sel ...

  • Sun Microsystems 150 - page 17

    Sun Blade 150 CD-ROM, D VD-ROM, and Hard Drive Installation 13 6. Detach the wrist strap, replace the system cover , and power on the system as described in “Finishing Component Replacement” on page 13. Finishing Component Replacement 1. Remove the wrist strap from the system chassis and from your wrist. 2. Position the system cover onto the sy ...

  • Sun Microsystems 150 - page 18

    14 Sun Blade 150 CD-ROM, DVD-ROM, and Hard Drive Installation Guide • June 2002 Powering On the System 1. Connect the system power cord to the system and to an AC power outlet. 2. Reconnect and turn on power to any peripherals (so that the system can recognize the peripherals when it is powered on). 3. Press the front panel power switch ( FIGURE ...

  • Sun Microsystems 150 - page 19

    Sun Blade 150 CD-ROM, D VD-ROM, and Hard Drive Installation 15 Har d Drive Mirroring Conf iguration The IDE subsystem of the Sun Blade 150 system has two independent channels designated “primary” and “secondary .” The system riser board has a connector for each IDE Channel, labelled IDE1 (J504) and IDE 2 (J503). Note – When mirroring har ...

  • Sun Microsystems 150 - page 20

    16 Sun Blade 150 CD-ROM, DVD-ROM, and Hard Drive Installation Guide • June 2002 2. Place the CD (label side up) into the tray . Ensure that the CD is pr operly set into the recessed area of the tray . 3. Push the tray to close it. Ejecting a CD or DVD Y ou may need to unmount the CD before manually ejecting it. There ar e three ways to eject a CD ...

Manufacturer Sun Microsystems Category Computer Drive

Documents that we receive from a manufacturer of a Sun Microsystems 150 can be divided into several groups. They are, among others:
- Sun Microsystems technical drawings
- 150 manuals
- Sun Microsystems product data sheets
- information booklets
- or energy labels Sun Microsystems 150
All of them are important, but the most important information from the point of view of use of the device are in the user manual Sun Microsystems 150.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Sun Microsystems 150, service manual, brief instructions and user manuals Sun Microsystems 150. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Sun Microsystems 150.

Similar manuals

A complete manual for the device Sun Microsystems 150, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Sun Microsystems 150 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Sun Microsystems 150.

A complete Sun Microsystems manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Sun Microsystems 150 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Sun Microsystems 150, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Sun Microsystems 150, that we can find in the current document
3. Tips how to use the basic functions of the device Sun Microsystems 150 - which should help us in our first steps of using Sun Microsystems 150
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Sun Microsystems 150
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Sun Microsystems 150 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Sun Microsystems 150?

Use the form below

If you did not solve your problem by using a manual Sun Microsystems 150, ask a question using the form below. If a user had a similar problem with Sun Microsystems 150 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)