Manual Allied Air Enterprises (2

14 pages 0.77 mb
Download

Go to site of 14

Summary
  • Allied Air Enterprises (2 - page 1

    506248-01 Page 1 of 14 Issue 0902 Save these instructions for future reference INST ALLA TION AND MAINTENANCE INSTRUCTIONS (2,4)PHP(13,15) Series Self-Contained Heat Pump Improper installation, adjustment, alteration, service, or maintenance can cause injury or property damage. Refer to this manual. For assistance or additional information, consult ...

  • Allied Air Enterprises (2 - page 2

    Page 2 of 14 506248-01 Issue 0902 INST ALLA TION These instructions explain the recommended method of installation of the PHP heat pump unit and associated electrical wiring. This unit is designed and approved for use as a self- contained air-to-air outdoor heat pump system. The units are factory equipped with a transformer and blower control for a ...

  • Allied Air Enterprises (2 - page 3

    506248-01 Page 3 of 14 Issue 0902 Using Accessory Lif t Kit Figure 1 Units may also be moved or lifted with a forklif t while still in the factory-supplied packaging. The lengths of the forks of the forklif t must be a minimum of 42". Roof Curb Installation If a roof curb is used, follow the manufacturer’s Installation Instructions and be su ...

  • Allied Air Enterprises (2 - page 4

    Page 4 of 14 506248-01 Issue 0902 Ductwork Ductwork should be designed and sized according to the methods in Manual Q of the Air Conditioning Contractors of America (ACCA). A closed return duct system shall be used. This shall not preclude use of economizers or outdoor fresh air intake. It is recommended that supply and return duct connections at t ...

  • Allied Air Enterprises (2 - page 5

    506248-01 Page 5 of 14 Issue 0902 Power supply to the unit must comply with all applicable codes and the National Electical Code (NEC) or Canadian Electrical Code (CEC). A fused disconnect switch should be field provided for the unit. The switch must be sep arate from all other circuit s. Figure 5 Electrical Access Heater P ow er Entr y Thermostat ...

  • Allied Air Enterprises (2 - page 6

    Page 6 of 14 506248-01 Issue 0902 Thermostat The room thermostat should be located on an inside wall where it will not be subject to draft s, sun exposure, or heat from electrical fixtures or appliances. Follow the manufacturer ’ s instructions enclosed with thermostat for general installation procedure. Color-coded insulated wires (#18 A WG) sho ...

  • Allied Air Enterprises (2 - page 7

    506248-01 Page 7 of 14 Issue 0902 OPERA TION Sequence of Operation Cooling When the thermostat is in the cooling mode, the O circuit is powered which energizes the reversing valve. Upon cooling demand, the thermostat closes circuit R and Y . Closing R and Y closes the unit cont actor , starting the compressor and outdoor fan. The thermostat automat ...

  • Allied Air Enterprises (2 - page 8

    Page 8 of 14 506248-01 Issue 0902 jumper is not in place, the control defaults to a 90-minute defrost interval. The maximum defrost period is 14 minutes and cannot be adjusted. A test option is provided for troubleshooting. The test mode may be started any time the unit is in the heating mode and the defrost thermostat is closed or jumpered. If the ...

  • Allied Air Enterprises (2 - page 9

    506248-01 Page 9 of 14 Issue 0902 There is no blower “on” delay after a call for heating or cooling. Blower “off” delay is 90 seconds af ter the thermostat is satisfied. V ariable Speed Motor Units equipped with a variable speed circulation air blower motor will deliver a constant airflow within a wide range of external static pressures. Ot ...

  • Allied Air Enterprises (2 - page 10

    Page 10 of 14 506248-01 Issue 0902 Owner Record Model # _________________________________ Serial # _________________________________ Installation Date ___________________________ Installed by: Dealer __________________________________ Address _________________________________ T elephone # ______________________________ License # ___________________ ...

  • Allied Air Enterprises (2 - page 11

    506248-01 Page 11 of 14 Issue 0902 Figure 9 208/230V -1-60 G W1 CR O BLK RED YEL RED CONT ACT OR THERMOST A T HIGH PRESSURE SWITCH (IF USED) L1 T1 T2 L2 C H F CONDENSER F AN MO TOR COMPRESSOR CONT ACT OR COMPRESSOR CONT ACT OR DUAL CAP ACIT OR COMPRESSOR TRANSFORMER C S R WHT L2 L1 BLK BRN PUR RED RED BLK 208V 240V 24V INDOOR BLOWER MOTO R S4 S1 K1 ...

  • Allied Air Enterprises (2 - page 12

    Page 12 of 14 506248-01 Issue 0902 Connection Diagram Single Phase – V ariable Speed Motor P/N 48374-001 Figure 10 DIAGNOSTIC DISPLA Y Note: Because the pressure switches are monitored only when "Y1" (Input) is activ e, the code for pressure s witch open will not be seen when "Y1" is off . Instead, the “Normal Operation" ...

  • Allied Air Enterprises (2 - page 13

    506248-01 Page 13 of 14 Issue 0902 ALLIED AIR ENTERPRISES EQUIPMENT LIMITED W ARRANTY APPLIES IN U.S.A. AND CANADA ONL Y F AILURE T O MAINT AIN YOUR EQUIPMENT WILL VOID THIS W ARRANTY COVERED EQUIPMENT The following Allied Air Enterprises heating and cooling equipment is covered by the Limited Warranty , Condensing Units: 2SCU13, 4SCU13, 4SCU14, 4S ...

  • Allied Air Enterprises (2 - page 14

    Page 14 of 14 506248-01 Issue 0902 Allied Air Enterprises Inc. (“Allied Air”) provides its air conditioning and heating product s with a S tandard Limited Parts W a rranty for five (5) years. This additional 5-Y ear Limited Extended Parts W arranty is in addition to and is intended to supplement Allied Air ’s St andard Limited Parts W arranty ...

Manufacturer Allied Air Enterprises Category Heat Pump

Documents that we receive from a manufacturer of a Allied Air Enterprises (2 can be divided into several groups. They are, among others:
- Allied Air Enterprises technical drawings
- (2 manuals
- Allied Air Enterprises product data sheets
- information booklets
- or energy labels Allied Air Enterprises (2
All of them are important, but the most important information from the point of view of use of the device are in the user manual Allied Air Enterprises (2.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Allied Air Enterprises (2, service manual, brief instructions and user manuals Allied Air Enterprises (2. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Allied Air Enterprises (2.

A complete manual for the device Allied Air Enterprises (2, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Allied Air Enterprises (2 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Allied Air Enterprises (2.

A complete Allied Air Enterprises manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Allied Air Enterprises (2 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Allied Air Enterprises (2, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Allied Air Enterprises (2, that we can find in the current document
3. Tips how to use the basic functions of the device Allied Air Enterprises (2 - which should help us in our first steps of using Allied Air Enterprises (2
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Allied Air Enterprises (2
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Allied Air Enterprises (2 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Allied Air Enterprises (2?

Use the form below

If you did not solve your problem by using a manual Allied Air Enterprises (2, ask a question using the form below. If a user had a similar problem with Allied Air Enterprises (2 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)