English dropdown-ico

Manual Shindaiwa 80775

16 pages 0.79 mb
Download

Go to site of 16

Summary
  • Shindaiwa 80775 - page 1

    SHINDAIW A OWNER’S/ OPERA TOR'S MANUAL HT231 HEDGE TRIMMER WARNING! Minimize the risk of injury to yourself and others! Read this manual and familiarize yourself with the contents. Always wear eye and hearing protection when operating this unit. Part Number 80775 Rev. 9/03 姞 SHINDAIW A MANUAL DEL PROPIET ARIO/OPERADOR COR T ADORA DE SETOS ...

  • Shindaiwa 80775 - page 2

    2 WARNING! A statement preceded by the triangu- lar Attention Symbol and the word "WARNING" contains information that should be acted upon to prevent serious bodily injury. IMPORTANT! The operational procedures described in this manual are intended to help you get the most from your unit, and to protect you and others from harm. These pro ...

  • Shindaiwa 80775 - page 3

    3 Work Safely Shindaiwa hedge trimmers operate at very high speeds and can do serious damage or injury if they are misused or abused. Never allow a person without training or instruction to operate your unit! WARNING! Use Good Judgment Stay Alert You must be physically and mentally fit to operate this unit safely. General Safety Instructions WARNIN ...

  • Shindaiwa 80775 - page 4

    4 Safety Equipment and Labels HT231_1 Cover Caution Label ON-OFF Switch Throttle Interlock Protector Caution Label IMPORTANT! Caution, Danger, Warning, and Opera- tion Information Labels: Make sure all information labels are undamaged and readable. Immediately replace damaged or missing information labels. New labels are available from your local a ...

  • Shindaiwa 80775 - page 5

    5 HT231_2 Unit Description Using the accompanying illustrations as a guide, familiarize yourself with your unit and its various components. Understand- ing your unit helps ensure top perfor- mance, long service life, and safer operation. Air Cleaner Cover Fuel Tank Protector Gearcase Throttle Trigger Front Handle Choke Rear Handle ON-OFF Switch Gui ...

  • Shindaiwa 80775 - page 6

    6 IMPORTANT! Mix only enough fuel for your immediate needs! If fuel must be stored longer than 30 days and oil with fuel stabilizer is not used, it should first be treated with a fuel stabilizer such as StaBil™. Filling the Fuel T ank 1. Place the trimmer on a flat, level surface. 2. Clear any dirt or other debris from around the fuel filler cap. ...

  • Shindaiwa 80775 - page 7

    7 HT231_11 HT231_10 HT231_8 HT231_9 Starting Procedure 2. Set the throttle trigger to the “fast idle” position by performing the following: a. Depress and hold the throttle lock, and then squeeze the throttle trigger. b. Depress and hold the “fast idle” button. c. While depressing the fast idle button, release the throttle lock and throttle ...

  • Shindaiwa 80775 - page 8

    8 HT231_16 HT231_15 The engine must return to idle speed whenever the throttle lever is released. Idle speed is adjustable, and must be set low enough to permit the engine clutch to disengage the cutters. Adjusting Engine Idle Stopping the Engine Idle Adjustment Screw Ignition Switch Ignition OFF 1. Cool the engine by allowing it to idle for 2–3 ...

  • Shindaiwa 80775 - page 9

    9 HT231_7a Maintenance and Adjustments IMPORTANT! Maintenance, replacement or repair of emission control devices and systems may be performed by any repair estab- lishment or individual; however, warranty repairs must be performed by a dealer or service center authorized by Shin- daiwa Kogyo Co., Ltd. The use of parts that are not equivalent in per ...

  • Shindaiwa 80775 - page 10

    10 HT231_23 HT231_21 HT231_24 1. Remove the cylinder cover, and clean any grass and debris from the cylinder fins. 2. Remove and inspect the spark plug. Replace any damaged or worn spark plug with a new Champion CJ8Y or equivalent. Adjust spark plug gap to 0.024 inch (0.6mm) and reinstall. If a torque wrench is available, torque the plug to 148–1 ...

  • Shindaiwa 80775 - page 11

    11 HT231_25 5 mm Muffler Screws Lower Muffler Screw Forward Muffler Shield Spark Arrester Screen Rear Muffler Shield Catalyst Muffler Rear Muffler Shield Bolt 135-hour Maintnenace Every 135 hours of operation, remove and clean the muffler. IMPORTANT! Please use screw lock material such as ThreeBond 1360 in the muffler bolt threads at reassembly. IM ...

  • Shindaiwa 80775 - page 12

    12 ENGINE DOES NOT START T roubleshooting Guide Does the engine crank? Faulty recoil starter. Fluid in the crankcase. Internal damage. Consult with an authorized servicing dealer. Consult with an authorized servicing dealer. Consult with an authorized servicing dealer. NO Good compression? Loose spark plug. Excess wear on cylinder, piston, rings. T ...

  • Shindaiwa 80775 - page 13

    13 T roubleshooting Guide (continued) LOW POWER OUTPUT Is the engine overheating? Operator is overworking the unit. Carburetor mixture is too lean. Improper fuel ratio. Fan, fan cover, cylinder fins dirty or damaged. Carbon deposits on the piston or in the muffler. Shorten trimmer line. Cut at a slower rate. Consult with an authorized servicing dea ...

  • Shindaiwa 80775 - page 14

    14 T roubleshooting Guide (continued) ADDITIONAL PROBLEMS Poor acceleration. Clogged air cleaner element. Clogged fuel filter. Carburetor mixture too lean. Idle speed set too low. Clean the air cleaner element. Replace the fuel filter. Consult with an authorized servicing dealer. Adjust: 3,000 ( Ⳳ 250) rpm (min -1 ) Symptom Possible Cause Remedy ...

  • Shindaiwa 80775 - page 15

    15 Owners Warranty Responsibilities As the small off-road engine owner, you are responsible for the performance of the required maintenance listed in this owners manual. Shindaiwa Kogyo Co., Ltd. recommends that you retain all receipts covering maintenance on your small off-road engine, but Shindaiwa Kogyo Co., Ltd. cannot deny warranty solely for ...

  • Shindaiwa 80775 - page 16

    姞 Shindaiwa Inc. 11975 S.W. Herman Rd. Tualatin, Oregon 97062 Telephone: 503 692-3070 Fax: 503 692-6696 www.shindaiwa.com NOTES: Shindaiwa Kogyo Co., Ltd. Head Office: 6-2-11 Ozuka Nishi, Asaminami-ku Hiroshima, 731-3167, Japan Telephone: 81-82-849-2220 Fax: 81-82-849-2481 䊚 2003 Shindaiwa, Inc. Part Number 80775 Revision 9/03 Shindaiwa is a re ...

Manufacturer Shindaiwa Category Trimmer

Documents that we receive from a manufacturer of a Shindaiwa 80775 can be divided into several groups. They are, among others:
- Shindaiwa technical drawings
- 80775 manuals
- Shindaiwa product data sheets
- information booklets
- or energy labels Shindaiwa 80775
All of them are important, but the most important information from the point of view of use of the device are in the user manual Shindaiwa 80775.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Shindaiwa 80775, service manual, brief instructions and user manuals Shindaiwa 80775. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Shindaiwa 80775.

Similar manuals

A complete manual for the device Shindaiwa 80775, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Shindaiwa 80775 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Shindaiwa 80775.

A complete Shindaiwa manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Shindaiwa 80775 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Shindaiwa 80775, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Shindaiwa 80775, that we can find in the current document
3. Tips how to use the basic functions of the device Shindaiwa 80775 - which should help us in our first steps of using Shindaiwa 80775
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Shindaiwa 80775
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Shindaiwa 80775 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Shindaiwa 80775?

Use the form below

If you did not solve your problem by using a manual Shindaiwa 80775, ask a question using the form below. If a user had a similar problem with Shindaiwa 80775 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)