Manual Winegard RM-EX02

11 pages 0.87 mb
Download

Go to site of 11

Summary
  • Winegard RM-EX02 - page 1

    ® R V DIGIT AL SA TELLITE SYSTEM with Digital Elevation Sensor Model RM-EX02 Made in U.S.A. Winegard Company • 3000 Kirkwood St. • Burlington, IA 52601-2000 319/754-0600 • F AX 319/754-0787 • www . winegard.com Printed in U.S.A. © Winegard Company 2009 2452168 REV6 12/12 ...

  • Winegard RM-EX02 - page 2

    T uning Antenna STEP 1 . Y our receiver should indicate it is receiving a signal. T o tune your antenna for the best signal strength. SLOWL Y move the antenna left, then right, until you have found the position that gives the highest signal strength. It is important to turn the antenna slowly . Because the signal is digital, the receiver takes a fe ...

  • Winegard RM-EX02 - page 3

    4 5 Things you need — Screwdrivers (Phillips and slot) 1-3/4” hole saw 7/16” wrench ABS glue Drill with 1/8” bit T ape measure Non-hardening sealant (Check manufacturer ’s specications for compatibility with your roof material.) Winegard’ s Digital Elevation Sensor has been INST ALLED and CALIBRA TED at the factory STEP 1. Choose a l ...

  • Winegard RM-EX02 - page 4

    THREADED ROD, W ASHER AND NUT FIGURE 8 INSIDE RV Special instructions: For roof thickness greater than 6-1/2”. Parts Needed: (not included) RP-4400 14” worm gear for roof 3200369 Directional handle extension 2162031 Long threaded rod Instructions: STEP 8. Place nut on threaded rod. See Figure 8. STEP 9. Measure and cut the threaded rod with a h ...

  • Winegard RM-EX02 - page 5

    See template on reverse side. STEP 15. The directional handle and threaded rod will t roofs up to 5-1/4” thick. If you are using wedges to compensate for roof/cceiling slope, be sure to allow fo r this extra thickness. Y ou may add an extension to the directional handle for thicker roofs. Each extension will increase the length of the directio ...

  • Winegard RM-EX02 - page 6

    ALIGN WITH BASEPLA TE AREA MARKED “FRONT” POINT T O FRONT OF VEHICLE  Roof T emplate 1/8” DRILL BIT 8 HOLES. DO NOT DRILL THROUGH CEILING. 1-3/4” DIA. DRILL COMPLETEL Y THROUGH CEILING  ...

  • Winegard RM-EX02 - page 7

    9 300 310 320 330 340 350 50 20 30 40 POINT NORTH 290 10 60 70 240 250 CAUTION! After INITIAL INST ALLA TION , the antenna SHOULD ROT A TE APPROXIMA TEL Y360°FROM TRA VEL POSITION. The pointer on the DIRECTIONAL HANDLE should point towards the RED SCREW ON THE ROT A TION CLAMP when in the TRA VEL POSITION. FIGURE 14 FIGURE 15 FIGURE 16 POINT ...

  • Winegard RM-EX02 - page 8

    10 11 FIGURE 17 Based on 5 minutes a day of usage, standard new alkaline batteries should last 88 days. STEP 19. See Figure 17. If using the SM-1000 surface mount box, feed cable through hole in box. STEP 20. Connect wires coming from sensor on roof to wall plate display in vehicle. It is important to properly connect the wires at the roof and the ...

  • Winegard RM-EX02 - page 9

    Parts List Feed Arm P .N. 2744946 46cmReector (4) Flat Head Bolts Back-up Frame Pivot Bracket Pin, 1/4 x 3.25” long (Not Shown: E-clip for 1/4” Pin T ravel Support LNBF LB-6000 Carriage Bolt (not shown) Flange Nut 1/4-20 Roller Hex Head Bolt 1/4-20 x 2.5” Nylock Nut 1/4-20 (not shown) Screw #10-24 x 3/4 (4) Clamp (2) (2) #10-32 x 1/2 ...

  • Winegard RM-EX02 - page 10

    14 15 Notes Notes ...

  • Winegard RM-EX02 - page 11

    ANTENNA & MOUNT Height when raised 30” vertical max. Height in the travel position 8” max. Operating radius 17” (34” diameter circle) Roof space required 26” LNB Compatible with DIRECTV ® , DISH ® , and Bell TV™ (northern U.S. and Canada) Weight 12 lbs Color Cool gray Antenna height 20.9” Antenna width 19.2” F/D 0.59 Offset an ...

Manufacturer Winegard Category Satellite TV System

Documents that we receive from a manufacturer of a Winegard RM-EX02 can be divided into several groups. They are, among others:
- Winegard technical drawings
- RM-EX02 manuals
- Winegard product data sheets
- information booklets
- or energy labels Winegard RM-EX02
All of them are important, but the most important information from the point of view of use of the device are in the user manual Winegard RM-EX02.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Winegard RM-EX02, service manual, brief instructions and user manuals Winegard RM-EX02. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Winegard RM-EX02.

Similar manuals

A complete manual for the device Winegard RM-EX02, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Winegard RM-EX02 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Winegard RM-EX02.

A complete Winegard manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Winegard RM-EX02 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Winegard RM-EX02, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Winegard RM-EX02, that we can find in the current document
3. Tips how to use the basic functions of the device Winegard RM-EX02 - which should help us in our first steps of using Winegard RM-EX02
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Winegard RM-EX02
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Winegard RM-EX02 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Winegard RM-EX02?

Use the form below

If you did not solve your problem by using a manual Winegard RM-EX02, ask a question using the form below. If a user had a similar problem with Winegard RM-EX02 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)